LNLes Norman

Les Norman

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Les Norman has a total of 6 co-authors. Here are the top co-authors by number of shared publications:

  • Alina Zabnienska- Gora

    Heat Pipe and Thermal Management Research Group, College of Engineering, Design and Physical Sciences, Brunel University London, London UB8 3PH, UK

    1 shared publication
  • Darem Ahmad

    Heat Pipe and Thermal Management Research Group, College of Engineering, Design and Physical Sciences, Brunel University London, Uxbridge, London UB8 3PH, UK

    1 shared publication
  • Hussam Jouhara

    Heat Pipe and Thermal Management Research Group, College of Engineering, Design and Physical Sciences, Brunel University, London, U.K.

    1 shared publication
  • Lujean Ahmad

    Heat Pipe and Thermal Management Research Group, College of Engineering, Design and Physical Sciences, Brunel University London, Uxbridge, London UB8 3PH, UK

    1 shared publication
  • Navid Khordehgah

    Heat Pipe and Thermal Management Research Group, College of Engineering, Design and Physical Sciences, Brunel University London, Uxbridge, London UB8 3PH, UK

    1 shared publication
  • Qusay Doraghi

    Heat Pipe and Thermal Management Research Group, College of Engineering, Design and Physical Sciences, Brunel University London, Uxbridge, London UB8 3PH, UK

    1 shared publication

Latest Publications

  • Open Access

    Investigation and Computational Modelling of Variable TEG Leg Geometries

    by Qusay Doraghi, Navid Khordehgah, Alina Żabnieńska-Góra, Lujean Ahmad, Les Norman, Darem Ahmad, Hussam Jouhara

    In this work, computational modelling and performance assessment of several different types of variable thermoelectric legs have been performed under steady-state conditions and the results reviewed. The study conducted has covered geometries, not previously analysed in the literature, such as Cone-leg and Diamond-leg, based on the corresponding thermoelectric generator leg shape structure. According to the findings, it has been demonstrated that the inclusion of a variable cross-section can have an impact on the efficiency of a thermoelectric generator. It has been concluded that the Diamond configuration generated a slightly larger voltage difference than the conventional Rectangular geometry. In addition, for two cases, Rectangular and Diamond configurations, the voltage generated by a TEG module consisting of 128 pairs of legs was analysed. As thermal stress analysis is an important factor in the selection of TEG leg geometries, it was observed based on simulations that the newly implemented Diamond-leg geometry encountered lower thermal stresses than the traditional Rectangular model, while the Cone-shape may fail structurally before the other TEG models. The proposed methodology, taking into account the results of the simulation carried out, provides guidance for the development of thermoelectric modules with different forms of variable leg geometry.