Camila F. Pereira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Camila F. Pereira has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- André Olean-Oliveira
Electrochemistry for Energy Conversion Max‐Planck Institute for Chemical Energy Conversion Mülheim an der Ruhr Germany
2 shared publications - Marcos Fernando Souza Teixeira
Universidade Estadual Paulista Julio de Mesquita Filho, Department of Chemistry and Biochemistry, São Paulo, SP, Brazil
2 shared publications Diego N. David-Parra
Department of Chemistry and Biochemistry, School of Science and Technology - Sao Paulo State University (UNESP), Rua Roberto Simonsen 305, CEP 19060-900, Presidente Prudente, SP, Brazil
1 shared publicationDiego N. David‐Parra
Department of Chemistry and Biochemistry School of Science and Technology Sao Paulo State University (UNESP) Rua Roberto Simonsen, 305 CEP 19060-900 - Presidente Prudente, SP Brazil
1 shared publication
Latest Publications
- 28 August 2018
- Published by Wiley in ChemElectroChem
- Vol. 5 (22) , 3557-3565
Electrocatalytic Study of the Thin Metallopolymer Film of [2,2′‐{1,2‐Ethanediylbis[Nitrilo(1E)‐1‐Ethyl‐1‐Ylidene]}Diphenolate]‐Nickel(II) for Ethanol Electrooxidation
The present paper describes the electrochemical activity of a Ni(II)‐Schiff base metallopolymer electrode for the oxidation of ethanol in alkaline media. The scanning electron microscope results show that the metallopolymer at the glassy carbon surface has a nanoflake‐like lamellar structure, and there is no molecular structural change after treatment with NaOH. Voltammetry measurements indicate that the metallopolymer acts as efficient material for the electrocatalytic oxidation of ethanol, where a high‐valent nickel(IV) was revealed as the reactive intermediate during the anodic scan. An isopotential point can be observed in rotating disk electrode voltammetry for ethanol oxidation. The electrode surface may be considered to consist of two independent electrochemical regions, one corresponding to the ethanol electro‐oxidation by nickel(IV) and the second corresponding to water oxidation. The Tafel slopes were found to be 246 mV dec−1 at low overpotentials and 44 mV dec−1 at high overpotentials, which suggest that the first electron transfer step is the rate controlling step. The specific activity of the metallopolymer‐modified electrode for the ethanol electro‐oxidation reaction was 6.66 mA cm−2 for 0.130 μmol cm−2 of electroactive species of metallopolymer at 0.6 V vs. SCE.
- 28 August 2018
- Published by Wiley in ChemElectroChem
- Vol. 5 (22) , 3557-3565
Electrocatalytic Study of the Thin Metallopolymer Film of [2,2′‐{1,2‐Ethanediylbis[Nitrilo(1E)‐1‐Ethyl‐1‐Ylidene]}Diphenolate]‐Nickel(II) for Ethanol Electrooxidation
The present paper describes the electrochemical activity of a Ni(II)‐Schiff base metallopolymer electrode for the oxidation of ethanol in alkaline media. The scanning electron microscope results show that the metallopolymer at the glassy carbon surface has a nanoflake‐like lamellar structure, and there is no molecular structural change after treatment with NaOH. Voltammetry measurements indicate that the metallopolymer acts as efficient material for the electrocatalytic oxidation of ethanol, where a high‐valent nickel(IV) was revealed as the reactive intermediate during the anodic scan. An isopotential point can be observed in rotating disk electrode voltammetry for ethanol oxidation. The electrode surface may be considered to consist of two independent electrochemical regions, one corresponding to the ethanol electro‐oxidation by nickel(IV) and the second corresponding to water oxidation. The Tafel slopes were found to be 246 mV dec−1 at low overpotentials and 44 mV dec−1 at high overpotentials, which suggest that the first electron transfer step is the rate controlling step. The specific activity of the metallopolymer‐modified electrode for the ethanol electro‐oxidation reaction was 6.66 mA cm−2 for 0.130 μmol cm−2 of electroactive species of metallopolymer at 0.6 V vs. SCE.