EOEhsan Omranian

Ehsan Omranian

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ehsan Omranian has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Development of the Performance-Based Plastic Design Method by Considering the Effects of Aftershocks

    by Gholamreza Abdollahzadeh, Ali Mohammadgholipour, Ehsan Omranian

    One of the efficient methods for seismic design of structures is Performance-based Plastic Design (PBPD) in which by choosing the desired yield mechanism and the target drift at the beginning of the design, unlike that in conventional design methods, there is no need for a time-consuming process of trial and error to achieve the desired performance. On the other hand, recent earthquakes have shown that aftershocks can increase the damage to a building after the main earthquake and thereby threaten the safety of the inhabitants. However, the seismic hazard of aftershocks is still not explicitly included in the current design codes. In this study, attempts have been made to develop the PBPD method for considering the effects of aftershocks. For this purpose, by performing an incremental dynamic analysis (IDA), the ductility factor μ and the ductility reduction factor Rμ of six PBPD frames (2-, 4-, 6-, 8-, 10-, and 12-story) were calculated under mainshock and mainshock-aftershock sequences. Then, the energy modification factor γ, which is related to the two parameters μ and Rμ, was calculated for both the mainshock and the mainshock-aftershock sequences. An equation is presented in order to calculate the ratio of the energy modification factor of the mainshock-aftershock sequence to the mainshock energy modification factor ( γms+asγms) according to the design period, and the factor obtained is multiplied by the energy modification factor γ so that the effect of aftershock can be considered for the frame design, and by using this modification, the performance of the frame under the mainshock-aftershock sequence can be improved. The results of the time-history analysis performed on the modified PBPD frames show better performance by the frames designed on the basis of modified PBPD than the frames designed on the basis of the original PBPD method under MS-AS sequences in terms of inter-story drift and rotation of plastic hinges.


  • A New Method for Generating Aftershock Records Using Artificial Neural Network

    by Vahid Vahedian, Ehsan Omranian, Gholamreza Abdollahzadeh

    Due to the potential of strong aftershocks to cause further damage to mainshock-damaged structures, accurate evaluation of the structural performance during a real seismic sequence is essential. Because of the deficiency of such real data, the necessity for developing artificial aftershock accelerograms consistent with the real mainshock accelerogram is indisputable. This article presents a new method for generating aftershock spectrum, using an artificial neural network. In this procedure, a multilayer perceptron neural network is used to create a network, whose input is response acceleration spectrum of the mainshock and the output is response acceleration spectrum of the aftershock corresponds to the mainshock with equal hazard level. To train this network, 126 seismic sequences recorded on soil type C are used. Results show good agreement between the response acceleration spectrum derived from the artificial neural network and the real aftershock spectrum. In the next step, a simple approximate logarithmic equation is proposed to calculate the aftershock strong-motion duration in terms of the mainshock strong-motion duration, and the ratio of mainshock-aftershock intensity. Finally, with the presence of the response acceleration spectrum and the aftershock strong-motion duration, accelerograms consistent with this aftershock artificial spectrum is extracted using the wavelet method.


  • Application of the Artificial Neural Network for Predicting Mainshock-Aftershock Sequences in Seismic Assessment of Reinforced Concrete Structures

    by Gholamreza Abdollahzadeh, Ehsan Omranian, Vahid Vahedian

    Studies from past earthquakes have shown that aftershocks can increase the vulnerability of structures damaged under mainshocks. However, the main challenge is to take these threats into account during the process of design and retrofit. Using the accelerograms that are compatible with the mainshock and the corresponding aftershocks can lead to a proper evaluation of seismic performance of a structure during the mainshock and aftershock, based on time history analyses. Therefore, it is necessary to simulate the aftershock motions consistent with the predicted mainshock spectrum. This study first investigates the relationship between the frequency content of an aftershock and its corresponding mainshock. It then discusses the development of a method for the generation of artificial aftershocks based on the acceleration response spectrum obtained from the artificial neural networks. To evaluate the effectiveness of the proposed method for the generation of artificial seismic sequences, a large number of time-history analyses have been conducted using both the current (the conventional back-to-back approach) and the proposed methods for three different structures including a column (representing the pier of a bridge), a reinforced concrete (RC) building, and an RC bridge. In these analyses, a wide range of different elements and materials have been employed and different responses, including maximum drift, residual drift, inter-story drift, floor acceleration, column curvature, and base shear, have also been studied. The results revealed that the proposed method produces the appropriate estimation of structural responses, and has a considerably higher efficiency compared to the conventional BTB approach that often introduces considerably large errors in the estimation of responses.


  • Fragility Curve Development for the Seismic Vulnerability Assessment of Retrofitted RC Bridges under Mainshock-Aftershock Seismic Sequences

    by Ehsan Omranian, Adel Abdelnaby, Gholamreza Abdollahzadeh, Mehdi Rostamian, Farid Hosseinpour

    Bridges are one of the most important lifeline structures such that loss of functionality of the network system is directly related to the social and economic losses experienced following an earthquake. Due to the potential of strong aftershocks to cause further damage to mainshock damaged bridges, accurate evaluation of the structural performance during a real seismic sequence is essential. This paper investigates the seismic damage of a reinforced concrete (RC) skewed bridge subject to a sequence of earthquake ground motions. Fragility curves are developed for both with and without consideration of the effects of aftershocks on the seismic vulnerability of the bridges for two cases: original bridge and retrofitted bridge by FRP. Results of this study have revealed that the effect of aftershocks on damage states appears to increase the seismic vulnerability of RC bridges. In addition, the strategy of retrofit will significantly affect the seismic response and therefore fragility of bridges.


  • Seismic Evaluation of Steel Moment Frames Under Mainshock–Aftershock Sequence Designed by Elastic Design and PBPD Methods

    by Gholamreza Abdollahzadeh, Ali Mohammadgholipour, Ehsan Omranian

    Aftershocks can increase building vulnerability and decrease life-safety of the residents; nevertheless, no practical design method has yet been considered the seismic risk of aftershock. In this study, a new design method known as performance-based plastic design (PBPD) has been utilized instead of conventional elastic design (ED) for steel moment frames which considers nonlinear behavior of structures directly in the design process. Result of time-history analysis shows that drift increase due to aftershock for ED-frame is more than PBPD-frame. In addition, plastic hinge and hysteretic energy distributions for PBPD-frame when subjected to mainshock–aftershock sequence is more desirable than ED-frame.