NSNorman Syakir

Norman Syakir

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Norman Syakir has a total of 105 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    EIS investigation on the Addition of rGO Mass in rGO/TiO₂ Composites for Photoelectrochemical Reduction of CO₂

    by Tri Komala Junita, Ferry Faizal, Norman Syakir, I Made Joni, Fitri Fitrilawati

    The electrocatalytic behavior of reduced graphene oxide/titanium dioxide (rGO/TiO2) nanocomposites with varying compositions was investigated for CO2 reduction using Electrochemical Impedance Spectroscopy (EIS). The composites were synthesized via a hydrothermal method, and their successful formation was confirmed by Fourier-Transform Infrared (FTIR) spectroscopy through the detection of characteristic Ti–O–C bonds. To analyze the charge transfer dynamics and reaction kinetics, EIS measurements were conducted under both dark and illuminated conditions using a modified Randles circuit model. This equivalent circuit enabled the deconvolution of charge carrier recombination dynamics and mass transport limitations at the semiconductor/electrolyte interface. The EIS results demonstrated that the GT60 composite (60% rGO) exhibited the lowest charge-transfer resistance (RCT = 329 Ω) under illumination, significantly lower than pristine TiO2 (8,007 Ω) and other composite ratios. Furthermore, illumination consistently enhanced charge separation efficiency across all samples, as evidenced by the systematic decrease in RCT values under light conditions compared to dark measurements. These findings highlight the crucial role of optimal rGO/TiO2 composition and interfacial structure in facilitating efficient charge transfer for enhanced electrocatalytic CO2 reduction.

  • Open Access

    Gold nanoparticle-modified screen-printed carbon electrodes for label-free detection of SARS-CoV-2 RNA using drop casting and spray coating methods

    by Salma Nur Zakiyyah, Nadya Putri Satriana, Natasha Fransisca, Shabarni Gaffar, Norman Syakir, Irkham Irkham, Yeni Wahyuni Hartati

    Background and purpose: This study aimed to explore the modification of screen-printed carbon electrode (SPCE) to produce an extensive conductive surface with gold nanoparticles (AuNPs) for the detection of Severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) ribonucleic acid (RNA). Experimental approach: The experiment was carried out using drop casting (DC) and spray coating (SC) methods. Au-S covalent interactions were formed between thiolated single-stranded DNA (ssDNA ) and Au surface, which further hybridized with the target RNA to be detected using differential pulse voltammetry (DPV). Optimization of experimental conditions was performed using Box-Behnken design (BBD) on probe ssDNA concentration, probe ssDNA immobilization time, and target hybridization time. The morphology of the modified electrode was characterized using a scanning electron microscope, while the electrochemical behaviour was determined with DPV and electron impedance spectroscopy. Key results: The results showed that SPCE modification with AuNPs by DC produced a higher peak current height of 12.267 μA with an Rct value of 2.534 kΩ, while SC improved the distribution of AuNPs in the electrode surface. The optimum experimental conditions obtained using BBD were 0.5 µg mL-1 ssDNA-probe concentration, an immobi¬liza¬tion time of 22 minutes, and a hybridization time of 12 minutes. The limit of SARS-CoV-2 RNA detection at a concentration range of 0.5 to 10 μg mL-1 was 0.1664 and 0.694 μg mL-1 for DC and SC, respectively. The T-test results for both methods show that the current response of target RNA with SPCE/AuNP by DC does not show the same result, indicating a significant difference in the current response between those two methods. Conclusion: SPCE/AuNP by DC is better than SPCE/AuNP by SC for immobilizing inosine-substituted ssDNA, which subsequently hybridizes with viral RNA, enabling label-free detection of guanine from SARS-CoV-2 RNA.


  • Effect of mass ratio on rGO/TiO2 composite as catalyst for methylene blue degradation under UV irradiation

    by Tri Komala Junita, Cecilia Michele Natan, Jedija Manondang Aurellia, Nur Khanifah, Norman Syakir, Ferry Faizal, Rahmat Hidayat, Fitri Fitrilawati

    Adsorption and photocatalytic are commonly used methods for the removal of dye contained in industrial wastewater. Therefore, this study aimed to combine reduced Graphene Oxide (rGO) with Titanium Oxide (TiO2) through various compositions using the hydrothermal method to obtain a catalyst of rGO/TiO2 nanocomposites for the removal of contaminants from wastewater. The synthesized rGO/TiO2 nanocomposites were mixed with methylene blue (MB) to reduce their content in water under dark conditions and UV light irradiation. The change of the optical properties of MB under both conditions was also examined, where a decrease in absorbance was observed. Under UV light irradiation, the maximum wavelength [ ] of MB shifted from 664[ ]nm to 649[ ]nm but remained constant at 664[ ]nm in dark conditions. The results of optical characterizations confirmed that the adsorption of MB by rGO/TiO2 nanocomposites under dark conditions did not change the MB structure. However, a significant degradation was observed with photocatalytic process under UV light irradiation. Nanocomposites rGO/TiO2 with rGO 60% and TiO2 40% (GT40) have better performance in reducing MB under UV light irradiation.


