Farid Sheikholeslam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Farid Sheikholeslam has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Ali Mohammadi
Department of Electrical and Computer Engineering, Isfahan University of Technology, Isfahan, Iran
4 shared publications - Seyedali Mirjalili
Centre for Artificial Intelligence Research and Optimisation, Torrens University Australia, Brisbane, Australia
3 shared publications - Iman Izadi
Department of Electrical and Computer Engineering, Isfahan University of Technology, Isfahan, Iran
2 shared publications - Maryam Zekri
Department of Electrical and Computer Engineering, Isfahan University of Technology, Isfahan, Iran
2 shared publications - Mehdi Emami
Department of Electrical and Computer Engineering, Yazd University, Yazd, Iran
2 shared publications - Abbas-Ali Zamani
Department of Electrical Engineering Technical and Vocational University (TVU) Tehran Iran
1 shared publication
Latest Publications
- 20 November 2025
- Published by Elsevier in Fuzzy Sets and Systems
- Vol. 527
Adaptive fuzzy wavelet network control for nonlinear cooperative load transportation systems
- 20 November 2025
- Published by Elsevier in Fuzzy Sets and Systems
- Vol. 527
Adaptive fuzzy wavelet network control for nonlinear cooperative load transportation systems
- 6 February 2024
- Published by Elsevier in Fuzzy Sets and Systems
- Vol. 481
Online sequential type-2 fuzzy wavelet extreme learning machine: A nonlinear observer application
- 6 February 2024
- Published by Elsevier in Fuzzy Sets and Systems
- Vol. 481
Online sequential type-2 fuzzy wavelet extreme learning machine: A nonlinear observer application
- 12 April 2023
- Published by Springer Nature in Neural Computing and Applications
- Vol. 35 (21) , 15461-15475
Designing INS/GNSS integrated navigation systems by using IPO algorithms
- 12 April 2023
- Published by Springer Nature in Neural Computing and Applications
- Vol. 35 (21) , 15461-15475
Designing INS/GNSS integrated navigation systems by using IPO algorithms
- Open Access
- 21 November 2022
- Published by Springer Nature in Archives of Computational Methods in Engineering
- Vol. 30 (5) , 3481
Correction to: Nature-Inspired Metaheuristic Search Algorithms for Optimizing Benchmark Problems: Inclined Planes System Optimization to State-of-the-Art Methods
- 21 November 2022
- Published by Springer Nature in Archives of Computational Methods in Engineering
- Vol. 30 (5) , 3481
Open AccessCorrection to: Nature-Inspired Metaheuristic Search Algorithms for Optimizing Benchmark Problems: Inclined Planes System Optimization to State-of-the-Art Methods
- 29 August 2022
- Published by Springer Nature in Archives of Computational Methods in Engineering
- Vol. 30 (1) , 331-389
Nature-Inspired Metaheuristic Search Algorithms for Optimizing Benchmark Problems: Inclined Planes System Optimization to State-of-the-Art Methods
- 29 August 2022
- Published by Springer Nature in Archives of Computational Methods in Engineering
- Vol. 30 (1) , 331-389
Nature-Inspired Metaheuristic Search Algorithms for Optimizing Benchmark Problems: Inclined Planes System Optimization to State-of-the-Art Methods
- 30 March 2022
- Published by Springer Nature
- p. 45-72
Metaheuristic Algorithms for Integrated Navigation Systems
- 30 March 2022
- Published by Springer Nature
- p. 45-72
Metaheuristic Algorithms for Integrated Navigation Systems
- Open Access
- 26 June 2021
- Published by Institution of Engineering and Technology (IET) in IET Control Theory & Applications
- Vol. 15 (14) , 1832-1848
Backstepping boundary control design for a cascaded viscous Hamilton–Jacobi PDE–ODE system
This paper develops state‐feedback and output‐feedback control design methodologies for boundary stabilization of a class of systems that involves cascade connection of a non‐linear viscous Hamilton–Jacobi partial differential equation (PDE) and a possibly unstable linear ordinary differential equation (ODE). First, an explicit state‐feedback controller is designed based on the infinite‐dimensional backstepping method and by utilizing a locally invertible feedback linearizing transformation whose role is to convert the non‐linear viscous Hamilton–Jacobi PDE to a linear heat equation. Next, an output‐feedback controller is proposed which makes the closed‐loop system exponentially stable through the measured output of the system. The main feature of the proposed output‐feedback scheme is that the distributed integral terms are avoided in the feedback law. This is achieved by exploiting the derived state‐feedback controller and introducing a virtual ODE–PDE system, whose ODE state determines the stabilizing feedback law. Then, an observer is proposed that generates state estimates of the virtual system. In both schemes, local exponential stability is shown via Lyapunov analysis and an estimate of the region of attraction is provided. Finally, simulation examples for an unstable ODE are presented to validate the effectiveness of the proposed results.
