Akbar Halimov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Akbar Halimov has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
- Jasurjon Akhatov
Doctor of Technical Sciences, Professor, S. A. Azimov Physical-Technical Institute, Academy of Sciences of the Republic of Uzbekistan, Tashkent, Uzbekistan
8 shared publications - Tukhtamurod Juraev
Physical-Technical Institute of the Uzbekistan Academy of Sciences
8 shared publications J. S. Akhatov
Physical-Technical Institute, Academy of Sciences of the Republic of Uzbekistan, Tashkent, Uzbekistan
6 shared publications- Dilshod Jalilov
Physical-Technical institute of Uzbekistan Academy of Sciences, Tashkent, Uzbekistan
4 shared publications Jasurjon Akhatov
Physical-Technical Institute of the Uzbekistan Academy of Sciences, Tashkent, Uzbekistan
4 shared publicationsZ. S. Iskandarov
Tashkent State Agrarian University, Kibray region, Uzbekistan
3 shared publications
Latest Publications
- 19 November 2026
- Published by Elsevier in Solar Energy
- Vol. 321
Experimental study on concentrated solar atmospheric water harvesting with layered and rolled ACF-LiCl adsorption beds
- 19 November 2026
- Published by Elsevier in Solar Energy
- Vol. 321
Experimental study on concentrated solar atmospheric water harvesting with layered and rolled ACF-LiCl adsorption beds
- 31 May 2026
- Published by Azerbaijan State University of Economics (UNEC) in UNEC journal of engineering and applied sciences
- Vol. 6 (1) , 39-58
Integrated thermal-hydraulic and exergy-based optimisation of volumetric flow rate in parabolic trough collectors using commercial heat transfer fluids
The optimization of volumetric flow rate in parabolic trough collectors (PTCs) represents a complex thermo-hydraulic challenge, since an increase in flow rate improves convective heat transfer inside the receiver while also causing greater pressure losses and higher pumping power requirements. Traditional assessment approaches generally emphasize useful heat gain or thermal efficiency; however, such criteria alone may not identify the most suitable operating conditions when the hydraulic energy demand becomes considerable. This study develops an integrated thermal-hydraulic and exergy-based optimisation framework for determining the optimum volumetric flow rate of commercial heat transfer fluids in an LS-2 parabolic trough collector. Eight fluids Syltherm 800, Therminol 55, Therminol 59, Therminol 66, Therminol 68, Therminol XP, Therminol VP1 and Therminol D-12 were analysed under identical collector geometry and operating conditions over an inlet-temperature range of 273.15-523.15 K. The model combines optical energy absorption, receiver heat losses, internal convective heat transfer, pressure drop, pumping power, net useful power, exergy efficiency and entropy-generation indicators. The thermal model was validated against the SEGS LS-2 experimental dataset, yielding a root mean square error of 0.79 K and a coefficient of determination of R² = 0.99992 for outlet-temperature prediction. The results show that the optimum volumetric flow rate generally increases with inlet temperature because viscosity reduction improves hydraulic behaviour and allows stronger internal convection. However, the optimum does not correspond to the maximum flow rate; it occurs where the marginal thermal benefit is balanced by the additional pumping-power penalty. Therminol D-12 and Therminol VP-1 provide the most favourable overall behaviour under the investigated conditions because they combine comparatively high net heat gain with low pumping-power demand. Therminol 55 exhibits the strongest performance deterioration at elevated temperatures, indicating limited suitability for high-temperature operation. The entropy-generation interpretation confirms that flow-rate optimisation cannot be based on thermal efficiency alone, because hydraulic irreversibility and pumping-power penalty can offset the thermal benefit of stronger circulation. The proposed framework provides a physically consistent basis for temperature-dependent flow-rate control, heat-transfer-fluid selection and industrial PTC loop design in concentrated solar power and solar process-heat systems.
