WWWan-Xia Wang

Wan-Xia Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Wan-Xia Wang has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A new strategy for fabricating low haze p-type CuI film

    by Hui Sun, Rui-Song You, Yi-Chen Wang, Shu-Lin Luo, Wan-Xia Wang

    As an intrinsic p-type transparent conductor with a wide band gap of 3.1 eV, γ-CuI full of potential has gradually attracted the attention of researchers. However, γ-CuI films deposited by various techniques generally exhibit high haze with a frosted glass-like appearance, which significantly affects the device performance. Herein, a new strategy is proposed in which true p-type CuI thin films with low haze have been successfully synthesised at room temperature. The specular transmittance of the CuI film over 85% in the visible region (400–800 nm) can be achieved. The haze of the as-prepared γ-CuI films can be as low as 0.7%. Meanwhile, the as-prepared CuI film has an FOM as high as 230 MΩ−1. This ideal stable p-type optoelectronic performance was significant among various typical p-type transparent conductive films.


  • Open Access

    Amorphous N-doped InSnZnO thin films deposited by RF sputtering for thin-film transistor application

    by Zhi-Yue Li, Shu-Mei Song, Wanxia Wang, Ming-Jiang Dai, Song-Sheng Lin, Ting-Yong Chen, Hui Sun

    N-doped InSnZnO (ITZO:N) thin films as the active layer of thin film transistors (TFTs) were prepared using radio frequency (RF) magnetron sputtering at room temperature.


  • Open Access

    Research Progress of p-Type Oxide Thin-Film Transistors

    by Zhuping Ouyang, Wanxia Wang, Mingjiang Dai, Baicheng Zhang, Jianhong Gong, Mingchen Li, Lihao Qin, Hui Sun

    The development of transparent electronics has advanced metal–oxide–semiconductor Thin-Film transistor (TFT) technology. In the field of flat-panel displays, as basic units, TFTs play an important role in achieving high speed, brightness, and screen contrast ratio to display information by controlling liquid crystal pixel dots. Oxide TFTs have gradually replaced silicon-based TFTs owing to their field-effect mobility, stability, and responsiveness. In the market, n-type oxide TFTs have been widely used, and their preparation methods have been gradually refined; however, p-Type oxide TFTs with the same properties are difficult to obtain. Fabricating p-Type oxide TFTs with the same performance as n-type oxide TFTs can ensure more energy-efficient complementary electronics and better transparent display applications. This paper summarizes the basic understanding of the structure and performance of the p-Type oxide TFTs, expounding the research progress and challenges of oxide transistors. The microstructures of the three types of p-Type oxides and significant efforts to improve the performance of oxide TFTs are highlighted. Finally, the latest progress and prospects of oxide TFTs based on p-Type oxide semiconductors and other p-Type semiconductor electronic devices are discussed.


  • Open Access

    In-Sn-Zn Oxide Nanocomposite Films with Enhanced Electrical Properties Deposited by High-Power Impulse Magnetron Sputtering

    by Hui Sun, Zhi-Yue Li, Sheng-Chi Chen, Ming-Han Liao, Jian-Hong Gong, Zhamatuofu Bai, Wan-Xia Wang

    In-Sn-Zn oxide (ITZO) nanocomposite films have been investigated extensively as a potential material in thin-film transistors due to their good electrical properties. In this work, ITZO thin films were deposited on glass substrates by high-power impulse magnetron sputtering (HiPIMS) at room temperature. The influence of the duty cycle (pulse off-time) on the microstructures and electrical performance of the films was investigated. The results showed that ITZO thin films prepared by HiPIMS were dense and smooth compared to thin films prepared by direct-current magnetron sputtering (DCMS). With the pulse off-time increasing from 0 μs (DCMS) to 2000 μs, the films’ crystallinity enhanced. When the pulse off-time was longer than 1000 μs, In2O3 structure could be detected in the films. The films’ electrical resistivity reduced as the pulse off-time extended. Most notably, the optimal resistivity of as low as 4.07 × 10−3 Ω·cm could be achieved when the pulse off-time was 2000 μs. Its corresponding carrier mobility and carrier concentration were 12.88 cm2V−1s−1 and 1.25 × 1020 cm−3, respectively.