Monica Pazos Urrea
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Monica Pazos Urrea has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Magnus Rønning
Department of Chemical Engineering, Norwegian University of Science and Technology (NTNU), Sem Sælands vei 4, NO-7491 Trondheim, Norway
2 shared publications Andrea De Giacinto
Institute for Chemical Technology and Polymer Chemistry, Karlsruhe Institute of Technology, Engesserstraße 20, 76131 Karlsruhe, Germany
1 shared publication- Anna Zimina
Institute of Catalysis Research and Technology, Karlsruhe Institute of Technology (KIT), Hermann-von-Helmholtz-Platz 1, 76344 Eggenstein-Leopoldshafen, Germany
1 shared publication - Boelo Schuur
Sustainable Process Technology, Faculty of Science and Technology
1 shared publication De Chen
Department of Chemical Engineering, Norwegian University of Science and Technology, 7491 Trondheim, Norway
1 shared publicationEnrico Tusini
Institute for Chemical Technology and Polymer Chemistry, Karlsruhe Institute of Technology, Engesserstraße 20, 76131 Karlsruhe, Germany
1 shared publication
Latest Publications
- Open Access
- 20 April 2026
- Published by Elsevier in SSRN Electronic Journal
Layered double hydroxide-derived bimetallic catalysts for low temperature ammonia decomposition
Low-temperature ammonia decomposition over hydrotalcite-derived catalysts based on the transition metals Co, Ni, Fe and Mn was performed. Characterization techniques XRD, TPR, BET, and XRF were used to obtain structural and chemical information about the synthesized catalysts, including operando XAS/XRD characterization. The monometallic cobalt catalyst exhibited higher activity than the bimetallic catalysts, achieving a hydrogen production rate of 0.038 molH2 gcat-1 h-1 at 450˚C at WHSV of 120000 mL g-1 h-1 in 0.5% ammonia. The cobalt catalyst demonstrated high stability and resistance to sintering throughout the high temperature reduction treatment (800 °C) and 4 hours on stream ammonia decomposition at 400˚C. The stable catalytic performance despite high cobalt dispersion is attributed to the strong metal-support interactions derived from the uniform cobalt distribution in the layered double hydroxide precursor. For the catalysts studied, the addition of a secondary metal such as Ni, Fe, or Mn did not have any significant promotional effect, but reduced the activity of cobalt by blocking active sites and thus limiting the ability of the active phase to decompose ammonia. This demonstrates that LDH-derived materials are a promising alternative for designing catalysts with enhanced dispersion and thermal robustness to maintain high and stable ammonia conversion.
- 20 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessLayered double hydroxide-derived bimetallic catalysts for low temperature ammonia decomposition
Low-temperature ammonia decomposition over hydrotalcite-derived catalysts based on the transition metals Co, Ni, Fe and Mn was performed. Characterization techniques XRD, TPR, BET, and XRF were used to obtain structural and chemical information about the synthesized catalysts, including operando XAS/XRD characterization. The monometallic cobalt catalyst exhibited higher activity than the bimetallic catalysts, achieving a hydrogen production rate of 0.038 molH2 gcat-1 h-1 at 450˚C at WHSV of 120000 mL g-1 h-1 in 0.5% ammonia. The cobalt catalyst demonstrated high stability and resistance to sintering throughout the high temperature reduction treatment (800 °C) and 4 hours on stream ammonia decomposition at 400˚C. The stable catalytic performance despite high cobalt dispersion is attributed to the strong metal-support interactions derived from the uniform cobalt distribution in the layered double hydroxide precursor. For the catalysts studied, the addition of a secondary metal such as Ni, Fe, or Mn did not have any significant promotional effect, but reduced the activity of cobalt by blocking active sites and thus limiting the ability of the active phase to decompose ammonia. This demonstrates that LDH-derived materials are a promising alternative for designing catalysts with enhanced dispersion and thermal robustness to maintain high and stable ammonia conversion.
- Open Access
- 4 March 2024
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 14 (6) , 4139-4154
Aqueous Phase Reforming over Platinum Catalysts on Doped Carbon Supports: Exploring Platinum–Heteroatom Interactions
A series of platinum catalysts supported on carbon nanofibers with various heteroatom dopings were synthesized to investigate the effect of the local platinum environment on the catalytic activity and selectivity in aqueous phase reforming (APR) of ethylene glycol (EG). Typical carbon dopants such as oxygen, nitrogen, sulfur, phosphorus, and boron were chosen based on their ability to bring acidic or basic functional groups to the carbon surface. In situ X-ray absorption spectroscopy (XAS) was used to identify the platinum oxidation state and platinum species formed during APR of EG through multivariate curve resolution alternating least-squares analysis, observing differences in activity, selectivity, and platinum local environment among the catalysts. The platinum-based catalyst on the nitrogen-doped carbon support demonstrated the most favorable properties for H2 production due to high Pt dispersion and basicity (H2 site time yield 22.7 h-1). Direct Pt-N-O coordination was identified by XAS in this catalyst. The sulfur-doped catalyst presented Pt-S contributions with the lowest EG conversion rate and minimal production of the gas phase components. Boron and phosphorus-doped catalysts showed moderate activity, which was affected by low platinum dispersion on the carbon support. The phosphorus-doped catalyst showed preferential selectivity to alcohols in the liquid phase, associated with the presence of acid sites and Pt-P contributions observed under APR conditions.
- 4 March 2024
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 14 (6) , 4139-4154
Open AccessAqueous Phase Reforming over Platinum Catalysts on Doped Carbon Supports: Exploring Platinum–Heteroatom Interactions
A series of platinum catalysts supported on carbon nanofibers with various heteroatom dopings were synthesized to investigate the effect of the local platinum environment on the catalytic activity and selectivity in aqueous phase reforming (APR) of ethylene glycol (EG). Typical carbon dopants such as oxygen, nitrogen, sulfur, phosphorus, and boron were chosen based on their ability to bring acidic or basic functional groups to the carbon surface. In situ X-ray absorption spectroscopy (XAS) was used to identify the platinum oxidation state and platinum species formed during APR of EG through multivariate curve resolution alternating least-squares analysis, observing differences in activity, selectivity, and platinum local environment among the catalysts. The platinum-based catalyst on the nitrogen-doped carbon support demonstrated the most favorable properties for H2 production due to high Pt dispersion and basicity (H2 site time yield 22.7 h-1). Direct Pt-N-O coordination was identified by XAS in this catalyst. The sulfur-doped catalyst presented Pt-S contributions with the lowest EG conversion rate and minimal production of the gas phase components. Boron and phosphorus-doped catalysts showed moderate activity, which was affected by low platinum dispersion on the carbon support. The phosphorus-doped catalyst showed preferential selectivity to alcohols in the liquid phase, associated with the presence of acid sites and Pt-P contributions observed under APR conditions.
- Open Access
- 2 July 2021
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 23 (16) , 5812-5824
Complex coacervates as extraction media
Macroscopic complex coacervates can be used to extract compounds from aqueous supernatants. Compound partitioning depends on the ionic strength, complex composition, and temperature. These findings show their potential as aqueous extraction media.
- 2 July 2021
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 23 (16) , 5812-5824
Open AccessComplex coacervates as extraction media
Macroscopic complex coacervates can be used to extract compounds from aqueous supernatants. Compound partitioning depends on the ionic strength, complex composition, and temperature. These findings show their potential as aqueous extraction media.