- 31 May 2026
- Published by Azerbaijan State University of Economics (UNEC) in UNEC journal of engineering and applied sciences
- Vol. 6 (1) , 39-58
Integrated thermal-hydraulic and exergy-based optimisation of volumetric flow rate in parabolic trough collectors using commercial heat transfer fluids
The optimization of volumetric flow rate in parabolic trough collectors (PTCs) represents a complex thermo-hydraulic challenge, since an increase in flow rate improves convective heat transfer inside the receiver while also causing greater pressure losses and higher pumping power requirements. Traditional assessment approaches generally emphasize useful heat gain or thermal efficiency; however, such criteria alone may not identify the most suitable operating conditions when the hydraulic energy demand becomes considerable. This study develops an integrated thermal-hydraulic and exergy-based optimisation framework for determining the optimum volumetric flow rate of commercial heat transfer fluids in an LS-2 parabolic trough collector. Eight fluids Syltherm 800, Therminol 55, Therminol 59, Therminol 66, Therminol 68, Therminol XP, Therminol VP1 and Therminol D-12 were analysed under identical collector geometry and operating conditions over an inlet-temperature range of 273.15-523.15 K. The model combines optical energy absorption, receiver heat losses, internal convective heat transfer, pressure drop, pumping power, net useful power, exergy efficiency and entropy-generation indicators. The thermal model was validated against the SEGS LS-2 experimental dataset, yielding a root mean square error of 0.79 K and a coefficient of determination of R² = 0.99992 for outlet-temperature prediction. The results show that the optimum volumetric flow rate generally increases with inlet temperature because viscosity reduction improves hydraulic behaviour and allows stronger internal convection. However, the optimum does not correspond to the maximum flow rate; it occurs where the marginal thermal benefit is balanced by the additional pumping-power penalty. Therminol D-12 and Therminol VP-1 provide the most favourable overall behaviour under the investigated conditions because they combine comparatively high net heat gain with low pumping-power demand. Therminol 55 exhibits the strongest performance deterioration at elevated temperatures, indicating limited suitability for high-temperature operation. The entropy-generation interpretation confirms that flow-rate optimisation cannot be based on thermal efficiency alone, because hydraulic irreversibility and pumping-power penalty can offset the thermal benefit of stronger circulation. The proposed framework provides a physically consistent basis for temperature-dependent flow-rate control, heat-transfer-fluid selection and industrial PTC loop design in concentrated solar power and solar process-heat systems.
- Open Access
- 14 May 2026
- Published by Atlantis Press SARL
- p. 520-528
Determination of Final Energy Consumption in the Residential Sector of Uzbekistan
- 14 May 2026
- Published by Atlantis Press SARL
- p. 520-528
Open AccessDetermination of Final Energy Consumption in the Residential Sector of Uzbekistan
- Open Access
- 14 May 2026
- Published by Atlantis Press SARL
- p. 40-50
Application of Phase Change Materials (PCM) in Solar Greenhouse Drying Systems
- 14 May 2026
- Published by Atlantis Press SARL
- p. 40-50
Open AccessApplication of Phase Change Materials (PCM) in Solar Greenhouse Drying Systems
- Open Access
- 14 May 2026
- Published by Atlantis Press SARL
- p. 529-538
Assessment of Energy Flexibility of Residential Buildings with Phase Change Materials in Uzbekistan Using the Flexibility Evaluation Tool
- 14 May 2026
- Published by Atlantis Press SARL
- p. 529-538
Open AccessAssessment of Energy Flexibility of Residential Buildings with Phase Change Materials in Uzbekistan Using the Flexibility Evaluation Tool
- Open Access
- 14 May 2026
- Published by Atlantis Press SARL
- p. 468-477
Taguchi-Based Optimization of Air-Gap Membrane Distillat
- 14 May 2026
- Published by Atlantis Press SARL
- p. 468-477
Open AccessTaguchi-Based Optimization of Air-Gap Membrane Distillat
- Open Access
- 5 May 2026
- Published by Elsevier in Materials Research Bulletin
- Vol. 203
Development and characterization of hybrid water-based nanofluids for solar thermal applications
- 5 May 2026
- Published by Elsevier in Materials Research Bulletin
- Vol. 203
Open AccessDevelopment and characterization of hybrid water-based nanofluids for solar thermal applications
- 1 April 2026
- Published by Allerton Press in Applied Solar Energy
- Vol. 62 (2) , 235-255
Low-Concentration Photovoltaic/Thermal Systems Integrated with Electrical and Thermal Energy Storage: A Review
The global imperative for energy transition demands advanced, high-efficiency solar energy systems capable of overcoming both the thermal degradation of ph
- 1 April 2026
- Published by Allerton Press in Applied Solar Energy
- Vol. 62 (2) , 235-255
Low-Concentration Photovoltaic/Thermal Systems Integrated with Electrical and Thermal Energy Storage: A Review
The global imperative for energy transition demands advanced, high-efficiency solar energy systems capable of overcoming both the thermal degradation of ph
- 1 February 2026
- Published by Allerton Press in Applied Solar Energy
- Vol. 62 (1) , 49-70
Thermal Energy Storage in Greenhouses: A Brief Critical Review
This paper examines modern approaches to the design and modeling of thermal energy storage (TES) systems for solar greenhouses. It is shown that integratin
- 1 February 2026
- Published by Allerton Press in Applied Solar Energy
- Vol. 62 (1) , 49-70
Thermal Energy Storage in Greenhouses: A Brief Critical Review
This paper examines modern approaches to the design and modeling of thermal energy storage (TES) systems for solar greenhouses. It is shown that integratin
- 24 January 2026
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 62 (2) , 9
Stability enhancement of oxidized carbon black nanofluids: effects of concentration, sonication time, and SDS surfactant
- 24 January 2026
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 62 (2) , 9
Stability enhancement of oxidized carbon black nanofluids: effects of concentration, sonication time, and SDS surfactant