Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Lei Qin has a total of 103 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Regulating KO 2 deposition via crystal–void size matching in K–O 2 batteries

    by Xinyang Zhang, Jieren Shao, Lei Qin

    The pore architecture of gas-diffusion-layers dictates KO 2 deposition behaviors: size-matched voids enable bulk accommodation while mismatched voids trigger premature surface passivation.

  • Open Access

    A KO2-Based Solid Superoxide Reservoir for Irreversible Capacity Compensation in Superoxide-Based Na–O2 Batteries

    by Cuiyi Deng, Yu Zhong, Lei Qin, Yiying Wu

    Sodium–oxygen (Na–O2) batteries are plagued by persistent discharge–charge capacity imbalances stemming from parasitic reactions and the incompletely reversible oxygen redox chemistry induced by the reactive superoxide species. Herein, we propose the integration of commercial potassium superoxide (KO2) as a sacrificial solid reservoir to actively compensate for the rechargeable superoxide loss in sodium superoxide (NaO2)-based Na–O2 batteries. Mechanistic and spectroscopic investigations reveal that the preloaded KO2 serves a dual function: it acts as an extra superoxide source to directly replenish early stage capacity losses while simultaneously functioning as a promoter to mediate the formation of NaO2. Benefiting from this reservoir-mediated regulation, the KO2-configured Na–O2 cells exhibit unprecedented cyclability, delivering a near-unity Coulombic efficiency (98.5% on average) and sustaining a prolonged lifespan of over 600 cycles. This work establishes a robust paradigm for active capacity compensation, offering a highly scalable design principle to unlock the full potential of alkali metal–air battery systems.

  • Janus Highly Fluorinated Ether: K + ‐Channel Activator or Anode Corrosion Trigger in High‐Concentration Electrolytes for K–O 2 Batteries?

    by Yu Zhong, Xiaojuan Chen, Xinyang Zhang, Lei Qin

    The capacity and lifespan of superoxide‐based potassium–oxygen batteries (POBs) are limited by the failure of the potassium (K) anode due to oxygen crossover. The high‐concentration potassium bis(trifluoromethanesulfonyl)imide (KTFSI)/dimethoxyethane recipe enables efficient anode passivation, but its high viscosity and elevated cost necessitate the use of a highly fluorinated ether co‐solvent. In this study, we elucidate the indeterminate role of fluoroether in constructing the anode passivation layer. The fluoroether participates with TFSI − anions to form a robust solid electrolyte interphase (SEI) that effectively mitigates oxygen crossover. Moreover, the fluoroether shows a Janus effect that excessive addition triggers severe K corrosion, while an optimal amount leads to a desirable SEI on the K surface. This SEI acts both as an oxygen permeation barrier and as an efficient K + ‐conductive channel. With a more stable environment for the K anode, a POB utilizing the KTFSI‐based electrolyte delivers over 200 cycles (above 800 h) with low round‐trip overpotentials and high average coulombic efficiency (98.1%) as opposed to one using the potassium hexafluorophosphate‐based electrolyte that fails early. Spectroscopic analyses and theoretical simulations were utilized to elucidate the molecular‐scale interactions in the electrolyte components. This study provides fundamental insights and practical strategies for the development of long‐life POBs.


  • Empowering the Potassium–Sulfur Battery with Commendable Reaction Kinetics and Capacity Output by Localized High-Concentration Electrolytes

