María Luisa Contreras
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
María Luisa Contreras has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
A. Bahillo
Sustainable Thermochemical Valorization, Department of Energy, CIEMAT, Madrid, Spain
6 shared publicationsAlberto Bahillo
Sustainable Thermochemical Valorization Unit, Department of Energy, Research Centre for Energy, Environment and Technology (CIEMAT) , Avda. Complutense 40, Madrid 28040
2 shared publicationsF.J. García-Frutos
2 shared publications- I. Rodilla2 shared publications
Ana Gajate
1 shared publicationCristina Laserna
1 shared publication
Latest Publications
- Open Access
- 22 January 2026
- Published by Oxford University Press (OUP) in Clean Energy
- Vol. 10 (3) , 47-58
Operational and environmental assessment of solid biomass residues for bioenergy generation
Biomass waste contains considerable amounts of ash-forming elements that adversely affect boiler operation and consequently reduce economic efficiency. Moreover, such waste may contain heavy metals, requiring thorough assessment prior to use. In this study, the mode of association of ash-forming matter in various categories of biomass waste was determined using a chemical fractionation method. The results obtained were subsequently verified through experimental testing in a bubbling fluidized bed pilot plant. Laboratory results showed that K and Cl exhibit similar modes of association across the different biomass types examined, whereas notable differences were identified for major ash-forming elements such as Na, Ca, S, and P. Based on the differing modes of occurrence of these elements, wheat straw presented the highest risk of hydroxide or carbonate release into the flue gas phase during combustion, followed by eucalyptus wood (EW). This indicates a greater risk of fouling and corrosion compared with the other biomasses studied. Analyses of ash samples from fluidized bed combustion experiments were consistent with the chemical fractionation results, confirming the reliability of the method as a useful tool for predicting the ash-related behavior of new fuels. In the final part of the study, heavy metals in biomass combustion tests were assessed. A significant content of certain commercially valuable metals was found in fly ash (FA) from different biomass wastes, indicating the potential for recovery and contributing to the promotion of a circular economy.
- 22 January 2026
- Published by Oxford University Press (OUP) in Clean Energy
- Vol. 10 (3) , 47-58
Open AccessOperational and environmental assessment of solid biomass residues for bioenergy generation
Biomass waste contains considerable amounts of ash-forming elements that adversely affect boiler operation and consequently reduce economic efficiency. Moreover, such waste may contain heavy metals, requiring thorough assessment prior to use. In this study, the mode of association of ash-forming matter in various categories of biomass waste was determined using a chemical fractionation method. The results obtained were subsequently verified through experimental testing in a bubbling fluidized bed pilot plant. Laboratory results showed that K and Cl exhibit similar modes of association across the different biomass types examined, whereas notable differences were identified for major ash-forming elements such as Na, Ca, S, and P. Based on the differing modes of occurrence of these elements, wheat straw presented the highest risk of hydroxide or carbonate release into the flue gas phase during combustion, followed by eucalyptus wood (EW). This indicates a greater risk of fouling and corrosion compared with the other biomasses studied. Analyses of ash samples from fluidized bed combustion experiments were consistent with the chemical fractionation results, confirming the reliability of the method as a useful tool for predicting the ash-related behavior of new fuels. In the final part of the study, heavy metals in biomass combustion tests were assessed. A significant content of certain commercially valuable metals was found in fly ash (FA) from different biomass wastes, indicating the potential for recovery and contributing to the promotion of a circular economy.
- 27 March 2023
- Published by Grupo Pacifico
Anafilaxia inducida por ejercicio: a propósito de un caso
- Open Access
- 18 October 2022
- Published by Springer Nature in International Journal of Energy and Environmental Engineering
- Vol. 14 (4) , 699-718
Prediction of biomass corrosiveness over different coatings in fluidized bed combustion
Energy production in biomass fired boilers is increasing rapidly due to the advantages of CO2 neutrality and renewability, however damaging agents present in biomass composition accelerates power plant components corrosion. This study evaluates the influence of the biomass burned in fluidized bed combustion processes on high-temperature corrosion, by means of thermodynamic equilibrium modelling, considering those reactions occurring between the combustion atmosphere and different protective coatings (isFeAl, isNiAl and isSiCrAl). Fuels composition and operating conditions from a 10 kW BFB boiler were introduced as input data to improve the performance of the model. Representative samples from agricultural waste, industrial wood and forestry wood waste were selected for evaluation. Results showed industrial wood waste as highly damaging for most coatings studied, with high risk of salt stickiness, deposits formation and release of acidic gases. The elevated volatiles percentage together with significant ash content determined might lead to a major ash components release to the gas phase, available to later condense in the metals surfaces. Silication of alkali and deposited alkali chlorides were the dominant corrosion mechanisms observed for most cases. An increase in alloys corrosion resistance was detected through the model when nickel or chromium was present, showing isSiCrAl as the most resistant. However, alloys protection exhibited significant variations depending upon the biomass burned, thus materials selection should consider the compatibility with conditions for its final use. Thermodynamic modelling, based on real conditions and fuels composition, provides a useful tool to identify key factors for protective coatings design when employing new waste fuels.
