Amin Pourkaveh Dehkordi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Amin Pourkaveh Dehkordi has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Andrey Vovk
Leibniz-Institut für Werkstofforientierte Technologien—WT, D-28359 Bremen, Germany
1 shared publication - Bernhard Karpuschewski
Bremen Institute for Metrology, Automation and Quality Science, University of Bremen, Bremen, Germany
1 shared publication - Jens Sölter
Bremen Institute for Metrology, Automation and Quality Science, University of Bremen, Bremen, Germany
1 shared publication - Rainer Glüge
DB Netz AG, Maybachstr. 26, D-39104 Magdeburg, Germany
1 shared publication
Latest Publications
- Open Access
- 17 August 2021
- Published by MDPI AG in Applied Mechanics
- Vol. 2 (3) , 571-580
Modification of the Johnson–Cook Material Model for Improved Simulation of Hard Milling High-Performance Steel Components
Understanding the effect of thermomechanical loads during finish cutting processes, in our case hard milling, on the surface integrity of the workpiece is crucial for the creation of defined quality characteristics of high-performance components. Compared to computationally generated modifications by simulation, the measurement-based determination of material modifications can only be carried out selectively and on a point-by-point basis. In practice, however, detailed knowledge of the changes in material properties at arbitrary points of the high-performance component is of great interest. In this paper, a modification of the well-known Johnson–Cook material model using the finite element software Abaqus is presented. Special attention was paid to the kinematic hardening behavior of the used steel material. Cyclic loads are relevant for the chip formation simulation because, during milling, after each cut, the material under the surface is loaded plastically several times and not necessarily in the same direction. Therefore, in analogy, multiple bending was investigated on samples made of 42CrMo4. A pronounced Bauschinger effect was observed in the bending tests. An adaptation of the material model to the results of the bending tests was only possible to a limited extent without kinematic hardening, which is why the Johnson–Cook model was supplemented by the Armstrong–Frederick hardening approach. The modified Johnson–Cook–Armstrong–Frederick material model was developed for practical use as a VUMAT and verified by bending tests for simulation use.
- 17 August 2021
- Published by MDPI AG in Applied Mechanics
- Vol. 2 (3) , 571-580
Open AccessModification of the Johnson–Cook Material Model for Improved Simulation of Hard Milling High-Performance Steel Components
Understanding the effect of thermomechanical loads during finish cutting processes, in our case hard milling, on the surface integrity of the workpiece is crucial for the creation of defined quality characteristics of high-performance components. Compared to computationally generated modifications by simulation, the measurement-based determination of material modifications can only be carried out selectively and on a point-by-point basis. In practice, however, detailed knowledge of the changes in material properties at arbitrary points of the high-performance component is of great interest. In this paper, a modification of the well-known Johnson–Cook material model using the finite element software Abaqus is presented. Special attention was paid to the kinematic hardening behavior of the used steel material. Cyclic loads are relevant for the chip formation simulation because, during milling, after each cut, the material under the surface is loaded plastically several times and not necessarily in the same direction. Therefore, in analogy, multiple bending was investigated on samples made of 42CrMo4. A pronounced Bauschinger effect was observed in the bending tests. An adaptation of the material model to the results of the bending tests was only possible to a limited extent without kinematic hardening, which is why the Johnson–Cook model was supplemented by the Armstrong–Frederick hardening approach. The modified Johnson–Cook–Armstrong–Frederick material model was developed for practical use as a VUMAT and verified by bending tests for simulation use.