Murli Manohar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Murli Manohar has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Vinod K. Shahi
8 shared publications- Vinod Kumar Shahi
Electro-Membrane Processes Laboratory, Membrane Science and Separation Technology Division, CSIR-Central Salt and Marine Chemicals Research Institute, Gijubhai Badheka Marg, Bhavnagar, Gujarat 364 002, India
6 shared publications Amit K. Thakur
3 shared publications- Arindam Kumar Das
WestCHEM, School of Chemistry, University of Glasgow, University Avenue, Glasgow G12 8QQ, UK
3 shared publications - Ravi Prakash Pandey
Qatar Environment and Energy Research Institute (QEERI), Hamad Bin Khalifa University (HBKU), Doha, Qatar
3 shared publications Geetanjali Shukla
2 shared publications
Latest Publications
- 1 July 2020
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 45 (37) , 18693-18703
Highly charged and stable cross-linked polysulfone alkaline membrane for fuel cell applications: 4,4,-((3,3'-bis(chloromethyl)-(1,1'-biphenyl)-4,4-diyl)bis(oxy))dianiline (BCBD) a novel cross-linker
- 1 July 2020
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 45 (37) , 18693-18703
Highly charged and stable cross-linked polysulfone alkaline membrane for fuel cell applications: 4,4,-((3,3'-bis(chloromethyl)-(1,1'-biphenyl)-4,4-diyl)bis(oxy))dianiline (BCBD) a novel cross-linker
- 6 September 2019
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 7 (19) , 16493-16500
Advantageous of Hybrid Fuel Cell Operation under Self-Humidification for Energy Efficient Bipolar Membrane
- 6 September 2019
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 7 (19) , 16493-16500
Advantageous of Hybrid Fuel Cell Operation under Self-Humidification for Energy Efficient Bipolar Membrane
- 20 March 2019
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 3 (5) , 1269-1282
Fabrication of a low-cost functionalized poly(vinylidene fluoride) nanohybrid membrane for superior fuel cells
Nanochannels were created in poly(vinylidene fluoride) and its nanohybrid films by bombarding with high-energy swift heavy ions. The nanochannel dimensions of the membranes varied from 80 to 100 nm using 5 × 107 ion fluence of SHIs. The walls of the nanochannels were grafted with the monomer 3-hexylthiophene using the free radicals generated by the swift heavy ions, which was followed by their sulphonation for better ion conduction. Organically modified nanoclay enhanced the electroactive β-phase in the polymer and its extent increased after irradiation, grafting and sulphonation, resulting in a better material for different electroactive applications. The semiconducting current–voltage characteristics of the functionalized nanochannels were studied through a parameter analyzer of the bulk film against the insulating behavior of the neat polymer. The current–voltage characteristic of the membrane exhibited strong dependency on functionalization and showed superior conduction in the functionalized nanohybrid membrane. The proton conductivity of the functionalized nanohybrid was 4.59 × 10−2 S cm−1 at 30 °C, while methanol permeability was drastically reduced as compared to that of standard Nafion 117; this indicated the higher values of the selectivity parameter, which is a key feature of the better performance of the fuel cell membrane: 1.02 × 105 S cm−3 s as opposed to the value of 0.73 × 105 S cm−3 s for Nafion 117. The membrane electrode assembly studies of the functionalized nanohybrid showed 0.76 V open circuit voltage, leading to power density of 92 mW cm−2 and current density of 252 mA cm−2, which were significantly higher than those of the functionalized pure polymer and standard Nafion 117 membrane, indicating its good potential for applications in fuel cells.
- 20 March 2019
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 3 (5) , 1269-1282
Fabrication of a low-cost functionalized poly(vinylidene fluoride) nanohybrid membrane for superior fuel cells
Nanochannels were created in poly(vinylidene fluoride) and its nanohybrid films by bombarding with high-energy swift heavy ions. The nanochannel dimensions of the membranes varied from 80 to 100 nm using 5 × 107 ion fluence of SHIs. The walls of the nanochannels were grafted with the monomer 3-hexylthiophene using the free radicals generated by the swift heavy ions, which was followed by their sulphonation for better ion conduction. Organically modified nanoclay enhanced the electroactive β-phase in the polymer and its extent increased after irradiation, grafting and sulphonation, resulting in a better material for different electroactive applications. The semiconducting current–voltage characteristics of the functionalized nanochannels were studied through a parameter analyzer of the bulk film against the insulating behavior of the neat polymer. The current–voltage characteristic of the membrane exhibited strong dependency on functionalization and showed superior conduction in the functionalized nanohybrid membrane. The proton conductivity of the functionalized nanohybrid was 4.59 × 10−2 S cm−1 at 30 °C, while methanol permeability was drastically reduced as compared to that of standard Nafion 117; this indicated the higher values of the selectivity parameter, which is a key feature of the better performance of the fuel cell membrane: 1.02 × 105 S cm−3 s as opposed to the value of 0.73 × 105 S cm−3 s for Nafion 117. The membrane electrode assembly studies of the functionalized nanohybrid showed 0.76 V open circuit voltage, leading to power density of 92 mW cm−2 and current density of 252 mA cm−2, which were significantly higher than those of the functionalized pure polymer and standard Nafion 117 membrane, indicating its good potential for applications in fuel cells.
