Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Anandhi Sivaramalingam has a total of 41 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Mechanochemically Synthesized Nanocrystalline Cu2ZnSnSe4 as a Multifunctional Material for Energy Conversion and Storage Applications

    by Angel Agnes Johnrose, Devika Rajan Sajitha, Vengatesh Panneerselvam, Anandhi Sivaramalingam, Kamalan Kirubaharan Amirtharaj Mosas, Beauno Stephen, Shyju Thankaraj Salammal

    Cu2ZnSnSe4 is a promising light-absorbing material for cost-effective and eco-friendly thin-film solar cells; however, its synthesis often leads to secondary phases that limit device efficiency. To overcome these challenges, we devised a straightforward and efficient method to obtain single-phase Cu2ZnSnSe4 nanocrystalline powders directly from the elements Cu, Zn, Sn, and Se via mechanochemical synthesis followed by vacuum annealing at 450 °C. Phase evolution monitored by X-ray diffraction (XRD) and Raman spectroscopy at two-hour milling intervals confirmed the formation of phase-pure kesterite Cu2ZnSnSe4 and enabled tracking of transient secondary phases. Raman spectra revealed the characteristic A1 vibrational modes of the kesterite structure, while XRD peaks and Rietveld refinement (χ2 ~ 1) validated single-phase formation with crystallite sizes of 10–15 nm and dislocation densities of 3.00–3.20 1015 lines/m2. Optical analysis showed a direct bandgap of ~1.1 eV, and estimated linear and nonlinear optical constants validate its potential for photovoltaic applications. Scanning electron microscopy (SEM) analysis showed uniformly distributed particles 50–60 nm, and energy dispersive X-ray (EDS) analysis confirmed a near-stoichiometric Cu:Zn:Sn:Se ratio of 2:1:1:4. X-ray photoelectron spectroscopy (XPS) identified the expected oxidation states (Cu+, Zn2+, Sn4+, and Se2−). Electrical characterization revealed p-type conductivity with a mobility (μ) of 2.09 cm2/Vs, sheet resistance (ρ) of 4.87 Ω cm, and carrier concentrations of 1.23 × 1019 cm−3. Galvanostatic charge–discharge testing (GCD) demonstrated an energy density of 2.872 Wh/kg−1 and a power density of 1083 W kg−1, highlighting the material’s additional potential for energy storage applications.


  • Open Access

    Electrochemical Anodization-Induced {001} Facet Exposure in A-TiO2 for Improved DSSC Efficiency

    by Jolly Mathew, Shyju Thankaraj Salammal, Anandhi Sivaramalingam, Paulraj Manidurai

    We developed dye-sensitized solar cells based on anatase–titanium dioxide (A-TiO2) nanotubes (TiNTs) and nanocubes (TiNcs) with {001} crystal facets generated using simple and facile electrochemical anodization. We also demonstrated a simple way of developing one-dimensional, two-dimensional, and three-dimensional self-assembled TiO2 nanostructures via electrochemical anodization, using them as an electron-transporting layer in DSSCs. TiNTs maintain tubular arrays for a limited time before becoming nanocrystals with {001} facets. Using FESEM and TEM, we observed that the TiO2 nanobundles were transformed into nanocubes with {001} facets and lower fluorine concentrations. Optimizing the reaction approach resulted in better-ordered, crystalline anatase TiNTs/Ncs being formed on the Ti metal foil. The anatase phase of as-grown TiO2 was confirmed by XRD, with (101) being the predominant intensity and preferred orientation. The nanostructured TiO2 had lattice values of a = 3.77–3.82 and c = 9.42–9.58. The structure and morphology of these as-grown materials were studied to understand the growth process. The photoconversion efficiency and impedance spectra were explored to analyze the performance of the designed DSSCs, employing N719 dye as a sensitizer and the I−/I3− redox pair as electrolytes, sandwiched with a Pt counter-electrode. As a result, we found that self-assembled TiNTs/Ncs presented a more effective photoanode in DSSCs than standard TiO2 (P25). TiNcs (0.5 and 0.25 NH4F) and P25 achieved the highest power conversion efficiencies of 3.47, 3.41, and 3.25%, respectively. TiNcs photoanodes have lower charge recombination capability and longer electron lifetimes, leading to higher voltage, photocurrent, and photovoltaic performance. These findings show that electrochemical anodization is an effective method for preparing TiNTs/Ncs and developing low-cost, highly efficient DSSCs by fine-tuning photoanode structures and components.


  • Open Access

    Size-Dependent Antibacterial, Antidiabetic, and Toxicity of Silver Nanoparticles Synthesized Using Solvent Extraction of Rosa indica L. Petals

    by Satheesh Kumar Balu, Swetha Andra, Fouad Damiri, Anandhi Sivaramalingam, Manisha Vidyavathy Sudandaradoss, Karthikeyan Kumarasamy, Kishore Bhakthavachalam, Faraat Ali, Milton Kumar Kundu, Habibur Rahman, et al.

