YKYuliana Koliesnik

Yuliana Koliesnik

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yuliana Koliesnik has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Research on Vibrations and Force Loading of a Tractor Dump Trailer

    by Ivan Koliesnik, Evgeny Kalinin, Vladimir Manoylo, Yuliana Koliesnik, Blesnyuk Oleg

  • Open Access

    DURATION OF THE TURNING MANEUVER OF A WHEELED TRACTOR IN AN UNSTABLE MODE WHEN COMBINING ACCELERATION AND BRAKING

    by Ivan Koliesnik, Yuliana Koliesnik, Arsenii Motuziuk

    The article discusses the process of performing a turning maneuver of a wheeled tractor in an unstable mode of movement under conditions of combined acceleration and braking. It is shown that when a tractor is working with mounted, semi-mounted, or trailed equipment, a significant part of the working cycle is devoted to such maneuvers, especially when performing loading, transport, and technological operations in a confined space. It has been established that the duration and radius of the turn significantly affect the length of the trajectory, the dynamic loads on the running gear components, and the total duration of the tractor's working cycle.A step-by-step structure of the turn is proposed, which begins and ends at zero speed and with the steered wheels in a neutral position. The main phases of the maneuver are considered: turning with simultaneous acceleration and increase in the turning angle of the steered wheels, steady turning with a minimum radius, and turning with braking and a decrease in the steering angle. For theoretical analysis, the assumptions of uniformly accelerated acceleration and braking of the tractor and a constant angular speed of the steering wheels are made.Analytical dependencies were obtained to determine the duration of an unstable turn, the angular velocity, and the average turning radius for tractors with a single steerable axle and an articulated frame. An approximate empirical formula is also proposed, which can be used in the early stages of design or in engineering calculations of performance. The results of the calculations were compared with experimental data, which confirmed their sufficient convergence. The obtained dependencies allow refining the methodology for determining the duration of the working cycle and can be used to improve the efficiency of wheeled tractors.

  • Open Access

    FEATURES OF OPERATION OF TRACTOR TRAINS IN TRANSIENT TRAFFIC MODES

    by Yuliana Koliesnik

    When braking tractor trains, the safety of their movement is ensured by the appropriate action of the tractor and trailer braking system, which achieves a stop of the tractor train on the shortest possible section of the track or the necessary speed reduction while maintaining stable movement in any load and road conditions.The practice of operating tractor trains has shown that if the braking system does not meet safety requirements, when braking a tractor train, trailers collide with the tractor, "folding" and overturning of train links occur, which often lead to human casualties.Despite the fact that the speeds of tractor trains are significantly lower than those of automobile trains, tractor trains have a greater tendency to skid and overturn during braking compared to automobile trains due to a number of design and operational features. In this regard, the technical requirements for traffic safety for the braking system of tractor and automobile trains differ from each other.

  • THE INFLUENCE OF THE TYPE OF TRACTIONAL COUPLING DEVICE ON THE REDISTRIBUTION OF BRAKING TORQUES WHEN THE OPERATIONAL AND DESIGN FACTORS OF THE TRAILER CHANGE

    by Ivan Kolesnik, Yevhen Kalinin, Yuliana Kolesnik

    A modern tractor is a complex mechanical system consisting of a large number of elements united into one whole by various types of connections. The relevance of this work lies in the fact that the tire-vehicle-driver system acts as an oscillating system when the tractor train moves on different road surfaces and off-road. At the same time, it must be taken into account that the entire variety of disturbing influences is taken into account by the "double" (dynamic and kinematic) and "two-frequency" nature of excitation. Both are mainly related to the unevenness of the road surface and the imbalance of the rotating and gradually moving masses. It must be said that almost all research on vibration protection of a person and a transport unit was reduced to the study of high-frequency vibrations. However, along with high-frequency oscillations, low-frequency oscillations have a significant impact on the human operator and the transport unit. The study of any oscillating system includes two stages: 1. Study of disturbing influences. 2. Study of vibration dampers. The study of disturbing influences is mainly reduced to the study of the interaction of the micro-profile of the road and the drivers of the transport unit, to the mathematical description of the road profile and, at the same time, the mathematical description of the laws of change in the relative movement of the driver. It should be noted that the impact on the studied indicators of the road body and the laws of motion is given by the speed of movement, since the frequency and amplitude properties of the influences change. The state of the road, in turn, affects the traction forces, the nature of the interaction between the road surface and the driver in terms of power. Thus, taking into account the peculiarities of the study of the road-tyre-vehicle-driver oscillatory system, in order to determine the influence of the traffic parameters of the transport-technological train and the characteristics of the road background on the performance indicators of the transport-technological train in general and the operator in particular, it is necessary to draw up a system of differential equations that describes the movement of the transport-technological train taking into account the type of traction-towing device used.


  • Open Access

    ENERGY BALANCE OF THE TRACTOR-TRANSPORT TRAIN

    by Ivan Koliesnik, Evgeny Kalinin, Yuliana Koliesnik, Oksana Pankova, Іван Колєснік, Євген Калінін, Юліана Колєснік

    The article presents dynamic dependencies that substantiate the power and energy parameters of the tractor-transport train movement in the range of transport works with different road surfaces, which experimentally and analytically substantiate the possibility of using energy-rich tractors in transport works, with an increase in the efficiency of the use of the tractor-transport train. The optimization of the object of scientific and experimental research is intended for the clear definition and further assignment of blocks of research, which represent a general program concept divided into solving private tasks on the developed structural scheme.


