Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


José Antonio Jiménez-Valera has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Geotechnical aspects of decommissioning tailings storage facilities (TSF) in mining districts of Southern Spain

    by Iván Alhama Manteca, Emilio Trigueros Tornero, Francisco Abel Jiménez Cantizano, Teresa M. Bodas Freitas, Jerôme Viers, José Antonio Jiménez-Valera, Lola Yesares

    Production practices in the mining industry during the last century have left numerous inactive facilities that current administrations have to deal with. In the case of tailings storage, the risk of pollution dispersion or large-scale damage caused by stability failures requires specific actions. In southern Spain, 28 abandoned tailings dams in the mining districts of Mazarrón, Cartagena and La Unión and 59 in the mining districts located in Andalucian Provinces, have been classified as hazardous for potential pollution risk, according to European regulations. In this document, we gather the experiences of 23 case studies in tailing decommission projects planned during the 2010-24 period, focusing on the most recent case of the San Cristobal-II tailings dam (SC-II). The actions conducted consist essentially of sealing, introduction of drainage elements, slope reprofiling and surface revegetation. The geotechnical characterization and monitoring conducted during decommissioning have emphasized that action must focus on pore water pressure control throughout all the phases of the project. The analysis of the actions involved in the decommissioning projects shows some positive experiences but also the need to improve in-depth geotechnical data acquisition, to ensure long-term safety while optimizing the decommissioning costs.


  • Open Access

    Interdependence Between River Aquifer Groundwater Flow and Temperature–Depth Profiles: Type Curves Based on Pi Theorem and Numerical Simulations

    by José Antonio Jiménez-Valera, Iván Alhama, Carlos Duque, David Labat

    The interaction between surface water and groundwater has been extensively studied due to its water management implications and the potential environmental impacts arising from it. Experimental studies and numerical modeling have supported analytical solutions; these solutions have been proposed for specific cases in which the aim has been to understand discharge/recharge and aquifer characterization. In this study, new graphical solutions or type curves are provided to estimate the subsurface flow and thermal–mechanical parameters in anisotropic porous media. Using the non-dimensionalization technique of the governing equations, new dimensionless groups (lumped parameters) that govern the solution of both the mechanical problem (uncoupled) and the thermal problem are obtained. From these groups, and by applying the pi theorem and examining numerical simulations of numerous cases, user-friendly type curves are obtained. The recharge flow and hydraulic conductivity are calculated when the thermal properties, geometrical parameters, and temperature variables are known. To evaluate the reliability of the type curves, two real case studies are presented: the interaction between the Guadalfeo River and the Motril-Salobreña coastal aquifer, and the artificial recharge program in the coastal aquifer of Agua Amarga in southern Spain. For verification, the groundwater flow obtained from the type curves is compared with the recharge data. In the case of the river–aquifer interaction, the recharge flow obtained is 13% less than that estimated in previous studies. Regarding the artificial recharge of the coastal aquifer, the flow obtained is 21% less than the volume irrigated over the salt marsh. The uncertainties related to hydrogeological features are considered to have the greatest influence on the error.

  • Open Access

    Type-curves to assess seepage under sheet-piles for dewatering geotechnical works in limited 2D geometries

    by S. Navarro Carrasco, J.A. Jiménez-Valera, I. Alhama Manteca

    Graphical methods based on flownets or numerical modelling are two procedures traditionally used to estimate groundwater flow under different geotechnical structures (dams, sheet-piles, diaphragm walls, among others). In this work, both methods are combined with dimensionless analysis to set out and verify the dimensionless groups that govern the groundwater discharge. The results are a set of type-curves charts easy-to-use to assess seepage per metre transversal length of sheet-pile. The chart is applied to flow under sheet-piles for maritime or fluvial shored scenarios, where permanent dewatering is required in the enclosure. Geometrical parameters like sheet-pile height, depth of sheet-pile embedment, impervious bedrock depth, excavation width, horizontal stretch in the back face and water levels and physical parameters as hydraulic conductivity are input data in the chart, all of them included in the monomials. The physical scenario assumes isotropic medium and cross-section symmetry.

