Dong Hyeok Moon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dong Hyeok Moon has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Hyen Goo Cho
Department of Geology and Research Institute of Natural Science, Gyeongsang National University, Jinju 52828, Korea
3 shared publications Myeong Seong Lee
Conservation Science Division, National Research Institute of Cultural Heritage, Daejeon, Republic of Korea
2 shared publicationsNa Ra Lee
Conservation Science Division, National Research Institute of Cultural Heritage, Daejeon, Republic of Korea
2 shared publicationsSo Jin Kim
Conservation Science Division, National Research Institute of Cultural Heritage, Daejeon, Republic of Korea
2 shared publications- Young Rang Uhm
HANARO Utilization Division, Korea Atomic Energy Research Institute, Daejeon, Republic of Korea
2 shared publications Ali Nematollahzadeh
1 shared publication
Latest Publications
- Open Access
- 30 September 2026
- Published by GeoAI Data Society in GEO DATA
- Vol. 8 (3) , 330-343
Potential of Quantitative Mineral Phase Dataset for Geo-archaeological Applications
The application of newly developed analytical datasets has contributed significantly to addressing a wide range of scientific problems in the geosciences. Among the most widely used analytical techniques, X-ray diffraction (XRD) has become one of the most powerful tools for understanding the mineralogical composition of geological materials. In particular, XRD is increasingly being applied to diverse geological investigations because it enables both qualitative and quantitative mineralogical analyses of geological samples that are not suitable for microscopic examination, such as fine-grained rocks, sediments, soils, and weathering or alteration products. In this study, we explored the potential application of quantitative mineral phase data to geo-archaeological research using archaeological ceramics as a case study. Rather than focusing solely on the qualitative identification of mineral phases, we evaluated how quantitatively derived mineralogical datasets can provide archaeologically meaningful information regarding the utilization of geological resources, particularly clay ores and clay-rich soils, in ancient ceramic production. Special attention was given to evaluating the potential of a standardized Rietveld-based quantitative mineral phase dataset, obtained through a systematic XRD analytical workflow, to provide archaeologically meaningful information.
- 30 September 2026
- Published by GeoAI Data Society in GEO DATA
- Vol. 8 (3) , 330-343
Open AccessPotential of Quantitative Mineral Phase Dataset for Geo-archaeological Applications
The application of newly developed analytical datasets has contributed significantly to addressing a wide range of scientific problems in the geosciences. Among the most widely used analytical techniques, X-ray diffraction (XRD) has become one of the most powerful tools for understanding the mineralogical composition of geological materials. In particular, XRD is increasingly being applied to diverse geological investigations because it enables both qualitative and quantitative mineralogical analyses of geological samples that are not suitable for microscopic examination, such as fine-grained rocks, sediments, soils, and weathering or alteration products. In this study, we explored the potential application of quantitative mineral phase data to geo-archaeological research using archaeological ceramics as a case study. Rather than focusing solely on the qualitative identification of mineral phases, we evaluated how quantitatively derived mineralogical datasets can provide archaeologically meaningful information regarding the utilization of geological resources, particularly clay ores and clay-rich soils, in ancient ceramic production. Special attention was given to evaluating the potential of a standardized Rietveld-based quantitative mineral phase dataset, obtained through a systematic XRD analytical workflow, to provide archaeologically meaningful information.
- Open Access
- 2 August 2023
- Published by Elsevier in Open Ceramics
- Vol. 15
Mineralogical and microstructural characterization of ceramics from the fifth and fourth millennium BC in the central plateau of Iran
- 2 August 2023
- Published by Elsevier in Open Ceramics
- Vol. 15
Open AccessMineralogical and microstructural characterization of ceramics from the fifth and fourth millennium BC in the central plateau of Iran
- 14 June 2023
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 332 (12) , 5175-5184
Characterization of iron oxides-based red pigments in the ancient Gaya region, South Korea
- 14 June 2023
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 332 (12) , 5175-5184
Characterization of iron oxides-based red pigments in the ancient Gaya region, South Korea
- 17 November 2022
- Published by Springer Nature in Geosciences Journal
- Vol. 27 (2) , 161-176
Non-invasive mineral analysis of pigments of wall paintings in the Sungseonjeon Hall
- 17 November 2022
- Published by Springer Nature in Geosciences Journal
- Vol. 27 (2) , 161-176
Non-invasive mineral analysis of pigments of wall paintings in the Sungseonjeon Hall
- Open Access
X-ray Diffraction Analysis of Clay Particles in Ancient Baekje Black Pottery: Indicator of the Firing Parameters
An X-ray diffraction (XRD) analysis was conducted after separating clay particles from three shards, to analyze the production technique of black pottery excavated from a historical site of ancient Baekje in Seoul, South Korea. Through the analysis, clay minerals and iron oxides that were not recognized in the XRD patterns of the bulk powder samples were identified. A pottery type with a blackened portion from the surface to the margin and the core was estimated to have been produced in a reduction firing environment of less than 900 °C, by detecting illite and magnetite. As for the other blackened pottery, a brown soil color remained in the core, and the presence of illite and kaolin was confirmed. In addition, while magnetite was detected on the black surface and margin, hematite was detected in the core. These results confirm that this type of blackened pottery was produced through reduction firing at a temperature below 550 °C. In particular, the results indicate that there is a new category of pottery, produced by firing at lower temperatures in a reduction atmosphere, previously not reported by research on ancient Baekje black pottery, which could be discovered due to its specific clay particles.
