Sheida Atashkar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sheida Atashkar has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Tooraj Massahi
Kermanshah University of Medical Sciences
4 shared publications - Mohammad Jasimi
Student Research Committee, School of Public Health, Kermanshah University of Medical Sciences, Kermanshah, Iran
2 shared publications - Hooshyar Hossini
Department of Environmental Health Engineering, Faculty of Health, Kermanshah University of Medical Sciences, Kermanshah, Iran
1 shared publication Maryam Sharafi
Department of Environmental Health Engineering, School of Public Health, and Research Center for Environmental Determinants of Health (RCEDH), Health Institute, Kermanshah University of Medical Sciences, Kermanshah, Iran
1 shared publication- Negar Faridi
Student Research Committee, School of Public Health, Kermanshah University of Medical Sciences, Kermanshah, Iran
1 shared publication
Latest Publications
- Open Access
- 5 December 2021
- Published by Brieflands in Journal of Health Reports and Technology
- Vol. 8 (2)
Iranian Environmental Health Strategies and the Challenges Against COVID-19
Keywords Iran Coronavirus Pandemic COVID-19 Environmental Health
- 5 December 2021
- Published by Brieflands in Journal of Health Reports and Technology
- Vol. 8 (2)
Open AccessIranian Environmental Health Strategies and the Challenges Against COVID-19
Keywords Iran Coronavirus Pandemic COVID-19 Environmental Health
- Open Access
- 10 September 2021
- Published by Brieflands in Annals of Military and Health Sciences Research
- Vol. 19 (3)
Novel Coronavirus and the Wastewater Treatment Plants Workers
Keywords SARS-CoV-2 WWTPs Wastewater Workers COVID-19
- 10 September 2021
- Published by Brieflands in Annals of Military and Health Sciences Research
- Vol. 19 (3)
Open AccessNovel Coronavirus and the Wastewater Treatment Plants Workers
Keywords SARS-CoV-2 WWTPs Wastewater Workers COVID-19
- Open Access
- 20 July 2021
- Published by Brieflands in International Journal of Health and Life Sciences
- Vol. 7 (3)
Face Mask Consumption and Medical Waste Generation During the COVID-19 Pandemic in Iran: Challenges and Problems
Background: The outbreak of COVID-19 has caused a devastating pandemic scenario in the world. The mortality rate has increased and new socio-economic challenges are emerging. Millions of gloves, gowns, face masks, and face shields are used daily to prevent airborne transmission and facilitate the treatment of COVID-19. Mismanagement of these wastes can lead to increased concerns due to their contamination potential. A comprehensive plan to improve the management of medical wastes in every country requires awareness of the current status of solid waste. Objectives: The study aimed to calculate and estimate the consumption rate of face masks and medical waste generation rate during the COVID-19 pandemic in Iran. Also, the performance of different departments of medical waste management and future challenges are discussed. Methods: The daily consumption of face masks and medical waste generation were calculated based on the population data, the percentage of the urban population, face mask acceptance rate, the number of face masks needed per person per day, total COVID-19 confirmed cases, and medical waste generation rate (kg/bed/day). Results: The consumption of face masks in Iran is estimated at 46576000 pieces per day. Also, the three provinces of Tehran (9,560,000 pieces), Khorasan Razavi (3,825,600 pieces), and Isfahan (3,523,200 pieces) have the highest consumption rate of masks, respectively. Increasing the number of confirmed COVID-19 cases has increased the medical waste generation rate. Until April 3, 2021, more than 1,920,394 cases of COVID-19 have been confirmed in Iran, and calculations show that the medical waste generation rate in Iran is about 7,585.56 tons per day. Conclusions: COVID-19 is a highly infectious and problematic disease. The continuous increase in the number of confirmed COVID-19 cases has increased face mask consumption rate and medical waste generation rate, and as a result, new challenges have emerged in the field of solid waste management. These emerging challenges in managing solid waste during the COVID-19 pandemic necessitate the development of appropriate waste management policies and strategies.
