Dechao Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dechao Lu has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Xuqiang Zheng
Institute of Microelectronics of the Chinese Academy of Sciences
2 shared publications - Bin Liang
School of Computer, National University of Defense Technology, Changsha 410003, China
1 shared publication - Chen Cai
Institute of Microelectronics, Chinese Academy of Sciences, Beijing 100029, China
1 shared publication - Danyu Wu
Institute of Microelectronics of the Chinese Academy of Sciences, Beijing 100029, China
1 shared publication - Fangxu Lv
School of Computer, National University of Defense Technology, Changsha 410003, China
1 shared publication - Feng Zhao
MoE Key Laboratory of Brain-inspired Intelligent Perception and Cognition, University of Science and Technology of China, Hefei, China
1 shared publication
Latest Publications
- Open Access
- 6 August 2021
- Published by MDPI AG in Electronics
- Vol. 10 (16) , 1888
Analysis and Modeling of Mueller–Muller Clock and Data Recovery Circuits
In this paper, an accurate linear model of the Mueller–Muller phase detector (MMPD)-based clock and data recovery circuit (MM-CDR) is proposed, which analyzes several critical points of the MM-CDR including the linearization of the MMPD and the gain of the voter. Using our technique, the jitter between the recovery clock and the input data can be estimated with a sub-picosecond accuracy, as demonstrated in the simulation results of a 56 Gb/s quarter-rate MM-CDR implemented in 28 nm CMOS.
- 6 August 2021
- Published by MDPI AG in Electronics
- Vol. 10 (16) , 1888
Open AccessAnalysis and Modeling of Mueller–Muller Clock and Data Recovery Circuits
In this paper, an accurate linear model of the Mueller–Muller phase detector (MMPD)-based clock and data recovery circuit (MM-CDR) is proposed, which analyzes several critical points of the MM-CDR including the linearization of the MMPD and the gain of the voter. Using our technique, the jitter between the recovery clock and the input data can be estimated with a sub-picosecond accuracy, as demonstrated in the simulation results of a 56 Gb/s quarter-rate MM-CDR implemented in 28 nm CMOS.
- Open Access
- 4 August 2021
- Published by MDPI AG in Electronics
- Vol. 10 (16) , 1873
A 1.55-to-32-Gb/s Four-Lane Transmitter with 3-Tap Feed Forward Equalizer and Shared PLL in 28-nm CMOS
This paper presents a fully integrated physical layer (PHY) transmitter (TX) suiting for multiple industrial protocols and compatible with different protocol versions. Targeting a wide operating range, the LC-based phase-locked loop (PLL) with a dual voltage-controlled oscillator (VCO) was integrated to provide the low jitter clock. Each lane with a configurable serialization scheme was adapted to adjust the data rate flexibly. To achieve high-speed data transmission, several bandwidth-extended techniques were introduced, and an optimized output driver with a 3-tap feed-forward equalizer (FFE) was proposed to accomplish high-quality data transmission and equalization. The TX prototype was fabricated in a 28-nm CMOS process, and a single-lane TX only occupied an active area of 0.048 mm2. The shared PLL and clock distribution circuits occupied an area of 0.54 mm2. The proposed PLL can support a tuning range that covers 6.2 to 16 GHz. Each lane’s data rate ranged from 1.55 to 32 Gb/s, and the energy efficiency is 1.89 pJ/bit/lane at a 32-Gb/s data rate and can tune an equalization up to 10 dB.
- 4 August 2021
- Published by MDPI AG in Electronics
- Vol. 10 (16) , 1873
Open AccessA 1.55-to-32-Gb/s Four-Lane Transmitter with 3-Tap Feed Forward Equalizer and Shared PLL in 28-nm CMOS
This paper presents a fully integrated physical layer (PHY) transmitter (TX) suiting for multiple industrial protocols and compatible with different protocol versions. Targeting a wide operating range, the LC-based phase-locked loop (PLL) with a dual voltage-controlled oscillator (VCO) was integrated to provide the low jitter clock. Each lane with a configurable serialization scheme was adapted to adjust the data rate flexibly. To achieve high-speed data transmission, several bandwidth-extended techniques were introduced, and an optimized output driver with a 3-tap feed-forward equalizer (FFE) was proposed to accomplish high-quality data transmission and equalization. The TX prototype was fabricated in a 28-nm CMOS process, and a single-lane TX only occupied an active area of 0.048 mm2. The shared PLL and clock distribution circuits occupied an area of 0.54 mm2. The proposed PLL can support a tuning range that covers 6.2 to 16 GHz. Each lane’s data rate ranged from 1.55 to 32 Gb/s, and the energy efficiency is 1.89 pJ/bit/lane at a 32-Gb/s data rate and can tune an equalization up to 10 dB.