Beidou Xi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Beidou Xi has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Rengui Weng
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
3 shared publications Feng Tian
Indoor Environment Engineering Research Center of Fujian Province, Fujian University of Technology, Fuzhou, 350118, China
2 shared publications- Feng Tian
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
2 shared publications - Guohong Chen
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
2 shared publications - Xin Huang
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
2 shared publications - Dongqi Liao
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
1 shared publication
Latest Publications
- Open Access
Geochemical Characteristics of Tailings from Typical Metal Mining Areas in Tibet Autonomous Region
With the exploring and developing of mineral resources in the Tibet Autonomous Region for many years, a large number of tailings have been produced. A total of 17 tailings samples from borehole cores were collected from different tailings ponds in different regions of Tibet. The results showed that the mineral composition and content of tailings in each research area were different. Among them, quartz was the most abundant mineral in most tailings. The major elements of tailings mainly included Si, Al, Fe, Mg, Mn, Ca, Na, K and so on. S existed in different types of tailings. In the analysis of trace element composition, it was found that the content of some elements had approached the lowest industrial grade, which has potential recycling value, such as Mn, Zn, Pb and P. Through the detection of radioactive elements (Ra-226, Th-232 and K-40), it was shown that there were great differences among different types of tailings, and their different contents would bring potential hazards to the safety of the surrounding environment and human health. Similar results were found in the analysis of particle size characteristics of tailings. These results are of great significance for the future utilization and resource utilization of tailings pond.
Open AccessGeochemical Characteristics of Tailings from Typical Metal Mining Areas in Tibet Autonomous Region
With the exploring and developing of mineral resources in the Tibet Autonomous Region for many years, a large number of tailings have been produced. A total of 17 tailings samples from borehole cores were collected from different tailings ponds in different regions of Tibet. The results showed that the mineral composition and content of tailings in each research area were different. Among them, quartz was the most abundant mineral in most tailings. The major elements of tailings mainly included Si, Al, Fe, Mg, Mn, Ca, Na, K and so on. S existed in different types of tailings. In the analysis of trace element composition, it was found that the content of some elements had approached the lowest industrial grade, which has potential recycling value, such as Mn, Zn, Pb and P. Through the detection of radioactive elements (Ra-226, Th-232 and K-40), it was shown that there were great differences among different types of tailings, and their different contents would bring potential hazards to the safety of the surrounding environment and human health. Similar results were found in the analysis of particle size characteristics of tailings. These results are of great significance for the future utilization and resource utilization of tailings pond.
- Open Access
Preparation and Characterization of Regenerated Cellulose Membrane Blended with ZrO2 Nanoparticles
It is of great significance to search for efficient, renewable, biodegradable and economical membrane materials. Herein, we developed an organic-inorganic hybrid regenerated cellulose membrane (ZrO2/BCM) with excellent hydrophilic and anti-fouling properties. The membrane was prepared by introducing ZrO2 particles into an N-Methylmorpholine-N-oxide(NMMO)/bamboo cellulose(BC) solution system by the phase inversion method. The physi-chemical structure of the membranes were characterized based on thermal gravimetric analysis (TGA), Fourier transform infrared spectroscopy (ATR-FTIR), field emission scanning electron microscopy (FE-SEM), and X-ray diffraction (XRD). The modified regenerated cellulose membrane has the excellent rejection of bovine serum albumin (BSA) and anti-fouling performance. The membrane flux of ZrO2/BCM is 321.49 (L/m2·h), and the rejection rate of BSA is 91.2%. Moreover, the membrane flux recovery rate after cleaning with deionized water was 90.6%. This new type of separation membrane prepared with green materials holds broad application potential in water purification and wastewater treatment.
Open AccessPreparation and Characterization of Regenerated Cellulose Membrane Blended with ZrO2 Nanoparticles
It is of great significance to search for efficient, renewable, biodegradable and economical membrane materials. Herein, we developed an organic-inorganic hybrid regenerated cellulose membrane (ZrO2/BCM) with excellent hydrophilic and anti-fouling properties. The membrane was prepared by introducing ZrO2 particles into an N-Methylmorpholine-N-oxide(NMMO)/bamboo cellulose(BC) solution system by the phase inversion method. The physi-chemical structure of the membranes were characterized based on thermal gravimetric analysis (TGA), Fourier transform infrared spectroscopy (ATR-FTIR), field emission scanning electron microscopy (FE-SEM), and X-ray diffraction (XRD). The modified regenerated cellulose membrane has the excellent rejection of bovine serum albumin (BSA) and anti-fouling performance. The membrane flux of ZrO2/BCM is 321.49 (L/m2·h), and the rejection rate of BSA is 91.2%. Moreover, the membrane flux recovery rate after cleaning with deionized water was 90.6%. This new type of separation membrane prepared with green materials holds broad application potential in water purification and wastewater treatment.