    In this study, silver nanoparticles (AgNPs) are synthesized through a green approach by employing Rosa indica L. petal (RE) extracts as reducing and stabilizing agents, which are extracted using three different solvents: ethanol (Et), acetone (Ac), and water (Aq). The phase formation of the AgNPs is confirmed using X-ray diffraction (XRD). Morphological analysis is performed using a field-emission scanning electron microscope (FESEM), which reveals that the AgNPs are spherical in shape. The size is estimated using ImageJ software, which is found to be ~12, 18, and 770 nm for RE-Ac-Ag, RE-Et-Ag, and RE-Aq-Ag, respectively. The phytochemicals of Rosa indica L. petals involved in the formation of the AgNPs are studied using Fourier transform infrared spectroscopy (FTIR). Finally, these materials are studied for their antibacterial, antidiabetic, antioxidant, and hemolytic activity, as well as cell toxicity properties. The materials, RE-Ac-Ag and RE-Et-Ag, are found to be more effective than RE-Aq-Ag in inhibiting E. coli (Gram-negative bacteria) and S. aureus (Gram-positive bacteria). Hemolytic studies reveal that all of the samples show concentration-dependent activity up to 50 µg/mL. RE-Ac-Ag and RE-Et-Ag exhibit nonhemolytic behavior, whereas RE-Aq-Ag remains nonhemolytic until 100 µg/mL. The antidiabetic ability of the AgNPs is evaluated using α-amylase inhibition assay (DNSA assay) and α-glucosidase inhibition assay. The results are found to be effective, with IC50 values of α-amylase and α-glycosidase being 50, 50, and 75 µg/mL for RE-Et-Ag, RE-Ac-Ag, and RE-Aq-Ag, respectively. DPPH assay shows that the AgNPs inhibited the antioxidants well, with IC50 values of 40 µg/mL for RE-Et-Ag and RE-Ac-Ag and 60 µg/mL for RE-Aq-Ag. The toxicity study reveals that the AgNPs show size- and concentration-dependent behavior. Overall, it is realized from the findings that RE-Ac-Ag, RE-Et-Ag, and RE-Aq-Ag show size-dependent antibacterial, antidiabetic, and toxicity properties.


  • Studies on nonlinear optical properties of a mixture of 4-nitroaniline-picric acid (2/1)

    by K V Karthikeyan, S Anandhi, V Ramkumar, T S Shyju, S N Jaisankar, R Suriakarthick, Ram Kumar, Karthick Suria


  • Hyperpolarizability and two photon observation of imidazolium picrate

    by S. Anandhi, K. Mani Rahulan, T.S. Shyju


  • Substitution effect on chalcone based materials for corrosion and photocrosslinking applications

    by V. Ramkumar, S. Anandhi, P. Kannan, R. Gopalakrishnan

    Hydroxy (–OH) and benzyloxy (–OCH2Ph) substituted chalcone based crystalline materials were synthesized and characterized; these materials exhibited high corrosion inhibitor efficiency and enhanced photo-crosslinking applications.


  • Studies on Lead Sulfide (PbS) Semiconducting Thin Films Deposited from Nanoparticles and Its NLO Application

    by T. S. Shyju, S. Anandhi, R. Sivakumar, R. Gopalakrishnan

    Nanoparticle Lead sulfide was synthesized via simple chemical method and deposited on glass substrates at different substrate temperatures by thermal evaporation technique. The synthesized nanoparticle PbS was analyzed and confirmed by X-ray diffraction (XRD), Scanning electron microscopy SEM with EDX and thermogravimetry. The structural, optical, morphological and electrical properties of the deposited films were studied using XRD, UV-Vis, Raman, SEM with EDX, atomicforce microscopy AFM and Hall Effect measurements. The thickness of the deposited samples was measured using thickness profilometer. The Raman shift in the peak occurs toward lower energy with increasing substrate temperature deposited lead sulfide. The Z-scan study with open aperture was carried out at 532 nm using 5 ns laser pulse on the deposited films which shows that nonlinear absorption arises from saturable absorption process. The deposited PbS film exhibits p-type conductivity in Hall measurement.


  • Synthesis, single crystal growth, characterization and comparison of two new enone shifted chalcones and their NLO behaviour

    by V. Ramkumar, S. Anandhi, P. Kannan, R. Gopalakrishnan

    Chalcone based materials are widely used in many industrial applications. The two new similar chalcone based single crystals, namely (E)-3-(4-(benzyloxy)phenyl)-1-(4-hydroxyphenyl)prop-2-en-1-one (Crystal A) and (E)-1-(4-(benzyloxy)phenyl)-3-(4-hydroxyphenyl)prop-2-en-1-one (Crystal B) were synthesized and grown as single crystals by slow evaporation solution growth technique in acetone. The structures of the grown crystals were solved and refined by single crystal XRD and this demonstrates that crystal A shows an orthorhombic system with a space group of Pca21 and crystal B crystallizes in a monoclinic system with a space group of C2/c. The morphology of the crystals A and B was predicted using WINXMORPH. The hyperpolarizability studies were carried out for the chalcone single crystals using density functional theory (DFT) - triply parameter hybrid model DFT/B3LYP using GAUSSIAN 03. The calculated first order hyperpolarizability was found as 0.1314 × 10−30 e.s.u. for crystal A and 0.188 × 10−30 e.s.u. for crystal B. The second harmonic generation was studied by Kurtz–Perry test. The comparison statement of the enone shifted material properties enumerates interesting results in all the studies.