Amir Aghamohammadi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Amir Aghamohammadi has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad Khorrami
Department of Fundamental Physics, Faculty of Physics, Alzahra University, Tehran, Iran
71 shared publications - Ahmad Shariati
Department of Physics, Faculty of Physics and Chemistry, Alzahra University, Tehran, Iran
10 shared publications - Amir H. Fatollahi
Department of Fundamental Physics, Faculty of Physics, Alzahra University, Tehran, Iran
9 shared publications A. Shariati
Institute for Studies in Theoretical Physics and Mathematics
4 shared publicationsCina Aghamohammadi
Sharif Univ Technol, Dept Elect Engn, Tehran 1136511155, Iran
3 shared publicationsM. Alimohammadi
Physics Department|University of Tehran
3 shared publications
Latest Publications
- 1 July 2025
- Published by Canadian Science Publishing in Canadian Journal of Physics
- Vol. 103 (7) , 623-629
Incompressible laminar and inviscid flow through a cylindrical duct of an arbitrary cross section, using dimensional analysis
The problem of laminar and inviscid flow in a duct, taking into account the effect of roughness of inner walls, is studied based on an extended use of dimensional analysis. We demonstrate how using dimensional analysis, combined with symmetries of the system and general forms of equations governing the flow, some general results including approximate expressions for the flow rate and average velocity can be obtained.
- 1 July 2025
- Published by Canadian Science Publishing in Canadian Journal of Physics
- Vol. 103 (7) , 623-629
Incompressible laminar and inviscid flow through a cylindrical duct of an arbitrary cross section, using dimensional analysis
The problem of laminar and inviscid flow in a duct, taking into account the effect of roughness of inner walls, is studied based on an extended use of dimensional analysis. We demonstrate how using dimensional analysis, combined with symmetries of the system and general forms of equations governing the flow, some general results including approximate expressions for the flow rate and average velocity can be obtained.
- 21 January 2025
- Published by Springer Nature in The European Physical Journal E
- Vol. 48 (1) , 1-20
Simulation of a liquid drop on a soft substrate
A liquid drop resting on a soft substrate is numerically simulated as an energy minimization problem. The elastic substrate is modeled as a cubic lattice o
- 21 January 2025
- Published by Springer Nature in The European Physical Journal E
- Vol. 48 (1) , 1-20
Simulation of a liquid drop on a soft substrate
A liquid drop resting on a soft substrate is numerically simulated as an energy minimization problem. The elastic substrate is modeled as a cubic lattice o
- 1 November 2024
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 16 (6)
Rotating solar furnace
A rotary solar furnace is conceptually introduced. In contrast to a conventional solar furnace, where the concentrator is fixed, in a rotary solar furnace both the concentrator and the heliostat rotate in concentric circular path around the concentrator's focus such that at each instant of time they face each other. The angular velocity of this motion equals the angular velocity of the Sun's projection line onto the Earth. In this dynamic solar furnace, the Sun appears always right above the heliostat. Consequently, the heliostat needs only a single-axis elevation tracking to redirect the sunlight along the concentrator's optical axis. This implies that the amount of harvested energy is maximal while the focus remains fixed in space. The daily concentrated radiation energy is analytically computed for each day of the year given the geographical latitude. It is shown the daily energy increase percentage crucially depends on the day of year and geographical latitude. This increase percentage reaches it maximum value in the summer solstice, which is slightly above 140 percent, for instance, in Tehran, Iran.
- 1 November 2024
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 16 (6)
Rotating solar furnace
A rotary solar furnace is conceptually introduced. In contrast to a conventional solar furnace, where the concentrator is fixed, in a rotary solar furnace both the concentrator and the heliostat rotate in concentric circular path around the concentrator's focus such that at each instant of time they face each other. The angular velocity of this motion equals the angular velocity of the Sun's projection line onto the Earth. In this dynamic solar furnace, the Sun appears always right above the heliostat. Consequently, the heliostat needs only a single-axis elevation tracking to redirect the sunlight along the concentrator's optical axis. This implies that the amount of harvested energy is maximal while the focus remains fixed in space. The daily concentrated radiation energy is analytically computed for each day of the year given the geographical latitude. It is shown the daily energy increase percentage crucially depends on the day of year and geographical latitude. This increase percentage reaches it maximum value in the summer solstice, which is slightly above 140 percent, for instance, in Tehran, Iran.
