Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Davor Skrlec has a total of 50 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Potentials and Limitations of Using Sentinel Data for Power System Operation and Control: Case Study of Protection Against Forest Fires and Aerosol Contamination

    by Amalija Božiček, Božidar Filipović-Grčić, Bojan Franc, Davor Škrlec, Frano Tomašević

    The power network is directly or indirectly exposed to various weather and climate conditions that can positively and negatively influence it. Forest fires and various aerosol contaminations may negatively affect the power network. Surface observations and measurements (e.g., weather stations) help protect against unfavorable influences, but the network is usually poor. That challenge may be solved by including satellite data in the power network planning, operation, and maintenance. This article presents the possibilities of using Sentinel mission’s data, at various temporal and spatial levels, for those purposes through examples of protection against forest fires and aerosol contamination. In the case of forest fires, satellite data enable a more-precise calculation of forest fire-spreading danger for areas with no installed weather stations, which may be used in the power system contingency analysis calculation. The analysis showed that aerosol contamination has a correlation with outage appearance in the 25 kV 50 Hz electric traction network. Sentinel 5p data may serve as a tool in a surface air-quality measurement data control to confirm/deny the high concentration of PM10 particles. Analysis showed that Sentinel data are favorable for power network operations on intra-day and day-ahead operations, as well as for long-term operations, which include planning and maintenance. The spatial resolution of Sentinel data is more than enough to fulfill the surface weather station network. Satellite data also enable the use of additional data that are not measured at ground stations.


  • Top Cited Papers

    Review of energy storage allocation in power distribution networks: applications, methods and future research

    by Matija Zidar, Pavlos S. Georgilakis, Nikos D. Hatziargyriou, Tomislav Capuder, Davor Škrlec

    Changes in the electricity business environment, dictated mostly by the increasing integration of renewable energy sources characterised by variable and uncertain generation, create new challenges especially in the liberalised market environment. The role of energy storage systems (ESS) is recognised as a mean to provide additional system security, reliability and flexibility to respond to changes that are still difficult to accurately forecast. However, there are still open questions about benefits these units bring to the generation side, system operators and the consumers. This study provides a comprehensive overview of the current research on ESS allocation (ESS sizing and siting), giving a unique insight into issues and challenges of integrating ESS into distribution networks and thus giving framework guidelines for future ESS research.


  • Capacity Optimization of Renewable Energy Sources and Battery Storage in an Autonomous Telecommunication Facility

    by Tomislav Dragicevic, Hrvoje Pandzic, Davor Skrlec, Igor Kuzle, Josep M. Guerrero, Daniel S. Kirschen

    This paper describes a robust optimization approach to minimize the total cost of supplying a remote telecommunication station exclusively by renewable energy sources (RES). Due to the intermittent nature of RES, such as photovoltaic (PV) panels and small wind turbines, they are normally supported by a central energy storage system (ESS), consisting of a battery and a fuel cell. The optimization is carried out as a robust mixed-integer linear program (RMILP), and results in different optimal solutions, depending on budgets of uncertainty, each of which yields different RES and storage capacities. These solutions are then tested against a set of possible outcomes, thus simulating the future operation of the system. Since battery cycling is inevitable in this application, an algorithm that counts the number of cycles and associated depths of discharges (DoD) is applied to the optimization results. The annual capacity reduction that results from these cycles is calculated for two types of battery technologies, i.e., valve-regulated lead-acid (VRLA) and lithium-ion (Li-ion), and treated as an additional cost. Finally, all associated costs are added up and the ideal configuration is proposed.


  • Top Cited Papers

    Advanced LVDC Electrical Power Architectures and Microgrids: A step toward a new generation of power distribution networks

    by Tomislav Dragicevic, Juan C. Vasquez, Josep M. Guerrero, Davor Skrlec

    Current trends indicate that worldwide electricity distribution networks are experiencing a transformation toward direct current (dc) at both the generation and consumption level. This tendency is powered by the outburst of various electronic loads and, at the same time, the struggle to meet the lofty goals for the sharing of renewable energy sources (RESs) in satisfying total demand. RESs operate either natively at dc or have a dc link in the heart of their power electronic interface, whereas the end-point connection of electronic loads, batteries, and fuel cells is exclusively dc. Therefore, merging these devices into dedicated dc distribution architectures through corresponding dc?dc converters is an attractive option not only in terms of enhancing efficiency because of reduction of conversion steps but also for realizing power quality independence from the utility mains. These kinds of systems generally provide improved reliability in comparison to their alternating current (ac) counterparts since the number of active elements in dc?dc power electronic devices is smaller than in dc-ac converters. Control design in dc systems is also significantly simpler since there are no reactive and harmonic power flows or problems with synchronization.


