Kenji Ito
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kenji Ito has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Hiroki Nagasawa
Chemical Engineering Program, Graduate School of Advanced Science and Engineering, Hiroshima University
3 shared publications - Masakoto Kanezashi
Chemical Engineering Program, Graduate School of Advanced Science and Engineering, Hiroshima University, Higashi-hiroshima, Japan
3 shared publications - Norihiro Moriyama
Chemical Engineering Program, Graduate School of Advanced Science and Engineering, Hiroshima University, 1-4-1 Kagamiyama, Higashi-Hiroshima 739-8527, Japan
3 shared publications - Toshinori Tsuru
Chemical Engineering Program, Graduate School of Advanced Science and Engineering, Hiroshima University, Higashi-hiroshima, Japan
3 shared publications - Akira Ishida
Department of Physics Graduate School of Science The University of Tokyo 7-3-1 Hongo Bunkyo-ku 113-0033 Tokyo Japan
2 shared publications - Kenji Shu
Photon Science Centre, School of Engineering, The University of Tokyo, Yayoi, Bunkyo-ku, Tokyo, Japan
2 shared publications
Latest Publications
- Open Access
- 16 November 2026
- Published by American Chemical Society (ACS) in ACS Engineering Au
Molecular-Net Transfer via Thermal Coalescence of Preorganized Polysiloxane Particles into Gas-Sieving Membranes
Polysiloxane membranes are among the most attractive candidates for gas separation; however, their fabrication remains challenging due to the two-to-three-orders-of-magnitude mismatch between the pore size of the support, typically in the sub-micrometer to micrometer range, and the size of sol particles, which often necessitates complex multilayer structures. In this study, we propose a strategy to overcome this limitation, termed “molecular-net transfer”. This strategy employs micrometer-sized sol particles to prevent penetration into the porous support. Subsequent heat treatment induces relaxation of the gel particles, promoting their coalescence and resulting in the direct formation of a uniform polysiloxane layer without a conventional nanoporous intermediate layer. The resulting membrane exhibited an H2 permeance as high as 5.6 × 10−7 mol m−2 s−1 Pa−1 with an H2/SF6 permeance ratio of 2600, demonstrating the simultaneous achievement of simple fabrication and size-sieving-based high permselectivity. Notably, the chemical structure and sub-nanometer network of the dried gel were largely preserved during heat treatment, despite macroscopic transformation from discrete particles to a continuous film. This feature enables the direct transfer of pre-organized pore structures into the final membrane, offering a new strategy for controlling microstructure in molecular-sieving membranes.
- 16 November 2026
- Published by American Chemical Society (ACS) in ACS Engineering Au
Open AccessMolecular-Net Transfer via Thermal Coalescence of Preorganized Polysiloxane Particles into Gas-Sieving Membranes
Polysiloxane membranes are among the most attractive candidates for gas separation; however, their fabrication remains challenging due to the two-to-three-orders-of-magnitude mismatch between the pore size of the support, typically in the sub-micrometer to micrometer range, and the size of sol particles, which often necessitates complex multilayer structures. In this study, we propose a strategy to overcome this limitation, termed “molecular-net transfer”. This strategy employs micrometer-sized sol particles to prevent penetration into the porous support. Subsequent heat treatment induces relaxation of the gel particles, promoting their coalescence and resulting in the direct formation of a uniform polysiloxane layer without a conventional nanoporous intermediate layer. The resulting membrane exhibited an H2 permeance as high as 5.6 × 10−7 mol m−2 s−1 Pa−1 with an H2/SF6 permeance ratio of 2600, demonstrating the simultaneous achievement of simple fabrication and size-sieving-based high permselectivity. Notably, the chemical structure and sub-nanometer network of the dried gel were largely preserved during heat treatment, despite macroscopic transformation from discrete particles to a continuous film. This feature enables the direct transfer of pre-organized pore structures into the final membrane, offering a new strategy for controlling microstructure in molecular-sieving membranes.
- 1 May 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (5)
Layer-specific porosity analysis in sub-nanoporous silica thin films using variable-energy positron annihilation lifetime technique, ellipsometric porosimetry, and attenuated total reflection infrared spectroscopy
We present a hybrid analytical method that combines the variable-energy positron annihilation lifetime (VEPAL) technique with in situ attenuated total reflection infrared (ATR-IR) spectroscopy to examine the depth-resolved open porosity (surface-connected pore fraction relevant to adsorbate-accessible open pores) of sub-nanoporous silica thin films. Model samples with low-, high-, and bilayer-porosity architectures were fabricated by plasma-enhanced chemical vapor deposition and characterized using VEPAL, ellipsometric porosimetry (EP), and ATR-IR. The depth-dependent ortho-positronium lifetimes obtained by VEPAL revealed distinct porous sublayers in the bilayer films, consistent with their designed architecture. Open porosity values derived from EP correlated well with ATR-IR absorbance under controlled humidity, validating the semi-quantitative use of IR spectroscopy for probing open pores near the surface. The cross-validation of the three techniques enabled nondestructive, layer-specific quantification of open porosity, offering a versatile platform for optimizing the structure and function of porous materials in sensing, dielectric, and membrane applications.
