Kei Mizuta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Kei Mizuta has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
Toshio Tsutsui
Department of Chemical Engineering, Kagoshima University, 1-21-40 Korimoto, Kagoshima, Japan
7 shared publicationsSusumu Nii
6 shared publications- Takashi Goshima
Department of Chemical Engineering, Graduate School of Science and Engineering, Kagoshima University, 1-21-40 Korimoto, Kagoshima 890-0065, Japan
5 shared publications Kenta Fukudome
Department of Chemical Engineering, Kagoshima University, Kaogshima-city, Japan
4 shared publicationsTsutomu Nakazato
Department of Chemical Engineering, Kagoshima University
3 shared publications- Fumimaru Ogino
Department of Chemical Engineering, Kyoto University
2 shared publications
Latest Publications
- Open Access
- 22 June 2022
- Published by Elsevier in Chemical Engineering Journal Advances
- Vol. 11
Development of a fine bubble generator through the active control of gas chamber pressure
- 22 June 2022
- Published by Elsevier in Chemical Engineering Journal Advances
- Vol. 11
Open AccessDevelopment of a fine bubble generator through the active control of gas chamber pressure
- 1 January 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 146, 843-853
Quasi one-dimensional approach to evaluate temperature dependent anisotropic thermal conductivity of a flat laminate vapor chamber
- 1 January 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 146, 843-853
Quasi one-dimensional approach to evaluate temperature dependent anisotropic thermal conductivity of a flat laminate vapor chamber
- 24 July 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (20) , 2400-2406
Conversion of jatropha oil into lower olefins over zeolite catalysts in the presence of water
A simple method, supplying water with Jatropha oil, was proposed to enhance the conversion of selectivity of lower olefins over zeolite catalysts, H-ZSM-5 and SAPO-11. The yield of lower olefins was as high as 54 C mol%, and the selectivity for lower olefins reached 58 C mol%. The optimum condition on catalytic conversion of jatropha oil was 600 °C of reaction temperature, 3.0 s of contact time and 0.7 of water fraction with SAPO-11. The presence of water effectively suppressed the progress of Diels-Alder and hydrogen transfer reaction probably due to the reduced number of acid sites.
- 24 July 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (20) , 2400-2406
Conversion of jatropha oil into lower olefins over zeolite catalysts in the presence of water
A simple method, supplying water with Jatropha oil, was proposed to enhance the conversion of selectivity of lower olefins over zeolite catalysts, H-ZSM-5 and SAPO-11. The yield of lower olefins was as high as 54 C mol%, and the selectivity for lower olefins reached 58 C mol%. The optimum condition on catalytic conversion of jatropha oil was 600 °C of reaction temperature, 3.0 s of contact time and 0.7 of water fraction with SAPO-11. The presence of water effectively suppressed the progress of Diels-Alder and hydrogen transfer reaction probably due to the reduced number of acid sites.
- 20 July 2018
- Published by Society of Chemical Engineers, Japan in KAGAKU KOGAKU RONBUNSHU
- Vol. 44 (4) , 278-283
Conditions for Acid Fermentation of Molasses for Effective Production of Propylene from Biomass
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 20 July 2018
- Published by Society of Chemical Engineers, Japan in KAGAKU KOGAKU RONBUNSHU
- Vol. 44 (4) , 278-283
Conditions for Acid Fermentation of Molasses for Effective Production of Propylene from Biomass
総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。
- 1 January 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (3) , 306-311
Feasibility of zeolites in converting butyric acid into propylene for biorefineries
The biorefinery has been recognized as a new industry to produce both energy and chemical materials such as olefins and BTX from renewable resources. In this context the conversion of butyric acid over zeolites was investigated for establishing a new production route of propylene. Propylene was mainly generated by decarbonylation and dehydration of butyric acid. Our study proved that H-ZSM-5 (750) and silicalite were the best industrial catalyst among the tested ones. For H-ZSM-5 (750), the selectivity of propylene reached 64.2 C% and the ratio of the yield for propylene to theoretical yield (75 C%) became 85.6%.
