Husam Sabeeh Al-Arab
Husam Sabeeh Al-Arab has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Asrar Abdulmunem Saeed
Department of Physics, College of Science, Mustansiriyah University, 10052 Baghdad, IRAQ
2 shared publications K. Ibrahim
School of Physics, Universiti Sains Malaysia, Penang, Malaysia
2 shared publicationsM. Bououdina
Department of Physics, College of Science, University of Bahrain, Zallaq, Kingdom of Bahrain
2 shared publicationsMohamed S. Mahdi
Directorate of Renewable Energy, Ministry of Science and Technology, Baghdad, Iraq
2 shared publicationsA. Hmood
1 shared publication- Aed I. Owaid
Environement, Water and Renewable Energy Directorate
1 shared publication
Latest Publications
- 1 March 2026
- Published by Pleiades Publishing Ltd in Journal of Experimental and Theoretical Physics
- Vol. 142 (3) , 219-226
Theoretical Design and Performance Evaluation of a Hot-Mirror Optical Filter for Photovoltaic Cells
- 1 March 2026
- Published by Pleiades Publishing Ltd in Journal of Experimental and Theoretical Physics
- Vol. 142 (3) , 219-226
Theoretical Design and Performance Evaluation of a Hot-Mirror Optical Filter for Photovoltaic Cells
- 1 March 2025
- Published by Gazi University Journal of Science in Gazi University Journal of Science
- Vol. 38 (1) , 159-165
On-Grid Flat Plate Solar Water Heater Collector Application for Electrical Energy Saving Contribution
This study introduces a novel approach in Baghdad, Iraq, where flat plate solar heaters are directly connected to the electric heater without the use of storage tanks. This setup operates in a manner similar to solar cells connected to the electric grid, without the need for electrical energy storage during daylight hours (on-grid). A series of solar heaters, covering a total area of 3 m2, have been linked to the electric water heater. This arrangement allows the water supplied to the electric heater to either be pre-heated by the solar heaters or delivered directly. The percentage of electrical energy saved to obtain 100 liters of hot water at 40 °C using a water mixer was 53% and 57% when adjusting the electrical heater thermostat to 60 °C and 80 °C, respectively. This was found by comparing the electrical energy usage of the electric heater in both cases (preheating and direct supply).
- 1 March 2025
- Published by Gazi University Journal of Science in Gazi University Journal of Science
- Vol. 38 (1) , 159-165
On-Grid Flat Plate Solar Water Heater Collector Application for Electrical Energy Saving Contribution
This study introduces a novel approach in Baghdad, Iraq, where flat plate solar heaters are directly connected to the electric heater without the use of storage tanks. This setup operates in a manner similar to solar cells connected to the electric grid, without the need for electrical energy storage during daylight hours (on-grid). A series of solar heaters, covering a total area of 3 m2, have been linked to the electric water heater. This arrangement allows the water supplied to the electric heater to either be pre-heated by the solar heaters or delivered directly. The percentage of electrical energy saved to obtain 100 liters of hot water at 40 °C using a water mixer was 53% and 57% when adjusting the electrical heater thermostat to 60 °C and 80 °C, respectively. This was found by comparing the electrical energy usage of the electric heater in both cases (preheating and direct supply).
- 7 October 2024
- Published by Springer Nature in Journal of Optics
- Vol. 55 (2) , 1789-1797
Analyzes and compares the optical characteristics for two types of solar dish concentrators
- 7 October 2024
- Published by Springer Nature in Journal of Optics
- Vol. 55 (2) , 1789-1797
Analyzes and compares the optical characteristics for two types of solar dish concentrators
- 1 January 2021
- Published by Gazi University Journal of Science in Gazi University Journal of Science
- Vol. 34 (2) , 550-560
Estimation of Theoretical Models of Photophysical Processes for Fluorescein Laser Dye with Ag Nanoparticles
In this study, a novel theoretical method for the absorption and fluorescence spectral estimations has been presented. These estimations have been based on experimental measurements of absorption and fluorescence spectra for the solutions of Fluorescein laser dye with Silver (Ag) nanoparticles in distilled water. The used concentration was (1x10(-5) M) for Fluorescein dye, while the mass amounts were (0.003g, 0.005g, 0.0065g, 0.008g and 0.0085g) for Silver nanoparticles. A spectral absorption enhancement was detected in the case of increased Silver nanoparticle masses, which specify that the doped Fluorescein dye with Ag nanoparticles has an important effect on the dye absorption spectra. On the other hand, each fluorescence emission spectrum for the dye has quenched as Ag nanoparticle's mass amounts have increased. The related amounts of mass increase as a consequence of Forster resonance energy transfer (FRET). The novel approach of theoretical estimations has been based on curve fitting using Logistic Power Peak (LPP) function to estimate theoretical models for the absorption and fluorescence spectra of these samples. These rated models have excellent matching profiles with the experimental profiles so that the estimated models can replace the experimental measurements.
