Handong Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Handong Li has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Yutai Li
Xuefeng Mountain Energy Equipment Safety National Observation and Research Station, Chongqing University, Chongqing 400044, China
4 shared publications - Haiyun Luo
Department of Electrical Engineering, Tsinghua University, Beijing, China
3 shared publications - Xiaobing Zou
Department of Electrical Engineering, Tsinghua University, Beijing 100084, People’s Republic of China
3 shared publications - Xinxin Wang
Department of Electrical Engineering, Tsinghua University, Beijing, China
3 shared publications Peng Wang
Department of Electrical Engineering Tsinghua University Beijing China
2 shared publications- Yangyang Fu
Tsinghua University
2 shared publications
Latest Publications
- Open Access
- 25 August 2022
- Published by Institution of Engineering and Technology (IET) in High Voltage
- Vol. 8 (2) , 340-346
Effect of photoionisation on initial discharge in air under nanosecond pulse voltage
Effects of photoionisation on the development and electron runaway of the initial discharge in atmospheric air under nanosecond pulse voltage were studied via two‐dimensional particle‐in‐cell/Monte Carlo collision simulations. It was found that photoionisation has little effect at the beginning of the initial discharge. However, as the discharge channel gradually develops towards the anode, photoionisation shows greater impacts on the morphology of discharge but has little influence on the velocity of discharge development. Photoionisation does not appear to have a decisive effect on the growth trend of the highest energy of runaway electrons, but it does affect the change rate of the highest energy and overall distribution of electron energy, resulting in a higher proportion of energetic electrons. The difference in the distributions of the electron energy between the two cases, with and without considering photoionisation, can be attributed to the impact of photoionisation on the discharge morphology, which in turn distorted the electric field. The spatial density distributions of the electrons produced by photoionisation further explained the differences. The authors’ results explicitly demonstrate the influence of photoionisation on the development and the electron runaway of the initial discharge under nanosecond pulse voltage, which provides more comprehensive knowledge for the atmospheric air gap nanosecond pulse discharge physics.
- 25 August 2022
- Published by Institution of Engineering and Technology (IET) in High Voltage
- Vol. 8 (2) , 340-346
Open AccessEffect of photoionisation on initial discharge in air under nanosecond pulse voltage
Effects of photoionisation on the development and electron runaway of the initial discharge in atmospheric air under nanosecond pulse voltage were studied via two‐dimensional particle‐in‐cell/Monte Carlo collision simulations. It was found that photoionisation has little effect at the beginning of the initial discharge. However, as the discharge channel gradually develops towards the anode, photoionisation shows greater impacts on the morphology of discharge but has little influence on the velocity of discharge development. Photoionisation does not appear to have a decisive effect on the growth trend of the highest energy of runaway electrons, but it does affect the change rate of the highest energy and overall distribution of electron energy, resulting in a higher proportion of energetic electrons. The difference in the distributions of the electron energy between the two cases, with and without considering photoionisation, can be attributed to the impact of photoionisation on the discharge morphology, which in turn distorted the electric field. The spatial density distributions of the electrons produced by photoionisation further explained the differences. The authors’ results explicitly demonstrate the influence of photoionisation on the development and the electron runaway of the initial discharge under nanosecond pulse voltage, which provides more comprehensive knowledge for the atmospheric air gap nanosecond pulse discharge physics.
- 1 May 2022
- Published by AIP Publishing in Physics of Plasmas
- Vol. 29 (5) , 053508
Investigation of the microsecond-pulse acoustic wave generated by a single nanosecond-pulse discharge
A single nanosecond-pulse discharge can produce a high-intensity pulsed acoustic wave. The pulse width of the acoustic wave is much wider than that of the current, more than 20 μs at 30 cm from the source, which is the basis of synthesizing low-frequency sound by repetitively nanosecond-pulse discharges. The investigations of electroacoustic characteristics and the sound formation process of the single nanosecond-pulse discharge are vital to advance this technology. In this paper, an experimental platform for the single nanosecond-pulse discharge was built, and time-domain waveforms of the voltage, the current, and the sound pressure were measured. The effects of electrode shape, current limiting resistors, and current pulse width on the acoustic wave were discussed. To analyze the formation process of the acoustic wave, the gas densities near the electrodes at different moments after the discharge were diagnosed by laser Schlieren photography. The result shows that the formation of the acoustic wave is much slower than the discharge. A two-stage model was developed to qualitatively describe the formation process of the acoustic wave, and numerical calculations were carried out using thermodynamic and hydrodynamic equations. At the end of the discharge, a huge pressure difference is formed inside and outside the gas channel due to the Joule heating, which can be considered as a shock wave. During the outward propagation, the wave tail is elongated by the difference in sound velocity at each point, and the thickness of the shock wave increases due to the dissipation. This eventually leads to the half-duration of more than 20 μs.
