Hongyu Sheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hongyu Sheng has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Yanchun Shen
Information Engineering Institute, Guangzhou Railway Polytechnic, Guangzhou 510432, China
2 shared publications - Dejun Liu
Shanghai Normal University
1 shared publication - Hongmei Liu
College of Information Engineering, Guangzhou Railway Polytechnic, Guangzhou 511300, China
1 shared publication Hongyu Sheng
College of Robotics Beijing Union University Beijing 100101, China
1 shared publicationHuang Yong
1 shared publication- Jing Yang
College of Information Engineering, Guangzhou Railway Polytechnic, Guangzhou 511300, China
1 shared publication
Latest Publications
- Open Access
- 25 December 2023
- Published by MDPI AG in Micromachines
- Vol. 15 (1) , 43
Double-Strip Array-Based Metasurfaces with BICs for Terahertz Thin Membrane Detection
A double-strip array-based metasurface that supports the sharp quasi-bound states in the continuum (quasi-BICs) is demonstrated in terahertz regions. By tuning the structural parameters of metal strips, the conversion of BICs and quasi-BICs is controllable. The simulated results exhibit an achieved maximum Q-factor for quasi-BICs that exceeds 500, corresponding to a bandwidth that is less than 1 GHz. The optical response of quasi-BICs is mainly affected by the properties of substrates. Resonant frequencies decrease linearly with increasing refractive index. The bandwidth of quasi-BICs decreases to 0.9 GHz when n is 2.2. The sharp quasi-BICs are also sensitive to changes in material absorption. Low-loss materials show higher Q-factors. Thus, the selection of a suitable substrate material will be beneficial in achieving resonance with a high Q value. The sensitivity of DSAs for molecules is assessed using a thin membrane layer. The DSAs show high sensitivity, which achieves a frequency shift of 70 GHz when the thickness of the membrane is 10 μm, corresponding to a sensitivity of 87.5 GHz/RIU. This metasurface with sharp quasi-BICs is expected to perform well in THz sensing.
- 25 December 2023
- Published by MDPI AG in Micromachines
- Vol. 15 (1) , 43
Open AccessDouble-Strip Array-Based Metasurfaces with BICs for Terahertz Thin Membrane Detection
A double-strip array-based metasurface that supports the sharp quasi-bound states in the continuum (quasi-BICs) is demonstrated in terahertz regions. By tuning the structural parameters of metal strips, the conversion of BICs and quasi-BICs is controllable. The simulated results exhibit an achieved maximum Q-factor for quasi-BICs that exceeds 500, corresponding to a bandwidth that is less than 1 GHz. The optical response of quasi-BICs is mainly affected by the properties of substrates. Resonant frequencies decrease linearly with increasing refractive index. The bandwidth of quasi-BICs decreases to 0.9 GHz when n is 2.2. The sharp quasi-BICs are also sensitive to changes in material absorption. Low-loss materials show higher Q-factors. Thus, the selection of a suitable substrate material will be beneficial in achieving resonance with a high Q value. The sensitivity of DSAs for molecules is assessed using a thin membrane layer. The DSAs show high sensitivity, which achieves a frequency shift of 70 GHz when the thickness of the membrane is 10 μm, corresponding to a sensitivity of 87.5 GHz/RIU. This metasurface with sharp quasi-BICs is expected to perform well in THz sensing.
- Open Access
- 2 August 2021
- Published by Springer Nature in SN Applied Sciences
- Vol. 3 (9) , 1-7
Terahertz broadband polarization converter based on the double-split ring resonator metasurface
A terahertz broadband polarization converter based on the metasurface of a double-split ring resonator is proposed. The structural parameters of this device have been optimized in numerical simulations. The results show that in the frequency range from 0.49 to 1.88 THz (bandwidth of 1.39 THz) the proposed device rotates incident linearly polarized waves through 90°. The polarization conversion rate is more than 80%. The coefficient of reflection for cross polarization is greater than 90% with a transmission loss of 1 dB. The surface current distribution of this structure was simulated and analyzed at three frequencies that give high conversion rates of the polarization. The mechanism underlying this high conversion rate is presented, and the dependence of the conversion rate on incident angle and polarization angle is stimulated and analyzed. The results show that the conversion performance of this device is good for incidence angles ranging from 0 to 30° and polarization angles ranging from − 10 to 10°. Compared with previous designs, the polarization converter has a simple structure and a broad operational bandwidth. It has potential applications in the field of terahertz polarization modulation.