  • Multilayer Reduced Graphene Oxide Deposited on Carbon Sheet as Electrodes for Supercapacitor Device

    by Diyan Unmu Dzujah, Rahmat Hidayat, Fitrilawati Fitrilawati, Norman Syakir

    Supercapacitor or often referred to as ultracapacitor is well-known for its long-life cycle, rapid charge-discharge cycles, its ability to bridge between battery and conventional capacitor in terms of power density and energy density values [1]. Carbon allotropes like graphene, carbon nanotube, etc. are widely used as electrodes for supercapacitor mainly due to its large porosity and high electrical conductivity. Pure graphene is very difficult to be prepared in large scale, then Reduced Graphene Oxide (rGO) is used as an alternative to graphene with properties similar to graphene. On the previous work [2], it was shown that carbon sheet can act as electrodes for supercapacitor, thus depositing rGO on carbon sheet (C-rGO) as electrode of supercapacitor can be a good choice to increase the capacitance through their high surface area. This research focused on studying the characteristics of symmetric supercapacitor device with C-rGO|C-rGO device configuration in 1M KCl electrolyte system. 0.5 mg/ml GO was deposited on carbon sheet by using UV-Oven Spraying method, creating multilayer rGO with total of 70 layers. The system then measured in Galvanostatic Charge-Discharge with current variations of 1, 2, 3, 4, 5, and 10 mA. Energy storage characteristics of supercapacitor is then to be determined from the obtained measurement results. The measurement showed that the device has energy density of 0.25 Wh/kg to 0.72 Wh/kg and power density of 250 W/kg to 3,000 W/kg. Based on the value of energy density and power density showed that the device made had met requirements as supercapacitor.

  • Optimization of Polydimethylsiloxane Synthesized Parameters as Vitreous Humour Substitutes

    by Soni Setiadji, Fitrilawati Fitrilawati, Anna Niska Fauza, Atikah Ardi, Ressa Novianti, Norman Syakir, Waslaluddin Waslaluddin, Iman Rahayu, Arief Sjamsulaksan Kartasasmita, Risdiana Risdiana

    Polydimethylsiloxane (PDMS) with two type viscosity that commonly used as vitreous humour substitutes in vitreoretinal surgery has been successfully synthesized by ring-opening polymerization. Optimization of synthesized parameters such as ratio of monomer and chain terminator, the amount of initiator, mixing temperature and reaction time was carried out to obtain PDMS materials having similar properties with commercial product. PDMS with viscosity of 1.17 Pas that very close to viscosity of commercial PDMS of 1.08 Pas, was successfully synthesized with a ratio of 26:10 monomer and terminator chain, 0.58 M of initiator KOH, 170 oC of mixing temperature and 35 minutes of reaction time. By changing reaction time to 40 minutes, PDMS was successfully synthesized with viscosity of 3.42 that similar to that of commercial one.


  • Energy Storage Characteristics of Electrochemically Deposited Graphene Oxide on ITO and Cu Substrates

    by Fitrilawati Fitrilawati, Vika Marcelina, Diyan Unmu Dzujah, Ayi Bahtiar, Yeni Wahyuni Hartati, Norman Syakir

    Graphene Oxide (GO) is two dimensional material that has been widely studied as an electrode material for supercapasitor. We prepared thin films of GO on metal oxide substrate of indium tin oxide (ITO) and metal substrate of Copper (Cu) using electrochemical deposition technique from 0.5 mg/ml GO dispersed in water. ITO-GO film was prepared using voltage range of -1.6 V to 0 V (ITO) and Cu-GO film was prepared using voltage range of 0 V to 1 V at scan rate of 50 mV/s. Both samples were characterized using Cyclic Voltammetry (CV) measurements in 1 M KCl electrolyte at varied scan speed with platinum (Pt) as counter electrode and Ag/AgCl as reference electrode. We compare energy storage characteristics of ITO-GO and Cu-GO using cyclic voltammogram data. It is found that GO deposited in metal substrate of Cu has higer energy density compare to that deposited in metal oxide substrate of ITO.


  • Physical Properties of Encapsulated Iron Oxide

    by Togar Saragi, Bayu Permana, Arnold Therigan, Sahrul Hidayat, Norman Syakir, Risdiana Risdiana

    The size effect of magnetic nanoparticles provides a various magnetic characteristic as a change of domain size. We report, synthesis of core-shell iron oxide and magnetic properties. Iron oxide particles were synthesized by co-precipitation method of iron (III) FeCl3.6H2O, iron (II) FeCl2.4H2O, in the mixture of with or without TEOS to investigated the physical properties. From XRD measurement, it was observed that all iron oxide particles with or without mixture of SiO2 has a hematite phase of a-Fe2O3. From M-H loop measurement, it was observed that the iron oxide without SiO2 has a ferromagnetic characteristic, while the iron oxide with SiO2 showed a medium state as a contribution of superparamagnetic and ferromagnetic properties.


  • Study of transport and magnetic properties of electron-doped superconducting cuprates Eu1.85Ce0.15Cu1-yZnyO4+α-δ

    by Risdiana, M. Manawan, L. Safriani, T. Saragi, W.A. Somantri, A. Aprilia, N. Syakir, S. Hidayat, A. Bahtiar, Fitrilawati, et al.


  • Open Access

    Study of structure and resistivity of electron-doped superconducting cuprates Eu1.85Ce0.15Cu1-yZnyO4+α-δ

    by Risdiana, M. Manawan, L Safriani, T Saragi, A Aprilia, N Syakir, S Hidayat, A Bahtiar, Fitlilawati, R E Siregar