Isaac Jacob
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Isaac Jacob has a total of 235 co-authors. Here are the top co-authors by number of shared publications:
M.H. Mintz
Dept. of Nuclear Eng., Ben-Gurion Univ. of the Negev, POB 653, Beer-Sheva 84105, Israel
16 shared publicationsR. Moreh
Nuclear Research Center–Negev, Beer Sheva 84190, Israel
14 shared publicationsA. Wolf
Nuclear Research Center–Negev, Beer Sheva 84190, Israel
11 shared publicationsM. Bereznitsky
9 shared publicationsJ. Bloch
8 shared publicationsD. Shaltiel
The Racah Institute of Physics, The Hebrew University of Jerusalem, Jerusalem Israel
7 shared publications
Latest Publications
- Open Access
- 11 September 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (18) , 12510-12521
The Activating Effect of Carnallite and Hydrated MgCl2 on Hydrogen Absorption in Magnesium
We present activation strategies to enhance hydrogen absorption in magnesium. Magnesium chips, produced by mechanical chipping with a laboratory-scale milling device, were hydrogenated after adding activators and compared to pure Mg chips. It was found that following activation by turbomolecular evacuation at 300 °C for 3 h, MgCl2·6H2O-added Mg chips absorbed hydrogen at temperatures as low as 200 °C. Also, the addition of the activator eliminated the incubation period and improved the hydrogen absorption rate by a factor of three compared with pure Mg chips. These enhancements are attributed to the decomposition of MgCl2·6H2O during the activation process, which releases HCl gas. The HCl gas reacts with surface constituents on the Mg chips to form MgCl2. This reaction is associated with breaking the oxide and carbonate layers, subsequently forming cracks and exposing an active surface. The modified surface chemistry promotes hydrogen dissociation and diffusion, thereby accelerating the first hydrogen absorption. Kinetic analysis of the first hydrogenation of activated Mg chips reveals that the process is governed by a low-dimensional nucleation and growth mechanism, like the mechanism taking place during the first hydrogen absorption in pure Mg chips. Application of the Avrami model further shows that the apparent activation energies for hydrogen absorption in activated Mg chips are lower than the values previously reported in the literature for pure Mg. This study highlights the benefits of adding small amounts, 4 wt % or less, of activator, which eliminates the incubation period, lowers the hydrogen absorption temperature, and increases the hydrogenation rate. These results demonstrate the potential of adding activators to produce highly reactive hydrogen storage materials.
- 11 September 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (18) , 12510-12521
Open AccessThe Activating Effect of Carnallite and Hydrated MgCl2 on Hydrogen Absorption in Magnesium
We present activation strategies to enhance hydrogen absorption in magnesium. Magnesium chips, produced by mechanical chipping with a laboratory-scale milling device, were hydrogenated after adding activators and compared to pure Mg chips. It was found that following activation by turbomolecular evacuation at 300 °C for 3 h, MgCl2·6H2O-added Mg chips absorbed hydrogen at temperatures as low as 200 °C. Also, the addition of the activator eliminated the incubation period and improved the hydrogen absorption rate by a factor of three compared with pure Mg chips. These enhancements are attributed to the decomposition of MgCl2·6H2O during the activation process, which releases HCl gas. The HCl gas reacts with surface constituents on the Mg chips to form MgCl2. This reaction is associated with breaking the oxide and carbonate layers, subsequently forming cracks and exposing an active surface. The modified surface chemistry promotes hydrogen dissociation and diffusion, thereby accelerating the first hydrogen absorption. Kinetic analysis of the first hydrogenation of activated Mg chips reveals that the process is governed by a low-dimensional nucleation and growth mechanism, like the mechanism taking place during the first hydrogen absorption in pure Mg chips. Application of the Avrami model further shows that the apparent activation energies for hydrogen absorption in activated Mg chips are lower than the values previously reported in the literature for pure Mg. This study highlights the benefits of adding small amounts, 4 wt % or less, of activator, which eliminates the incubation period, lowers the hydrogen absorption temperature, and increases the hydrogenation rate. These results demonstrate the potential of adding activators to produce highly reactive hydrogen storage materials.
