Meer Sakib
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Meer Sakib has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- Haisheng Rong
Intel Corporation, Santa Clara, CA, USA
3 shared publications - Hasitha Jayatilleka
Department of Electrical and Computer Engineering, University of British Columbia, 2332 Main Mall, Vancouver, British Columbia V6T 1Z4, Canada
3 shared publications - Ranjeet Kumar
Intel Corporation
3 shared publications Chaoxuan Ma
Intel Corporation, 2200 Mission College Blvd, Santa Clara, CA 95054
2 shared publicationsDuanni Huang
Intel Corporation, 2200 Mission College Blvd, Santa Clara, CA 95054
2 shared publicationsGuan-Lin Su
Intel Corporation, 2200 Mission College Blvd, Santa Clara, CA 95054
2 shared publications
Latest Publications
- 1 January 2022
- Published by Optica Publishing Group
- p. M2D.4
A 240 Gb/s PAM4 Silicon Micro-Ring Optical Modulator
We report a micro-ring modulator with 0.53 V·cm phase efficiency, 54 GHz bandwidth, and 16.3 nm FSR. We have achieved 224 and 240 Gb/s PAM4 eye diagrams with 1.6 dB and 3.9 dB TDECQ, respectively.
- 1 January 2022
- Published by Optica Publishing Group
- p. M2D.4
A 240 Gb/s PAM4 Silicon Micro-Ring Optical Modulator
We report a micro-ring modulator with 0.53 V·cm phase efficiency, 54 GHz bandwidth, and 16.3 nm FSR. We have achieved 224 and 240 Gb/s PAM4 eye diagrams with 1.6 dB and 3.9 dB TDECQ, respectively.
- Top Cited Papers
- 25 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (15) , 5083-5088
Post-Fabrication Trimming of Silicon Photonic Ring Resonators at Wafer-Scale
Silicon ring resonator-based devices, such as modulators, detectors, filters, and switches, play important roles in integrated photonic circuits for optical communication, high-performance computing, and sensing applications. However, the high sensitivity to fabrication variations has limited their volume manufacturability and commercial adoption. Here, we report a low-cost post-fabrication trimming method to tune the resonance wavelength of a silicon ring resonator and correct for fabrication variations at wafer-scale. We use a Ge implant to create an index trimmable section in the ring resonator and an on-chip heater to apply a precise and localized thermal annealing to tune and set its resonance to a desired wavelength. We demonstrate resonance wavelength trimming of ring resonators fabricated across a 300 mm silicon-on-insulator (SOI) wafer to within +/-32 pm of a target wavelength of 1310 nm, providing a viable path to high-volume manufacturing and opening up new practical applications for these devices.
- 25 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (15) , 5083-5088
Top Cited PapersPost-Fabrication Trimming of Silicon Photonic Ring Resonators at Wafer-Scale
Silicon ring resonator-based devices, such as modulators, detectors, filters, and switches, play important roles in integrated photonic circuits for optical communication, high-performance computing, and sensing applications. However, the high sensitivity to fabrication variations has limited their volume manufacturability and commercial adoption. Here, we report a low-cost post-fabrication trimming method to tune the resonance wavelength of a silicon ring resonator and correct for fabrication variations at wafer-scale. We use a Ge implant to create an index trimmable section in the ring resonator and an on-chip heater to apply a precise and localized thermal annealing to tune and set its resonance to a desired wavelength. We demonstrate resonance wavelength trimming of ring resonators fabricated across a 300 mm silicon-on-insulator (SOI) wafer to within +/-32 pm of a target wavelength of 1310 nm, providing a viable path to high-volume manufacturing and opening up new practical applications for these devices.
- 1 January 2021
- Published by Optica Publishing Group
- p. SF1C.3
A high-speed micro-ring modulator for next generation energy-efficient optical networks beyond 100 Gbaud
We demonstrate a silicon micro-ring modulator supporting 128 Gb/s NRZ modulation with SNR=5.2, ER=3.8dB, 0.8 Vpp drive swing, and 5.3 fJ/bit power consumption. We have also achieved 192 Gb/s PAM-4 modulation with TDECQ of 2.5dB.
- 1 January 2021
- Published by Optica Publishing Group
- p. SF1C.3
A high-speed micro-ring modulator for next generation energy-efficient optical networks beyond 100 Gbaud
We demonstrate a silicon micro-ring modulator supporting 128 Gb/s NRZ modulation with SNR=5.2, ER=3.8dB, 0.8 Vpp drive swing, and 5.3 fJ/bit power consumption. We have also achieved 192 Gb/s PAM-4 modulation with TDECQ of 2.5dB.
- Top Cited Papers
- 19 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (4) , 1155-1161
1.6 Tbps Silicon Photonics Integrated Circuit and 800 Gbps Photonic Engine for Switch Co-Packaging Demonstration
We describe the performance of high bandwidth-density Silicon Photonic based Integrated Circuits (SiPh ICs) that enabled the first fully functional Photonic Engine (PE) module co-packaged with an Ethernet switch. We demonstrate the 1.6 Tbps SiPh transmitter (Tx) IC that integrates on-die all the lasers, micro ring modulators, monitor photodetectors, spot size converters and V-grooves that are needed to support sixteen 106.25 Gbps PAM4 optical transmit channels. This SiPh Tx, together with discrete receiver (Rx) SiPh ICs, enabled an 800Gbps PE. The PE is designed to allow up to sixteen modules to be co-packaged around a high-bandwidth switch ASIC. The PE test results described in this paper were obtained using sixteen 53.125 Gbps electrical channels that were multiplexed to drive eight simultaneously operating 106.25 Gbps optical channels. We report DR4 IEEE standards compliant high-speed optical eye performance as well as full link operation. Post-FEC error-free operation over temperature and over extended time duration is demonstrated on all channels.
