Bing Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Bing Lu has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
Xun Zhang
3 shared publicationsJinchao Zhu
College of Safety Science and Engineering, Liaoning Technical University 1 , Fuxin, Liaoning 123000, China
2 shared publications- Jing Zhang
Inner Mongolia University of Science and Technology
2 shared publications Ling Qiao
2 shared publications- Bin Zeng
College of Mining Engineering, Liaoning Technical University 1 , Fuxin, Liaoning 123000, China
1 shared publication - Chengyun Wang
Key Laboratory for Advanced Materials and Institute of Fine Chemicals, School of Chemistry and Molecular Engineering, East China University of Science and Technology, Shanghai 200237, China
1 shared publication
Latest Publications
- Open Access
- 1 August 2022
- Published by AIP Publishing in AIP Advances
- Vol. 12 (8) , 085226
Experimental research on spontaneous combustion of coal oxidized by ultraviolet photocatalysis
To study the effect of ultraviolet light on the spontaneous combustion characteristics of coal, Lijiahao long-flame coal was selected for irradiation treatment with a self-made ultraviolet light irradiation device. After irradiation for 0, 1, 2, 4, and 8 h, thermogravimetric experiments and Fourier transform infrared spectroscopy experiments were carried out. Compared with the raw coal, the dry cracking temperature, the ignition point temperature, and the maximum weight loss rate temperature of coal samples irradiated for 2 h by ultraviolet light were advanced to different degrees. The ignition activation energy was 0.62, 0.56, 0.59, and 0.91 times that of the raw coal after 1, 2, 4, and 8 h of ultraviolet light irradiation. The ultraviolet light irradiation accelerated the oxidation of –CH3, –CH2−, and –OH, resulting in enhanced coal activity. It shows that ultraviolet light irradiation has a promoting effect on the spontaneous combustion of coal, and the best promotion effect is observed when ultraviolet light is irradiated for 2 h. After 2 h of ultraviolet light irradiation, compared with the raw coal, the content of ether group in the coal structure decreased by 6.79%, the content of methyl and methylene in the benzene ring decreased by 8.68%, the content of C=O and carboxylic acid increased by 30.21%, the content of hydroxy ether and hydroxyl π hydrogen bond decreased by 14.94%, and the content of self-associating hydroxyl hydrogen bonds increased by 16.59%. It shows that ultraviolet light can destroy aromatic hydrocarbons in coal, catalyze the hydrolysis reaction of esters and ethers in coal to generate –OH and –COOH, and promote the oxidative spontaneous combustion of coal.
- 1 August 2022
- Published by AIP Publishing in AIP Advances
- Vol. 12 (8) , 085226
Open AccessExperimental research on spontaneous combustion of coal oxidized by ultraviolet photocatalysis
To study the effect of ultraviolet light on the spontaneous combustion characteristics of coal, Lijiahao long-flame coal was selected for irradiation treatment with a self-made ultraviolet light irradiation device. After irradiation for 0, 1, 2, 4, and 8 h, thermogravimetric experiments and Fourier transform infrared spectroscopy experiments were carried out. Compared with the raw coal, the dry cracking temperature, the ignition point temperature, and the maximum weight loss rate temperature of coal samples irradiated for 2 h by ultraviolet light were advanced to different degrees. The ignition activation energy was 0.62, 0.56, 0.59, and 0.91 times that of the raw coal after 1, 2, 4, and 8 h of ultraviolet light irradiation. The ultraviolet light irradiation accelerated the oxidation of –CH3, –CH2−, and –OH, resulting in enhanced coal activity. It shows that ultraviolet light irradiation has a promoting effect on the spontaneous combustion of coal, and the best promotion effect is observed when ultraviolet light is irradiated for 2 h. After 2 h of ultraviolet light irradiation, compared with the raw coal, the content of ether group in the coal structure decreased by 6.79%, the content of methyl and methylene in the benzene ring decreased by 8.68%, the content of C=O and carboxylic acid increased by 30.21%, the content of hydroxy ether and hydroxyl π hydrogen bond decreased by 14.94%, and the content of self-associating hydroxyl hydrogen bonds increased by 16.59%. It shows that ultraviolet light can destroy aromatic hydrocarbons in coal, catalyze the hydrolysis reaction of esters and ethers in coal to generate –OH and –COOH, and promote the oxidative spontaneous combustion of coal.
- Open Access
- 1 August 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (8) , 085205
Molecular simulation of C2H4/CO2/N2/O2 adsorption characteristics in lignite and anthracite
As an index gas of spontaneous combustion, C2H4 has been used in several coal mines, but its adsorption on residual coal during the process from generation to sampling has an impact on evaluation. The molecular structure models of lignite and anthracite were constructed through molecular mechanics and dynamics, and the Grand Canonical Monte Carlo systems were used to simulate the adsorption of C2H4 and other common gases on lignite and anthracite at temperatures of 288.15–318.15 K. The order of adsorption capacity was CO2 > C2H4 > O2 > N2 in the lignite and anthracite molecular models within the low-pressure zone. When the pressure increases, the adsorption capacity of O2 and N2 exceeded that of C2H4. The C2H4 and CO2 have similar and concentrated adsorption sites, and it is easier to reach the limit adsorption capacity; O2 and N2 have similar adsorption sites, the number of sites is much more than that of C2H4 and CO2, and their limit adsorption capacities are larger than those of C2H4 and CO2. When C2H4 is monitored in a goaf, its concentration is not quite accurate because of the adsorption of residual coal, which is different from the detected temperature of the C2H4 concentration obtained from the experiment. This is of great significance to further experiments and more on-site data statistics to fix the problem for coal mines.
