Zhongdi Duan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhongdi Duan has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Hongxiang Xue
11 shared publicationsMingxuan Shi
6 shared publicationsZhiwei Wang
5 shared publicationsHaoran Sun
4 shared publicationsShiwen Liu
4 shared publicationsChengyun Wu
3 shared publications
Latest Publications
- 1 October 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (10)
Mechanistic and statistical study of two-phase flow instability in a heat removal pipeline under rolling motion
Passive residual heat removal systems are influenced by oscillatory inertial forces under marine conditions, making two-phase flow instability more complex than under static conditions. In this study, visualization experiments were conducted to investigate two-phase flow instability in a residual heat removal pipeline under different rolling frequencies and amplitudes. Four instability modes were identified based on their initiation locations and interfacial evolution: cold-side instability, solitary-wave impact instability, global interfacial instability, and vapor-side impact instability. Within the tested conditions, rolling frequency more strongly affected instability transition than amplitude, which mainly affected instability intensity and mode diversity. At the representative condition of 0.3 Hz and 3°, the rolling period was comparable to the characteristic thermal-hydraulic response time, and pronounced phase-locking was observed, with concentrated instability triggering dominated by Mode IV. At this condition, the event count increased by approximately 27% relative to 0.1 Hz, and all recorded peak pressures remained below 1 MPa. At higher rolling frequencies, stronger inertial effects promoted multi-mode instability and complex interfacial evolution. Together, these results identified three response regions characterized by condensation-dominated instability, gravity-constrained synchronized response, and inertia-enhanced multi-mode instability. Non-inertial-frame analysis identified the Coriolis acceleration as the dominant rolling-induced component and quantified the increasing modulation of the pipe-normal effective acceleration, supporting the proposed response-region interpretation.
- 1 October 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (10)
Mechanistic and statistical study of two-phase flow instability in a heat removal pipeline under rolling motion
Passive residual heat removal systems are influenced by oscillatory inertial forces under marine conditions, making two-phase flow instability more complex than under static conditions. In this study, visualization experiments were conducted to investigate two-phase flow instability in a residual heat removal pipeline under different rolling frequencies and amplitudes. Four instability modes were identified based on their initiation locations and interfacial evolution: cold-side instability, solitary-wave impact instability, global interfacial instability, and vapor-side impact instability. Within the tested conditions, rolling frequency more strongly affected instability transition than amplitude, which mainly affected instability intensity and mode diversity. At the representative condition of 0.3 Hz and 3°, the rolling period was comparable to the characteristic thermal-hydraulic response time, and pronounced phase-locking was observed, with concentrated instability triggering dominated by Mode IV. At this condition, the event count increased by approximately 27% relative to 0.1 Hz, and all recorded peak pressures remained below 1 MPa. At higher rolling frequencies, stronger inertial effects promoted multi-mode instability and complex interfacial evolution. Together, these results identified three response regions characterized by condensation-dominated instability, gravity-constrained synchronized response, and inertia-enhanced multi-mode instability. Non-inertial-frame analysis identified the Coriolis acceleration as the dominant rolling-induced component and quantified the increasing modulation of the pipe-normal effective acceleration, supporting the proposed response-region interpretation.
- 1 October 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (10)
A deep learning-based surrogate model of nonlinear sloshing subjected to random excitations
Liquid sloshing under external excitation produces strongly nonlinear free-surface motion that is expensive to simulate and difficult to predict over long times with purely data-driven surrogates, which tend to lose stability during recursive rollout. This study presents a deep learning-based surrogate model for nonlinear sloshing subjected to random excitations using a Lagrangian method. The model partitions the dynamics into an explicitly computed response to external forces and an implicitly learned correction for particle interactions, which reduces the learning burden and improves interpretability while enabling fast and stable rollout. In the tested cases, the accumulated error grows approximately linearly at early steps and then stays within a bounded range around 25 mm. The model applies across coupled multi-degree-of-freedom excitation, different tank geometries and dimensions, and varying filling ratios, while preserving the dominant free-surface dynamics. Further analysis traces this stability to the convolution operator, whose kernel is stored on a fixed grid and evaluated by interpolation. This structure constrains the local perturbation response, yielding a narrow distribution of empirical Lipschitz estimates, with only 7% of the states exceeding the neutral value, compared with 47% for an otherwise identical graph-neural-network baseline using a free multilayer-perceptron kernel. It also reduces the disruption caused by topology switching by more than an order of magnitude, from 0.176 to 0.01. The proposed surrogate offers a fast and reliable route to sloshing prediction and provides a useful reference for building particle-level sloshing surrogates in digital-twin applications.
