Chong Shik Park
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Chong Shik Park has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Chang-Ki Min
Pohang Accelerator Laboratory, POSTECH, Pohang, Republic of Korea
3 shared publicationsEun-San Kim
Department of Accelerator Science, Graduate School, Korea University, Sejong, Korea
3 shared publicationsSeong Hee Park
Department of Accelerator Science, Graduate School, Korea University, Sejong, Korea
3 shared publicationsWoo Jun Byeon
Pohang Accelerator Laboratory, POSTECH, Pohang, Republic of Korea
3 shared publicationsChanmi Kim
Department of Accelerator Science, Graduate School, Korea University, Sejong, Korea
2 shared publications- Chanmi Kim
Department of Accelerator Science, Graduate School, Korea University, Sejong, South Korea
2 shared publications
Latest Publications
- Open Access
- 31 December 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 58 (5)
Tracking simulation of third-integer resonant extraction for Fermilab’s Mu2e experiment
- 31 December 2025
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 58 (5)
Open AccessTracking simulation of third-integer resonant extraction for Fermilab’s Mu2e experiment
- 2 December 2024
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 86 (1) , 23-30
Error analysis study for electron linear accelerator optimized using multi-objective genetic algorithm
- 2 December 2024
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 86 (1) , 23-30
Error analysis study for electron linear accelerator optimized using multi-objective genetic algorithm
- Open Access
- 31 October 2024
- Published by Springer Nature in Research Square
Error Analysis Study for Electron Linear Accelerator Optimized Using Multi Objective Genetic Algorithm
The injector system of 4th generation synchrotron radiation accelerators should be optimally designed to produce a good quality beam. In the previous study, we used Multi-Objective Genetic Algorithm (MOGA) to optimize the injector system parameters to meet the beam requirements. To ensure that the injector operation parameters optimized by MOGA fall within practical ranges, we conducted an error analysis. The injector, composed of RF cavities and magnets, includes an analysis of potential errors in RF cavity phase and gradient, and magnet strengths across three distinct steps. First, we considered errors that could occur during operation, such as input phases of RF cavities and strengths of cavities and magnets. Second, we considered installation errors, including rotation errors of devices. Lastly, we simulated scenarios where all errors occur simultaneously. The simulation results showed that even when errors occurred, the beam quality remained within our acceptable range. Through this error analysis, we confirmed that the linac operation parameters optimized by MOGA are indeed practical and usable.
- 31 October 2024
- Published by Springer Nature in Research Square
Open AccessError Analysis Study for Electron Linear Accelerator Optimized Using Multi Objective Genetic Algorithm
The injector system of 4th generation synchrotron radiation accelerators should be optimally designed to produce a good quality beam. In the previous study, we used Multi-Objective Genetic Algorithm (MOGA) to optimize the injector system parameters to meet the beam requirements. To ensure that the injector operation parameters optimized by MOGA fall within practical ranges, we conducted an error analysis. The injector, composed of RF cavities and magnets, includes an analysis of potential errors in RF cavity phase and gradient, and magnet strengths across three distinct steps. First, we considered errors that could occur during operation, such as input phases of RF cavities and strengths of cavities and magnets. Second, we considered installation errors, including rotation errors of devices. Lastly, we simulated scenarios where all errors occur simultaneously. The simulation results showed that even when errors occurred, the beam quality remained within our acceptable range. Through this error analysis, we confirmed that the linac operation parameters optimized by MOGA are indeed practical and usable.
- 27 February 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 71 (3) , 242-254
Physics Design of a 200-MeV Electron Injector Linac With a Thermionic Electron Gun for the Korean Fourth-Generation Storage Ring Light Source
This study presents a comprehensive physics design and optimization investigation of an electron injector system for the Korea 4th Generation Storage Ring (Korea-4GSR) Light Source with a target operating energy of around 200 MeV. The Korea-4GSR construction project is currently underway and expected to continue until 2027. The injector system comprises a thermionic DC gun, buncher systems, and four accelerating cavities. The thermionic gun was designed to achieve a combination of low emittance and high current. Through beam dynamics simulations, we investigated different types of buncher and accelerating cavities. Optimization was performed on the geometries and electromagnetic properties of each cavity type to enhance beam bunching and acceleration. Non-linear optimization techniques were employed to maximize transmission efficiency by adjusting solenoidal magnet strengths and minimize energy spread by optimizing RF input phases and cavity positions. Our results demonstrated a transmission efficiency of 98.71 %, an rms energy spread of 0.54 %, a bunch length of 4.11 ps, and an normalized rms transverse emittance of 3.2219 mm-mrad, meeting the design requirements of the Korea-4GSR injector system.
- 27 February 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 71 (3) , 242-254
Physics Design of a 200-MeV Electron Injector Linac With a Thermionic Electron Gun for the Korean Fourth-Generation Storage Ring Light Source
This study presents a comprehensive physics design and optimization investigation of an electron injector system for the Korea 4th Generation Storage Ring (Korea-4GSR) Light Source with a target operating energy of around 200 MeV. The Korea-4GSR construction project is currently underway and expected to continue until 2027. The injector system comprises a thermionic DC gun, buncher systems, and four accelerating cavities. The thermionic gun was designed to achieve a combination of low emittance and high current. Through beam dynamics simulations, we investigated different types of buncher and accelerating cavities. Optimization was performed on the geometries and electromagnetic properties of each cavity type to enhance beam bunching and acceleration. Non-linear optimization techniques were employed to maximize transmission efficiency by adjusting solenoidal magnet strengths and minimize energy spread by optimizing RF input phases and cavity positions. Our results demonstrated a transmission efficiency of 98.71 %, an rms energy spread of 0.54 %, a bunch length of 4.11 ps, and an normalized rms transverse emittance of 3.2219 mm-mrad, meeting the design requirements of the Korea-4GSR injector system.
- 1 January 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (01) , P01023
Optimization study for RF cavity and beam dynamics simulation in the electron linear accelerator using the multi-objective genetic algorithm
This work presents an optimization study on the RF cavity geometry design and beam dynamics of an electron injector linac for the Korea Fourth-Generation Storage Ring (Korea-4GSR). It is challenging to achieve an optimal design for a linac system due to the nonlinear nature of accelerator system and the associated beam dynamics with numerous knobs to control. To address this challenge, we employed the Multi-Objective Genetic Algorithm (MOGA) for efficient optimization. Through the utilization of MOGA, we effectively optimized the electron linac for the Korea-4GSR. The optimized design yielded a horizontal normalized rms emittance of approximately 3.79 mm-mrad and an energy spread of about 307.37 keV, which met design requirements of the Korea-4GSR. This approach facilitated the design of an electron linac tailored for the Korea-4GSR with enhanced efficiency and effectiveness.
- 1 January 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (01) , P01023
Optimization study for RF cavity and beam dynamics simulation in the electron linear accelerator using the multi-objective genetic algorithm
This work presents an optimization study on the RF cavity geometry design and beam dynamics of an electron injector linac for the Korea Fourth-Generation Storage Ring (Korea-4GSR). It is challenging to achieve an optimal design for a linac system due to the nonlinear nature of accelerator system and the associated beam dynamics with numerous knobs to control. To address this challenge, we employed the Multi-Objective Genetic Algorithm (MOGA) for efficient optimization. Through the utilization of MOGA, we effectively optimized the electron linac for the Korea-4GSR. The optimized design yielded a horizontal normalized rms emittance of approximately 3.79 mm-mrad and an energy spread of about 307.37 keV, which met design requirements of the Korea-4GSR. This approach facilitated the design of an electron linac tailored for the Korea-4GSR with enhanced efficiency and effectiveness.