- 1 May 2022
- Published by AIP Publishing in Physics of Plasmas
- Vol. 29 (5) , 053508
Investigation of the microsecond-pulse acoustic wave generated by a single nanosecond-pulse discharge
A single nanosecond-pulse discharge can produce a high-intensity pulsed acoustic wave. The pulse width of the acoustic wave is much wider than that of the current, more than 20 μs at 30 cm from the source, which is the basis of synthesizing low-frequency sound by repetitively nanosecond-pulse discharges. The investigations of electroacoustic characteristics and the sound formation process of the single nanosecond-pulse discharge are vital to advance this technology. In this paper, an experimental platform for the single nanosecond-pulse discharge was built, and time-domain waveforms of the voltage, the current, and the sound pressure were measured. The effects of electrode shape, current limiting resistors, and current pulse width on the acoustic wave were discussed. To analyze the formation process of the acoustic wave, the gas densities near the electrodes at different moments after the discharge were diagnosed by laser Schlieren photography. The result shows that the formation of the acoustic wave is much slower than the discharge. A two-stage model was developed to qualitatively describe the formation process of the acoustic wave, and numerical calculations were carried out using thermodynamic and hydrodynamic equations. At the end of the discharge, a huge pressure difference is formed inside and outside the gas channel due to the Joule heating, which can be considered as a shock wave. During the outward propagation, the wave tail is elongated by the difference in sound velocity at each point, and the thickness of the shock wave increases due to the dissipation. This eventually leads to the half-duration of more than 20 μs.
- 1 July 2021
- Published by AIP Publishing in Physics of Plasmas
- Vol. 28 (7) , 073510
Breakdown, discharge modes, and gaseous recovery of atmospheric air with repetitive 10 ns pulses
The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.
- 1 July 2021
- Published by AIP Publishing in Physics of Plasmas
- Vol. 28 (7) , 073510
Breakdown, discharge modes, and gaseous recovery of atmospheric air with repetitive 10 ns pulses
The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.
- Open Access
- 1 July 2021
- Published by AIP Publishing in Physics of Plasmas
- Vol. 28 (7) , 073502
Effect of time interval between pulses on the synthetic sound generated by repetitive nanosecond pulse discharge
The time interval between pulses is the key parameter of sound synthesis generated by repetitive nanosecond pulse discharge. In this paper, the experimental studies on repetitive nanosecond pulse discharges at different intervals using a pin–pin electrode were carried out and the time-domain sound waveforms were obtained using a capacitor microphone. The experiment results show that a single pulse discharge with a FWHM (full width at half maxima) of 6 ns can produce a pulse sound with a much wider FWHM of 16 μs because of thermal inertia. Based on this measured waveform of the sound pressure and the burst modulation method, the time interval between the repetitive pulses for a better synthesis of 100 Hz sound was theoretically determined to be shorter than 15 μs. However, it was experimentally found that this theoretically determined time interval is too short for the gas to recover its insulating ability from the previous pulse discharge. The energy deposited into the discharge and the sound pressure generated by the following pulses are greatly reduced. The experimental synthetic sound is considerably lower than the theoretical one.
- 1 July 2021
- Published by AIP Publishing in Physics of Plasmas
- Vol. 28 (7) , 073502
Open AccessEffect of time interval between pulses on the synthetic sound generated by repetitive nanosecond pulse discharge
The time interval between pulses is the key parameter of sound synthesis generated by repetitive nanosecond pulse discharge. In this paper, the experimental studies on repetitive nanosecond pulse discharges at different intervals using a pin–pin electrode were carried out and the time-domain sound waveforms were obtained using a capacitor microphone. The experiment results show that a single pulse discharge with a FWHM (full width at half maxima) of 6 ns can produce a pulse sound with a much wider FWHM of 16 μs because of thermal inertia. Based on this measured waveform of the sound pressure and the burst modulation method, the time interval between the repetitive pulses for a better synthesis of 100 Hz sound was theoretically determined to be shorter than 15 μs. However, it was experimentally found that this theoretically determined time interval is too short for the gas to recover its insulating ability from the previous pulse discharge. The energy deposited into the discharge and the sound pressure generated by the following pulses are greatly reduced. The experimental synthetic sound is considerably lower than the theoretical one.