- Open Access
- 22 January 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (4) , 2145-2157
First Hydrogenation Kinetics and Properties of Mechanically Treated Pure Mg
- 22 January 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (4) , 2145-2157
Open AccessFirst Hydrogenation Kinetics and Properties of Mechanically Treated Pure Mg
- Open Access
- 25 May 2023
- Published by MDPI AG in Inorganics
- Vol. 11 (6) , 228
The Role of Bulk Stiffening in Reducing the Critical Temperature of the Metal-to-Hydride Phase Transition and the Hydride Stability: The Case of Zr(MoxFe1−x)2-H2
This study aims to shed light on the unusual trend in the stabilities of Zr(MoxFe1−x)2, 0 ≤ x ≤ 1, hydrides. Both the rule of reversed stability and the crystal volume criterion correlate with the increased hydride stabilities from x = 0 to x = 0.5, but are in contrast with the destabilization of the end member ZrMo2 hydride. The pressure-composition isotherms of ZrMo2-H2 exhibit very wide solid solubility regions, which may be associated with diminished H–H elastic interaction, uelas. In order to discern this possibility, we measured the elastic moduli of Zr(MoxFe1−x)2, x = 0, 0.5, 1. The shear modulus, G, shows a moderate variation in this composition range, while the bulk modulus, B, increases significantly and monotonically from 148.2 GPa in ZrFe2 to 200.4 GPa in ZrMo2. The H–H elastic interaction is proportional to B and therefore its increase cannot directly account for a decrease in uelas. Therefore, we turn our attention to the volume of the hydrogen atom, , which usually varies in a limited range. Two coexisting phases, a Laves cubic (a = 7.826 Å) and a tetragonal (a = 5.603 Å, c = 8.081 Å) hydride phase are identified in ZrMo2H3.5, obtained by cooling to liquid nitrogen temperature at about 50 atm. The volume of the hydrogen atom in these two hydrides is estimated to be 2.2 Å3/(H atom). Some very low values, have been reported by other investigators. The low values, as well as the one derived in this work, significantly reduce uelas for ZrMo2-H2, and thus reduce the corresponding critical temperature for the metal-to-hydride phase transition, and the heat of hydride formation. We suggest that the bulk stiffening in ZrMo2 confines the corresponding hydride expansion and thus reduces the H-H elastic interaction.- 25 May 2023
- Published by MDPI AG in Inorganics
- Vol. 11 (6) , 228
Open AccessThe Role of Bulk Stiffening in Reducing the Critical Temperature of the Metal-to-Hydride Phase Transition and the Hydride Stability: The Case of Zr(MoxFe1−x)2-H2
This study aims to shed light on the unusual trend in the stabilities of Zr(MoxFe1−x)2, 0 ≤ x ≤ 1, hydrides. Both the rule of reversed stability and the crystal volume criterion correlate with the increased hydride stabilities from x = 0 to x = 0.5, but are in contrast with the destabilization of the end member ZrMo2 hydride. The pressure-composition isotherms of ZrMo2-H2 exhibit very wide solid solubility regions, which may be associated with diminished H–H elastic interaction, uelas. In order to discern this possibility, we measured the elastic moduli of Zr(MoxFe1−x)2, x = 0, 0.5, 1. The shear modulus, G, shows a moderate variation in this composition range, while the bulk modulus, B, increases significantly and monotonically from 148.2 GPa in ZrFe2 to 200.4 GPa in ZrMo2. The H–H elastic interaction is proportional to B and therefore its increase cannot directly account for a decrease in uelas. Therefore, we turn our attention to the volume of the hydrogen atom, , which usually varies in a limited range. Two coexisting phases, a Laves cubic (a = 7.826 Å) and a tetragonal (a = 5.603 Å, c = 8.081 Å) hydride phase are identified in ZrMo2H3.5, obtained by cooling to liquid nitrogen temperature at about 50 atm. The volume of the hydrogen atom in these two hydrides is estimated to be 2.2 Å3/(H atom). Some very low values, have been reported by other investigators. The low values, as well as the one derived in this work, significantly reduce uelas for ZrMo2-H2, and thus reduce the corresponding critical temperature for the metal-to-hydride phase transition, and the heat of hydride formation. We suggest that the bulk stiffening in ZrMo2 confines the corresponding hydride expansion and thus reduces the H-H elastic interaction. - Open Access
- 8 June 2022
- Published by IOP Publishing in Progress in Energy
- Vol. 4 (3) , 032007
