Xu Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Xu Zhang has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
Lianjie Yue
State Key Laboratory of High Temperature Gas Dynamics, Chinese Academy of Sciences
7 shared publications- Qifan Zhang
Chinese Academy of Sciences
4 shared publications Weihang Luo
4 shared publicationsZhanbiao Gao
4 shared publicationsZhenjie Wu
4 shared publications- Hao Chen
State Key Laboratory of High Temperature Gas Dynamics, Institute of Mechanics, Chinese Academy of Sciences, Beijing 100190, China
3 shared publications
Latest Publications
- 1 June 2026
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 64 (6) , 3234-3245
Flame Stabilization Mode Transition Induced by Pilot Injection in a Cavity-Based Scramjet
The effects of pilot hot gas injection on flame stabilization in a cavity-based scramjet were investigated using three-dimensional unsteady Reynolds-averaged Navier–Stokes simulations. Ethylene fuel was injected within a dual-solution regime exhibiting two possible flame stabilization modes. Pilot injection assisted both ignition and flame stabilization. Two representative pilot heating levels, low and high enough, were examined to assess their impact on flame behavior and mode transition. Results show that flame stabilization was highly sensitive to pilot heating power: low heating sustained cavity shear-layer stabilization, whereas high enough heating induced a transition to jet-wake stabilization. This transition was primarily driven by reduced ignition delay in the unburned jet-wake region due to elevated temperatures from pilot heating. Additionally, pilot injection enhanced fuel–air mixing through vortex generation. Both effects intensified with increasing pilot heating power. Consequently, high enough heating power facilitated upstream flame propagation and flow separation, ultimately triggering the transition. A theoretical analysis based on the Semenov thermal ignition theory further showed that high enough pilot heating promoted chemical heat release within a control volume in the unburned jet-wake region, which exceeded the enthalpy outflow in the initial cavity shear-layer stabilization mode. This energy imbalance led to a sustained temperature rise, initiating the transition.
- 1 June 2026
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 64 (6) , 3234-3245
Flame Stabilization Mode Transition Induced by Pilot Injection in a Cavity-Based Scramjet
The effects of pilot hot gas injection on flame stabilization in a cavity-based scramjet were investigated using three-dimensional unsteady Reynolds-averaged Navier–Stokes simulations. Ethylene fuel was injected within a dual-solution regime exhibiting two possible flame stabilization modes. Pilot injection assisted both ignition and flame stabilization. Two representative pilot heating levels, low and high enough, were examined to assess their impact on flame behavior and mode transition. Results show that flame stabilization was highly sensitive to pilot heating power: low heating sustained cavity shear-layer stabilization, whereas high enough heating induced a transition to jet-wake stabilization. This transition was primarily driven by reduced ignition delay in the unburned jet-wake region due to elevated temperatures from pilot heating. Additionally, pilot injection enhanced fuel–air mixing through vortex generation. Both effects intensified with increasing pilot heating power. Consequently, high enough heating power facilitated upstream flame propagation and flow separation, ultimately triggering the transition. A theoretical analysis based on the Semenov thermal ignition theory further showed that high enough pilot heating promoted chemical heat release within a control volume in the unburned jet-wake region, which exceeded the enthalpy outflow in the initial cavity shear-layer stabilization mode. This energy imbalance led to a sustained temperature rise, initiating the transition.
- Open Access
- 4 October 2025
- Published by Elsevier in Chinese Journal of Aeronautics
- Vol. 39 (8)
Numerical research on flow and performance of adaptive throat combustor for wide-range scramjet
- 4 October 2025
- Published by Elsevier in Chinese Journal of Aeronautics
- Vol. 39 (8)
Open AccessNumerical research on flow and performance of adaptive throat combustor for wide-range scramjet
- 1 September 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 280
Oscillations in a circular scramjet combustor operating at different inflow total pressures
- 1 September 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 280
Oscillations in a circular scramjet combustor operating at different inflow total pressures
- 1 April 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (4)
Numerical study of periodic flame flashback in a cavity-based scramjet combustor
The periodic flame flashback phenomenon in an ethylene-fueled cavity-based scramjet combustor was numerically investigated by a three-dimensional unsteady Reynolds-averaged Navier–Stokes solver with two-step kinetics. The air inflow stagnation temperature is 1225 K, and its Mach number is 2.6. Spectral analyses revealed the combustion oscillations with flame flashbacks maintained in the separated scramjet mode with the establishment/vanishment of flow separation near the fuel injector, differing from previous studies of flame flashbacks connected to the ramjet/scramjet mode transitions. A mechanism with four evolution stages was proposed to elucidate the flow-flame interaction. In stage I, a rapid flame flashback upstream and shock-train extension were caused by the high-temperature induced auto-ignition tendency of well-mixed unburned gas in the near-sidewall low-speed region. In stage II, the combustion-induced back pressure and shock train gradually achieved an aerodynamic balance. The combustion flow barely changed in stage III. Meanwhile, a simplified model suggested that the gradual temperature rises occurring upstream of the cavity and away from the sidewall were caused by spanwise heat conduction. The higher temperatures would cause upstream flame propagation with enhanced heat release due to auto-ignition. However, the enhanced heat release occurred mostly in the subsonic flow, resulting in pressure decreases according to one-dimensional flow equations. A smaller near-sidewall separation was produced by the lower back-pressures, which prompted the rapid flame recession downstream in stage IV. Moreover, a simplified flame-spreading model was proposed to illuminate the flame propagation nature. The comparison of flame speeds with theoretical estimations indicated that the current flame was in the regime of turbulent flame propagation, rather than the C–J detonation or deflagration speculated in previous studies.