- 1 January 2021
- Published by Gazi University Journal of Science in Gazi University Journal of Science
- Vol. 34 (2) , 550-560
Estimation of Theoretical Models of Photophysical Processes for Fluorescein Laser Dye with Ag Nanoparticles
In this study, a novel theoretical method for the absorption and fluorescence spectral estimations has been presented. These estimations have been based on experimental measurements of absorption and fluorescence spectra for the solutions of Fluorescein laser dye with Silver (Ag) nanoparticles in distilled water. The used concentration was (1x10(-5) M) for Fluorescein dye, while the mass amounts were (0.003g, 0.005g, 0.0065g, 0.008g and 0.0085g) for Silver nanoparticles. A spectral absorption enhancement was detected in the case of increased Silver nanoparticle masses, which specify that the doped Fluorescein dye with Ag nanoparticles has an important effect on the dye absorption spectra. On the other hand, each fluorescence emission spectrum for the dye has quenched as Ag nanoparticle's mass amounts have increased. The related amounts of mass increase as a consequence of Forster resonance energy transfer (FRET). The novel approach of theoretical estimations has been based on curve fitting using Logistic Power Peak (LPP) function to estimate theoretical models for the absorption and fluorescence spectra of these samples. These rated models have excellent matching profiles with the experimental profiles so that the estimated models can replace the experimental measurements.
- 27 November 2020
- Published by Springer Nature in Applied Physics A
- Vol. 126 (12) , 1-8
Flexible and high-performance broadband nanoflowers tin sulfide photodetector
- 27 November 2020
- Published by Springer Nature in Applied Physics A
- Vol. 126 (12) , 1-8
Flexible and high-performance broadband nanoflowers tin sulfide photodetector
- 1 August 2020
- Published by Elsevier in Materials Letters
- Vol. 273
A high-performance near-infrared photodetector based on π-SnS phase
- 1 August 2020
- Published by Elsevier in Materials Letters
- Vol. 273
A high-performance near-infrared photodetector based on π-SnS phase
- Open Access
- 26 April 2020
- Published by University of Baghdad College of Science in Iraqi Journal of Science
- p. 780-790
The Establishment of a Theoretical Model for the Estimation of Some Photo-Physical Processes in Laser Dyes
In this study, a new theoretical method for the estimation of absorption and fluorescence spectra is accomplished. These estimations were established following experimental measurements of absorption and fluorescence spectra for the solutions of fluorescein laser dye mixed with titanium dioxide (TiO2) nanoparticlesin distilled water. The used concentration of fluorescein dye was 1x10-5 M, whereas the masses of titanium dioxide nanoparticles were 0.0003g, 0.0005g, 0.001g and 0.002g. An absorption spectra improvement was observed upon raising the mass of TiO2 nanoparticles, which specifies that doping the fluorescein dye with TiO2 nanoparticles have an essential influence on the dye absorption spectra. On the other side, all fluorescence spectra for the dye quenched as TiO2 nanoparticles mass was increased, because of the induced electron transfer. The new method of theoretical estimations was based on curve fitting using Logistic Power Peak (LPP) function to estimate theoretical models for the absorption and fluorescence spectra of thesesamples. The results revealed that these estimated models had exceptional matching shapes with the experimental shapes, so that the estimated models can substitute the experimental measurements.
- 26 April 2020
- Published by University of Baghdad College of Science in Iraqi Journal of Science
- p. 780-790
Open AccessThe Establishment of a Theoretical Model for the Estimation of Some Photo-Physical Processes in Laser Dyes
In this study, a new theoretical method for the estimation of absorption and fluorescence spectra is accomplished. These estimations were established following experimental measurements of absorption and fluorescence spectra for the solutions of fluorescein laser dye mixed with titanium dioxide (TiO2) nanoparticlesin distilled water. The used concentration of fluorescein dye was 1x10-5 M, whereas the masses of titanium dioxide nanoparticles were 0.0003g, 0.0005g, 0.001g and 0.002g. An absorption spectra improvement was observed upon raising the mass of TiO2 nanoparticles, which specifies that doping the fluorescein dye with TiO2 nanoparticles have an essential influence on the dye absorption spectra. On the other side, all fluorescence spectra for the dye quenched as TiO2 nanoparticles mass was increased, because of the induced electron transfer. The new method of theoretical estimations was based on curve fitting using Logistic Power Peak (LPP) function to estimate theoretical models for the absorption and fluorescence spectra of thesesamples. The results revealed that these estimated models had exceptional matching shapes with the experimental shapes, so that the estimated models can substitute the experimental measurements.
- Open Access
- 6 May 2019
- Published by Al-Mustansiriyah Journal of Science in Al-Mustansiriyah Journal of Science
- Vol. 29 (4) , 134-137
Efficiency of Energy Transfer for TiO2 Nanoparticles with Fluorescein Dye
For different amount of masses of TiO2 nanoparticles in dye solution, absorption and Fluorescence profiles of the suspension for TiO2 nanoparticles with Fluorescein (F) in distilled water solution, has been explored. An absorption spectra enhancement were detected for changed amount of masses, which specifies that the doping with TiO2 nanoparticles has a major effect on the dye absorption spectra. Contrarily, all fluorescence emission spectra for the dye, were quenched as TiO2 nanoparticles amount of masses increases because of Förster resonance energy transfer (FRET).
- 6 May 2019
- Published by Al-Mustansiriyah Journal of Science in Al-Mustansiriyah Journal of Science
- Vol. 29 (4) , 134-137
Open AccessEfficiency of Energy Transfer for TiO2 Nanoparticles with Fluorescein Dye
For different amount of masses of TiO2 nanoparticles in dye solution, absorption and Fluorescence profiles of the suspension for TiO2 nanoparticles with Fluorescein (F) in distilled water solution, has been explored. An absorption spectra enhancement were detected for changed amount of masses, which specifies that the doping with TiO2 nanoparticles has a major effect on the dye absorption spectra. Contrarily, all fluorescence emission spectra for the dye, were quenched as TiO2 nanoparticles amount of masses increases because of Förster resonance energy transfer (FRET).