  • Open Access

    On Mechanical and Chaotic Problem Modeling and Numerical Simulation Using Electric Networks

    by Pedro Aráez, José Antonio Jiménez-Valera, Iván Alhama

    After reviewing the use of electrical circuit elements to model dynamic processes or the operation of devices or equipment, both in real laboratory implementations and through ideal circuits implemented in simulation software, a network model design protocol is proposed. This approach, following the basic rules of circuit theory, makes use of controlled generators to implement any type of nonlinearity contained in the governing equations. Such a protocol constitutes an interesting educational tool that makes it possible for nonexpert students in mathematics to design and numerically simulate complex physical processes. Three applications to mechanical and chaotic problems are presented to illustrate the versatility of the proposed protocol.

  • Open Access

    Using Remote Sensing to Assess the Vegetation Cover of a Protected Salt Marsh Subjected to Artificial Recharge and Groundwater Abstractions during the Period 1925–2022 (Alicante, SE Spain)

    by José Marín Salcedo, Iván Alhama, Manuel Alcaraz, José Álvarez-Rogel, José Antonio Jiménez-Valera

    The Agua Amarga salt marsh has been subjected to artificial seawater recharge on its surface during the period 1925–1969 for industrial purposes (saltwork activity) and from 2008 to present to compensate for coastal groundwater abstraction to supply Alicante desalination plants. This groundwater abstraction has caused piezometric depletion in the coastal aquifer connected to the protected salt marsh. The seawater recharge program also involved vegetation monitoring to control the impact on the salt marsh ecosystem, allowing data to be collected about the halophyte vegetation species growing in the salt marsh (Arthrocnemum macrostachyum, Sarcocornia fruticosa, and Ruppia maritima, among others) from spring and autumn field surveys. In this work, vegetation development is assessed with remote sensing for the period 1929–2022 using images with visible and near-infrared spectral resolution. Different spectral indices (NDVI, BI, and NDWI) and classification algorithms (random forest) are used to calculate the vegetation cover. Field data are employed to evaluate the protocols and compare the results, showing a 46% decrease caused by the salt works and a 50% increase as a result of natural evolution and artificial recharge. The spread of Phragmites australis is also addressed by comparing LiDAR data with field monitoring, showing an increase of 12% during the period 2005–2023. The advantages and complementarity of field monitoring and remote sensing information are explained.


  • Open Access

    Inverse Problem Protocol to Estimate Horizontal Groundwater Velocity from Temperature–Depth Profiles in a 2D Aquifer

    by Francisco Alhama, José Antonio Jiménez-Valera, Iván Alhama

    A general and precise protocol that follows the standards of an inverse problem in engineering is proposed to estimate groundwater velocity from experimental lectures of temperature vertical profiles in a 2D aquifer. Several values of error in the temperature measurements are assumed. Since a large quantity of parameters and initial conditions influence the solution of this process, the protocol is very complex and needs to be tested to ensure its reliability. The studied scenario takes into account the input temperature of the water as well as the isothermal conditions at the surface and bottom of the aquifer. The existence of an input region, in which profiles develop to become linear, allows us to eliminate experimental measurements beyond such a region. Once the protocol is developed and tested, it is successfully applied to estimate the regional (lateral) groundwater velocity of the real aquifer and the result compared with estimations coming from the piezometric map.


  • Open Access

    Deduction of the Dimensionless Groups and Type Curves of Temperature Profiles in Two-Layer Soils with Water Flow at Depth

    by Iván Alhama, José Antonio Jiménez-Valera, Manuel Cánovas, Francisco Alhama

    In the common hydrogeologic scenarios of horizontal groundwater flow and a water table below the surface, the steady-state 2D thermal field resulting from the coupling between water flow and heat flow and transport gives rise to a vertical temperature profile that develops progressively over a finite extent of the domain. Beyond this region, the temperature profiles are linear and independent of horizontal position. Such profiles are related to the groundwater velocity so they can be usefully used to estimate this velocity in the form of an inverse problem. By non-dimensionalization of the governing equations and boundary conditions, this manuscript formally derives the precise dimensionless groups governing the main unknowns of the problem, namely, (i) extent of the profile development region, (ii) time required for the steady-state temperature profile solution to be reached and (iii) the temperature–depth profiles themselves at each horizontal position of the development region. After verifying the mathematical dependencies of these unknowns on the deduced dimensionless groups, and by means of a large number of accurate numerical simulations, the type curves related to the horizontal extension of the development of the steady-state profiles, the characteristic time to develop such profiles and the dimensionless vertical temperature profiles inside the characteristic region are derived. These universal graphs can be used for the estimation of groundwater horizontal velocities from temperature–depth measurements.


