C. Achille Fumtchum
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
C. Achille Fumtchum has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Florin Hutu
INSA Lyon, Inria, CITI, UR3720, Villeurbanne, France
2 shared publications Emmanuel Tanyi
University of Buea, Buea, Cameroon
1 shared publication- Emmanuel Tanyi
Faculty of Engineering and Technology, University of Buea, SW, Buea, Cameroon
1 shared publication Guillaume Villemaud
Univ Lyon, INSA Lyon, Inria, CITI, Villeurbanne, F-69621, France
1 shared publication- Guillaume Villemaud
INSA Lyon, Inria, CITI, UR3720, Villeurbanne, France
1 shared publication Pierre Tsafack
University of Buea, Buea, Cameroon
1 shared publication
Latest Publications
- Open Access
- 9 October 2021
- Published by MDPI AG in Electronics
- Vol. 10 (20) , 2449
Towards a Battery-Free Wake-Up Radio
This paper proposes a contribution to the development of autonomous wake-up radios from the energy supply perspective. More precisely, a rectifier circuit, designed and manufactured in order to provide the energy needed for a quasi passive wake-up radio receiver (WuRx). The WuRx is intended to operate continuously and to ensure a zero energy consumption in standby mode.After the presentation of the said WuRx, the energy requirement for its power supply is defined. Then, the energy harvesting circuit, able to power up the quasi-passive WuRx, is designed, implemented, and then measured. Compared to the state of the art, the energy harvester that we present here is among the few recent designs that replaced the matching network lumped component by butterfly stubs, which brings compactness to the circuit. The rectifier is built on a high efficiency substrate which increases its performance and reduces its form factor.
- 9 October 2021
- Published by MDPI AG in Electronics
- Vol. 10 (20) , 2449
Open AccessTowards a Battery-Free Wake-Up Radio
This paper proposes a contribution to the development of autonomous wake-up radios from the energy supply perspective. More precisely, a rectifier circuit, designed and manufactured in order to provide the energy needed for a quasi passive wake-up radio receiver (WuRx). The WuRx is intended to operate continuously and to ensure a zero energy consumption in standby mode.After the presentation of the said WuRx, the energy requirement for its power supply is defined. Then, the energy harvesting circuit, able to power up the quasi-passive WuRx, is designed, implemented, and then measured. Compared to the state of the art, the energy harvester that we present here is among the few recent designs that replaced the matching network lumped component by butterfly stubs, which brings compactness to the circuit. The rectifier is built on a high efficiency substrate which increases its performance and reduces its form factor.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
High Efficiency Rectifier for a Quasi-Passive Wakeup Radio
The ubiquity of wireless sensor networks (WSN), as well as the rapid development of the Internet of Things (IoT), impel new approaches to reduce the energy consumption of the connected devices. The wake-up radio receivers (WuRx) were born in this context to reduce as much as possible the energy consumption of the radio communication part. This article aims at proposing a low-cost, high-efficiency rectifier to improve a quasi-passive WuRx performance in terms of communication range. By optimizing the wideband matching circuit and the proposed rectifier's load impedance, the sensitivity was increased by 5 dB, corresponding to an increase of the communication range (13 meters in free space).
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
High Efficiency Rectifier for a Quasi-Passive Wakeup Radio
The ubiquity of wireless sensor networks (WSN), as well as the rapid development of the Internet of Things (IoT), impel new approaches to reduce the energy consumption of the connected devices. The wake-up radio receivers (WuRx) were born in this context to reduce as much as possible the energy consumption of the radio communication part. This article aims at proposing a low-cost, high-efficiency rectifier to improve a quasi-passive WuRx performance in terms of communication range. By optimizing the wideband matching circuit and the proposed rectifier's load impedance, the sensitivity was increased by 5 dB, corresponding to an increase of the communication range (13 meters in free space).