- 1 August 2021
- Published by AIP Publishing in AIP Advances
- Vol. 11 (8) , 085205
Open AccessMolecular simulation of C2H4/CO2/N2/O2 adsorption characteristics in lignite and anthracite
As an index gas of spontaneous combustion, C2H4 has been used in several coal mines, but its adsorption on residual coal during the process from generation to sampling has an impact on evaluation. The molecular structure models of lignite and anthracite were constructed through molecular mechanics and dynamics, and the Grand Canonical Monte Carlo systems were used to simulate the adsorption of C2H4 and other common gases on lignite and anthracite at temperatures of 288.15–318.15 K. The order of adsorption capacity was CO2 > C2H4 > O2 > N2 in the lignite and anthracite molecular models within the low-pressure zone. When the pressure increases, the adsorption capacity of O2 and N2 exceeded that of C2H4. The C2H4 and CO2 have similar and concentrated adsorption sites, and it is easier to reach the limit adsorption capacity; O2 and N2 have similar adsorption sites, the number of sites is much more than that of C2H4 and CO2, and their limit adsorption capacities are larger than those of C2H4 and CO2. When C2H4 is monitored in a goaf, its concentration is not quite accurate because of the adsorption of residual coal, which is different from the detected temperature of the C2H4 concentration obtained from the experiment. This is of great significance to further experiments and more on-site data statistics to fix the problem for coal mines.
- Open Access
- 3 June 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-11
Molecular simulation of gases competitive adsorption in lignite and analysis of original CO desorption
To study the adsorption characteristics of CO, CO2, N2, O2, and their binary-components in lignite coal, reveal the influence of CO2 or N2 injection and air leakage on the desorption of CO in goafs, a lignite model (C206H206N2O44) was established, and the supercell structure was optimized under temperatures of 288.15–318.15 K for molecular simulation. Based on molecular dynamics, the Grand Canonical Monte Carlo method was used to simulate the adsorption characteristics and the Langmuir equation was used to fit the adsorption isotherms of gases. The results show that for single-components, the order of adsorption capacity is CO2 > CO > O2 > N2. For binary-components, the competitive adsorption capacities of CO2 and CO are approximate. In the low-pressure zone, the competitive adsorption capacity of CO2 is stronger than that of CO, and the CO is stronger than N2 or O2. From the simulation, it can be seen that CO2, N2 or O2 will occupy adsorption sites, causing CO desorption. Therefore, to prevent the desorption of the original CO in the goaf, it is not suitable to use CO2 or N2 injection for fire prevention, and the air leakage at the working faces need to be controlled.
- 3 June 2021
- Published by Springer Nature in Scientific Reports
- Vol. 11 (1) , 1-11
Open AccessMolecular simulation of gases competitive adsorption in lignite and analysis of original CO desorption
To study the adsorption characteristics of CO, CO2, N2, O2, and their binary-components in lignite coal, reveal the influence of CO2 or N2 injection and air leakage on the desorption of CO in goafs, a lignite model (C206H206N2O44) was established, and the supercell structure was optimized under temperatures of 288.15–318.15 K for molecular simulation. Based on molecular dynamics, the Grand Canonical Monte Carlo method was used to simulate the adsorption characteristics and the Langmuir equation was used to fit the adsorption isotherms of gases. The results show that for single-components, the order of adsorption capacity is CO2 > CO > O2 > N2. For binary-components, the competitive adsorption capacities of CO2 and CO are approximate. In the low-pressure zone, the competitive adsorption capacity of CO2 is stronger than that of CO, and the CO is stronger than N2 or O2. From the simulation, it can be seen that CO2, N2 or O2 will occupy adsorption sites, causing CO desorption. Therefore, to prevent the desorption of the original CO in the goaf, it is not suitable to use CO2 or N2 injection for fire prevention, and the air leakage at the working faces need to be controlled.
- 13 October 2015
- Published by Zhejiang University Press in Frontiers of Information Technology & Electronic Engineering
- Vol. 16 (10) , 848-857
Fault evolution-test dependency modeling for mechanical systems
Tracking the process of fault growth in mechanical systems using a range of tests is important to avoid catastrophic failures. So, it is necessary to study
- 13 October 2015
- Published by Zhejiang University Press in Frontiers of Information Technology & Electronic Engineering
- Vol. 16 (10) , 848-857
Fault evolution-test dependency modeling for mechanical systems
Tracking the process of fault growth in mechanical systems using a range of tests is important to avoid catastrophic failures. So, it is necessary to study
- 1 April 1995
- Published by Elsevier in Journal of Chromatography A
- Vol. 697 (1-2) , 317-327
Indirect detection of saccharides in reversed-phase liquid chromatography with highly alkaline mobile phases
- 1 April 1995
- Published by Elsevier in Journal of Chromatography A
- Vol. 697 (1-2) , 317-327
Indirect detection of saccharides in reversed-phase liquid chromatography with highly alkaline mobile phases
- 1 July 1992
- Published by Elsevier in Nanostructured Materials
- Vol. 1 (4) , 347-353
On the thermal stability of pure and doped SnO2 ultrafine particles
- 1 July 1992
- Published by Elsevier in Nanostructured Materials
- Vol. 1 (4) , 347-353
On the thermal stability of pure and doped SnO2 ultrafine particles