- 26 June 2021
- Published by Institution of Engineering and Technology (IET) in IET Control Theory & Applications
- Vol. 15 (14) , 1832-1848
Open AccessBackstepping boundary control design for a cascaded viscous Hamilton–Jacobi PDE–ODE system
This paper develops state‐feedback and output‐feedback control design methodologies for boundary stabilization of a class of systems that involves cascade connection of a non‐linear viscous Hamilton–Jacobi partial differential equation (PDE) and a possibly unstable linear ordinary differential equation (ODE). First, an explicit state‐feedback controller is designed based on the infinite‐dimensional backstepping method and by utilizing a locally invertible feedback linearizing transformation whose role is to convert the non‐linear viscous Hamilton–Jacobi PDE to a linear heat equation. Next, an output‐feedback controller is proposed which makes the closed‐loop system exponentially stable through the measured output of the system. The main feature of the proposed output‐feedback scheme is that the distributed integral terms are avoided in the feedback law. This is achieved by exploiting the derived state‐feedback controller and introducing a virtual ODE–PDE system, whose ODE state determines the stabilizing feedback law. Then, an observer is proposed that generates state estimates of the virtual system. In both schemes, local exponential stability is shown via Lyapunov analysis and an estimate of the region of attraction is provided. Finally, simulation examples for an unstable ODE are presented to validate the effectiveness of the proposed results.
- 1 December 2020
- Published by Elsevier in ISA Transactions
- Vol. 107, 52-62
Robust ADP-based solution of a class of nonlinear multi-agent systems with input saturation and collision avoidance constraints
- 1 December 2020
- Published by Elsevier in ISA Transactions
- Vol. 107, 52-62
Robust ADP-based solution of a class of nonlinear multi-agent systems with input saturation and collision avoidance constraints
- 1 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 637-644
Control Design Method for Obtaining Special Performances in Discrete-Time Linear Switched Systems with Time-Varying Delay Based on the Average Dwell-Time Approach
This paper devotes to propose control design methods imposing general quadratic and bounded peak to peak gain performances on discrete-time linear switched positive systems with time-varying delay. General quadratic constraints are limitations that are modeled as a quadratic matrix to make a relationship between exogenous input and output signals. Moreover, the problem of bounding outputs peak amplitude for bounded disturbance inputs is named bounded peak to peak gain performance. Sufficient conditions are derived for the existence of a set of state feedback controllers guaranteeing the closed-loop switched system with time-varying delay in states not only is positive and globally uniform exponential stable but also has two stated performances for switching signals with an average dwell-time, which is greater than a positive certain constant. By using the Lyapunov-Krasovskii functional theorem, these conditions are formulated in terms of linear matrix inequalities. The quadruple tank system model is employed to illustrate the effectiveness of the proposed method.
- 1 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 637-644
Control Design Method for Obtaining Special Performances in Discrete-Time Linear Switched Systems with Time-Varying Delay Based on the Average Dwell-Time Approach
This paper devotes to propose control design methods imposing general quadratic and bounded peak to peak gain performances on discrete-time linear switched positive systems with time-varying delay. General quadratic constraints are limitations that are modeled as a quadratic matrix to make a relationship between exogenous input and output signals. Moreover, the problem of bounding outputs peak amplitude for bounded disturbance inputs is named bounded peak to peak gain performance. Sufficient conditions are derived for the existence of a set of state feedback controllers guaranteeing the closed-loop switched system with time-varying delay in states not only is positive and globally uniform exponential stable but also has two stated performances for switching signals with an average dwell-time, which is greater than a positive certain constant. By using the Lyapunov-Krasovskii functional theorem, these conditions are formulated in terms of linear matrix inequalities. The quadruple tank system model is employed to illustrate the effectiveness of the proposed method.
- 1 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 418-423
Robust Dynamic Surface Control of da Vinci Robot Manipulator Considering Uncertainties: A Fuzzy Based Approach
da Vinci is a robotic platform used to perform surgical tasks. The use of this robotic platform can have a significant effect on the reduction of operation time and improvement of the surgical task outcomes. However, the dynamic model of the da Vinci robot especially the friction model of the prismatic joint is unknown. Therefore, the design of an adaptive torque controller for da Vinci system can be the optimal solution for autonomous control strategies. In this work, we propose a fuzzy dynamic surface controller as a suitable application of the fuzzy method to tune the gain of the dynamic surface as an adaptive and robust controller for the da Vinci robot. The proposed controller is able to observe and eliminate the uncertainties. Lyaponuv method is used to guarantee the stability of the closed loop system. Finally, experiments are conducted to verify the proper performance of the proposed approach. It is worth noting that the experimental results indicate the robustness of the controller against uncertainties of the system.
- 1 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 418-423
Robust Dynamic Surface Control of da Vinci Robot Manipulator Considering Uncertainties: A Fuzzy Based Approach
da Vinci is a robotic platform used to perform surgical tasks. The use of this robotic platform can have a significant effect on the reduction of operation time and improvement of the surgical task outcomes. However, the dynamic model of the da Vinci robot especially the friction model of the prismatic joint is unknown. Therefore, the design of an adaptive torque controller for da Vinci system can be the optimal solution for autonomous control strategies. In this work, we propose a fuzzy dynamic surface controller as a suitable application of the fuzzy method to tune the gain of the dynamic surface as an adaptive and robust controller for the da Vinci robot. The proposed controller is able to observe and eliminate the uncertainties. Lyaponuv method is used to guarantee the stability of the closed loop system. Finally, experiments are conducted to verify the proper performance of the proposed approach. It is worth noting that the experimental results indicate the robustness of the controller against uncertainties of the system.