- 18 April 2024
- Published by IOP Publishing in European Journal of Physics
- Vol. 45 (3) , 035804
Strange property of physical quantities of some petal shape objects
We study various physical quantities of objects with petal shapes. N-petal shapes exhibit N-fold rotational symmetry. Furthermore, they might have an additional characteristic: the equation defining their boundaries could be represented by F(N θ). We will show that physical quantities of objects with these characteristics may show strange properties. By ‘physical quantities’, we refer to aspects such as electric potential and electric field due to a charged petal-shaped plate or cylinder on the rotation axis, their mass and moment of inertia. We are going to show that for such objects, these physical observables do not depend on the number of petals, N. This intriguing result has a simple reason.
- 18 April 2024
- Published by IOP Publishing in European Journal of Physics
- Vol. 45 (3) , 035804
Strange property of physical quantities of some petal shape objects
We study various physical quantities of objects with petal shapes. N-petal shapes exhibit N-fold rotational symmetry. Furthermore, they might have an additional characteristic: the equation defining their boundaries could be represented by F(N θ). We will show that physical quantities of objects with these characteristics may show strange properties. By ‘physical quantities’, we refer to aspects such as electric potential and electric field due to a charged petal-shaped plate or cylinder on the rotation axis, their mass and moment of inertia. We are going to show that for such objects, these physical observables do not depend on the number of petals, N. This intriguing result has a simple reason.
- Open Access
- 1 September 2023
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 15 (5)
Evaluation of direct beam energy received by convex solar collectors and their optimal orientations
We use analytical and numerical methods to evaluate the daily beam energy received by some convex surfaces. Spherical, hemispherical, cylindrical, and semi-cylindrical convex surfaces with arbitrary tilt angles have been investigated and compared with a flat surface of unit area. Diffusive irradiations (sky and ground) were not considered. For hemispherical and semi-cylindrical surfaces, the optimal orientations at which the received beam energy is maximal were obtained for each day of the year. The dependence of the optimal tilt angle on the day of the year is qualitatively the same as for the flat surface. Clear sky condition has been assumed to hold in this work. It is shown that a flat surface per unit of its area receives highest beam energy among other convex surfaces whereas a sphere receives the least amount. Furthermore, the received daily beam energy per unit of the ground-occupied area has been calculated. In this case, a cylindrical surface with a range of values of radius to height ratio receives the highest amount of energy whereas a flat surface receives the least. This aspect becomes noticeable in places where there are some limits, e.g., land price or any other limitation on the available surface area.
- 1 September 2023
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 15 (5)
Open AccessEvaluation of direct beam energy received by convex solar collectors and their optimal orientations
We use analytical and numerical methods to evaluate the daily beam energy received by some convex surfaces. Spherical, hemispherical, cylindrical, and semi-cylindrical convex surfaces with arbitrary tilt angles have been investigated and compared with a flat surface of unit area. Diffusive irradiations (sky and ground) were not considered. For hemispherical and semi-cylindrical surfaces, the optimal orientations at which the received beam energy is maximal were obtained for each day of the year. The dependence of the optimal tilt angle on the day of the year is qualitatively the same as for the flat surface. Clear sky condition has been assumed to hold in this work. It is shown that a flat surface per unit of its area receives highest beam energy among other convex surfaces whereas a sphere receives the least amount. Furthermore, the received daily beam energy per unit of the ground-occupied area has been calculated. In this case, a cylindrical surface with a range of values of radius to height ratio receives the highest amount of energy whereas a flat surface receives the least. This aspect becomes noticeable in places where there are some limits, e.g., land price or any other limitation on the available surface area.
- Open Access
- 5 August 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-15
Efficiency comparison between tracking and optimally fixed flat solar collectors
We investigate the optimal orientation for a fixed flat plate solar collector using the clear sky model. The ground reflection component of irradiation that hits the collector’s surface is ignored due to its relatively small magnitude when compared to the direct beam and sky diffusive components. Analytical calculations demonstrate that regardless of the collector’s latitude, the most effective azimuthal angle, $$\gamma ^*$$ , is 0, which generally corresponds to a North–South direction. However, the optimal tilt angle, $$\beta ^*$$ , is dependent on both the Day of Year (DoY) and the collector’s local latitude. For latitudes typical of mid-altitude climate zones, we can calculate the optimal tilt angle and the maximum energy that the collector can harvest during each DoY. We compare the maximum daily received energy—which is the sum of the direct beam and sky diffusive energies—associated with this optimal orientation to their corresponding values when the flat plate tracks the Sun. The relative increase in total energy due to Sun tracking depends critically on the DoY, with a minimum value of about $$17\%$$ in early winter and a maximum value of $$40\%$$ over a large interval.- 5 August 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-15
Open AccessEfficiency comparison between tracking and optimally fixed flat solar collectors
