Xiang Gao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xiang Gao has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Bingcai Pan
Nanjing University
4 shared publications - Chao Shan
State Key Laboratory of Water Pollution Control and Green Resource Recycling School of Environment Nanjing University Nanjing 210023 China
2 shared publications Yanyang Zhang
State Key Laboratory of Pollution Control and Resource Reuse, School of the Environment, Nanjing University, Nanjing 210023, China
2 shared publications- Yanyang Zhang
Nanjing University
2 shared publications Goulven Inial
Plastic Metal Technology (PMT), Veolia Water Technology, France
1 shared publicationKate Smith
School of Environment, Tsinghua University, Haidian District, Beijing, 100084, China
1 shared publication
Latest Publications
- 1 November 2019
- Published by Elsevier in Water Research
- Vol. 164, 114888
Integrating water quality and operation into prediction of water production in drinking water treatment plants by genetic algorithm enhanced artificial neural network
- 1 November 2019
- Published by Elsevier in Water Research
- Vol. 164, 114888
Integrating water quality and operation into prediction of water production in drinking water treatment plants by genetic algorithm enhanced artificial neural network
- 1 September 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 683, 609-616
Fluoride uptake by three lanthanum based nanomaterials: Behavior and mechanism dependent upon lanthanum species
- 1 September 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 683, 609-616
Fluoride uptake by three lanthanum based nanomaterials: Behavior and mechanism dependent upon lanthanum species
- 27 November 2018
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 53 (1) , 365-372
Unexpected Favorable Role of Ca2+ in Phosphate Removal by Using Nanosized Ferric Oxides Confined in Porous Polystyrene Beads
- 27 November 2018
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 53 (1) , 365-372
Unexpected Favorable Role of Ca2+ in Phosphate Removal by Using Nanosized Ferric Oxides Confined in Porous Polystyrene Beads
- Top Cited Papers
- 15 January 2016
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 50 (3) , 1447-1454
Enhanced Phosphate Removal by Nanosized Hydrated La(III) Oxide Confined in Cross-linked Polystyrene Networks
A new nanocomposite adsorbent La-201 of extremely high capacity and specific affinity towards phosphate was fabricated and well characterized, where hydrated La(III) oxide (HLO) nanoclusters were immobilized inside the networking pores of the polystyrene anion exchanger D-201. La-201 exhibited enhanced phosphate adsorption in the presence of competing anions (chloride, sulfate, nitrate, bicarbonate and silicate) at greater levels (up to molar ratio of 20), with working capacity 2-4 times higher than a commercial Fe(III) oxide-based nanocomposite HFO-201 in batch runs. Column adsorption runs by using La-201 could effectively treat ~6500 bed volumes (BV) of a synthetic feeding solution before breakthrough occurred (from 2.5 mg P/L in influent to <0.5 mg P/L in effluent), approximately 11 times magnitude higher than HFO-201. The exhausted La-201 could be regenerated with NaOH-NaCl binary solution at 60 °C for repeated use without any significant capacity loss. The underlying mechanism for the specific sorption of phosphate by La-201 was revealed with the aid of STEM-EDS, XPS, XRD, and SSNMR analysis, and the formation of LaPO4·xH2O is verified to be the dominant pathway for selective phosphate adsorption by the immobilized nano-HLO. The results indicated that La-201 was very promising in highly efficient removal of phosphate from contaminated waters.
- 15 January 2016
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 50 (3) , 1447-1454
Top Cited PapersEnhanced Phosphate Removal by Nanosized Hydrated La(III) Oxide Confined in Cross-linked Polystyrene Networks
A new nanocomposite adsorbent La-201 of extremely high capacity and specific affinity towards phosphate was fabricated and well characterized, where hydrated La(III) oxide (HLO) nanoclusters were immobilized inside the networking pores of the polystyrene anion exchanger D-201. La-201 exhibited enhanced phosphate adsorption in the presence of competing anions (chloride, sulfate, nitrate, bicarbonate and silicate) at greater levels (up to molar ratio of 20), with working capacity 2-4 times higher than a commercial Fe(III) oxide-based nanocomposite HFO-201 in batch runs. Column adsorption runs by using La-201 could effectively treat ~6500 bed volumes (BV) of a synthetic feeding solution before breakthrough occurred (from 2.5 mg P/L in influent to <0.5 mg P/L in effluent), approximately 11 times magnitude higher than HFO-201. The exhausted La-201 could be regenerated with NaOH-NaCl binary solution at 60 °C for repeated use without any significant capacity loss. The underlying mechanism for the specific sorption of phosphate by La-201 was revealed with the aid of STEM-EDS, XPS, XRD, and SSNMR analysis, and the formation of LaPO4·xH2O is verified to be the dominant pathway for selective phosphate adsorption by the immobilized nano-HLO. The results indicated that La-201 was very promising in highly efficient removal of phosphate from contaminated waters.
- 1 April 2013
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 13 (4) , 3016-3019
Synthesis of LiMnPO4 Porous Structures Under Mixed Solvents System
Porous structure LiMnPO4 with pore size from 4 to 9 nm was successfully synthesized in mixed solvents. By changing ratios of glycerol to distilled water and stirring time, LiMnPO4 morphologies were adjusted. Shuttles with different sizes and porous structure of LiMnPO4 were formed in sequence. Ratio of glycerol to distilled water influences the solubility of LiMnPO4 and solutions viscosity. This factor and stirring time are both causes influencing the nucleation rate and diffusion rate of the initial formed particles of final products. Through adjusting these factors, chemicals with specific morphology can be obtained. The phase composition was investigated by X-ray diffraction (XRD), and the microstructure was verified by transmission electron microscopy (TEM). This synthetic method provides us a new idea to obtain new structure materials.
- 1 April 2013
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 13 (4) , 3016-3019
Synthesis of LiMnPO4 Porous Structures Under Mixed Solvents System
Porous structure LiMnPO4 with pore size from 4 to 9 nm was successfully synthesized in mixed solvents. By changing ratios of glycerol to distilled water and stirring time, LiMnPO4 morphologies were adjusted. Shuttles with different sizes and porous structure of LiMnPO4 were formed in sequence. Ratio of glycerol to distilled water influences the solubility of LiMnPO4 and solutions viscosity. This factor and stirring time are both causes influencing the nucleation rate and diffusion rate of the initial formed particles of final products. Through adjusting these factors, chemicals with specific morphology can be obtained. The phase composition was investigated by X-ray diffraction (XRD), and the microstructure was verified by transmission electron microscopy (TEM). This synthetic method provides us a new idea to obtain new structure materials.