DCDavid Capek

David Capek

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


David Capek has a total of 179 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Geminids are initially cracked by atmospheric thermal stress

    by Tomáš Henych, Jiří Borovička, David Čapek, Vlastimil Vojáček, Pavel Spurný, Pavel Koten, Lukáš Shrbený

    Context . Geminids have the highest bulk density of all major meteor showers and their mechanical strength appears to depend on their mass. They are also the most active annual shower, enabling detailed studies of the dependence of their physical and mechanical properties on mass. Aims . We calculated the fragmentation cascades of 39 bright Geminid fireballs, as well as faint video meteors, to derive fragmentation pressures and other physical properties characterizing the meteoroids, such as their bulk densities. Our goal is to describe the mechanical properties across a broad range of initial masses and explain the cause of the observed behavior. Methods . We used a physical fragmentation model with a semiautomatic method based on parallel genetic algorithms to fit the radiometric and regular light curve and dynamics data. We also calculated the thermal stress of model bodies with the type of physical properties and trajectories as the observed Geminids. Then, we compared the outcomes of these simulations to our observations. Results . We find that the Geminids are probably cracked by thermal stress in the atmosphere first and then eroded by mechanical forces. The most compact Geminids are in the 20–200 g mass range. The largest observed meteoroids have a wide range of grain sizes, from about 20 μm to large, non-fragmenting parts of 1–20 mm in size. The derived bulk densities range from about 1400 to 2800 kg m −3 for smaller meteoroids and approach the assumed grain density of 3000 kg m −3 for larger Geminids.


  • Open Access

    3D shape models for describing monolithic asteroids and meteoroids

    by David Čapek, Michal Petřík, Jiří Pachman, Erkai Watson, Jakub Haloda, Robert Macke, Tomáš Henych, Pavel Koten, Martin Schimmerohn, Zuzana Stravová, et al.

    Context. Detailed knowledge of shapes is necessary for modeling certain processes affecting small Solar System bodies, such as the influence of radiative effects – like the YORP effect – on rotation. For meteoroids and small monolithic asteroids, such shapes have not been available up till now. This has strongly limited the possibilities of theoretical studies of the non-gravitational phenomena acting on these bodies. Aims. Our goal is to create a database of digital 3D shape models that would be suitable for describing the shapes of meteoroids and small monolithic asteroids. Methods. We performed catastrophic disruption experiments on samples from L3-6 ordinary chondrite NWA 869 and terrestrial tephriphonolite, including one hypervelocity impact and two explosion experiments. We selected fragments with masses of m ≥ 0.2 g that originated from the interior of the samples and did not contain the original target surface. Their size range is approximately 5–24 mm. Their shapes were digitized using X-ray computed tomography, with voxel sizes of about 50 µm. Results. The resulting database contains 868 shape models in Wavefront OBJ format, as well as a list of the basic properties of each one. The numbers of triangular surface facets of these models range from ∼20 000 to ∼760 000. These shape models correspond to meteoroids and small asteroids created by hypervelocity collisions. When using this database for a particular purpose, it is necessary to consider the selection of appropriate models based on the absence or presence of certain morphological features, such as chondrules, significant cracks, or minor artefacts. The possible presence of these features in a specific shape model has been recorded in the database.


  • Open Access

    Ejection velocities, age, and formation process of SPE meteoroid cluster

    by David Čapek, Pavel Koten, Pavel Spurný, Lukáš Shrbený

    Context. Meteoroid clusters represent a unique opportunity to study processes of meteoroid disruptions in interplanetary space. We follow our previous work about the September epsilon Perseid (SPE) meteoroid cluster from 2016 with a detailed analysis of the observed data and cluster formation conditions. Aims. Our goal is to determine ejection velocities of the cluster members and SPE’s age, as well as to estimate the most probable formation process. Methods. We precisely determined mutual positions and masses of all meteoroids including the errors. We assumed that the massdominated meteoroid is the parent body of the cluster and that the observed positions of meteoroids are controlled by the ejection velocities and the action of solar radiation pressure. A formula for the dependence of meteoroid ejection velocities on the mutual positions, masses, and cluster age was derived. It was assumed that the time at which the initial kinetic energy of all meteoroids reached a minimum value corresponds to the age of the cluster. Knowing values and directions of ejection velocities together with meteoroid masses then allowed us to determine the most likely process of cluster formation. Results. The meteoroids occupy a volume of 66 × 67 × 50 km and are shifted in the antisolar direction by 27 km relative to the parent meteoroid. The age of the cluster is 2.28 ± 0.44 days. The ejection velocities range from 0.13 ± 0.05 m s−1 to 0.77 ± 0.34 m s−1 with a mean value of 0.35 m s−1. The ejection velocity directions are inside the cone with an apex angle of 101 ± 5°. The axis of the cone is ~45° away from the solar direction and ~34° away from the mean direction of the flux of small meteoroids’ incident on the parent meteoroid. Formation due to the separation of part of the surface due to very fast rotation is the least likely thing to occur. We estimate the rotation frequency to be about 2 Hz and the corresponding stress is several orders of magnitude lower than the predicted strength limit. It is also difficult to explain the formation of the cluster by an impact of a small meteoroid on the parent body. However, this possibility, although not very likely, cannot be completely ruled out. The most probable process is the exfoliation due to thermal stresses. Their estimated magnitude is sufficient and the derived ejection velocities are consistent with this process of formation.