- 18 October 2022
- Published by Springer Nature in International Journal of Energy and Environmental Engineering
- Vol. 14 (4) , 699-718
Open AccessPrediction of biomass corrosiveness over different coatings in fluidized bed combustion
Energy production in biomass fired boilers is increasing rapidly due to the advantages of CO2 neutrality and renewability, however damaging agents present in biomass composition accelerates power plant components corrosion. This study evaluates the influence of the biomass burned in fluidized bed combustion processes on high-temperature corrosion, by means of thermodynamic equilibrium modelling, considering those reactions occurring between the combustion atmosphere and different protective coatings (isFeAl, isNiAl and isSiCrAl). Fuels composition and operating conditions from a 10 kW BFB boiler were introduced as input data to improve the performance of the model. Representative samples from agricultural waste, industrial wood and forestry wood waste were selected for evaluation. Results showed industrial wood waste as highly damaging for most coatings studied, with high risk of salt stickiness, deposits formation and release of acidic gases. The elevated volatiles percentage together with significant ash content determined might lead to a major ash components release to the gas phase, available to later condense in the metals surfaces. Silication of alkali and deposited alkali chlorides were the dominant corrosion mechanisms observed for most cases. An increase in alloys corrosion resistance was detected through the model when nickel or chromium was present, showing isSiCrAl as the most resistant. However, alloys protection exhibited significant variations depending upon the biomass burned, thus materials selection should consider the compatibility with conditions for its final use. Thermodynamic modelling, based on real conditions and fuels composition, provides a useful tool to identify key factors for protective coatings design when employing new waste fuels.
- Open Access
- 20 June 2018
- Published by Oxford University Press (OUP) in Clean Energy
- Vol. 2 (2) , 167-174
Evaluation of trace element mobilization and control under different fluidized bed combustion scenarios
As consequence of its relatively abundant reserves compared to other energy sources, coal will continue to be widely employed in power plants. To reduce coal’s negative impact on the environment, new approaches have been evaluated and adopted by various countries in recent years to minimize CO2 emissions. Initial developments focused on the selection of new fuels (such as biomass fuels) to combine with coal to reduce emissions from coal combustion, whereas subsequent approaches aimed at implementing new processes for CO2 capture and storage, such as oxy-fuel combustion. In addition, coal combustion is one of the main anthropogenic sources of trace elements (TE) emitted to the atmosphere. The increasing knowledge acquired as to the impact of these pollutants in the environment has led to more restricted emission standards for some of these elements and to increased research on the technologies and pathways to control these emissions. This article reviews the main factors involved in TE capture by comparing results obtained for Hg and other TEs under different control scenarios. Both the effect of novel combustion processes and the potential of different pollution control techniques toward these pollutants are discussed.
- 20 June 2018
- Published by Oxford University Press (OUP) in Clean Energy
- Vol. 2 (2) , 167-174
Open AccessEvaluation of trace element mobilization and control under different fluidized bed combustion scenarios
As consequence of its relatively abundant reserves compared to other energy sources, coal will continue to be widely employed in power plants. To reduce coal’s negative impact on the environment, new approaches have been evaluated and adopted by various countries in recent years to minimize CO2 emissions. Initial developments focused on the selection of new fuels (such as biomass fuels) to combine with coal to reduce emissions from coal combustion, whereas subsequent approaches aimed at implementing new processes for CO2 capture and storage, such as oxy-fuel combustion. In addition, coal combustion is one of the main anthropogenic sources of trace elements (TE) emitted to the atmosphere. The increasing knowledge acquired as to the impact of these pollutants in the environment has led to more restricted emission standards for some of these elements and to increased research on the technologies and pathways to control these emissions. This article reviews the main factors involved in TE capture by comparing results obtained for Hg and other TEs under different control scenarios. Both the effect of novel combustion processes and the potential of different pollution control techniques toward these pollutants are discussed.
- 9 October 2015
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 123 (2) , 1643-1655
Study of the thermal behaviour of coal/biomass blends during oxy-fuel combustion by thermogravimetric analysis
- 9 October 2015
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 123 (2) , 1643-1655
Study of the thermal behaviour of coal/biomass blends during oxy-fuel combustion by thermogravimetric analysis
- Open Access
- 17 November 2011
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 19 (4) , 1084-1096
Mercury policy and regulations for coal-fired power plants
Mercury is a high-priority regulatory concern because of its persistence and bioaccumulation in the environment and evidence of its having serious adverse effects on the neurological development of children. Mercury is released into the atmosphere from both natural and anthropogenic sources. Coal-fired utilities are considered to be one of the largest anthropogenic mercury emission sources. The period since the late 1990s has been marked by increasing concern over mercury emissions from combustion systems to the extent that a number of national governments have either already implemented or are in the process of implementing, legislation aimed at enforcing tighter control over mercury emissions and a reduction in mercury consumption. This review examines the most important national and international policies and agreements for controlling mercury emissions from coal-fired combustion systems. To provide a global perspective, this study lists the countries with the largest estimated mercury emissions and regulatory efforts to reduce them.
- 17 November 2011
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 19 (4) , 1084-1096
Open AccessMercury policy and regulations for coal-fired power plants
Mercury is a high-priority regulatory concern because of its persistence and bioaccumulation in the environment and evidence of its having serious adverse effects on the neurological development of children. Mercury is released into the atmosphere from both natural and anthropogenic sources. Coal-fired utilities are considered to be one of the largest anthropogenic mercury emission sources. The period since the late 1990s has been marked by increasing concern over mercury emissions from combustion systems to the extent that a number of national governments have either already implemented or are in the process of implementing, legislation aimed at enforcing tighter control over mercury emissions and a reduction in mercury consumption. This review examines the most important national and international policies and agreements for controlling mercury emissions from coal-fired combustion systems. To provide a global perspective, this study lists the countries with the largest estimated mercury emissions and regulatory efforts to reduce them.