- 19 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 39 (4) , 1155-1161
Top Cited Papers1.6 Tbps Silicon Photonics Integrated Circuit and 800 Gbps Photonic Engine for Switch Co-Packaging Demonstration
We describe the performance of high bandwidth-density Silicon Photonic based Integrated Circuits (SiPh ICs) that enabled the first fully functional Photonic Engine (PE) module co-packaged with an Ethernet switch. We demonstrate the 1.6 Tbps SiPh transmitter (Tx) IC that integrates on-die all the lasers, micro ring modulators, monitor photodetectors, spot size converters and V-grooves that are needed to support sixteen 106.25 Gbps PAM4 optical transmit channels. This SiPh Tx, together with discrete receiver (Rx) SiPh ICs, enabled an 800Gbps PE. The PE is designed to allow up to sixteen modules to be co-packaged around a high-bandwidth switch ASIC. The PE test results described in this paper were obtained using sixteen 53.125 Gbps electrical channels that were multiplexed to drive eight simultaneously operating 106.25 Gbps optical channels. We report DR4 IEEE standards compliant high-speed optical eye performance as well as full link operation. Post-FEC error-free operation over temperature and over extended time duration is demonstrated on all channels.
- 30 August 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (1) , 131-138
A 112 Gb/s PAM4 Silicon Photonics Transmitter With Microring Modulator and CMOS Driver
Microring modulators (MRMs) with CMOS electronics enable compact low power transmitter solutions for 400G Ethernet and future on-package optical transceivers. In this paper, we present a 112 Gb/s PAM4 transmitter using silicon photonic MRM, on-chip laser and co-packaged 28nm CMOS driver. We describe the impact of static and dynamic MRM nonlinearity on PAM4 signaling and present a dual path nonlinear pre-distortion technique to compensate both effects. PAM4 measurement results of our transmitter at 112 Gb/s show that TDECQ <0.7 dB is achieved from 30°C to 60°C while dissipating 6 pJ/bit. We also present link level measurements at 112 Gb/s PAM4 obtained by coupling this transmitter with our previously published CMOS TIA-based receiver, to demonstrate the feasibility of low cost optical transceivers through CMOS integration of optical interface circuits.
- 30 August 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (1) , 131-138
A 112 Gb/s PAM4 Silicon Photonics Transmitter With Microring Modulator and CMOS Driver
Microring modulators (MRMs) with CMOS electronics enable compact low power transmitter solutions for 400G Ethernet and future on-package optical transceivers. In this paper, we present a 112 Gb/s PAM4 transmitter using silicon photonic MRM, on-chip laser and co-packaged 28nm CMOS driver. We describe the impact of static and dynamic MRM nonlinearity on PAM4 signaling and present a dual path nonlinear pre-distortion technique to compensate both effects. PAM4 measurement results of our transmitter at 112 Gb/s show that TDECQ <0.7 dB is achieved from 30°C to 60°C while dissipating 6 pJ/bit. We also present link level measurements at 112 Gb/s PAM4 obtained by coupling this transmitter with our previously published CMOS TIA-based receiver, to demonstrate the feasibility of low cost optical transceivers through CMOS integration of optical interface circuits.
- Top Cited PapersOpen Access
- 26 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 37 (1) , 110-115
A 128 Gb/s PAM4 Silicon Microring Modulator With Integrated Thermo-Optic Resonance Tuning
We report the first demonstration of a silicon photonic microring modulator with modulation data rate up to 128 Gb/s (64 GBaud PAM4). The microring modulator exhibits an electro-optic phase efficiency of V $_{μ}\cdot$ L = 0.52 V $\cdot$ cm, an electro-optic bandwidth of 50 GHz, and a measured transmitter dispersion eye closure quaternary (TDECQ) of 3.0 dB at this data rate. In addition, the resonant wavelength of the microring modulator can be tuned across a full free spectral range (FSR) using an integrated heater with a thermo-optic phase efficiency of 19.5 mW/μ-phase shift.- 26 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 37 (1) , 110-115
Top Cited PapersOpen AccessA 128 Gb/s PAM4 Silicon Microring Modulator With Integrated Thermo-Optic Resonance Tuning
We report the first demonstration of a silicon photonic microring modulator with modulation data rate up to 128 Gb/s (64 GBaud PAM4). The microring modulator exhibits an electro-optic phase efficiency of V $_{μ}\cdot$ L = 0.52 V $\cdot$ cm, an electro-optic bandwidth of 50 GHz, and a measured transmitter dispersion eye closure quaternary (TDECQ) of 3.0 dB at this data rate. In addition, the resonant wavelength of the microring modulator can be tuned across a full free spectral range (FSR) using an integrated heater with a thermo-optic phase efficiency of 19.5 mW/μ-phase shift.