Henrique de Andrade Penido
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Henrique de Andrade Penido has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Alessandro Guimarães
Logging and Drilling Department, Geosol S.A, Belo Horizonte, Brazil
2 shared publicationsAndré Pacheco de Assis
Civil and Environmental Engineering Department, University of Brasilia, Brasilia, Brazil
2 shared publications- Juan Manuel Girao Sotomayor
Vale Institute of Technology, Ouro Preto, Brazil
2 shared publications Rodrigo Peluci de Figueiredo
School of Mines, Federal University of Ouro Preto, Ouro Preto, Brazil
2 shared publicationsVidal Félix Navarro Torres
Mining, Vale Technological Institute, Ouro Preto, Brazil
2 shared publicationsAkio Funato
Research Fellow, Fukada Geological Institute, Tokyo, Japan
1 shared publication
Latest Publications
- 3 September 2022
- Published by Taylor & Francis in Geomechanics and Geoengineering
- Vol. 17 (5) , 1670-1694
Application of the HF, DRA and DCDA technologies for in situ stress determination in Iron Quadrangle rock masses
This study presents an unprecedented campaign of measurements (magnitudes and orientations) of the in situ stresses in itabirite rocks of the Brazilian Iron Quadrangle region using the hydraulic fracturing (HF), deformation rate analysis (DRA) and diametrical core deformation analysis (DCDA) methods. The previous studies of this rock mass consider estimated values of k, and the practice of using in situ stress tests to support geotechnical analyses of the rock mass of this region has not been adopted. The study site is located at a depth of up to 400 m around a pit. The rock mass under study shows the presence of different geological structures, which made performing the tests difficult. The DRA results show a marked difference compared to the HF and DCDA results; the horizontal stresses were greater than the vertical stresses, which is a finding that may occur due to local geodynamic influences. The results contribute to the understanding of the strains and stresses induced by mining activities in the Brazilian Iron Quadrangle. For a better determination of the regional in situ stresses in the rock mass of the Brazilian Iron Quadrangle, new HF tests, as well as hydraulic testing of pre-existing fractures are recommended.
- 3 September 2022
- Published by Taylor & Francis in Geomechanics and Geoengineering
- Vol. 17 (5) , 1670-1694
Application of the HF, DRA and DCDA technologies for in situ stress determination in Iron Quadrangle rock masses
This study presents an unprecedented campaign of measurements (magnitudes and orientations) of the in situ stresses in itabirite rocks of the Brazilian Iron Quadrangle region using the hydraulic fracturing (HF), deformation rate analysis (DRA) and diametrical core deformation analysis (DCDA) methods. The previous studies of this rock mass consider estimated values of k, and the practice of using in situ stress tests to support geotechnical analyses of the rock mass of this region has not been adopted. The study site is located at a depth of up to 400 m around a pit. The rock mass under study shows the presence of different geological structures, which made performing the tests difficult. The DRA results show a marked difference compared to the HF and DCDA results; the horizontal stresses were greater than the vertical stresses, which is a finding that may occur due to local geodynamic influences. The results contribute to the understanding of the strains and stresses induced by mining activities in the Brazilian Iron Quadrangle. For a better determination of the regional in situ stresses in the rock mass of the Brazilian Iron Quadrangle, new HF tests, as well as hydraulic testing of pre-existing fractures are recommended.
- 22 August 2021
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 40 (3) , 1619-1627
Hydrofracturing in situ stress measurements of itabirite in the Brazilian Ferriferous Quadrangle and their limitations
- 22 August 2021
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 40 (3) , 1619-1627
Hydrofracturing in situ stress measurements of itabirite in the Brazilian Ferriferous Quadrangle and their limitations
- Open Access
- 27 July 2021
- Published by Springer Nature in Research Square
Hydrofracturing in Situ Stress Measurements in Itabirite Brazilian Ferriferous Quadrilater, and their Limitations
This article presents a first attempt to carry out measurements (magnitudes and orientations) of the in situ stress in itabirite rocks in the region of the Brazilian Ferriferous Quadrilater obtained by hydraulic fracture tests at a depth of 399 m. Previous studies available in this rock mass consider estimated values of k index (Sh / Sv), and it is not a practice adopted to carry out in situ stress tests in this region and rockmass to support geotechnical analysis. The area of study is located at a depth of 500 m in a pit; therefore, the determination of the in situ stress distribution is very important to assess the stability of the mining open pit. The activities, from the planning to the execution of the tests, and the results are presented. The rock mass under study shows the presence of different geological structures, such as banding and foliation, which resulted in difficulties with performing the tests, and only 12.5% of the tests were successful. The results contribute to understanding the strains and stresses induced by mining activities in slopes in the Brazilian Ferriferous Quadrilater and their impacts on surrounding structures. For a better determination of the regional in situ stresses in the rock mass of the Brazilian Ferriferous Quadrilater, it is recommended to perform hydraulic tests on pre-existing fractures.
- 27 July 2021
- Published by Springer Nature in Research Square
Open AccessHydrofracturing in Situ Stress Measurements in Itabirite Brazilian Ferriferous Quadrilater, and their Limitations
This article presents a first attempt to carry out measurements (magnitudes and orientations) of the in situ stress in itabirite rocks in the region of the Brazilian Ferriferous Quadrilater obtained by hydraulic fracture tests at a depth of 399 m. Previous studies available in this rock mass consider estimated values of k index (Sh / Sv), and it is not a practice adopted to carry out in situ stress tests in this region and rockmass to support geotechnical analysis. The area of study is located at a depth of 500 m in a pit; therefore, the determination of the in situ stress distribution is very important to assess the stability of the mining open pit. The activities, from the planning to the execution of the tests, and the results are presented. The rock mass under study shows the presence of different geological structures, such as banding and foliation, which resulted in difficulties with performing the tests, and only 12.5% of the tests were successful. The results contribute to understanding the strains and stresses induced by mining activities in slopes in the Brazilian Ferriferous Quadrilater and their impacts on surrounding structures. For a better determination of the regional in situ stresses in the rock mass of the Brazilian Ferriferous Quadrilater, it is recommended to perform hydraulic tests on pre-existing fractures.