- Open Access
- 31 August 2018
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 3 (8) , 10331-10340
Cation-Exchange Membrane with Low Frictional Coefficient and High Limiting Current Density for Energy-Efficient Water Desalination
A sulfonated poly(ether ether ketone) (SPEEK) and phosphorylated graphene oxide (PGO) composite of a cation-exchange membrane with low frictional coefficient and high limiting current density has been reported for water desalination by rapid electrodialysis. The incorporation of PGO in the membrane matrix showed a significant impact on the macroscopic properties, counterion frictional coefficient, and performance of the membrane. A well-optimized SPEEK/PGO-8 (8% PGO content, w/w) membrane showed improved conductivity (4.15 × 10–2 S cm–1) and permselectivity (87%), and excellent stabilities (thermal, mechanical, and chemical) because of cherished polymer–PGO (filler) interaction via H-bonding. The efficiency of the SPEEK/PGO-8 membrane was also evaluated for the desalination of brackish water near limiting current density (Ilim). Ion concentration polarization (ICP) was assessed by i–V curves, and below Ilim, water splitting or change in product water pH was ruled out. While above Ilim (10.5 mA cm–2), ICP was significant and could be finally tuned with applied current density for producing desalinated water with a desired pH. Furthermore, improved Ilim, high current efficiency (82.9%), and low energy consumption (7.9 kWh kg–1 of the salt removed) of the SPEEK/PGO-8 membrane during electrodialysis provide a broad current window for efficient and rapid water desalination/purification.
- 31 August 2018
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 3 (8) , 10331-10340
Open AccessCation-Exchange Membrane with Low Frictional Coefficient and High Limiting Current Density for Energy-Efficient Water Desalination
A sulfonated poly(ether ether ketone) (SPEEK) and phosphorylated graphene oxide (PGO) composite of a cation-exchange membrane with low frictional coefficient and high limiting current density has been reported for water desalination by rapid electrodialysis. The incorporation of PGO in the membrane matrix showed a significant impact on the macroscopic properties, counterion frictional coefficient, and performance of the membrane. A well-optimized SPEEK/PGO-8 (8% PGO content, w/w) membrane showed improved conductivity (4.15 × 10–2 S cm–1) and permselectivity (87%), and excellent stabilities (thermal, mechanical, and chemical) because of cherished polymer–PGO (filler) interaction via H-bonding. The efficiency of the SPEEK/PGO-8 membrane was also evaluated for the desalination of brackish water near limiting current density (Ilim). Ion concentration polarization (ICP) was assessed by i–V curves, and below Ilim, water splitting or change in product water pH was ruled out. While above Ilim (10.5 mA cm–2), ICP was significant and could be finally tuned with applied current density for producing desalinated water with a desired pH. Furthermore, improved Ilim, high current efficiency (82.9%), and low energy consumption (7.9 kWh kg–1 of the salt removed) of the SPEEK/PGO-8 membrane during electrodialysis provide a broad current window for efficient and rapid water desalination/purification.
- 24 January 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 6 (3) , 3463-3471
Graphene Oxide–Polyaniline as a Water Dissociation Catalyst in the Interfacial Layer of Bipolar Membrane for Energy-Saving Production of Carboxylic Acids from Carboxylates by Electrodialysis
- 24 January 2018
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 6 (3) , 3463-3471
Graphene Oxide–Polyaniline as a Water Dissociation Catalyst in the Interfacial Layer of Bipolar Membrane for Energy-Saving Production of Carboxylic Acids from Carboxylates by Electrodialysis
- 1 July 2017
- Published by Elsevier in Desalination
- Vol. 413, 101-108
Alternative preparative route for efficient and stable anion-exchange membrane for water desalination by electrodialysis
- 1 July 2017
- Published by Elsevier in Desalination
- Vol. 413, 101-108
Alternative preparative route for efficient and stable anion-exchange membrane for water desalination by electrodialysis