HMHennie Johannes van der Meiden

Hennie Johannes van der Meiden

*This is an algorithmically generated author record based on publicly available information.

Hennie Johannes van der Meiden has a total of 217 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dynamic response of detached plasma to intermittent heat and particle fluxes induced by double-pulse ECH in GAMMA 10/PDX

    by Masayuki Yoshikawa, Junko Kohagura, Naomichi Ezumi, Tsuyoshi Kariya, Ryutaro Minami, Tomoharu Numakura, Mafumi Hirata, Satoshi Togo, Yoriko Shima, Takuma Okamoto, et al.

    Detached plasma dynamics under transient upstream perturbations were investigated in the divertor simulation module of GAMMA 10/PDX using double pulse central electron cyclotron heating (C ECH) to generate controlled transient heat and particle fluxes. Detached plasma was produced by radiator gas injection, and its temporal evolution was measured with electrostatic probes, Thomson scattering, microwave interferometry, and high speed Balmer line imaging. The intermittent particle fluxes generated by C ECH induced rapid and repeatable transitions between detached and attached states, with characteristic collapse and recovery times of approximately 1 ms. Spatiotemporal Hα/Hβ measurements revealed a transient, heating-driven shift of the recombining (MAR-dominated) region toward the target plate, accompanied by a transition to an ionization-dominated regime. Comparison with a collisional–radiative model indicates that the observed variations in Hα/Hβ reflect temperature driven changes in excitation and recombination processes, although the line integrated nature of the measurement limits quantitative comparison. The response times are comparable to those reported in Magnum PSI transient pulse experiments, demonstrating that detachment stability is sensitive to millisecond scale perturbations across different magnetic configurations and plasma species. These results establish double pulse C ECH as a precise actuator for studying and controlling detachment like plasma states in the end region of mirror devices.


  • Open Access

    Dynamic response of atomic processes in detached helium plasma induced by high-density transient pulse in Magnum-PSI

    by Yuki Hayashi, Hirohiko Tanaka, Shin Kajita, Noriyasu Ohno, Dogyun Hwangbo, Jordy Vernimmen, John Scholten, Hennie van der Meiden, Ivo Classen, Thomas Morgan

    Pulsed plasma experiments simulating the transient divertor heat loads caused by edge-localized modes (ELMs) were conducted in Magnum-PSI, a linear plasma device capable of generating ITER-relevant conditions. The dynamic responses of detached recombining helium (He) plasmas to the pulsed plasma were observed through time-resolved laser Thomson scattering measurements and optical emission spectroscopy. Experimental results indicate that He atom depletion occurs in high-density pulsed plasmas due to a reduced mean-free-path and increased plasma pressure. This limits plasma-neutral interactions, suppressing energy dissipation via direct excitation and electron–ion recombination processes. The He II and He I emissions were found to peak sequentially, suggesting that doubly-ionized He ions recombine first, followed by the recombination of singly-ionized He ions. These findings suggest that the neutral penetration and recombination efficiency are significantly reduced in pulsed plasmas, challenging heat flux mitigation in fusion divertors. The results provide critical insights into the behavior of He ash transported by ELMs and plasma detachment under high-density pulsed conditions, highlighting the need for further studies on neutral fueling strategies in ITER-relevant environments.


  • Open Access

    Behavior of detached simulation plasma by suddenly changed particle flux in GAMMA 10/PDX

    by Masayuki Yoshikawa, Junko Kohagura, Naomichi Ezumi, Tsuyoshi Kariya, Ryutaro Minami, Tomoharu Numakura, Mafumi Hirata, Satoshi Togo, Mizuki Sakamoto, Yousuke Nakashima, et al.

    Plasma detachment is one of the most significant factors affecting nuclear fusion reactors. GAMMA 10/PDX has a divertor simulation experimental module (D-module) for detached plasma studies in the end region. To investigate the effect of suddenly changing the higher-density particle flux into the detached plasma condition, similar to edge-localized mode simulations, we performed supersonic molecular beam injection (SMBI) and electron cyclotron heating (ECH) experiments to produce a higher-density and higher-temperature core plasma and introduced it to the divertor simulation plasma in the D-module. With the application of ECH, the detached plasma moved to the attached condition. Moreover, with the injection of SMBI into the ECH-injected plasma, the attached plasma moved to a detached condition. This study revealed the effect of sudden changes in the particle flux on detached simulation plasma for the first time.


