Brenna K. Cashman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Brenna K. Cashman has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Aaron Maurice Tondreau
Los Alamos National Laboratory
2 shared publications - Taylor V. Fetrow
Pit Technologies, Los Alamos National Laboratory, Los Alamos, New Mexico 87545, United States
2 shared publications - Bonnie Ellen Klamm
Pit Technologies, Los Alamos National Laboratory, Los Alamos, New Mexico 87545, United States
1 shared publication - Harris Edward Mason
Los Alamos National Laboratory
1 shared publication Karissa M. Sandmann
Department of Chemistry , The University of Texas at Austin , 105 East 24th Street, Stop A5300 , Austin , Texas 78712 , United States
1 shared publication- Michael J. Rose
The University of Texas at Austin
1 shared publication
Latest Publications
- Open Access
- 8 July 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 15 (30) , 12138-12147
Flexible interactions of the rare-earth elements Y, La, and Lu with phosphorus in metallacyclohexane rings
A geometrically flexible bifunctional (bis)aminophosphine ligand was synthesized in a three-component, one-pot Kabachnik–Fields reaction using tertbutylphosphine, paraformaldehyde, and 3,5-dimethyl aniline. The product, bis((3,5-dimethylphenyl)aminomethyl)tertbutylphosphine (ArBiAMPtBu), containing two secondary amines and a tertiary phosphine, was isolated in good yields. Deprotonation of both N–H groups with (trimethylsilyl)methylpotassium (K-CH2SiMe3), followed by salt metathesis with LaI3, YI3, and LuI3 generated the corresponding MI(ArBiAMPtBu)(thf)3 complexes (M = Y (1), La (2), and Lu (3)) in good yields. A sterically encumbered indene, 1,3-diisopropyl-4,7-dimethyl-1H-indene, iPrMeInd, was deprotonated in situ and installed via salt-metathesis to generate the organometallic series of η5-indenide complexes, M(ArBiAMPtBu)(η5-iPrMeInd)(thf) (M = Y (4), La (5), and Lu (6)). 1H, 31P, 13C, and 89Y NMR experiments, IR spectroscopy, and single crystal X-ray diffraction (SC-XRD), were used to characterize these complexes. The Y–P coupling constant was found to be variable depending on the modifiable coordination environment of the metal center, indicating potential as both a spectroscopic handle as well as providing insight into the influence of additional ligands on the metal center.
- 8 July 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 15 (30) , 12138-12147
Open AccessFlexible interactions of the rare-earth elements Y, La, and Lu with phosphorus in metallacyclohexane rings
A geometrically flexible bifunctional (bis)aminophosphine ligand was synthesized in a three-component, one-pot Kabachnik–Fields reaction using tertbutylphosphine, paraformaldehyde, and 3,5-dimethyl aniline. The product, bis((3,5-dimethylphenyl)aminomethyl)tertbutylphosphine (ArBiAMPtBu), containing two secondary amines and a tertiary phosphine, was isolated in good yields. Deprotonation of both N–H groups with (trimethylsilyl)methylpotassium (K-CH2SiMe3), followed by salt metathesis with LaI3, YI3, and LuI3 generated the corresponding MI(ArBiAMPtBu)(thf)3 complexes (M = Y (1), La (2), and Lu (3)) in good yields. A sterically encumbered indene, 1,3-diisopropyl-4,7-dimethyl-1H-indene, iPrMeInd, was deprotonated in situ and installed via salt-metathesis to generate the organometallic series of η5-indenide complexes, M(ArBiAMPtBu)(η5-iPrMeInd)(thf) (M = Y (4), La (5), and Lu (6)). 1H, 31P, 13C, and 89Y NMR experiments, IR spectroscopy, and single crystal X-ray diffraction (SC-XRD), were used to characterize these complexes. The Y–P coupling constant was found to be variable depending on the modifiable coordination environment of the metal center, indicating potential as both a spectroscopic handle as well as providing insight into the influence of additional ligands on the metal center.