- 1 May 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (5)
Layer-specific porosity analysis in sub-nanoporous silica thin films using variable-energy positron annihilation lifetime technique, ellipsometric porosimetry, and attenuated total reflection infrared spectroscopy
We present a hybrid analytical method that combines the variable-energy positron annihilation lifetime (VEPAL) technique with in situ attenuated total reflection infrared (ATR-IR) spectroscopy to examine the depth-resolved open porosity (surface-connected pore fraction relevant to adsorbate-accessible open pores) of sub-nanoporous silica thin films. Model samples with low-, high-, and bilayer-porosity architectures were fabricated by plasma-enhanced chemical vapor deposition and characterized using VEPAL, ellipsometric porosimetry (EP), and ATR-IR. The depth-dependent ortho-positronium lifetimes obtained by VEPAL revealed distinct porous sublayers in the bilayer films, consistent with their designed architecture. Open porosity values derived from EP correlated well with ATR-IR absorbance under controlled humidity, validating the semi-quantitative use of IR spectroscopy for probing open pores near the surface. The cross-validation of the three techniques enabled nondestructive, layer-specific quantification of open porosity, offering a versatile platform for optimizing the structure and function of porous materials in sensing, dielectric, and membrane applications.
- Open Access
- 28 July 2025
- Published by American Chemical Society (ACS) in ACS Materials Letters
- Vol. 7 (9) , 3058-3064
Ultrathin Highly Porous Molecular-Sieve Silica Membranes Developed by a Facile Process Using Atmospheric-Pressure Plasma Modification
- 28 July 2025
- Published by American Chemical Society (ACS) in ACS Materials Letters
- Vol. 7 (9) , 3058-3064
Open AccessUltrathin Highly Porous Molecular-Sieve Silica Membranes Developed by a Facile Process Using Atmospheric-Pressure Plasma Modification
- 1 May 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (19) , 9773-9781
Simple Strategy for the Fabrication of Thin Amine-Polysiloxane Hybrid Membranes Supported by Microfiltration Membranes
- 1 May 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 64 (19) , 9773-9781
Simple Strategy for the Fabrication of Thin Amine-Polysiloxane Hybrid Membranes Supported by Microfiltration Membranes
- Open Access
- 11 September 2024
- Published by Springer Nature in Nature
- Vol. 633 (8031) , 793-797
Cooling positronium to ultralow velocities with a chirped laser pulse train
When laser radiation is skilfully applied, atoms and molecules can be cooled1–3, allowing the precise measurements and control of quantum systems. This is essential for the fundamental studies of physics as well as practical applications such as precision spectroscopy4–7, ultracold gases with quantum statistical properties8–10 and quantum computing. In laser cooling, atoms are slowed to otherwise unattainable velocities through repeated cycles of laser photon absorption and spontaneous emission in random directions. Simple systems can serve as rigorous testing grounds for fundamental physics—one such case is the purely leptonic positronium11,12, an exotic atom comprising an electron and its antiparticle, the positron. Laser cooling of positronium, however, has hitherto remained unrealized. Here we demonstrate the one-dimensional laser cooling of positronium. An innovative laser system emitting a train of broadband pulses with successively increasing central frequencies was used to overcome major challenges posed by the short positronium lifetime and the effects of Doppler broadening and recoil. One-dimensional chirp cooling was used to cool a portion of the dilute positronium gas to a velocity distribution of approximately 1 K in 100 ns. A major advancement in the field of low-temperature fundamental physics of antimatter, this study on a purely leptonic system complements work on antihydrogen13, a hadron-containing exotic atom. The successful application of laser cooling to positronium affords unique opportunities to rigorously test bound-state quantum electrodynamics and to potentially realize Bose–Einstein condensation14–18 in this matter–antimatter system.