  • Open Access

    September epsilon Perseid cluster – collisional origin?

    by David Čapek, Pavel Koten

    A bright fireball together with eight fainter meteors on parallel atmospheric trajectories was observed within 2 seconds by Koten et al. (2017). We will present a detailed analysis of this case focused on the collisional origin of the cluster. We first estimate the age of the cluster and ejection velocities assuming influence of solar radiation pressure and taking into account observational uncertainties. Next we consider that the parent meteoroid producing the observed fireball collided with a micrometeoroid and that the eight observed meteors correspond to the largest fragments of the ejected material. We estimate the total ejected mass, distribution of mass and velocity of the impactor, and the probability of such an impact. Finally we discuss how reliable the explanation by the collision is.

  • The properties of cm–sized iron meteoroids

    by Vlastimil Vojáček, Jiří Borovička, Pavel Spurný, David Čapek


  • Small iron meteoroids

    by David Čapek, Pavel Koten, Jiří Borovička, Vlastimil Vojáček, Pavel Spurný, Rostislav Štork

    Context.A significant fraction of small meteors are produced by iron meteoroids. Their origin and the interaction with the atmosphere have not been well explained up to now.Aims.The goals of the study are to observe faint, slow, low altitude meteors, to identify candidates for iron meteoroids among them, to model their ablation and light curves, and to determine their properties.Methods.Double station video observations were used for the determination of atmospheric trajectories, heliocentric orbits, light curves, and spectra of meteors. Meteors with iron spectra or of suspected iron composition based on beginning heights and light curves were modeled. The immediate removal of liquid iron from the surface as a cloud of droplets with Nukiyama–Tanasawa size distribution and their subsequent vaporization was assumed as the main ablation process on the basis of our previous work. The numerical model has only five parameters: meteoroid initial velocityv∞, zenith distancez, initial massm∞, mean drop sizeDdr, and luminous efficiencyτ. The theoretical light curves were compared with the observed ones.Results.The model is able to explain the majority of the selected light curves, and meteoroid parameters that are not directly observable –m∞,Ddr, andτ– are determined. Unlike in most meteor studies, the mass and luminous efficiency are determined independently. Luminous efficiency ranges from 0.08 to 5.8%; it weakly decreases with increasing initial meteoroid mass. No simple dependency on initial velocity was found. The mean size of iron drops depends on the meteoroid velocity. Slower meteoroids can produce drops with a wide range of mean sizes, whereas faster ones are better matched with larger drops with a smaller dispersion of sizes.


  • A robust method to identify meteor showers new parent bodies from the SonotaCo and EDMOND meteoroid orbit databases

    by M. Guennoun, J. Vaubaillon, D. Čapek, P. Koten, Z. Benkhaldoun

    Context. Several new meteor showers are added to the International Astronomical Union (IAU) list of meteor showers every year. Given the multiplication of video meteor measurements new parent bodies are to be found in addition to new showers. Such an endeavor is usually performed by comparing orbital elements, using a high threshold single-linking D sh-criterion. However, questions remain about the accuracy of the method and the veracity of the newly associated parent bodies.Aims. Our goal is to find the presence of new parent bodies in a statistical meaningful way.Methods. A search for parent bodies was performed among SonotaCo and EDMOND databases. The association of asteroids with meteors was based on different methods, discussed and compared below. In addition, a thorough statistical test was performed in order to investigate the possible random associations.Results. A list of potential new parent bodies associated with at least 50 meteors is found. A statistical test was used to show whether the group of meteor orbits and the asteroid is a random coincidence or not. Out of 54 potential new parent bodies, only three new parent bodies are not excluded by the statistical test: 2014 BN 14, 2015 TX 24 and 2015 QT 3, with a probability of chance occurrence of 37, 10 and 13%, respectively. This shows the need for rigorous method when searching for the existence of meteor showers and parent bodies.Conclusions. Ideally, such a test (or even better, tests) should be conducted in order to confirm (or not) the current IAU list of meteor showers. Similarly, all meteor orbit data in our databases should ideally be revisited using the latest methods providing a better estimate of the real uncertainty and accuracy of the derived orbits.


  • September epsilon Perseid cluster as a result of orbital fragmentation

    by P. Koten, D. Čapek, P. Spurný, J. Vaubaillon, M. Popek, L. Shrbený

    Astronomy & Astrophysics (A&A) is an international journal which publishes papers on all aspects of astronomy and astrophysics


  • The Yarkovsky effect for 99942 Apophis

    by David Vokrouhlický, Davide Farnocchia, David Čapek, Steven R. Chesley, Petr Pravec, Petr Scheirich, Thomas G. Müller