Open AccessX-ray Diffraction Analysis of Clay Particles in Ancient Baekje Black Pottery: Indicator of the Firing Parameters
An X-ray diffraction (XRD) analysis was conducted after separating clay particles from three shards, to analyze the production technique of black pottery excavated from a historical site of ancient Baekje in Seoul, South Korea. Through the analysis, clay minerals and iron oxides that were not recognized in the XRD patterns of the bulk powder samples were identified. A pottery type with a blackened portion from the surface to the margin and the core was estimated to have been produced in a reduction firing environment of less than 900 °C, by detecting illite and magnetite. As for the other blackened pottery, a brown soil color remained in the core, and the presence of illite and kaolin was confirmed. In addition, while magnetite was detected on the black surface and margin, hematite was detected in the core. These results confirm that this type of blackened pottery was produced through reduction firing at a temperature below 550 °C. In particular, the results indicate that there is a new category of pottery, produced by firing at lower temperatures in a reduction atmosphere, previously not reported by research on ancient Baekje black pottery, which could be discovered due to its specific clay particles.
- Open Access
Ancient Pigments in Afrasiab Murals: Characterization by XRD, SEM, and Raman Spectroscopy
The Afrasiab murals discovered in the northeast of Samarkand, Uzbekistan—the center of the ancient Silk Road—are presumed to date to the mid-seventh century during the Sogdian era. Although previous studies have examined the primary materials of the pigments used in these murals using chemical and microscopic analyses, in-depth investigations of the pigment raw material composition have not been conducted to verify the results of these studies. We applied X-ray diffractometry, Raman spectroscopy, and scanning electron microscopy in conjunction with energy-dispersive X-ray spectroscopy for the first time to identify the raw materials of ancient pigments in fragments obtained from the Afrasiab murals. The results show that lazurite, cinnabar, and amorphous carbon were used as blue, red, and black pigments, respectively. Moreover, we identified that pigments were not directly painted on the wall surface; instead, they were painted on a white undercoat of gypsum plaster, similar to other ancient Silk Road wall paintings. The results of this study can benefit the provision of more accurate information with regard to the composition of raw materials and further support the selection of appropriate substances for the purposes of conservation and restoration of Afrasiab murals.
Open AccessAncient Pigments in Afrasiab Murals: Characterization by XRD, SEM, and Raman Spectroscopy
The Afrasiab murals discovered in the northeast of Samarkand, Uzbekistan—the center of the ancient Silk Road—are presumed to date to the mid-seventh century during the Sogdian era. Although previous studies have examined the primary materials of the pigments used in these murals using chemical and microscopic analyses, in-depth investigations of the pigment raw material composition have not been conducted to verify the results of these studies. We applied X-ray diffractometry, Raman spectroscopy, and scanning electron microscopy in conjunction with energy-dispersive X-ray spectroscopy for the first time to identify the raw materials of ancient pigments in fragments obtained from the Afrasiab murals. The results show that lazurite, cinnabar, and amorphous carbon were used as blue, red, and black pigments, respectively. Moreover, we identified that pigments were not directly painted on the wall surface; instead, they were painted on a white undercoat of gypsum plaster, similar to other ancient Silk Road wall paintings. The results of this study can benefit the provision of more accurate information with regard to the composition of raw materials and further support the selection of appropriate substances for the purposes of conservation and restoration of Afrasiab murals.
- 21 June 2021
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 330 (2) , 419-426
Magnetic and chemical characterization of black pottery from Hanseong Baekje archaeological site, South Korea
- 21 June 2021
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 330 (2) , 419-426
Magnetic and chemical characterization of black pottery from Hanseong Baekje archaeological site, South Korea
- 31 December 2020
- Published by The Korean Magnetics Society in Journal of Magnetics
- Vol. 25 (4) , 496-502
A Study on Magnetic Properties and Role of the Iron Oxides in Ancient Baekje Black Burnished Pottery by Mössbauer Spectroscopy
The magnetic properties and mineral composition of black burnished pottery and reddish-brown pottery with soot unearthed from Pungnaptoseong, and restored black burnished pottery were investigated to determine the black coloring mechanism and firing condition. Results indicate that an increase in the amount of magnetic iron oxide (especially Fe₃O₄) by the thermal reduction reaction of hematite influences the development of black color on the surface. Furthermore, for each sample, the black surface was determined to contain the highest amount of magnetic iron oxide, followed by the black to dark gray matrix, and then the brownish matrix. These results suggested that the ancient black burnished pottery was produced by a stronger reduction reaction on the surface, as compared to the matrix during the firing process. Further, the pottery with a black to dark gray matrix was produced through intense and prolonged reduction firing, compared to the pottery with a brownish matrix.
- 31 December 2020
- Published by The Korean Magnetics Society in Journal of Magnetics
- Vol. 25 (4) , 496-502
A Study on Magnetic Properties and Role of the Iron Oxides in Ancient Baekje Black Burnished Pottery by Mössbauer Spectroscopy
The magnetic properties and mineral composition of black burnished pottery and reddish-brown pottery with soot unearthed from Pungnaptoseong, and restored black burnished pottery were investigated to determine the black coloring mechanism and firing condition. Results indicate that an increase in the amount of magnetic iron oxide (especially Fe₃O₄) by the thermal reduction reaction of hematite influences the development of black color on the surface. Furthermore, for each sample, the black surface was determined to contain the highest amount of magnetic iron oxide, followed by the black to dark gray matrix, and then the brownish matrix. These results suggested that the ancient black burnished pottery was produced by a stronger reduction reaction on the surface, as compared to the matrix during the firing process. Further, the pottery with a black to dark gray matrix was produced through intense and prolonged reduction firing, compared to the pottery with a brownish matrix.