  • Open Access

    THEORETICAL BASIS OF EFFECTIVENESS OF THE TRANSPORT UNIT

    by Ivan Koliesnik, Evgeny Kalinin, Yuliana Koliesnik, Ihor Shevchenko

    The article provides a theoretical basis for the effectiveness of a high-speed transport unit, which results in increased productivity, reliability and durability of the robot, an increase in traction power, friction strength, durability, and reduction in The cost of firing the tractor is based on the mutually consistent and basic dynamic and kinematic conditions of the tractor and the trailer.


  • Open Access

    Analysis of the influence of factors on the braking efficiency of a tractor-transport train

    by Ivan Koliesnik, Ihor Shevchenko, Yuliana Koliesnik

    Ефективність використання тракторів на транспортних роботах визначається складом тракторного поїзда, кількістю причепів, їх типом та загальною вантажопідйомністю, маневреністю, швидкістю руху тракторного поїзда, його стійкістю, гальмівними якостями, умовами праці оператора. Однак висока швидкість руху тракторного поїзда і реалізація максимальної потужності трактора при різноманітності вантажів, що перевозяться, стан властивостей дорожніх фонів і ряду конструктивних особливостей рухомого складу призводять до підвищення динамічних навантажень. Це викликає виникнення підвищених коливальних процесів у системі «ґрунт - причіп ~ трактор», погіршує тягово-зчіпні властивості, керованість, стійкість, ергономічні та розгінно-гальмівні властивості.


  • RESEARCH OF OSCILLATIONS OF A TRACTOR DRIVING CLASS 3kN AND WAYS TO IMPROVE ITS RIDE SMOOTHNESS WITH REDUCING SPRING TENSION

    by Evgeny Kalinin, Alevtyna Filonenko, Yuliana Koliesnik, Ruslan Petrov, Євген Калінін, Алевтина Філоненко, Юліана Колєснік

    In order to improve the smoothness of the course of the T-150K tractors, the possibilities of changing the main parameters of the suspension system and its influence on the intensity of low-frequency oscillations of the machine were considered. The stiffness and drag coefficient of the front suspension, as well as the base of the machine, were subjected to changes, and the range of variation was limited by the possibility of implementing the parameters without rearranging the units and changing the traction characteristics of the machine. As criteria for evaluating the smoothness of the ride, the values of the transfer function of the movements of various points of the frame, seat and root-mean-square accelerations during the movement of the tractor along natural irregularities were taken. Based on the results of these studies, it was found that an increase in the tractor base by 10% has an insignificant and contradictory effect on the root-mean-square accelerations of the frame point over the rear axle over the entire range of design speeds from 2.5 to 7 m/s, and acceleration over the front axle and on the seat - up to a speed of 5 m/s. With a further increase in speed to 7 m/s (25 km/h), an increase in the tractor base by 10% reduces frame acceleration over the front axle by 15%, and on the seat by 20%. In addition, 11-leaf springs (when removing the 5th and 7th sheets), installed in the suspension with tractor hydraulic shock absorbers with optimal parameters, created on the basis of automobile shock absorbers of the MAZ-500E type, have smaller dynamic deflections during compression, than 13-leaf springs (suspension without hydraulic shock absorbers). According to this, the dynamic load on the 11-leaf spring, compared to the serial suspension, is reduced by 51% when the KhTZ-150K tractor is moving along a dirt road and by 30% when plowing the field across the furrows. Consequently, the stress on the sheets of an 11-leaf spring in the presence of shock absorbers in the tractor suspension will be less than that of a 13-leaf spring (without shock absorbers), which will ensure increased durability of the 11-leaf spring. In addition, the resource of the last spring should be increased by reducing the number of load cycles, since the suspension with these springs reduces the frequency of the tractor by 10% (according to experimental data).

  • TRACTION QUALITIES OF THE DRIVING WHEELS WHEN ROLLING THEM ALONG ONE TRACK

    by Evgeny Kalinin, Volodymyr Zhilin, Ruslan Petrov, Yuliana Koliesnik

    During rectilinear motion of a wheeled tractor on a deformable surface, its rear wheels move along the track formed by the front ones. The amount of soil compaction can be different depending on its physical and mechanical properties, the dimensions of the front wheels of the tractor, the weight load falling on the front axle, and the like. Accordingly, the traction abilities of the rear drive wheels will also be different. This circumstance should be taken into account when designing wheeled tractors, especially tractor-tractors with two driving axles, in which a change in any of the factors listed above, for example, the distribution of the load along the axles, affects not only the compaction of the surface on which the rear wheels move, but and on the traction qualities of the front. In the course of the research, it was found that with a decrease in the load distribution coefficient below 0.5, the role of the rear wheel, which is capable of developing a greater traction force than the front wheel at the same load, in the formation of the total traction force, decreases. Therefore, the total traction force of the driving wheels becomes lower. With an increase in this coefficient above 0.5, the amount of preliminary soil compaction by the front wheel decreases; as a result, the ability of the rear wheel to develop more traction than the front wheel under the same load is reduced. The greatest traction force of two driving wheels moving along the same track is achieved with the same weight loads. Thus, the position of the center of gravity of a tractor with four driving wheels of the same size should be chosen in such a way that the load on the front and rear wheels is equalized at the rated pull on the hook. When conducting research on a field prepared for sowing, with an active semi-trailer with different load distribution between the rear axle of the tractor and the axle of the semi-trailer, it was found that the center of gravity of the active semi-trailer can be selected in the same way as for the inactive one, i.e. taking into account the influence of the semi-trailer on traction performance. The dependences obtained in the work make it possible to analyze the traction qualities of several driving wheels when they roll along one track. With their help, it is possible to identify the effect of surface compaction on the traction qualities of the rear moving front wheels; the influence of load distribution along the axles of the driving wheels on their total traction force, etc.