    by Xiaojuan Chen, Yan Meng, Dan Xiao, Lei Qin

    Potassium-sulfur (K-S) batteries are one of the promising high-energy-density candidates beyond current lithium-ion batteries. Nevertheless, in practice, the utilization of K-S batteries is largely hindered due to the dissolution and shuttle effect of the cathode redox intermediates and the scarcity of an effective anode protection layer in conventional electrolytes. Herein, electrolyte engineering is applied to formulate an ether-based localized high-concentration electrolyte (LHCE) for the first time in a K-S cell with the mitigated parasitic effect of polysulfide dissolution and shuttle and the tuned anode-electrolyte interface property. A nonsolvating and polysulfide-stable fluoroether is sieved as a cosolvent in such an LHCE, which possesses the ultralow polysulfides solubility due to less roaming solvents and thus alleviates the polysulfides shuttle effect. The anion-derived solid electrolyte interphase enriched in inorganic components is constructed due to the strengthened cation-anion interplay in the primary solvation sheath and highlighted with accelerated interfacial kinetics in a K-S cell. It is validated that the proposed LHCE unlocks the theoretical capacity of the K-S cell based on the conversion between S and K2S3. It is further revealed that the lifespan is limited to the anode corrosion with severe cosolvent degradation caused by limited solvating solvent compatibility with metallic K, and the inevitable byproduct accumulation at the S cathode. The K-S cell based on the designed LHCE could achieve a prolonged lifespan with a reversible capacity of 448 mA h/gs after 80 cycles with an elaborate cathode design. This work shines a light on the electrolyte design perspective for full utilization and an in-depth mechanistic understanding of high-energy-density K-S batteries.


  • Open Access

    Design and Synthesis of Cubic K3−2xBaxSbSe4 Solid Electrolytes for K–O2 Batteries

    by Jieren Shao, Huiling Ao, Lei Qin, Jocelyn Elgin, Curtis E. Moore, Yehia Khalifa, Songwei Zhang, Yiying Wu

    Developing K‐ion conducting solid‐state electrolytes (SSEs) plays a critical role in the safe implementation of potassium batteries. In this work, a chalcogenide‐based potassium ion SSE is reported, K3SbSe4, which adopts a trigonal structure at room temperature. Single‐crystal structural analysis reveals a trigonal‐to‐cubic phase transition at the low temperature of 50 °C, which is the lowest among similar compounds and thus provides easy access to the cubic phase. The substitution of barium for potassium in K3SbSe4 leads to the creation of potassium vacancies, expansion of lattice parameters, and a transformation from a trigonal phase to a cubic phase. As a result, the maximum conductivity of K3−2xBaxSbSe4 reaches around 0.1 mS cm−1 at 40 °C for K2.2Ba0.4SbSe4, which is over two orders of magnitude higher than that of undoped K3SbSe4. This novel SSE is successfully employed in a K–O2 battery operating at room temperature where a polymer‐laminated K2.2Ba0.4SbSe4 pellet serves as a separator between the oxygen cathode and the potassium metal anode. Effective protection of the K metal anode against corrosion caused by O2 is demonstrated.


  • Feasibility of achieving two-electron K–O 2 batteries

    by Lei Qin, Huiling Ao, Yiying Wu

    A deep understanding of the oxygen (O2) reduction and evolution mechanisms is crucial for understanding metal–O2 batteries. It has become evident that the instability of superoxide in the presence of lithium (Li) ions and sodium (Na) ions is the root cause for the poor reversibility and energy efficiency of Li–O2 and Na–O2 batteries. A straightforward yet elegant method is stabilizing superoxide with the larger potassium (K) ions. Superoxide-based K–O2 batteries, invented by our group in 2013, are operated based on one-electron redox of O2/potassium superoxide (KO2) and have high energy efficiencies without any electrocatalysts. Nevertheless, limiting the anionic redox to O2/superoxide affects the capacity output. Therefore, it is attractive to explore the possibility of beyond KO2 in the K–O2 batteries, especially if the use of catalysts can still be avoided. In this research, solid KO2 was used as the condensed O2 source and pre-dissolved in the dimethyl sulfoxide (DMSO)-based electrolyte. It is encouraging to observe two sets of reversible peaks during the three-electrode cyclic voltammetry scan under an argon atmosphere. One pair of peaks is attributed to the KO2/potassium peroxide (K2O2) interconversion. Such redox has superb reversibility and a small overpotential of 239 mV in the absence of explicit electrocatalysts. Notably, it is further revealed that K2O2 reacts with gaseous O2. Therefore, a gas-open system with an O2 supply is unfavorable for realizing the reversible KO2/K2O2 redox, and a closed cell system with a KO2 supply as the starting active material is suggested instead.