Magnesium- and intermetallic alloys-based hydrides for energy storage: modelling, synthesis and properties
Hydrides based on magnesium and intermetallic compounds provide a viable solution to the challenge of energy storage from renewable sources, thanks to their ability to absorb and desorb hydrogen in a reversible way with a proper tuning of pressure and temperature conditions. Therefore, they are expected to play an important role in the clean energy transition and in the deployment of hydrogen as an efficient energy vector. This review, by experts of Task 40 ‘Energy Storage and Conversion based on Hydrogen’ of the Hydrogen Technology Collaboration Programme of the International Energy Agency, reports on the latest activities of the working group ‘Magnesium- and Intermetallic alloys-based Hydrides for Energy Storage’. The following topics are covered by the review: multiscale modelling of hydrides and hydrogen sorption mechanisms; synthesis and processing techniques; catalysts for hydrogen sorption in Mg; Mg-based nanostructures and new compounds; hydrides based on intermetallic TiFe alloys, high entropy alloys, Laves phases, and Pd-containing alloys. Finally, an outlook is presented on current worldwide investments and future research directions for hydrogen-based energy storage.
- 8 June 2022
- Published by IOP Publishing in Progress in Energy
- Vol. 4 (3) , 032007
Open AccessMagnesium- and intermetallic alloys-based hydrides for energy storage: modelling, synthesis and properties
Hydrides based on magnesium and intermetallic compounds provide a viable solution to the challenge of energy storage from renewable sources, thanks to their ability to absorb and desorb hydrogen in a reversible way with a proper tuning of pressure and temperature conditions. Therefore, they are expected to play an important role in the clean energy transition and in the deployment of hydrogen as an efficient energy vector. This review, by experts of Task 40 ‘Energy Storage and Conversion based on Hydrogen’ of the Hydrogen Technology Collaboration Programme of the International Energy Agency, reports on the latest activities of the working group ‘Magnesium- and Intermetallic alloys-based Hydrides for Energy Storage’. The following topics are covered by the review: multiscale modelling of hydrides and hydrogen sorption mechanisms; synthesis and processing techniques; catalysts for hydrogen sorption in Mg; Mg-based nanostructures and new compounds; hydrides based on intermetallic TiFe alloys, high entropy alloys, Laves phases, and Pd-containing alloys. Finally, an outlook is presented on current worldwide investments and future research directions for hydrogen-based energy storage.
- Top Cited PapersOpen Access
- 1 March 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (15) , 7780-7808
Application of hydrides in hydrogen storage and compression: Achievements, outlook and perspectives
- 1 March 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (15) , 7780-7808
Top Cited PapersOpen AccessApplication of hydrides in hydrogen storage and compression: Achievements, outlook and perspectives
- Top Cited PapersOpen Access
- 1 March 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (15) , 7809-7859
Magnesium based materials for hydrogen based energy storage: Past, present and future
- 1 March 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (15) , 7809-7859
Top Cited PapersOpen AccessMagnesium based materials for hydrogen based energy storage: Past, present and future
- 1 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 750, 206-212
Hydrogen sorption behavior of some Pd-containing compounds
- 1 June 2018
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 750, 206-212
Hydrogen sorption behavior of some Pd-containing compounds
- 1 December 2016
- Published by Elsevier in Applied Surface Science
- Vol. 388, 723-730
Syntheses and properties of several metastable and stable hydrides derived from intermetallic compounds under high hydrogen pressure
- 1 December 2016
- Published by Elsevier in Applied Surface Science
- Vol. 388, 723-730
Syntheses and properties of several metastable and stable hydrides derived from intermetallic compounds under high hydrogen pressure
- 9 March 2016
- Published by Springer Nature in Applied Physics A
- Vol. 122 (4) , 1-7
Hydrogen sorption behavior of CaAl1.5Li0.5
- 9 March 2016
- Published by Springer Nature in Applied Physics A
- Vol. 122 (4) , 1-7
Hydrogen sorption behavior of CaAl1.5Li0.5