  • Top Cited Papers

    Supervisory Control of an Adaptive-Droop Regulated DC Microgrid With Battery Management Capability

    by Tomislav Dragicevic, Josep M. Guerrero, Juan C. Vasquez, Davor Skrlec

    DC power systems are gaining an increasing interest in renewable energy applications because of the good matching with dc output type sources such as photovoltaic (PV) systems and secondary batteries. In this paper, several distributed generators (DGs) have been merged together with a pair of batteries and loads to form an autonomous dc microgrid (MG). To overcome the control challenge associated with coordination of multiple batteries within one stand-alone MG, a double-layer hierarchical control strategy was proposed. 1) The unit-level primary control layer was established by an adaptive voltage-droop method aimed to regulate the common bus voltage and to sustain the states of charge (SOCs) of batteries close to each other during moderate replenishment. The control of every unit was expanded with unit-specific algorithm, i.e., finish-of-charging for batteries and maximum power-point tracking (MPPT) for renewable energy sources, with which a smooth online overlap was designed and 2) the supervisory control layer was designed to use the low-bandwidth communication interface between the central controller and sources in order to collect data needed for adaptive calculation of virtual resistances (VRs) as well as transit criteria for changing unit-level operating modes. A small-signal stability for the whole range of VRs. The performance of developed control was assessed through experimental results.


  • An approach to the optimal operation of the microgrid with renewable energy sources and energy storage systems

    by Ivan Strnad, Davor Skrlec

    This paper proposes a model for analyzing the production and storage of electricity in the microgrid. The purpose of the model is the analysis of electricity production and storage in the microgrid with the goal of satisfying load demand at minimal production costs and CO 2 emissions. Apart from the description of the model itself, the paper presents the results of the simulation of the production and storage of electricity in the microgrid which is a part of a distribution network. The microgrid uses a photovoltaic plant, a wind turbine, a small pumped hydro and diesel and gas generators for power generation, and battery energy storage systems and the reservoir of a small pumped hydro as energy storages.


  • Optimal PV system placement in a distribution network on the basis of daily power consumption and production fluctuation

    by Rene Prenc, Davor Skrlec, Vitomir Komen

    For the last five years the Croatian power system has been witnessing a sudden increase in penetration of renewable electrical energy sources. Over the last few decades a combination of some requests has given rise to a greater interest in renewable electrical energy sources worldwide. Some of the afore-mentioned requests are reduction in CO 2 emission, energy efficiency programs, deregulation and opening of electricity sector and markets, diversification of energy sources and increased demands for self-sustainability of national power systems. By acquiring experience with practical examples of renewable sources' integration in distribution networks around the world, a set of new problems have arisen which further complicates distribution network planning and operation. The main problem is the mass integration of non-regulated renewable energy sources in passive designed distribution networks. In this paper the optimal placement of a photovoltaic (PV) power plant in distribution network is discussed with a goal of minimizing active and reactive power losses. PV system and loads are modeled with a characteristic daily electric production/consumption curves with discrete hour intervals, which expands the solution space, but in the same time presents solutions more precisely in accordance to the daily power fluctuations. The source code of the program is realized in Matlab programming environment.


  • A model for the efficient use of electricity produced from renewable energy sources for electric vehicle charging

    by I. Strnad, D. Skrlec, T. Tomisa

    The paper proposes a microgrid model composed of a photovoltaic plant, thermal unit, battery energy storage system and electric vehicle charging stations. The microgrid represents the power supply system of the Faculty of Electrical Engineering and Computing connected to the distribution network. Apart from the description of the microgrid model itself, the paper describes the technologies used in the model and the developed simulation model. The simulation model is realized in the FICO Xpress programming optimization tool. Additionally, the paper presents the results of the simulations for ensuring the maximal utilization of electricity produced from the PV plant and thermal units within the microgrid which are to be used for PEV charging and consequently for lowering the microgrid's peak load caused by PEV charging.