- 1 April 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (4)
Numerical study of periodic flame flashback in a cavity-based scramjet combustor
The periodic flame flashback phenomenon in an ethylene-fueled cavity-based scramjet combustor was numerically investigated by a three-dimensional unsteady Reynolds-averaged Navier–Stokes solver with two-step kinetics. The air inflow stagnation temperature is 1225 K, and its Mach number is 2.6. Spectral analyses revealed the combustion oscillations with flame flashbacks maintained in the separated scramjet mode with the establishment/vanishment of flow separation near the fuel injector, differing from previous studies of flame flashbacks connected to the ramjet/scramjet mode transitions. A mechanism with four evolution stages was proposed to elucidate the flow-flame interaction. In stage I, a rapid flame flashback upstream and shock-train extension were caused by the high-temperature induced auto-ignition tendency of well-mixed unburned gas in the near-sidewall low-speed region. In stage II, the combustion-induced back pressure and shock train gradually achieved an aerodynamic balance. The combustion flow barely changed in stage III. Meanwhile, a simplified model suggested that the gradual temperature rises occurring upstream of the cavity and away from the sidewall were caused by spanwise heat conduction. The higher temperatures would cause upstream flame propagation with enhanced heat release due to auto-ignition. However, the enhanced heat release occurred mostly in the subsonic flow, resulting in pressure decreases according to one-dimensional flow equations. A smaller near-sidewall separation was produced by the lower back-pressures, which prompted the rapid flame recession downstream in stage IV. Moreover, a simplified flame-spreading model was proposed to illuminate the flame propagation nature. The comparison of flame speeds with theoretical estimations indicated that the current flame was in the regime of turbulent flame propagation, rather than the C–J detonation or deflagration speculated in previous studies.
- Open Access
- 1 October 2022
- Published by Elsevier in Chinese Journal of Aeronautics
- Vol. 35 (10) , 118-133
Experimental study of hysteresis and catastrophe in a cavity-based scramjet combustor
- 1 October 2022
- Published by Elsevier in Chinese Journal of Aeronautics
- Vol. 35 (10) , 118-133
Open AccessExperimental study of hysteresis and catastrophe in a cavity-based scramjet combustor
- 1 July 2022
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 60 (7) , 4006-4014
Experimental Investigation of Abrupt Change in a Scramjet with Variable Mach-Number Flow
To study an abrupt phenomenon of a scramjet in the Mach-number variation process, a scramjet model was tested in the simulated acceleration and deceleration conditions between the flight Mach numbe...
- 1 July 2022
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 60 (7) , 4006-4014
Experimental Investigation of Abrupt Change in a Scramjet with Variable Mach-Number Flow
To study an abrupt phenomenon of a scramjet in the Mach-number variation process, a scramjet model was tested in the simulated acceleration and deceleration conditions between the flight Mach numbe...
- 1 April 2022
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 60 (4) , 2694-2700
Fuel Regulation Historical Effects on Flame Stabilizations in a Cavity-Based Scramjet Combustor
- 1 April 2022
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 60 (4) , 2694-2700
Fuel Regulation Historical Effects on Flame Stabilizations in a Cavity-Based Scramjet Combustor
- 1 August 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (54) , 27801-27815
Optical diagnostics in a detonation-driven direct-connected circular combustor fueled with hydrogen for mach 10 scramjet
- 1 August 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (54) , 27801-27815
Optical diagnostics in a detonation-driven direct-connected circular combustor fueled with hydrogen for mach 10 scramjet