Xu Zhao

To meet the energy-saving requirements of user equipment (UE) operating in Radio Resource Control idle/inactive states (RRC_IDLE/RRC_INACTIVE) in the 3rd-Generation Partnership Project (3GPP) 5G-Advanced (5G-A) networks, the New Radio (NR) downlink paging procedure relies on periodic monitoring and frequent synchronization signal block (SSB) measurements, which wastes energy when no paging arrivals occur. Meanwhile, heterogeneous Quality of Service (QoS) constraints make it difficult for fixed-parameter Idle Discontinuous Reception and Paging Early Indication mechanisms (IDRX/PEI) to balance energy, delay, and reliability. This paper develops a UAV-assisted 5G-A paging control framework that maps services into multiple QoS classes and models QoS violation risk and system energy consumption under unified accounting, including UE monitoring/reception energy and unmanned aerial vehicle (UAV) forwarding energy. We then propose a QoS-aware risk-driven paging strategy: an offline Long Short-Term Memory (LSTM) predictor is trained to estimate the time-to-next-arrival (TTNA) of paging events and produce a bounded urgency/risk signal to initialize class-dependent thresholds, while online triggering and QoS-feedback-based threshold adaptation regulate the empirical violation rate toward target constraints under varying loads, enabling a controllable energy–delay trade-off. A simulation-based evaluation is conducted to compare the proposed method with representative baselines (Enhanced Paging Monitoring (EPM), Split Paging Occasion (SPOP), and Predicted Paging Early Indication (PPEI)) and to examine the impact of SSB overhead and UAV relaying on the energy–delay–reliability trade-offs.

Due to the shortage of wireless resources and the emergence of a large number of users, determining how to guarantee the quality-of-service (QoS) requirements of users and make more users work in the same spectrum has become an urgent research topic. In this paper, we study a multi-user MIMO (MU-MIMO) cellular network system model in which cellular users (CUs) share the same spectrum resource with multiple device-to-device (D2D) pairs. To maximize the number of admitted D2D pairs sharing the same spectrum with the CUs, a joint power allocation and channel gain (JPACG) algorithm is proposed. The optimization problem is divided into two steps to be solved. First, the power allocation of CUs without D2D pairs admitted is solved. Then, the optimization problem is transformed into minimizing the interference to CUs when CUs are treated as primary users. The admittance order of D2D pairs is determined by the transmission power and channel gain. The proposed algorithm uses a convex optimization algorithm to solve the problem of power allocation joint interference channel gain in order to maximize the number of admitted D2D pairs under the constraints of the signal-to-interference-plus-noise ratio (SINR) threshold and maximum transmission power. In addition, the effect of the number of admitted D2D pairs on the total sum rate of all users is also analyzed. The simulation results show that the proposed JPACG algorithm can achieve better performance in admitting D2D pairs.

Participatory crowdsensing (PCS) is an innovative data sensing paradigm that leverages the sensors carried in mobile devices to collect large-scale environmental information and personal behavioral data with the user’s participation. In PCS, task assignment and path planning pose complex challenges. Previous studies have only focused on the assignment of individual tasks, neglecting or overlooking the associations between tasks. In practice, users often tend to execute similar tasks when choosing assignments. Additionally, users frequently engage in tasks that do not match their abilities, leading to poor task quality or resource wastage. This paper introduces a multi-task assignment and path-planning problem (MTAPP), which defines utility as the ratio of a user’s profit to the time spent on task execution. The optimization goal of MATPP is to maximize the utility of all users in the context of task assignment, allocate a set of task locations to a group of workers, and generate execution paths. To solve the MATPP, this study proposes a grade-matching degree and similarity-based mechanism (GSBM) in which the grade-matching degree determines the user’s income. It also establishes a mathematical model, based on similarity, to investigate the impact of task similarity on user task completion. Finally, an improved ant colony optimization (IACO) algorithm, combining the ant colony and greedy algorithms, is employed to maximize total utility. The simulation results demonstrate its superior performance in terms of task coverage, average task completion rate, user profits, and task assignment rationality compared to other algorithms.

This paper presents a binary orthogonal keying (BOK) incorporating M-ary phase shift keying (MPSK) modulation for Chirp transmission system. The BOK-MPSK symbol applies both BOK and phasing shift keying as modulation schemes, rather than using chirp as a spreading sequence. The system model and receiving algorithm of BOK-MPSK are presented in this paper. A BOK-MPSK signal is recovered by chirp correlation and judgement. The performance of bit error rate for BOK-MPSK has been analysed in contrast with MPSK. Simulations of bit error rate comparison between BOK-MPSK and MPSK are assessed, which are in accordance with theoretical analysis. It indicates that BOK-MPSK has advantageous of demodulation performance as well as bandwidth spectrum efficiency.

Spectrum sensing in Cognitive radio (CR) is a way to improve spectrum utilization by detecting spectral holes to achieve a dynamic allocation of spectrum resources. As it is often difficult to obtain accurate wireless environment information in real-world scenarios, the detection performance is limited. Signal-to-noise ratio (SNR), noise variance, and channel prior occupancy rate are critical parameters in wireless spectrum sensing. However, obtaining these parameter values in advance is challenging in practical scenarios. A lifting wavelet-assisted Expectation-Maximization (EM) joint estimation and detection method is proposed to estimate multiple parameters and achieve full-blind detection, which uses lifting wavelet in noise variance estimation to improve detection probability and convergence speed. Moreover, a stream learning strategy is used in estimating SNR and channel prior occupancy rate to fit the scenario where the SU has mobility. The simulation results demonstrate that the proposed method can achieve comparable detection performance to the semi-blind EM method.

Full-duplex (FD), Device-to-Device (D2D) and non-orthogonal multiple access (NOMA) are promising wireless communication techniques to improve the utilization of spectrum resources. Meanwhile, introducing FD, D2D and NOMA in cellular networks is very challenging due to the complex interference problem. To deal with the complex interference of FD D2D underlaying NOMA cellular networks, power allocation (PA) is extensively studied as an efficient interference management technique. However, most of the previous research works on PA to optimize energy efficiency only consider the system framework of partially joint combining techniques of FD, D2D and NOMA, and the constraints of optimization problem are very different. In this paper, in order to further improve the energy efficiency of a system, a dual-layer iteration power allocation algorithm is proposed to eliminate the complex interference. The outer-layer iteration is to solve the non-linear fractional objective function based on Dinkelbach, and the inner-layer iteration is to solve the non-convex optimization problem based on D.C. programming. Then, the non-convex and non-linear fractional objective function is transformed into a convex function to solve the optimal power allocation. In this approach, FD D2D users reuse the spectrum with downlink NOMA cellular users. Imperfect self-interference (SI) cancellation at the FD D2D users and the successive interference cancellation (SIC) at the strong NOMA user are considered in the system framework. The optimization problem is constructed to maximize the system’s energy efficiency with the constraints of successful SIC, QoS requirements, the maximum transmit power of BS and FD D2D users. Numerical results demonstrate that the proposed algorithm outperforms the traditional orthogonal multiple access (OMA) in terms of energy efficiency with a higher system sum rate.