- 1 January 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (3) , 306-311
Feasibility of zeolites in converting butyric acid into propylene for biorefineries
The biorefinery has been recognized as a new industry to produce both energy and chemical materials such as olefins and BTX from renewable resources. In this context the conversion of butyric acid over zeolites was investigated for establishing a new production route of propylene. Propylene was mainly generated by decarbonylation and dehydration of butyric acid. Our study proved that H-ZSM-5 (750) and silicalite were the best industrial catalyst among the tested ones. For H-ZSM-5 (750), the selectivity of propylene reached 64.2 C% and the ratio of the yield for propylene to theoretical yield (75 C%) became 85.6%.
- 5 September 2017
- Published by Wiley in Chemical Engineering & Technology
- Vol. 40 (12) , 2295-2304
Experimental Investigation on Gas‐Solid Behavior in Fluidized Beds with Superfine Particles
- 5 September 2017
- Published by Wiley in Chemical Engineering & Technology
- Vol. 40 (12) , 2295-2304
Experimental Investigation on Gas‐Solid Behavior in Fluidized Beds with Superfine Particles
- 1 July 2016
- Published by Elsevier in Applied Thermal Engineering
- Vol. 104, 461-471
Development and characterization of a flat laminate vapor chamber
- 1 July 2016
- Published by Elsevier in Applied Thermal Engineering
- Vol. 104, 461-471
Development and characterization of a flat laminate vapor chamber
- Open Access
- 10 September 2015
- Published by Elsevier in Physics Procedia
- Vol. 69, 556-563
Measurement of Coolant in a Flat Heat Pipe Using Neutron Radiography
- 10 September 2015
- Published by Elsevier in Physics Procedia
- Vol. 69, 556-563
Open AccessMeasurement of Coolant in a Flat Heat Pipe Using Neutron Radiography
- 1 January 2015
- Published by Taylor & Francis in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
- Vol. 48 (6) , 436-443
Pressure Fluctuation Analysis of the Defluidization Caused by a Reaction Involving Gas-Volume Reduction in a Fluidized Catalyst Bed
- 1 January 2015
- Published by Taylor & Francis in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
- Vol. 48 (6) , 436-443
Pressure Fluctuation Analysis of the Defluidization Caused by a Reaction Involving Gas-Volume Reduction in a Fluidized Catalyst Bed
- 12 September 2014
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 625, 298-305
Conversion of Biomass-Derived Oxygen-Containing Intermediates into Chemical Raw Materials with Zeolite
To establish a new production route of biomass-derived BTX and propylene, the catalytic conversion of oxygen-containing intermediates which are furfural, levulinic acid, acetic acid or butyric acid, obtained by hydrothermal reactions of bagasse or fermentation of molasses was investigated with zeolites, ZSM-5, SAPO-11 and SAPO-34. Levulinic acid and acetic acid were suitable for generating BTX with ZSM-5. On the other hand, the butyric acid was valuable for converting to chemical raw materials with ZSM-5. By using SAPO-11 as the catalyst, butyric acid converted to propylene at high yields. The yield for propylene was the maximum value 58.8C% at 723K, especially the ratio of propylene to gaseous hydrocarbon products increased up to 90.4C%.
- 12 September 2014
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 625, 298-305
Conversion of Biomass-Derived Oxygen-Containing Intermediates into Chemical Raw Materials with Zeolite
To establish a new production route of biomass-derived BTX and propylene, the catalytic conversion of oxygen-containing intermediates which are furfural, levulinic acid, acetic acid or butyric acid, obtained by hydrothermal reactions of bagasse or fermentation of molasses was investigated with zeolites, ZSM-5, SAPO-11 and SAPO-34. Levulinic acid and acetic acid were suitable for generating BTX with ZSM-5. On the other hand, the butyric acid was valuable for converting to chemical raw materials with ZSM-5. By using SAPO-11 as the catalyst, butyric acid converted to propylene at high yields. The yield for propylene was the maximum value 58.8C% at 723K, especially the ratio of propylene to gaseous hydrocarbon products increased up to 90.4C%.