  • Machine learning aided line intensity ratio method for helium–hydrogen mixed recombining plasmas

    by Shin Kajita, Daisuke Nishijima, Keisuke Fujii, Hirohiko Tanaka, Jordy Vernimmen, Hennie van der Meiden, Ivo Classen, Noriyasu Ohno

    The helium line intensity ratio (LIR) with the help of a collisional radiative (CR) model has long been used to measure the electron density, n e , and temperature, T e , and its potential and limitations for fusion applications have been discussed. However, it has been reported that the CR model approach leads to deviations in helium–hydrogen mixed plasmas and/or recombining plasmas. In this study, a machine learning (ML) aided LIR method is used to measure n e and T e from spectroscopic data of helium–hydrogen mixed recombining plasmas in the divertor simulator Magnum-PSI. To analyze mixed plasmas, which have more complex spectral shapes, the spectroscopy data were used directly for training instead of separating the intensities of each line. It is shown that the ML approach can provide a robust and simpler analysis method to deduce n e and T e from the visible emissions in helium–hydrogen mixed plasmas.


  • Plasma rotation and axial flow velocities in Magnum-PSI from cross-correlation measurements

    by C Costin, I Mihaila, H J van der Meiden, H Tanaka, J Scholten, H J N van Eck

    The plasma flow velocity in the azimuthal and axial directions was estimated from a cross-correlation analysis of ion saturation currents measured across the plasma column of Magnum-PSI using a 64-probe matrix acting as target. The radial profile of the plasma rotation velocity in azimuthal direction revealed a reversed rotation at larger radii (r > 12–16 mm, depending on the magnetic field strength). The result was confirmed by comparison with the azimuthal velocity calculated as the sum of the E × B drift (estimated from the radial profile of the plasma potential) and the diamagnetic drift (estimated from the radial profile of the ion pressure). The reversed rotation was associated with the electron current path in Magnum-PSI. The axial velocity was estimated based on the rotation velocity and cross-correlation measurements with a tilted target. Both the azimuthal and axial velocities are of the order of km s−1, corresponding to previously reported results obtained by optical methods.


  • Advances in Magnum-PSI probe diagnosis in support of plasma–surface interaction studies

    by C Costin, I Mihaila, H J van der Meiden, J Scholten, H J N van Eck, J W M Vernimmen

    Magnum-PSI is a linear plasma generator equipped with a superconducting magnet, assuring fusion devices relevant conditions at plasma–surface interface. The plasma column was diagnosed using 64 probes embedded in the target. The cross-sectional distributions of plasma parameters (floating potential, ion saturation current and electron temperature) were measured for hydrogen and deuterium plasmas under various discharge conditions. The radial profile of the floating potential across the plasma column can be described by a reversed Mexican hat-like wavelet, having the most negative potential at the center of the plasma column. The negativity of the floating potential diminishes when the discharge current increases or the magnetic field decreases. The axial gradient of the floating potential is reduced by increasing the magnetic field. The ion saturation current is maximum at the center of the plasma column, increasing with both the discharge current and magnetic field. The ion flux to the target, estimated from Thomson scattering (TS) data, was confirmed by probe measurements. The electron temperature estimated from the ion branch of the probe current–voltage characteristic is few times larger than that obtained from TS. By increasing the gas pressure in the target chamber, the time-dependent ion saturation current measured by probes changes from a constant average current (when the plasma column is attached to the target) to a fluctuating average current with scattered peaks (in a partially detached regime) which vanishes completely in the fully detached regime. With respect to hydrogen, the plasma column is wider in deuterium and is characterized by less negative floating potential distributions.


  • Reduction of pulsed particle load with dynamic pressure induced by transient recycled neutral flux

    by Yuki Hayashi, Hirohiko Tanaka, Noriyasu Ohno, Shin Kajita, Thomas Morgan, Hennie van der Meiden, John Scholten, Jordy Vernimmen, Hiroki Natsume, Keiji Sawada, et al.

    From pulsed plasma experiments focusing on neutral pressure dependence, the impacts of a transition from a low to a high recycling target on the particle load were investigated and discussed in the linear plasma device, Magnum-PSI. Time traces of the target ion flux were mitigated in high neutral pressure cases because of a plasma-neutral interaction. On the other hand, in low neutral-pressure cases, the target ion flux indicated partial suppression in the last part of the pulse. The Langmuir probe, located 200 mm upstream from the target plate, did not exhibit such a suppression. Pulse suppression can be expected from the localized interaction between recycled neutral flux and pulsed plasma in front of the target. The mean-free paths of recycled neutral particles regarding the charge exchange with pulse ions and elastic scattering with background neutral particles were compared. Modeling using a fluid code coupled with a neutral transport code was performed, and it was concluded that dynamic pressure induced by the transient recycled neutral flux caused sufficient momentum loss to stagnate the pulsed plasma toward the target plate.


