Bayron Lennin Murillo-Borjas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Bayron Lennin Murillo-Borjas has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Manuel Angel Quevedo-López
Department of Materials Science and Engineering, University of Texas at Dallas, Richardson, TX 75080, USA
1 shared publication - Maria Isabel Pintor-Monroy
Imec, Kapeldreef 75, 3001 Leuven, Belgium
1 shared publication - Massimo Catalano
Institute for Microelectronics and Microsystems, IMM-CNR
1 shared publication - Qing Gu
North Carolina State University
1 shared publication - Xi Li
Department of Electrical Engineering, University of Texas at Dallas, Richardson, TX 75080, USA
1 shared publication
Latest Publications
- 1 December 2021
- Published by Elsevier in Nano Communication Networks
- Vol. 30
High-speed nanoLEDs for chip-scale communication
- 1 December 2021
- Published by Elsevier in Nano Communication Networks
- Vol. 30
High-speed nanoLEDs for chip-scale communication
- 8 July 2019
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (30) , 27048-27056
Controlling Carrier Type and Concentration in NiO Films To Enable in Situ PN Homojunctions
In this work, the oxygen partial pressure during NiO deposition in reactive sputtering of a Ni target is used to control its carrier type and concentration, obtaining both n- and p- type films. Carrier concentration can be controlled, ranging from 1019 cm-3 to 1014 cm-3. Films deposition is carried out at 200 °C, a relatively low temperature that enables the use of glass as substrate. Experimental band diagrams for n- type NiO are obtained for the first time. Finally, A NiO homojunction is demonstrated by introducing a low carrier concentration layer in between n- and p+-type NiO layers. Layers are deposited in-situ, preventing contamination and improving the interface quality, as observed by TEM. The Ni:O ratio for each layer was also obtained by analytical TEM measurements, demonstrating the impact of the oxygen partial pressure on the films stoichiometry and the simplicity of our process to control carrier type and carrier concentration in oxide semiconductors.
- 8 July 2019
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (30) , 27048-27056
Controlling Carrier Type and Concentration in NiO Films To Enable in Situ PN Homojunctions
In this work, the oxygen partial pressure during NiO deposition in reactive sputtering of a Ni target is used to control its carrier type and concentration, obtaining both n- and p- type films. Carrier concentration can be controlled, ranging from 1019 cm-3 to 1014 cm-3. Films deposition is carried out at 200 °C, a relatively low temperature that enables the use of glass as substrate. Experimental band diagrams for n- type NiO are obtained for the first time. Finally, A NiO homojunction is demonstrated by introducing a low carrier concentration layer in between n- and p+-type NiO layers. Layers are deposited in-situ, preventing contamination and improving the interface quality, as observed by TEM. The Ni:O ratio for each layer was also obtained by analytical TEM measurements, demonstrating the impact of the oxygen partial pressure on the films stoichiometry and the simplicity of our process to control carrier type and carrier concentration in oxide semiconductors.