Fares Boudjema
Fares Boudjema has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Djamel Boukhetala
National Polytechnic School of Algiers
2 shared publications - Abdelghani Boucheloukh
Laboratoire De Commande Des Processus, Ecole Nationale Polytechnique (ENP), Algiers, Algeria
1 shared publication - Abdelkrim Nemra
Ecole Militaire Polytechnique
1 shared publication - Ahsene Boubakir
LAJ Laboratory, University of Jijel, Jijel, Algeria
1 shared publication - Boualam Benlahbib
Unité de Recherche Appliquée en Energies Renouvelables, URAER, Centre de Développement des Energies Renouvelables, CDER
1 shared publication - Fethi Demim
Ecole Militaire Polytechnique
1 shared publication
Latest Publications
- 2 August 2021
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 47 (1) , 9682-9707
Fuzzy based incremental conductance algorithm stabilized by an optimal integrator for a photovoltaic system under varying operating conditions
In renewable system control engineering, Maximum Power Point Tracking (MPPT) techniques are considered as one of the key steps in photovoltaic (PV) system development. Indeed, some MPPT techniques provide high performance under uniform irradiation and temperature conditions. However, their performance significantly degrades when the two preceding climatic conditions suddenly change. Therefore, this paper proposes a new voltage regulation based on Fuzzy Logic Control (FLC) strategy and small-signal model of DC–DC booster converter. The proposed control scheme is mainly based on the indirect incremental conductance (Inc) technique, equipped with an optimal integrator controller (OIC). It is implemented in a PV system, consisting of a DC–DC boost converter connected to a resistive load, with the main objective of ensuring a good MPP tracking behavior for variable operating conditions. To achieve this objective, the proposed MPPT strategy is designed around two stages. First, the smooth reference voltage is ensured by a Single-Input Single-Output (SISO) fuzzy logic controller using the Inc technique based on the MPPT approach. Then, the optimal integrator controller stabilizing the closed-loop system is integrated with optimization of its parameter according to Routh’s criterion for resistive load variations. Simulation results confirm the effectiveness of the proposed MPPT technique compared to some commonly used MPPT approaches. The superiority of the proposal is proven by using efficiency ratio, which rises more than 98% in all case studies. These objectives are ensured for both uniform and critical sudden change in weather conditions, regardless of resistive load variations.
- 2 August 2021
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 47 (1) , 9682-9707
Fuzzy based incremental conductance algorithm stabilized by an optimal integrator for a photovoltaic system under varying operating conditions
In renewable system control engineering, Maximum Power Point Tracking (MPPT) techniques are considered as one of the key steps in photovoltaic (PV) system development. Indeed, some MPPT techniques provide high performance under uniform irradiation and temperature conditions. However, their performance significantly degrades when the two preceding climatic conditions suddenly change. Therefore, this paper proposes a new voltage regulation based on Fuzzy Logic Control (FLC) strategy and small-signal model of DC–DC booster converter. The proposed control scheme is mainly based on the indirect incremental conductance (Inc) technique, equipped with an optimal integrator controller (OIC). It is implemented in a PV system, consisting of a DC–DC boost converter connected to a resistive load, with the main objective of ensuring a good MPP tracking behavior for variable operating conditions. To achieve this objective, the proposed MPPT strategy is designed around two stages. First, the smooth reference voltage is ensured by a Single-Input Single-Output (SISO) fuzzy logic controller using the Inc technique based on the MPPT approach. Then, the optimal integrator controller stabilizing the closed-loop system is integrated with optimization of its parameter according to Routh’s criterion for resistive load variations. Simulation results confirm the effectiveness of the proposed MPPT technique compared to some commonly used MPPT approaches. The superiority of the proposal is proven by using efficiency ratio, which rises more than 98% in all case studies. These objectives are ensured for both uniform and critical sudden change in weather conditions, regardless of resistive load variations.
- 4 July 2021
- Published by Taylor & Francis in International Journal of Modelling and Simulation
- Vol. 42 (4) , 595-616
UAV navigation based on adaptive fuzzy backstepping controller using visual odometry
This study investigates the 3D trajectory tracking of a quadrotor-type unmanned aerial vehicle (UAV) using a visual localization system integrated in the feedback control loop. First, adaptive stereo visual odometry (SVO) is proposed to solve the UAV localization problem. The proposed solution mainly employs adaptive iterative closest point speeded-up robust features. Second, a vision-based trajectory tracking algorithm is implemented using a backstepping controller, whose parameters are optimized using the particle swarm optimization algorithm. Finally, to avoid the limitations of visual localization (e.g. dark environment, uniform area, and dynamic scene), the visual pose is supported by the inertial pose obtained using a fuzzy adaptive Kalman filter (FAKF). Based on the number and average depth of the estimated 3D points, the FAKF algorithm adaptively tunes the extended Kalman filter parameters. The proposed algorithms are validated using simulation and experimental data. Many scenarios are considered with different trajectories. Good performance is achieved, confirming the efficiency of the proposed approach.