  • Open Access

    Latest results of Eurofusion plasma-facing components research in the areas of power loading, material erosion and fuel retention

    by M. Reinhart, S. Brezinsek, A. Kirschner, J.W. Coenen, T. Schwarz-Selinger, K. Schmid, A. Hakola, H. van der Meiden, R. Dejarnac, E. Tsitrone, et al.

    The interaction between the edge-plasma in a fusion reactor and the surrounding first-wall components is one of the main issues for the realisation of fusion energy power plants. The EUROfusion Work Package on plasma-facing components addresses the key areas of plasma-surface interaction in view of ITER and DEMO operation, which are mostly related to material erosion, surface damage and fuel retention. These aspects are both investigated experimentally (in tokamaks, linear plasma devices and lab experiments) and by modelling. Here, selective results regarding the main research topics are presented: in the area of tungsten (W) surface modifications, the interplay between W fuzz formation and W fuzz erosion depends strongly on the local plasma and surface conditions, as demonstrated by tokamak experiments. Complementary, experimental findings on the dependence of erosion on the surface structure in lab-scale experiments have led to the successful implementation of surface structure effects in numerical modelling. The qualification of ITER-like monoblocks at high fluences of up to 1031 D m−2 in linear plasma facilities has shown no visible damages at cold plasma conditions. However, experiments with simultaneous plasma and pulsed heat loading (edge-localized modes simulations) show that synergistic effects can lower the W damage thresholds. Additionally, fuel retention studies show that nitrogen as a plasma impurity increases the fuel retention in W, and that deuterium implanted in the surface of W is capable of stabilizing displacement damages caused by neutron damage. Finally, the implications of these results on ITER and DEMO operation are discussed and an outlook on follow-up experiments is given: the results indicate that there are possible impacts on the ITER divertor lifetime and tritium removal. Other areas like the divertor shaping and the erosion need additional investigations in the future to quantify the impact on ITER and DEMO operation.


  • Open Access

    Study of detached plasma profile in the divertor simulation experimental module of tandem mirror GAMMA 10/PDX

    by M. Yoshikawa, J. Kohagura, N. Ezumi, T. Iijima, K. Nojiri, A. Terakado, Y. Nakashima, T. Kariya, T. Numakura, M. Hirata, et al.

    A divertor simulation experimental module (D-module) in the tandem mirror GAMMA 10/PDX was used for the study of plasma detachment. In previous studies, it was difficult to measure far-upstream plasma parameters in the D-module, and only electrostatic probes on the target plate were used to perform electron temperature and density measurements. To study the detached plasma structure, a Thomson scattering (TS) system and a microwave interferometer system have been installed to measure the inside plasma parameters of the D-module, and a movable electrostatic probe has been placed at the inlet of the D-module to measure the inlet plasma density and temperature. The TS system in the central cell observed the electron temperature and density of the core plasma simultaneously. These measurements revealed the entire density and temperature structure from the core plasma to the divertor plate. The line average electron density measured by the microwave interferometer showed a rollover behavior during detachment. The results indicated that the ionization region was located around the center of the D-module, and it appears to move upstream along the axis.


  • Quantification of hydrogen isotopes by CF-LIBS in a W-based material (WZr) at atmospheric pressure: from ns towards ps

    by A Marín Roldán, V Dwivedi, M Veis, S Atikukke, H van der Meiden, M Držík, P Veis

    Tungsten-based materials are possible candidates as PFCs in future fusion devices. LIBS is one of the most suitable techniques for monitoring erosion and deposition processes including fuel retention, due to its versatility and ability to perform in situ measurements. By deploying ps-LIBS, instead of ns, the laser ablation occurs with fewer melting effects. This work compares ns- and ps- (CF)-LIBS characterization of WZr(D) samples, at the linear plasma generator at Magnum-PSI at the DIFFER. The laser energy has been optimized for both laser regimes, lowering the laser energy for the ns regime (from 19.9 mJ pulse −1 to 7.4 mJ pulse −1 ) to approximate to ps regime (0.3 mJ pulse −1 ). All the experimental measurements have been performed at P atm . The pure WZr samples have been analyzed in ambient air, while the WZrD sample measurements have been performed under Ar gas flow. The retained deuterium content varies from 4 at% to 0.3 at%.