  • Open Access

    A Universal Graphical Solution to Calculating Seepage in Excavation of Anisotropic Soils and Non-Limited Scenarios

    by Salvador Navarro Carrasco, José Antonio Jiménez-Valera, Ivan Alhama

    The interaction between groundwater and civil engineering works is a key aspect in geotechnical design. In the case of excavations confined in sheet pile walls, steel sheeting, diaphragm walls, cut-off walls, or cofferdams, this design requires the estimation, among other soil mechanics properties, of the groundwater flowing into the excavation (seepage) caused by piezometry depletion. Numerical methods, graphical solutions, and analytical procedures are the methodologies traditionally used to solve this issue, solutions of which require an understanding of basic soil mechanical properties, hydraulic conditions and structure geometry. In this work, the discriminated non-dimensionalization technique is applied to obtain, for the first time, the dimensionless groups that govern the seepage, in anisotropic conditions, in large-scale scenarios where groundwater flow is not conditioned by impervious bedrock or the length of the back of the wall: π1=ab,π2=kxb2kyc2 and, π3=T/b. Numerical simulations are carried out to check the validity of dimensionless groups and to develop three sets of type curves that relate to these groups. Once the physical and geometrical data are known, the seepage (Q), the characteristic depth (T*) and the characteristic horizontal extension (L*) can be directly and easily calculated from these abacuses. The influence of anisotropy on the characteristic lengths is also addressed.


  • Open Access

    Quantification of Groundwater Vertical Flow from Temperature Profiles: Application to Agua Amarga Coastal Aquifer (SE Spain) Submitted to Artificial Recharge

    by José Antonio Jiménez-Valera, Iván Alhama, Emilio Trigueros

    The Agua Amarga coastal aquifer has experienced different anthropic interventions over the last 100 years. Since 2008, groundwater abstractions along the coastline to supply the Alicante I and II desalination plants have been combined with artificial recharge. This measure, consisting of seawater irrigation over the salt marsh, has reduced the impact on the piezometry and surface ecosystems. The study of the effect of this measure on groundwater flow is addressed by applying an inverse problem protocol to temperature profiles monitored in a piezometer located inside the recharge area. Information on monthly seawater irrigation volumes, rainfall, and average air and seawater temperatures have also been gathered as input data to quantify vertical flow. An upward flow component for the period 2010–2022 that varies between 2 × 10−9 and 7.5 × 10−7 m/s has been found. These values decrease near the surface, where the flow is mainly horizontal.


  • Dimensional Characterization of Groundwater Oblique Flow Problems with Heat Transport

    by José Antonio Jiménez‐Valera, Francisco Alhama

    A dimensional study of two problems in which groundwater flow is oblique has been carried out in order to characterize the vertical profiles of temperature along the domain affected by the flow, determining an input region in which the profiles depend on the horizontal position followed by a region in which profiles only depend on the vertical component of the flow. In the first problem, the horizontal and vertical components of velocity are constant. In the second scenario, the oblique flow of groundwater is generated because in the boundary conditions, the hydraulic potentials present a constant value. From the discriminated dimensional analysis of the mathematical model (governing equations and boundary conditions), the dependencies of the unknowns of greatest interest, characteristic lengths for the development of temperature‐depth profiles, velocity profiles and the temperature field, with the dimensionless groups deduced are established. Once these dependencies have been verified, they are graphically represented by means of curves and surfaces as universal solutions to these problems. Based on these universal solutions an inverse problem protocol for estimating water flows from temperature measurements is proposed. The use of universal graphs of the two proposed scenarios avoids the large number of numerical simulations that this type of problem required.