  • Open Access

    Designing High‐Donicity Anions for Rechargeable Potassium Superoxide/Peroxide Batteries

    by Lei Qin, Luke Schkeryantz, Yiying Wu

    A battery cathode based on the superoxide/peroxide redox not only inherits the advantage of oxygen (O2) batteries in high capacities and low costs but also overcomes the disadvantages in O2storage, electrolyte evaporation, and anode deactivation due to O2crossover. Herein, we report an enhanced potassium superoxide (KO2)/peroxide (K2O2) conversion by adopting a high‐donicity anion additive in the ether‐based electrolyte. Such an anion was synthesized via a “Solvent‐in‐Anion” strategy and validated to enhance the electron donicity of the electrolyte. The use of high‐donicity anion could lead to enhanced KO2utilization (≈90.2 %) by retarding electrode passivation and allow the full charging back of K2O2through the solution‐mediated pathway without electrocatalysts. No apparent cell degradation is observed during the first 120 cycles by controlling the reversible depth‐of‐discharge capacity at 292 mAh g−1within an O2‐free region. The K−KO2cell delivers a high energy efficiency (>84.4 %) and a lifespan of over 1440 hours.

  • Open Access

    Designing High‐Donicity Anions for Rechargeable Potassium Superoxide/Peroxide Batteries

    by Lei Qin, Luke Schkeryantz, Yiying Wu

    A battery cathode based on the superoxide/peroxide redox not only inherits the advantage of oxygen (O2) batteries in high capacities and low costs but also overcomes the disadvantages in O2storage, electrolyte evaporation, and anode deactivation due to O2crossover. Herein, we report an enhanced potassium superoxide (KO2)/peroxide (K2O2) conversion by adopting a high‐donicity anion additive in the ether‐based electrolyte. Such an anion was synthesized via a “Solvent‐in‐Anion” strategy and validated to enhance the electron donicity of the electrolyte. The use of high‐donicity anion could lead to enhanced KO2utilization (≈90.2 %) by retarding electrode passivation and allow the full charging back of K2O2through the solution‐mediated pathway without electrocatalysts. No apparent cell degradation is observed during the first 120 cycles by controlling the reversible depth‐of‐discharge capacity at 292 mAh g−1within an O2‐free region. The K−KO2cell delivers a high energy efficiency (>84.4 %) and a lifespan of over 1440 hours.


  • Open Access

    Phase Transfer‐Mediated Degradation of Ether‐Based Localized High‐Concentration Electrolytes in Alkali Metal Batteries

    by Xiaojuan Chen, Lei Qin, Jiaonan Sun, Songwei Zhang, Dan Xiao, Yiying Wu

    Localized high‐concentration electrolytes (LHCEs) have attracted interest in alkali metal batteries due to the advantages of forming stable solid‐electrolyte interphases (SEIs) on anodes and good chemical/electrochemical stability. Herein, a new degradation mechanism is revealed for ether‐based LHCEs that questions their compatibility with alkali metal anodes (Li, Na, and K). Specifically, the ether solvent reacts with alkali metals to generate solvated electrons (es−) that attack hydrofluoroether co‐solvents to form a series of byproducts. The ether solvent essentially acts as a phase‐transfer reagent that continuously transfers electrons from solid‐phase metals into the solution phase, thus inhibiting the formation of stable SEI and leading to continuous alkali metal corrosion. Switching to an ester‐based solvating solvent or intercalation anodes such as graphite or molybdenum disulfide has been shown to avoid such a degradation mechanism due to the absence of es−.