Syariena Arshad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Syariena Arshad has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Muhamad Mat Salleh
Universiti Kebangsaan Malaysia
3 shared publications Muhammad Yahaya
3 shared publications- Aisyah Amini Amin
Faculty of Food Science and Nutrition, Universiti Malaysia Sabah
1 shared publication - Awis Qurni Sazili
Department of Animal Science, Faculty of Agriculture, Universiti Putra Malaysia (UPM), Serdang, Malaysia
1 shared publication - Bangun Prajanto Nusantoro
Faculty of Agricultural Technology, Universitas Gadjah Mada
1 shared publication - Helmi Wasoh
Department of Bioprocess Technology, Faculty of Biotechnology and Biomolecular Sciences, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia
1 shared publication
Latest Publications
- Open Access
- 5 November 2025
- Published by EDP Sciences in OCL
- Vol. 32, 35
Characterisation of mechanically-pressed avocado oil from cultivars grown in Sabah, Malaysia
This study investigates the lipid characteristics of mechanically-pressed crude pulp oil derived from three avocado ( Persea americana ) cultivars − Bacon Green (BG), SNR, and QAV1–with a focus on their physicochemical profiles, including fatty acid and triacylglycerol (TAG) compositions, and thermal behaviours. Notably, the BG cultivar produced oil that remained solid at room temperature (25°C), while oils from the SNR and QAV1 cultivars were liquid under the same conditions. All three oils were rich in unsaturated fatty acids, particularly monounsaturated oleic acid, which accounted for 32.74–44.50% of the total fatty acids across cultivars. Despite these compositional similarities, the cultivars exhibited significant differences in TAG distribution. While POL -i.e. Palmitic, Oleic, Linoleic TAG- (20.68–22.41%), PLL (11.46–17.15%), and POO (11.15–15.49%) were consistently among the major TAGs in all cultivars, differences in the concentrations of the overall TAG components contributed to variations in melting behaviour. While cooling profiles were relatively similar, distinct melting transitions were observed, indicating cultivar-specific thermal responses. These findings highlight the diversity in lipid properties among local Malaysian avocado cultivars and suggest promising industrial potential, with the solid-state BG oil offering potential as a natural alternative to hydrogenated fats in food formulations, while the liquid oils from SNR and QAV1 may be suitable for cosmetic and nutraceutical uses. The study underscores the value of underexplored tropical avocado varieties as functional lipid sources with tailored applications.
- 5 November 2025
- Published by EDP Sciences in OCL
- Vol. 32, 35
Open AccessCharacterisation of mechanically-pressed avocado oil from cultivars grown in Sabah, Malaysia
This study investigates the lipid characteristics of mechanically-pressed crude pulp oil derived from three avocado ( Persea americana ) cultivars − Bacon Green (BG), SNR, and QAV1–with a focus on their physicochemical profiles, including fatty acid and triacylglycerol (TAG) compositions, and thermal behaviours. Notably, the BG cultivar produced oil that remained solid at room temperature (25°C), while oils from the SNR and QAV1 cultivars were liquid under the same conditions. All three oils were rich in unsaturated fatty acids, particularly monounsaturated oleic acid, which accounted for 32.74–44.50% of the total fatty acids across cultivars. Despite these compositional similarities, the cultivars exhibited significant differences in TAG distribution. While POL -i.e. Palmitic, Oleic, Linoleic TAG- (20.68–22.41%), PLL (11.46–17.15%), and POO (11.15–15.49%) were consistently among the major TAGs in all cultivars, differences in the concentrations of the overall TAG components contributed to variations in melting behaviour. While cooling profiles were relatively similar, distinct melting transitions were observed, indicating cultivar-specific thermal responses. These findings highlight the diversity in lipid properties among local Malaysian avocado cultivars and suggest promising industrial potential, with the solid-state BG oil offering potential as a natural alternative to hydrogenated fats in food formulations, while the liquid oils from SNR and QAV1 may be suitable for cosmetic and nutraceutical uses. The study underscores the value of underexplored tropical avocado varieties as functional lipid sources with tailored applications.
