Michael Wang
Research Subjects
Michael Wang has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- James S. Speck
University of California, Santa Barbara
3 shared publications - Shuji Nakamura
University of California
3 shared publications - Steven DenBaars
University of California
3 shared publications - Christian J. Zollner
Materials Department, University of California 1 , Santa Barbara, California 93106, USA
2 shared publications Feng Wu
2 shared publications- Feng Wu
Materials Department, University of California 2 , Santa Barbara, California 93106, USA
2 shared publications
Latest Publications
- 3 August 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (5)
Green LEDs with V-defects formed from intentional dislocation half-loops
Group III-nitride light emitting diodes (LEDs) suffer from poor efficiency for longer wavelength emission. This is partly due to increased polarization-induced barriers to vertical carrier injection at InGaN/GaN interfaces in the polar c-plane, where higher In-content is required for long-wavelength emission. Polarization-induced barriers can be bypassed by lateral carrier injection through the semipolar sidewalls of V-defects, which form at the apex of threading dislocations (TDs) during kinetically limited growth. This increases wall-plug efficiency (WPE) through the reduction of forward voltage (VF). TD and resulting V-defect density can be controlled through the formation of edge dislocation half-loops prior to V-defect opening. In this work, we demonstrate a green V-defect LED with optimized AlGaN caps with high external quantum efficiency (EQE) and WPE. The green V-defect LED demonstrated here with such a device structure achieves a peak EQE and a peak WPE of 43.9% and 37.0%, respectively.
- 3 August 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (5)
Green LEDs with V-defects formed from intentional dislocation half-loops
Group III-nitride light emitting diodes (LEDs) suffer from poor efficiency for longer wavelength emission. This is partly due to increased polarization-induced barriers to vertical carrier injection at InGaN/GaN interfaces in the polar c-plane, where higher In-content is required for long-wavelength emission. Polarization-induced barriers can be bypassed by lateral carrier injection through the semipolar sidewalls of V-defects, which form at the apex of threading dislocations (TDs) during kinetically limited growth. This increases wall-plug efficiency (WPE) through the reduction of forward voltage (VF). TD and resulting V-defect density can be controlled through the formation of edge dislocation half-loops prior to V-defect opening. In this work, we demonstrate a green V-defect LED with optimized AlGaN caps with high external quantum efficiency (EQE) and WPE. The green V-defect LED demonstrated here with such a device structure achieves a peak EQE and a peak WPE of 43.9% and 37.0%, respectively.
- 30 April 2025
- Published by Optica Publishing Group in Optics Express
- Vol. 33 (9) , 19876-19884
10.4% external quantum efficiency 294 nm UV LEDs at 20 A/cm2 with a fully transparent tunnel junction
We report on the successful demonstration of an all metalorganic chemical vapor deposition (MOCVD) grown fully transparent tunnel junction (TJ) germicidal UV LED, resulting from the use of a lightly doped n--AlGaN contact layer enabling rapid MOCVD growth optimization. We found that the optimal condition for LED performance was a 3 nm p++-Al0.6Ga0.4N / 9 nm n++-Al0.65Ga0.35N TJ above a 20 period 1 nm p-Al0.8Ga0.2N/ 1 nm p-Al0.2Ga0.8N short-period superlattice (SPSL). We observed a peak external quantum efficiency (EQE) of the λ = 294 nm TJ UV LED of 12.1%, and an EQE of 10.4% at 20 A/cm2 and 9.1% at 35 A/cm2, with an excess voltage of 1.5 V at 1 A/cm2.
- 30 April 2025
- Published by Optica Publishing Group in Optics Express
- Vol. 33 (9) , 19876-19884
10.4% external quantum efficiency 294 nm UV LEDs at 20 A/cm2 with a fully transparent tunnel junction
We report on the successful demonstration of an all metalorganic chemical vapor deposition (MOCVD) grown fully transparent tunnel junction (TJ) germicidal UV LED, resulting from the use of a lightly doped n--AlGaN contact layer enabling rapid MOCVD growth optimization. We found that the optimal condition for LED performance was a 3 nm p++-Al0.6Ga0.4N / 9 nm n++-Al0.65Ga0.35N TJ above a 20 period 1 nm p-Al0.8Ga0.2N/ 1 nm p-Al0.2Ga0.8N short-period superlattice (SPSL). We observed a peak external quantum efficiency (EQE) of the λ = 294 nm TJ UV LED of 12.1%, and an EQE of 10.4% at 20 A/cm2 and 9.1% at 35 A/cm2, with an excess voltage of 1.5 V at 1 A/cm2.
- 25 April 2025
- Published by Optica Publishing Group in Optics Express
- Vol. 33 (9) , 19391-19398
Increasing light extraction efficiency for UV LEDs with a low coverage p-GaN hole injection layer
We report on the use of ultrathin low-coverage p-GaN hole injection islands on the top surface to improve the light extraction in UV LEDs, resulting in world-record UVB AlGaN UV LEDs emitting at 300 and 310 nm. With the optimization of the p-GaN island density, size, thickness, and doping, we demonstrated a 300 nm emitting device with a peak continuous wave (CW) external quantum efficiency (EQE) of 18.9%, a peak CW wall plug efficiency (WPE) of 16.8%, and a CW EQE of 8.8% at 20 A/cm2, and a 310 nm emitting device with a peak CW EQE of 20.3%, a peak CW WPE of 15.4%, and a CW EQE of 10.9% at 20 A/cm2.