- Open Access
- 18 October 2023
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 63 (21) , 9385-9389
Oxidative Dissolution of Lanthanide Metals Ce and Ho in Molten GaCl3
Gallium trichloride (GaCl3) was used as a solvent for the oxidative dissolution of the lanthanide (Ln) metals cerium (Ce) and holmium (Ho). Reactions were performed at temperatures above 100 degrees C in sealed vessels to maintain the liquid phase for GaCl3 during the oxidizing reactions. The best results were obtained from reactions using 8 equiv of GaCl3 to metal where the inorganic complexes [Ga][Ln(GaCl4)(4)] [Ln = Ce (1), Ho (2)] could be isolated. Recrystallization of 1 and 2 employing fluorobenzene (C6H5F) produced [Ga(eta(6)-C6H5F)(2)][Ln(GaCl4)(4)] [Ln = Ce (3), Ho (4)] where reversible eta(6) coordination of C6H5F to [Ga](+) was observed. All complexes were characterized through elemental analysis (F and Cl), IR and UV-vis-near-IR spectroscopies, and both solution and solid-state NMR techniques.
- 18 October 2023
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 63 (21) , 9385-9389
Open AccessOxidative Dissolution of Lanthanide Metals Ce and Ho in Molten GaCl3
Gallium trichloride (GaCl3) was used as a solvent for the oxidative dissolution of the lanthanide (Ln) metals cerium (Ce) and holmium (Ho). Reactions were performed at temperatures above 100 degrees C in sealed vessels to maintain the liquid phase for GaCl3 during the oxidizing reactions. The best results were obtained from reactions using 8 equiv of GaCl3 to metal where the inorganic complexes [Ga][Ln(GaCl4)(4)] [Ln = Ce (1), Ho (2)] could be isolated. Recrystallization of 1 and 2 employing fluorobenzene (C6H5F) produced [Ga(eta(6)-C6H5F)(2)][Ln(GaCl4)(4)] [Ln = Ce (3), Ho (4)] where reversible eta(6) coordination of C6H5F to [Ga](+) was observed. All complexes were characterized through elemental analysis (F and Cl), IR and UV-vis-near-IR spectroscopies, and both solution and solid-state NMR techniques.
- 10 October 2019
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 58 (20) , 13751-13754
Isolation and X-ray Structure of a Dialkylbismuth(III) Iodo “Nanosquare”: Breaking the Polymeric Mold of R2BiX
We report the synthesis, X-ray structure, and solution behavior of a “nanosquare” formed by four repeating (iPr2BiI) units. The title complex [iPr2BiI]4 (1) formed spontaneously as the major product from the reaction of iPr3Bi with MI2 (M = Mn, Co, Fe). Complex 1 was then more directly synthesized via bromination of iPr3Bi to form (iPr2BiBr), followed by iodide substitution. The X-ray structure of 1 exhibited acute Bi–I–Bi bonds (∼85–95°) that enabled formation of the hollow square motif. Synthetic control experiments with R2BiX (R = iPr, Bn; X = I, Br) revealed that the identities of both the halide and bismuth R group are determinants for square formation: the bromo-substituted [iPr2BiBr]n (2) and benzyl-substituted [Bn2BiI]n (3) variants formed only polymers as determined by X-ray crystallography. Density functional theory calculations revealed nearly pure p-orbital-based bonding molecular orbitals on both iodide and bismuth, facilitating the ∼90°/180° bonding motifs.
- 10 October 2019
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 58 (20) , 13751-13754
Isolation and X-ray Structure of a Dialkylbismuth(III) Iodo “Nanosquare”: Breaking the Polymeric Mold of R2BiX
We report the synthesis, X-ray structure, and solution behavior of a “nanosquare” formed by four repeating (iPr2BiI) units. The title complex [iPr2BiI]4 (1) formed spontaneously as the major product from the reaction of iPr3Bi with MI2 (M = Mn, Co, Fe). Complex 1 was then more directly synthesized via bromination of iPr3Bi to form (iPr2BiBr), followed by iodide substitution. The X-ray structure of 1 exhibited acute Bi–I–Bi bonds (∼85–95°) that enabled formation of the hollow square motif. Synthetic control experiments with R2BiX (R = iPr, Bn; X = I, Br) revealed that the identities of both the halide and bismuth R group are determinants for square formation: the bromo-substituted [iPr2BiBr]n (2) and benzyl-substituted [Bn2BiI]n (3) variants formed only polymers as determined by X-ray crystallography. Density functional theory calculations revealed nearly pure p-orbital-based bonding molecular orbitals on both iodide and bismuth, facilitating the ∼90°/180° bonding motifs.