We investigate the optimal orientation for a fixed flat plate solar collector using the clear sky model. The ground reflection component of irradiation that hits the collector’s surface is ignored due to its relatively small magnitude when compared to the direct beam and sky diffusive components. Analytical calculations demonstrate that regardless of the collector’s latitude, the most effective azimuthal angle, $$\gamma ^*$$ , is 0, which generally corresponds to a North–South direction. However, the optimal tilt angle, $$\beta ^*$$ , is dependent on both the Day of Year (DoY) and the collector’s local latitude. For latitudes typical of mid-altitude climate zones, we can calculate the optimal tilt angle and the maximum energy that the collector can harvest during each DoY. We compare the maximum daily received energy—which is the sum of the direct beam and sky diffusive energies—associated with this optimal orientation to their corresponding values when the flat plate tracks the Sun. The relative increase in total energy due to Sun tracking depends critically on the DoY, with a minimum value of about $$17\%$$ in early winter and a maximum value of $$40\%$$ over a large interval. - 7 July 2023
- Published by IOP Publishing in European Journal of Physics
- Vol. 44 (5) , 055002
On swimmer’s strategies in various currents
Finding an optimum strategy to reach a certain destination by swimming in a background flow is an interesting question that leads to non-trivial results and swimming paths. Here we consider different strategies for various types of surface currents, including parallel currents, and currents resulting from spring sources, and sinks. Swimmers may instinctively swim toward the destination point. It turns out that this idea may not lead to the desired result in the presence of the background current. We will show in some cases the best strategy is to swim towards a certain point other than the actual destination. A different strategy may be to obtain the path of the least time and then follow the minimized path. We study this alternative strategy, too.
- 7 July 2023
- Published by IOP Publishing in European Journal of Physics
- Vol. 44 (5) , 055002
On swimmer’s strategies in various currents
Finding an optimum strategy to reach a certain destination by swimming in a background flow is an interesting question that leads to non-trivial results and swimming paths. Here we consider different strategies for various types of surface currents, including parallel currents, and currents resulting from spring sources, and sinks. Swimmers may instinctively swim toward the destination point. It turns out that this idea may not lead to the desired result in the presence of the background current. We will show in some cases the best strategy is to swim towards a certain point other than the actual destination. A different strategy may be to obtain the path of the least time and then follow the minimized path. We study this alternative strategy, too.
- Open Access
On swimmer's strategies in various currents
Finding an optimum strategy to reach a certain destination by swimming in a background flow is an interesting question which leads to non-trivial results and swimming paths. Here we consider different strategies for various types of surface currents, including parallel currents, and currents resulting from spring sources, and sinks. Swimmers may instinctively swim toward the destination point. It turns out that this idea may not lead to the desired result in the presence of the background current. We will show in some cases the best strategy is to swim towards a certain point other than the actual destination. A different strategy may be to obtain the path of the least time and then follow the minimized path. We study this alternative strategy, too.
Open AccessOn swimmer's strategies in various currents
Finding an optimum strategy to reach a certain destination by swimming in a background flow is an interesting question which leads to non-trivial results and swimming paths. Here we consider different strategies for various types of surface currents, including parallel currents, and currents resulting from spring sources, and sinks. Swimmers may instinctively swim toward the destination point. It turns out that this idea may not lead to the desired result in the presence of the background current. We will show in some cases the best strategy is to swim towards a certain point other than the actual destination. A different strategy may be to obtain the path of the least time and then follow the minimized path. We study this alternative strategy, too.
- 21 April 2022
- Published by Elsevier in Physica A: Statistical Mechanics and its Applications
- Vol. 599
On a model for death, birth, and immigration
- 21 April 2022
- Published by Elsevier in Physica A: Statistical Mechanics and its Applications
- Vol. 599
On a model for death, birth, and immigration
- 24 March 2022
- Published by IOP Publishing in European Journal of Physics
- Vol. 43 (3) , 035005
Moment of inertia: tricky ways
We use dimensional analysis as well as the parallel axis theorem to obtain the moment of inertia for some homogeneous two-dimensional objects. These objects should possess some sort of symmetry: they should have shapes that can be decomposed into smaller copies of themselves. In the second part of the article, it is seen that as the moment of inertia of a composed object is the summation of the moment of inertia of its decomposed parts, this may give us a shortcut to obtaining the moment of inertia of some objects.
- 24 March 2022
- Published by IOP Publishing in European Journal of Physics
- Vol. 43 (3) , 035005
Moment of inertia: tricky ways
We use dimensional analysis as well as the parallel axis theorem to obtain the moment of inertia for some homogeneous two-dimensional objects. These objects should possess some sort of symmetry: they should have shapes that can be decomposed into smaller copies of themselves. In the second part of the article, it is seen that as the moment of inertia of a composed object is the summation of the moment of inertia of its decomposed parts, this may give us a shortcut to obtaining the moment of inertia of some objects.