- Open Access
- 15 September 2025
- Published by Taylor & Francis in Cogent Food & Agriculture
- Vol. 11 (1)
Impact of ground size on meat quality and meat products: a review
- 15 September 2025
- Published by Taylor & Francis in Cogent Food & Agriculture
- Vol. 11 (1)
Open AccessImpact of ground size on meat quality and meat products: a review
- 1 December 2008
- Published by American Scientific Publishers in Sensor Letters
- Vol. 6 (6) , 903-907
The Performance of Quartz Crystal Microbalance Coated TiO2-Porphyrin Nanocomposite Thin Film Gas Sensors
- 1 December 2008
- Published by American Scientific Publishers in Sensor Letters
- Vol. 6 (6) , 903-907
The Performance of Quartz Crystal Microbalance Coated TiO2-Porphyrin Nanocomposite Thin Film Gas Sensors
- 1 November 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 532-535
The selectivity of quartz crystal microbalance gas sensor coated with TiO2-porphyrin nanocomposite thin films towards volatile organic compounds
High and broad selectivity is among the important properties to fabricate a good gas sensor system. We had fabricated gas sensor by coating QCM with highly selective sensing elements. Many researches have been conducted using variety of sensing elements to fulfill these criteria and porphyrin has become among the potential candidates. This paper reports the use of TiO 2 -porphyrin nanocomposite as sensing element to detect ethanol, 2-propanol, acetone, cyclohexane, toluene and o-xylene vapors. Eight TiO 2 -porphyrin nanocomposite thin films were prepared via dip coating method. The sensing sensitivity was based on the change in the fundamental frequency of the QCM. It was observed that all the thin films have good selectivity properties towards these gases. From the results, it shows that the metal centre of the porphyrins and ligand plays a key role on the selectivity of the sensor.
- 1 November 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 532-535
The selectivity of quartz crystal microbalance gas sensor coated with TiO2-porphyrin nanocomposite thin films towards volatile organic compounds
High and broad selectivity is among the important properties to fabricate a good gas sensor system. We had fabricated gas sensor by coating QCM with highly selective sensing elements. Many researches have been conducted using variety of sensing elements to fulfill these criteria and porphyrin has become among the potential candidates. This paper reports the use of TiO 2 -porphyrin nanocomposite as sensing element to detect ethanol, 2-propanol, acetone, cyclohexane, toluene and o-xylene vapors. Eight TiO 2 -porphyrin nanocomposite thin films were prepared via dip coating method. The sensing sensitivity was based on the change in the fundamental frequency of the QCM. It was observed that all the thin films have good selectivity properties towards these gases. From the results, it shows that the metal centre of the porphyrins and ligand plays a key role on the selectivity of the sensor.
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 281-285
The Effect of Surface Microstructure on The Response of Titanium Dioxide Coated with Cobalt-Porphyrin Thin Films Towards Gases in Quartz Crystal Microbalance Sensor
A single-layer and multi-layer titanium dioxide (TiO2) coated with dye porphyrin thin films were prepared on Quartz Crystal Microbalance (QCM) using sol-gel dip coating method and were tested for sensing of volatile organic compounds (VOCs). The porphyrin was 2,3,7,8,12,13,17,18-octaethyl- 21H,23H-porphine cobalt (II). The sensing sensitivity was based on the change in the fundamental frequency of the QCM upon exposure towards three vapor samples, namely ethanol, acetone and 2-propanol. It was found that the thin films were sensitive towards all vapors and the sensing sensitivity was affected by the number of film layers. Although the three-layer film exhibited higher frequency response compared with the other films that have small number of layers, the sensing properties of this film are not repeatable and less selective. The performance of the QCM sensor was depended on microstructure of the thin film which was varied through the number layers.
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 281-285
The Effect of Surface Microstructure on The Response of Titanium Dioxide Coated with Cobalt-Porphyrin Thin Films Towards Gases in Quartz Crystal Microbalance Sensor
A single-layer and multi-layer titanium dioxide (TiO2) coated with dye porphyrin thin films were prepared on Quartz Crystal Microbalance (QCM) using sol-gel dip coating method and were tested for sensing of volatile organic compounds (VOCs). The porphyrin was 2,3,7,8,12,13,17,18-octaethyl- 21H,23H-porphine cobalt (II). The sensing sensitivity was based on the change in the fundamental frequency of the QCM upon exposure towards three vapor samples, namely ethanol, acetone and 2-propanol. It was found that the thin films were sensitive towards all vapors and the sensing sensitivity was affected by the number of film layers. Although the three-layer film exhibited higher frequency response compared with the other films that have small number of layers, the sensing properties of this film are not repeatable and less selective. The performance of the QCM sensor was depended on microstructure of the thin film which was varied through the number layers.