- 2 August 2021
- Published by Springer Nature in SN Applied Sciences
- Vol. 3 (9) , 1-7
Open AccessTerahertz broadband polarization converter based on the double-split ring resonator metasurface
A terahertz broadband polarization converter based on the metasurface of a double-split ring resonator is proposed. The structural parameters of this device have been optimized in numerical simulations. The results show that in the frequency range from 0.49 to 1.88 THz (bandwidth of 1.39 THz) the proposed device rotates incident linearly polarized waves through 90°. The polarization conversion rate is more than 80%. The coefficient of reflection for cross polarization is greater than 90% with a transmission loss of 1 dB. The surface current distribution of this structure was simulated and analyzed at three frequencies that give high conversion rates of the polarization. The mechanism underlying this high conversion rate is presented, and the dependence of the conversion rate on incident angle and polarization angle is stimulated and analyzed. The results show that the conversion performance of this device is good for incidence angles ranging from 0 to 30° and polarization angles ranging from − 10 to 10°. Compared with previous designs, the polarization converter has a simple structure and a broad operational bandwidth. It has potential applications in the field of terahertz polarization modulation.
- 1 September 2019
- Published by Coastal Education and Research Foundation in Journal of Coastal Research
- Vol. 93 (sp1) , 1019-1025
Intelligent Retrieval System for Ship Fault Information Based on Big Data Analysis
Sheng, H. and Wang, X., 2019. Intelligent retrieval system for ship fault information based on big data analysis. In: Guido-Aldana, P.A. and Mulahasan, S. (eds.), Advances in Water Resources and Exploration. Journal of Coastal Research, Special Issue No. 93, pp. 1019–1025. Coconut Creek (Florida), ISSN 0749-0208.In order to improve the efficiency of ship fault information retrieval and shorten the retrieval time, an intelligent retrieval system for ship fault information based on big data analysis is designed. The Lucene retrieval component is used to build a multi-level classification module, which matches the query keywords input in the process of ship fault information retrieval with the ship operation status to increase the intelligent retrieval conditions. Combining the big data analysis technology to classify the ship fault information at different levels, the tree classification structure is presented in the process of ship fault status classification, which can refine the classification of ship fault, describe the attributes of retrieval objects in detail, reduce the number of retrieval times, and improve the efficiency of ship fault status retrieval, thus completing the design of the intelligent retrieval system for ship fault information. The experimental results show that under the same conditions, the retrieval time of the system is nearly half shorter than that of the traditional system, and the longest retrieval time can be controlled within 2 seconds, which effectively improves the retrieval efficiency.
- 1 September 2019
- Published by Coastal Education and Research Foundation in Journal of Coastal Research
- Vol. 93 (sp1) , 1019-1025
Intelligent Retrieval System for Ship Fault Information Based on Big Data Analysis
Sheng, H. and Wang, X., 2019. Intelligent retrieval system for ship fault information based on big data analysis. In: Guido-Aldana, P.A. and Mulahasan, S. (eds.), Advances in Water Resources and Exploration. Journal of Coastal Research, Special Issue No. 93, pp. 1019–1025. Coconut Creek (Florida), ISSN 0749-0208.In order to improve the efficiency of ship fault information retrieval and shorten the retrieval time, an intelligent retrieval system for ship fault information based on big data analysis is designed. The Lucene retrieval component is used to build a multi-level classification module, which matches the query keywords input in the process of ship fault information retrieval with the ship operation status to increase the intelligent retrieval conditions. Combining the big data analysis technology to classify the ship fault information at different levels, the tree classification structure is presented in the process of ship fault status classification, which can refine the classification of ship fault, describe the attributes of retrieval objects in detail, reduce the number of retrieval times, and improve the efficiency of ship fault status retrieval, thus completing the design of the intelligent retrieval system for ship fault information. The experimental results show that under the same conditions, the retrieval time of the system is nearly half shorter than that of the traditional system, and the longest retrieval time can be controlled within 2 seconds, which effectively improves the retrieval efficiency.
- 1 January 2019
- Published by Totem Publisher, Inc. in International Journal of Performability Engineering
- Vol. 15 (11) , 2944
Crowdsourced Testing Ability for Mobile Apps: A Study on Mooctest
- 1 January 2019
- Published by Totem Publisher, Inc. in International Journal of Performability Engineering
- Vol. 15 (11) , 2944
Crowdsourced Testing Ability for Mobile Apps: A Study on Mooctest