- 11 September 2024
- Published by Springer Nature in Nature
- Vol. 633 (8031) , 793-797
Open AccessCooling positronium to ultralow velocities with a chirped laser pulse train
When laser radiation is skilfully applied, atoms and molecules can be cooled1–3, allowing the precise measurements and control of quantum systems. This is essential for the fundamental studies of physics as well as practical applications such as precision spectroscopy4–7, ultracold gases with quantum statistical properties8–10 and quantum computing. In laser cooling, atoms are slowed to otherwise unattainable velocities through repeated cycles of laser photon absorption and spontaneous emission in random directions. Simple systems can serve as rigorous testing grounds for fundamental physics—one such case is the purely leptonic positronium11,12, an exotic atom comprising an electron and its antiparticle, the positron. Laser cooling of positronium, however, has hitherto remained unrealized. Here we demonstrate the one-dimensional laser cooling of positronium. An innovative laser system emitting a train of broadband pulses with successively increasing central frequencies was used to overcome major challenges posed by the short positronium lifetime and the effects of Doppler broadening and recoil. One-dimensional chirp cooling was used to cool a portion of the dilute positronium gas to a velocity distribution of approximately 1 K in 100 ns. A major advancement in the field of low-temperature fundamental physics of antimatter, this study on a purely leptonic system complements work on antihydrogen13, a hadron-containing exotic atom. The successful application of laser cooling to positronium affords unique opportunities to rigorously test bound-state quantum electrodynamics and to potentially realize Bose–Einstein condensation14–18 in this matter–antimatter system.
- 24 November 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (5) , L050801
Observation of orthopositronium thermalization in silica aerogel at cryogenic temperatures
We report orthopositronium thermalization observed in cryogenic silica aerogel cooled from room temperature to 25 K. It was observed that the thermalization rate gets slower as itself is colder than room temperature. This energy dependence can be explained based on a model where the efficiency of kinetic energy exchange between and silica is determined by the de Broglie wavelength of . The present measurement confirmed that a cooling method which utilizes the thermalization process at cryogenic temperatures followed by laser cooling is applicable for the efficient production of an Bose-Einstein condensate.- 24 November 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (5) , L050801
Observation of orthopositronium thermalization in silica aerogel at cryogenic temperatures
We report orthopositronium thermalization observed in cryogenic silica aerogel cooled from room temperature to 25 K. It was observed that the thermalization rate gets slower as itself is colder than room temperature. This energy dependence can be explained based on a model where the efficiency of kinetic energy exchange between and silica is determined by the de Broglie wavelength of . The present measurement confirmed that a cooling method which utilizes the thermalization process at cryogenic temperatures followed by laser cooling is applicable for the efficient production of an Bose-Einstein condensate.- 1 June 2021
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 92 (6) , 063905
Improvement of the far-infrared optical property for glasses by plasma-assisted dispersion of fluorocarbon species into the shallow surface
Owing to global warming together with the demands for thermal energy storage in diverse fields, there is demand for transparent glasses achieving reflection of the short-wave far-infrared (IR) light from solar radiation while also absorbing the longer wavelength part. Here, we performed the plasma-assisted ion implantation using a desktop-type low-pressure fluorocarbon plasma generator system to improve the optical properties of transparent soda-lime glasses. Investigations using positron annihilation techniques for the plasma-treated glass demonstrated that the fluorocarbon species occupy the sub-nanoscale interstitial sites available in the glass network of the soda-lime glass as the intrinsic open spaces, forming an implantation layer in the shallow-surface region around a depth of 50 nm. As revealed by optical spectroscopy, the subsurface layer, due to the implanted fluorocarbon species, significantly cuts off the short-wave far-IR light around a wavelength of ∼3 µm and also acts as the absorber of the longer wavelength region from 7 to 12 µm. Plasma treatment could be a promising tool to improve the optical properties in the IR light region for various materials.
- 1 June 2021
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 92 (6) , 063905
Improvement of the far-infrared optical property for glasses by plasma-assisted dispersion of fluorocarbon species into the shallow surface
Owing to global warming together with the demands for thermal energy storage in diverse fields, there is demand for transparent glasses achieving reflection of the short-wave far-infrared (IR) light from solar radiation while also absorbing the longer wavelength part. Here, we performed the plasma-assisted ion implantation using a desktop-type low-pressure fluorocarbon plasma generator system to improve the optical properties of transparent soda-lime glasses. Investigations using positron annihilation techniques for the plasma-treated glass demonstrated that the fluorocarbon species occupy the sub-nanoscale interstitial sites available in the glass network of the soda-lime glass as the intrinsic open spaces, forming an implantation layer in the shallow-surface region around a depth of 50 nm. As revealed by optical spectroscopy, the subsurface layer, due to the implanted fluorocarbon species, significantly cuts off the short-wave far-IR light around a wavelength of ∼3 µm and also acts as the absorber of the longer wavelength region from 7 to 12 µm. Plasma treatment could be a promising tool to improve the optical properties in the IR light region for various materials.