Hengyang Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hengyang Wang has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Guang Han
College of Materials Science and Engineering
6 shared publications Bin Zhang
5 shared publicationsGuoyu Wang
4 shared publicationsXiaofang Liu
4 shared publicationsXiaoyuan Zhou
4 shared publicationsYao Chen
4 shared publications
Latest Publications
- 20 November 2025
- Published by Elsevier in Acta Materialia
- Vol. 303
Rational design and synthesis of second phases in n-type Ag2Se-based composites for enhanced thermoelectric and mechanical properties
- 20 November 2025
- Published by Elsevier in Acta Materialia
- Vol. 303
Rational design and synthesis of second phases in n-type Ag2Se-based composites for enhanced thermoelectric and mechanical properties
- 6 February 2023
- Published by Elsevier in Acta Materialia
- Vol. 248
AgSbSe2 inclusions enabling high thermoelectric and mechanical performance in n-type Ag2Se-based composites
- 6 February 2023
- Published by Elsevier in Acta Materialia
- Vol. 248
AgSbSe2 inclusions enabling high thermoelectric and mechanical performance in n-type Ag2Se-based composites
- 1 June 2022
- Published by Elsevier in Scripta Materialia
- Vol. 218
Simultaneously optimized thermoelectric and mechanical performance of p-type polycrystalline SnSe enabled by CNTs addition
- 1 June 2022
- Published by Elsevier in Scripta Materialia
- Vol. 218
Simultaneously optimized thermoelectric and mechanical performance of p-type polycrystalline SnSe enabled by CNTs addition
- 1 August 2020
- Published by Elsevier in Chemical Engineering Journal
- Vol. 393
General surfactant-free synthesis of binary silver chalcogenides with tuneable thermoelectric properties
- 1 August 2020
- Published by Elsevier in Chemical Engineering Journal
- Vol. 393
General surfactant-free synthesis of binary silver chalcogenides with tuneable thermoelectric properties
- 18 June 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 8 (30) , 10333-10341
Facile microwave-assisted hydrothermal synthesis of SnSe: impurity removal and enhanced thermoelectric properties
Bottom-up solution synthesis has been considered as a facile and energy-efficient approach for SnSe thermoelectric materials. Herein, we report a microwave-assisted hydrothermal method for the fast and controllable synthesis of SnSe with optimised thermoelectric properties. The NaOH concentration in solution precursors was demonstrated as a key factor influencing the phase composition, diameter, and morphology of the hydrothermal products as well as the thermoelectric properties of the corresponding sintered pellets. It is found that a NaOH : SnCl2 molar ratio of 30 leads to the formation of phase-pure SnSe microrods, and the pellet constructed from these rods obtains a maximum ZT of 1.08 and 0.78 at 773 K in parallel and perpendicular alignments to the pressing direction, respectively. These ZT values are significantly higher than the ZT value achieved by the pellet that was sintered from the hydrothermal powders prepared without NaOH and comprised the mixed phases of SnSe, SnO2, and SnSe2. This enhancement is primarily due to the improved power factor together with the lower lattice thermal conductivity owing to the significantly reduced fraction of SnO2 in the pellet. This study not only provides a microwave-assisted solution strategy for the fast, efficient, and controllable synthesis of SnSe materials, but also identifies the key synthesis parameters for securing better thermoelectric performance.
- 18 June 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 8 (30) , 10333-10341
Facile microwave-assisted hydrothermal synthesis of SnSe: impurity removal and enhanced thermoelectric properties
Bottom-up solution synthesis has been considered as a facile and energy-efficient approach for SnSe thermoelectric materials. Herein, we report a microwave-assisted hydrothermal method for the fast and controllable synthesis of SnSe with optimised thermoelectric properties. The NaOH concentration in solution precursors was demonstrated as a key factor influencing the phase composition, diameter, and morphology of the hydrothermal products as well as the thermoelectric properties of the corresponding sintered pellets. It is found that a NaOH : SnCl2 molar ratio of 30 leads to the formation of phase-pure SnSe microrods, and the pellet constructed from these rods obtains a maximum ZT of 1.08 and 0.78 at 773 K in parallel and perpendicular alignments to the pressing direction, respectively. These ZT values are significantly higher than the ZT value achieved by the pellet that was sintered from the hydrothermal powders prepared without NaOH and comprised the mixed phases of SnSe, SnO2, and SnSe2. This enhancement is primarily due to the improved power factor together with the lower lattice thermal conductivity owing to the significantly reduced fraction of SnO2 in the pellet. This study not only provides a microwave-assisted solution strategy for the fast, efficient, and controllable synthesis of SnSe materials, but also identifies the key synthesis parameters for securing better thermoelectric performance.
- Open Access
- 16 December 2019
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 8 (3) , 1394-1402
Facile in situ solution synthesis of SnSe/rGO nanocomposites with enhanced thermoelectric performance
Constructing nanostructured composite architectures has been considered as an effective strategy to reduce the lattice thermal conductivity (κL) and enhance the dimensionless figure of merit (ZT) of thermoelectric materials. Herein, a series of SnSe/reduced graphene oxide (rGO)-x (x = 0.1, 0.3, 0.5, 0.7 wt%) nanocomposites are controllably synthesised in situ via a facile single-step bottom-up solution method, where rGO nanosheets are incorporated intimately into the SnSe matrix. Nanocompositing performs two key functions: (i) significantly reducing the lattice thermal conductivity of the material, which can be attributed to enhanced phonon scattering from high-density SnSe/rGO interfaces, and (ii) improving the electrical conductivity over the low temperature range, as result of an increased carrier concentration. The subsequent thermoelectric performance of SnSe/rGO sintered pellets has been optimised by tuning the rGO mass fraction, with SnSe/rGO-0.3 achieving κL = 0.36 W m−1 K−1 at 773 K (cutting the κL of SnSe by 33%) to yield a maximum ZT of 0.91 at 823 K (representing a ∼47% increase compared to SnSe). This study provides a new pathway to improve the thermoelectric performance of polycrystalline SnSe by way of engineering metal chalcogenide/rGO composite architectures at the nanoscale.
- 16 December 2019
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 8 (3) , 1394-1402
Open AccessFacile in situ solution synthesis of SnSe/rGO nanocomposites with enhanced thermoelectric performance
Constructing nanostructured composite architectures has been considered as an effective strategy to reduce the lattice thermal conductivity (κL) and enhance the dimensionless figure of merit (ZT) of thermoelectric materials. Herein, a series of SnSe/reduced graphene oxide (rGO)-x (x = 0.1, 0.3, 0.5, 0.7 wt%) nanocomposites are controllably synthesised in situ via a facile single-step bottom-up solution method, where rGO nanosheets are incorporated intimately into the SnSe matrix. Nanocompositing performs two key functions: (i) significantly reducing the lattice thermal conductivity of the material, which can be attributed to enhanced phonon scattering from high-density SnSe/rGO interfaces, and (ii) improving the electrical conductivity over the low temperature range, as result of an increased carrier concentration. The subsequent thermoelectric performance of SnSe/rGO sintered pellets has been optimised by tuning the rGO mass fraction, with SnSe/rGO-0.3 achieving κL = 0.36 W m−1 K−1 at 773 K (cutting the κL of SnSe by 33%) to yield a maximum ZT of 0.91 at 823 K (representing a ∼47% increase compared to SnSe). This study provides a new pathway to improve the thermoelectric performance of polycrystalline SnSe by way of engineering metal chalcogenide/rGO composite architectures at the nanoscale.