- 1 December 2021
- Published by Elsevier in Chemosphere
- Vol. 285, 131542
Efficient mineralization of TBBPA via an integrated photocatalytic reduction/oxidation process mediated by MoS2/SnIn4S8 photocatalyst
- 1 December 2021
- Published by Elsevier in Chemosphere
- Vol. 285, 131542
Efficient mineralization of TBBPA via an integrated photocatalytic reduction/oxidation process mediated by MoS2/SnIn4S8 photocatalyst
- Open Access
- 14 June 2021
- Published by IWA Publishing in Water Supply
- Vol. 21 (8) , 4355-4368
Preparation of cellulose nanofiltration membranes and their removal of typical pollutants from drinking water
Cellulose membranes have the advantages of good hydrophilicity, excellent mechanical properties, and biodegradability. Therefore, they are the first choice to replace petroleum polymer membranes. In this study, cellulose (BC) and chitosan (CS) were used as raw materials, and N-methylmorpholine-N-oxide (NMMO) was used as solvent. A new kind of cellulose nanofiltration membrane (BC-NFM), cellulose/chitosan nanofiltration membrane (BC/CS-NFM), and interfacial polymerized cellulose/chitosan composite nanofiltration membrane (IP-BC/CS-NFM) were successfully prepared by NaOH hydrolysis and chloroacetic acid carboxymethylation modification, piperazine (PIP), and 1,3,5-trimellitic chloride (TMC) interfacial polymerization, respectively. These two methods were used for the preparation of cellulose nanofiltration membranes for the first time.We also studied their structure, separation performance and their capacity to remove typical pollutants. The results showed that obvious holes appeared on the surface of the nanofiltration membrane obtained by alkali hydrolysis and chloroacetic acid carboxymethylation modification, and the cross-section showed a spongelike structure. The surface of the nanofiltration membrane obtained by interfacial polymerization formed a rough and dense separation layer. The rejection rates of the three kinds of nanofiltration membranes were all over 30% for monovalent salt ions, over 60% for divalent salt ions, over 92% for methyl orange, and over 98% for methyl blue. They had good removal effects for typical pollutants in drinking water.
- 14 June 2021
- Published by IWA Publishing in Water Supply
- Vol. 21 (8) , 4355-4368
Open AccessPreparation of cellulose nanofiltration membranes and their removal of typical pollutants from drinking water
Cellulose membranes have the advantages of good hydrophilicity, excellent mechanical properties, and biodegradability. Therefore, they are the first choice to replace petroleum polymer membranes. In this study, cellulose (BC) and chitosan (CS) were used as raw materials, and N-methylmorpholine-N-oxide (NMMO) was used as solvent. A new kind of cellulose nanofiltration membrane (BC-NFM), cellulose/chitosan nanofiltration membrane (BC/CS-NFM), and interfacial polymerized cellulose/chitosan composite nanofiltration membrane (IP-BC/CS-NFM) were successfully prepared by NaOH hydrolysis and chloroacetic acid carboxymethylation modification, piperazine (PIP), and 1,3,5-trimellitic chloride (TMC) interfacial polymerization, respectively. These two methods were used for the preparation of cellulose nanofiltration membranes for the first time.We also studied their structure, separation performance and their capacity to remove typical pollutants. The results showed that obvious holes appeared on the surface of the nanofiltration membrane obtained by alkali hydrolysis and chloroacetic acid carboxymethylation modification, and the cross-section showed a spongelike structure. The surface of the nanofiltration membrane obtained by interfacial polymerization formed a rough and dense separation layer. The rejection rates of the three kinds of nanofiltration membranes were all over 30% for monovalent salt ions, over 60% for divalent salt ions, over 92% for methyl orange, and over 98% for methyl blue. They had good removal effects for typical pollutants in drinking water.