- 25 April 2025
- Published by Optica Publishing Group in Optics Express
- Vol. 33 (9) , 19391-19398
Increasing light extraction efficiency for UV LEDs with a low coverage p-GaN hole injection layer
We report on the use of ultrathin low-coverage p-GaN hole injection islands on the top surface to improve the light extraction in UV LEDs, resulting in world-record UVB AlGaN UV LEDs emitting at 300 and 310 nm. With the optimization of the p-GaN island density, size, thickness, and doping, we demonstrated a 300 nm emitting device with a peak continuous wave (CW) external quantum efficiency (EQE) of 18.9%, a peak CW wall plug efficiency (WPE) of 16.8%, and a CW EQE of 8.8% at 20 A/cm2, and a 310 nm emitting device with a peak CW EQE of 20.3%, a peak CW WPE of 15.4%, and a CW EQE of 10.9% at 20 A/cm2.
- Open Access
- 4 December 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (23)
10.6% external quantum efficiency germicidal UV LEDs grown on thin highly conductive n-AlGaN
We report on the material challenges of the growth of highly conductive n-AlGaN in germicidal ultraviolet light emitting diodes (GUV LEDs), with the degradation of the surface morphology of thick highly doped n-AlGaN due to the Si anti-surfactant effect. Threading dislocation inclination, increasing relaxation, and eventual cracking were observed with epitaxial n-AlGaN films thicker than 400 nm, along with an increasing Ga composition with the same metalorganic flows. With the optimization of the n-AlGaN conductivity in previous works, thin n-AlGaN films with high conductivity along with a smoothing superlattice were incorporated in GUV LED devices, resulting in LEDs with 285 nm electroluminescence, a low forward voltage of 4.2 V with a peak external quantum efficiency (EQE) of 10.6% and a peak wall-plug efficiency of 8.6% below 1 A/cm2, and an EQE of 5.5% at 20 A/cm2.
- 4 December 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (23)
Open Access10.6% external quantum efficiency germicidal UV LEDs grown on thin highly conductive n-AlGaN
We report on the material challenges of the growth of highly conductive n-AlGaN in germicidal ultraviolet light emitting diodes (GUV LEDs), with the degradation of the surface morphology of thick highly doped n-AlGaN due to the Si anti-surfactant effect. Threading dislocation inclination, increasing relaxation, and eventual cracking were observed with epitaxial n-AlGaN films thicker than 400 nm, along with an increasing Ga composition with the same metalorganic flows. With the optimization of the n-AlGaN conductivity in previous works, thin n-AlGaN films with high conductivity along with a smoothing superlattice were incorporated in GUV LED devices, resulting in LEDs with 285 nm electroluminescence, a low forward voltage of 4.2 V with a peak external quantum efficiency (EQE) of 10.6% and a peak wall-plug efficiency of 8.6% below 1 A/cm2, and an EQE of 5.5% at 20 A/cm2.
- Open Access
Highly Conductive n-Al0.65Ga0.35N Grown by MOCVD Using Low V/III Ratio
Highly conductive silicon-doped AlGaN and ohmic contacts are needed for deep-UV LEDs and ultrawide bandgap electronics. We demonstrate improved n-Al0.65Ga0.35N films grown by metal–organic chemical vapor deposition (MOCVD) on sapphire substrates using a low V/III ratio (V/III = 10). A reduced V/III ratio improves repeatability and uniformity by allowing a wider range of silicon precursor flow conditions. AlxGa1−xN:Si with x > 0.5 typically has an electron concentration vs. silicon concentration trend that peaks at a particular “knee” value before dropping sharply as [Si] continues to increase (self-compensation). The Al0.65Ga0.35N:Si grown under the lowest V/III conditions in this study does not show the typical knee behavior, and instead, it has a flat electron concentration trend for [Si] > 3 × 1019 cm−3. Resistivities as low as 4 mΩ-cm were achieved, with corresponding electron mobility of 40 cm2/Vs. AFM and TEM confirm that surface morphology and dislocation density are not degraded by these growth conditions. Furthermore, we report vanadium-based ohmic contacts with a resistivity of 7 × 10−5 Ω-cm2 to AlGaN films grown using a low V/III ratio. Lastly, we use these highly conductive silicon-doped layers to demonstrate a 284 nm UV LED with an operating voltage of 7.99 V at 20 A/cm2, with peak EQE and WPE of 3.5% and 2.7%, respectively.
Open AccessHighly Conductive n-Al0.65Ga0.35N Grown by MOCVD Using Low V/III Ratio
Highly conductive silicon-doped AlGaN and ohmic contacts are needed for deep-UV LEDs and ultrawide bandgap electronics. We demonstrate improved n-Al0.65Ga0.35N films grown by metal–organic chemical vapor deposition (MOCVD) on sapphire substrates using a low V/III ratio (V/III = 10). A reduced V/III ratio improves repeatability and uniformity by allowing a wider range of silicon precursor flow conditions. AlxGa1−xN:Si with x > 0.5 typically has an electron concentration vs. silicon concentration trend that peaks at a particular “knee” value before dropping sharply as [Si] continues to increase (self-compensation). The Al0.65Ga0.35N:Si grown under the lowest V/III conditions in this study does not show the typical knee behavior, and instead, it has a flat electron concentration trend for [Si] > 3 × 1019 cm−3. Resistivities as low as 4 mΩ-cm were achieved, with corresponding electron mobility of 40 cm2/Vs. AFM and TEM confirm that surface morphology and dislocation density are not degraded by these growth conditions. Furthermore, we report vanadium-based ohmic contacts with a resistivity of 7 × 10−5 Ω-cm2 to AlGaN films grown using a low V/III ratio. Lastly, we use these highly conductive silicon-doped layers to demonstrate a 284 nm UV LED with an operating voltage of 7.99 V at 20 A/cm2, with peak EQE and WPE of 3.5% and 2.7%, respectively.