- 20 July 2021
- Published by Brieflands in International Journal of Health and Life Sciences
- Vol. 7 (3)
Open AccessFace Mask Consumption and Medical Waste Generation During the COVID-19 Pandemic in Iran: Challenges and Problems
Background: The outbreak of COVID-19 has caused a devastating pandemic scenario in the world. The mortality rate has increased and new socio-economic challenges are emerging. Millions of gloves, gowns, face masks, and face shields are used daily to prevent airborne transmission and facilitate the treatment of COVID-19. Mismanagement of these wastes can lead to increased concerns due to their contamination potential. A comprehensive plan to improve the management of medical wastes in every country requires awareness of the current status of solid waste. Objectives: The study aimed to calculate and estimate the consumption rate of face masks and medical waste generation rate during the COVID-19 pandemic in Iran. Also, the performance of different departments of medical waste management and future challenges are discussed. Methods: The daily consumption of face masks and medical waste generation were calculated based on the population data, the percentage of the urban population, face mask acceptance rate, the number of face masks needed per person per day, total COVID-19 confirmed cases, and medical waste generation rate (kg/bed/day). Results: The consumption of face masks in Iran is estimated at 46576000 pieces per day. Also, the three provinces of Tehran (9,560,000 pieces), Khorasan Razavi (3,825,600 pieces), and Isfahan (3,523,200 pieces) have the highest consumption rate of masks, respectively. Increasing the number of confirmed COVID-19 cases has increased the medical waste generation rate. Until April 3, 2021, more than 1,920,394 cases of COVID-19 have been confirmed in Iran, and calculations show that the medical waste generation rate in Iran is about 7,585.56 tons per day. Conclusions: COVID-19 is a highly infectious and problematic disease. The continuous increase in the number of confirmed COVID-19 cases has increased face mask consumption rate and medical waste generation rate, and as a result, new challenges have emerged in the field of solid waste management. These emerging challenges in managing solid waste during the COVID-19 pandemic necessitate the development of appropriate waste management policies and strategies.
- Open Access
- 30 June 2021
- Published by Brieflands in International Journal of Health and Life Sciences
- Vol. 7 (2)
Assessing the Quantity of Solid Waste Produced in Kermanshah School of Public Health: Challenges and Suggestions
Background: Determining and recognizing solid waste composition can be considered as the first and main step in planning and developing waste management processes in an area. Objectives: The objective of this study was to investigate the production and determination of waste composition in Kermanshah School of Public Health, and evaluate the challenges ahead and present practical suggestions based on results for better solid waste management. Methods: Collection, separation, and weight measurement of solid wastes in the school of Public Health, and departments such as self-service, laboratories, buffet, office, and yard, were done during a working week from Saturday to Wednesday. Then the results and data were analyzed using Excel software version 2019. Results: The results of data analysis, after collecting, separating, and weighing each solid waste component revealed that food waste accounts for 48% of the total solid waste production. Also, other waste components include 32% plastic, 14% paper and cardboard, 6% garden waste, and nearly 0% glass and metals, together comprising an average amount of waste produced daily from Saturday to Wednesday during a week. It was also found that the generated waste per capita was 104.29 grams per person per day. The highest and lowest amount of generated waste per capita was related to food waste with 49.45 grams per day and metal waste with 0.17 grams per day, respectively. Conclusions: Due to the predominant percentage of organic matter and the small portion of the glass and metal waste in the composition of waste produced in the school, the application of compost production methods seems to be a justifiable and economical way to dispose of the waste generated in the School of Public Health. Also, the presence of paper, cardboard, and plastic in the mentioned quantities warns us to pay attention to the recycling programs from the source.
- 30 June 2021
- Published by Brieflands in International Journal of Health and Life Sciences
- Vol. 7 (2)
Open AccessAssessing the Quantity of Solid Waste Produced in Kermanshah School of Public Health: Challenges and Suggestions
Background: Determining and recognizing solid waste composition can be considered as the first and main step in planning and developing waste management processes in an area. Objectives: The objective of this study was to investigate the production and determination of waste composition in Kermanshah School of Public Health, and evaluate the challenges ahead and present practical suggestions based on results for better solid waste management. Methods: Collection, separation, and weight measurement of solid wastes in the school of Public Health, and departments such as self-service, laboratories, buffet, office, and yard, were done during a working week from Saturday to Wednesday. Then the results and data were analyzed using Excel software version 2019. Results: The results of data analysis, after collecting, separating, and weighing each solid waste component revealed that food waste accounts for 48% of the total solid waste production. Also, other waste components include 32% plastic, 14% paper and cardboard, 6% garden waste, and nearly 0% glass and metals, together comprising an average amount of waste produced daily from Saturday to Wednesday during a week. It was also found that the generated waste per capita was 104.29 grams per person per day. The highest and lowest amount of generated waste per capita was related to food waste with 49.45 grams per day and metal waste with 0.17 grams per day, respectively. Conclusions: Due to the predominant percentage of organic matter and the small portion of the glass and metal waste in the composition of waste produced in the school, the application of compost production methods seems to be a justifiable and economical way to dispose of the waste generated in the School of Public Health. Also, the presence of paper, cardboard, and plastic in the mentioned quantities warns us to pay attention to the recycling programs from the source.