- 4 July 2021
- Published by Taylor & Francis in International Journal of Modelling and Simulation
- Vol. 42 (4) , 595-616
UAV navigation based on adaptive fuzzy backstepping controller using visual odometry
This study investigates the 3D trajectory tracking of a quadrotor-type unmanned aerial vehicle (UAV) using a visual localization system integrated in the feedback control loop. First, adaptive stereo visual odometry (SVO) is proposed to solve the UAV localization problem. The proposed solution mainly employs adaptive iterative closest point speeded-up robust features. Second, a vision-based trajectory tracking algorithm is implemented using a backstepping controller, whose parameters are optimized using the particle swarm optimization algorithm. Finally, to avoid the limitations of visual localization (e.g. dark environment, uniform area, and dynamic scene), the visual pose is supported by the inertial pose obtained using a fuzzy adaptive Kalman filter (FAKF). Based on the number and average depth of the estimated 3D points, the FAKF algorithm adaptively tunes the extended Kalman filter parameters. The proposed algorithms are validated using simulation and experimental data. Many scenarios are considered with different trajectories. Good performance is achieved, confirming the efficiency of the proposed approach.
- Open Access
- 1 January 2016
- Published by The Scientific and Technological Research Council of Turkey (TUBITAK-ULAKBIM) - DIGITAL COMMONS JOURNALS in Turkish Journal of Electrical Engineering and Computer Sciences
- Vol. 24 (5) , 3898-3909
A multiobjective tuning approach of power system stabilizers using particle swarm optimization
- 1 January 2016
- Published by The Scientific and Technological Research Council of Turkey (TUBITAK-ULAKBIM) - DIGITAL COMMONS JOURNALS in Turkish Journal of Electrical Engineering and Computer Sciences
- Vol. 24 (5) , 3898-3909
Open AccessA multiobjective tuning approach of power system stabilizers using particle swarm optimization
- 1 July 2011
- Published by SAGE Publications in Journal of Vibration and Control
- Vol. 18 (2) , 228-239
A stable self-tuning proportional-integral-derivative controller for a class of multi-input multi-output nonlinear systems
This paper proposes a self-tuned proportional-integral-derivative (PID) controller for a class of uncertain continuous-time multi-input multi-output nonlinear dynamic systems. Within this scheme, the PID controller is employed to approximate an unknown ideal controller that can achieve control objectives. The three PID control gains are adjustable parameters and they are updated online with a stable adaptation mechanism designed to minimize the error between the unknown ideal controller and the used PID controller. The proposed approach can be regarded as a simple and effective model-free control because the mathematical model of the system is assumed unknown. The stability analysis of the closed-loop system is performed using a Lyapunov approach. It is proved that all signals in the closed-loop system are uniformly ultimately bounded and that the tracking error can be made to converge to zero in the absence of approximation errors. The effectiveness of the proposed adaptive PID control is demonstrated in simulation.
- 1 July 2011
- Published by SAGE Publications in Journal of Vibration and Control
- Vol. 18 (2) , 228-239
A stable self-tuning proportional-integral-derivative controller for a class of multi-input multi-output nonlinear systems
This paper proposes a self-tuned proportional-integral-derivative (PID) controller for a class of uncertain continuous-time multi-input multi-output nonlinear dynamic systems. Within this scheme, the PID controller is employed to approximate an unknown ideal controller that can achieve control objectives. The three PID control gains are adjustable parameters and they are updated online with a stable adaptation mechanism designed to minimize the error between the unknown ideal controller and the used PID controller. The proposed approach can be regarded as a simple and effective model-free control because the mathematical model of the system is assumed unknown. The stability analysis of the closed-loop system is performed using a Lyapunov approach. It is proved that all signals in the closed-loop system are uniformly ultimately bounded and that the tracking error can be made to converge to zero in the absence of approximation errors. The effectiveness of the proposed adaptive PID control is demonstrated in simulation.