- 1 October 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (10)
A deep learning-based surrogate model of nonlinear sloshing subjected to random excitations
Liquid sloshing under external excitation produces strongly nonlinear free-surface motion that is expensive to simulate and difficult to predict over long times with purely data-driven surrogates, which tend to lose stability during recursive rollout. This study presents a deep learning-based surrogate model for nonlinear sloshing subjected to random excitations using a Lagrangian method. The model partitions the dynamics into an explicitly computed response to external forces and an implicitly learned correction for particle interactions, which reduces the learning burden and improves interpretability while enabling fast and stable rollout. In the tested cases, the accumulated error grows approximately linearly at early steps and then stays within a bounded range around 25 mm. The model applies across coupled multi-degree-of-freedom excitation, different tank geometries and dimensions, and varying filling ratios, while preserving the dominant free-surface dynamics. Further analysis traces this stability to the convolution operator, whose kernel is stored on a fixed grid and evaluated by interpolation. This structure constrains the local perturbation response, yielding a narrow distribution of empirical Lipschitz estimates, with only 7% of the states exceeding the neutral value, compared with 47% for an otherwise identical graph-neural-network baseline using a free multilayer-perceptron kernel. It also reduces the disruption caused by topology switching by more than an order of magnitude, from 0.176 to 0.01. The proposed surrogate offers a fast and reliable route to sloshing prediction and provides a useful reference for building particle-level sloshing surrogates in digital-twin applications.
- 1 January 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (1)
Experimental investigation of phase transition effects on impact pressure dynamics in sloshing flows
The safe and efficient marine transportation of cryogenic fuels such as liquefied natural gas (LNG) presents significant technical challenges, particularly under sloshing conditions where violent impact may occur. Investigating phase transition effects in LNG sloshing is crucial for enhancing transport safety, since phase transition is an inherent feature of near-equilibrium sloshing whose effects on sloshing impacts have not been thoroughly understood. This study experimentally investigates the influence of phase transition on sloshing flow characteristics and impact loads. Utilizing a customized sloshing model tank and the refrigerant R141b, sloshing experiments are conducted under both phase transition and non-phase transition conditions. By analyzing high-speed images of the sloshing evolutions, typical sloshing modes are classified. Long-duration impact pressure signals are collected and analyzed from multiple perspectives in both time and frequency domains to characterize how phase transition modifies the evolution of impact pressure waveforms. In consideration of the randomness of pressure signals, statistical analyses of pressure peaks are also performed, revealing that phase transition leads to reduced peak values, narrower distributions, and decreased variability. Furthermore, the study explores the implications of pressure rise time on dynamic structural response. The findings provide essential insights into incorporating phase transition mechanisms into impact load assessment frameworks. This contributes to the development of safer, more reliable, and cost-effective design standards for LNG containment systems in marine transportation.
- 1 January 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (1)
Experimental investigation of phase transition effects on impact pressure dynamics in sloshing flows
The safe and efficient marine transportation of cryogenic fuels such as liquefied natural gas (LNG) presents significant technical challenges, particularly under sloshing conditions where violent impact may occur. Investigating phase transition effects in LNG sloshing is crucial for enhancing transport safety, since phase transition is an inherent feature of near-equilibrium sloshing whose effects on sloshing impacts have not been thoroughly understood. This study experimentally investigates the influence of phase transition on sloshing flow characteristics and impact loads. Utilizing a customized sloshing model tank and the refrigerant R141b, sloshing experiments are conducted under both phase transition and non-phase transition conditions. By analyzing high-speed images of the sloshing evolutions, typical sloshing modes are classified. Long-duration impact pressure signals are collected and analyzed from multiple perspectives in both time and frequency domains to characterize how phase transition modifies the evolution of impact pressure waveforms. In consideration of the randomness of pressure signals, statistical analyses of pressure peaks are also performed, revealing that phase transition leads to reduced peak values, narrower distributions, and decreased variability. Furthermore, the study explores the implications of pressure rise time on dynamic structural response. The findings provide essential insights into incorporating phase transition mechanisms into impact load assessment frameworks. This contributes to the development of safer, more reliable, and cost-effective design standards for LNG containment systems in marine transportation.
- Open Access
- 29 August 2025
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 74
Numerical investigation on steam bubble condensation and water hammer effects in cold seawater pipe for passive heat removal
- 29 August 2025
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 74
Open AccessNumerical investigation on steam bubble condensation and water hammer effects in cold seawater pipe for passive heat removal
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Experimental investigation on liquid–gas interfacial dynamics and phase transition effects under non-isothermal sloshing conditions
Non-isothermal sloshing frequently occurs in cryogenic fuel tanks (e.g., liquefied natural gas and liquefied hydrogen) during marine transportation. The resulting liquid–gas phase transition is strongly influenced by sloshing flows, inducing instantaneous pressure and temperature variations that compromise operational safety and reliability of liquid cargo systems. This paper experimentally investigates the liquid–gas interfacial dynamics and phase transition effects on tank thermodynamics under non-isothermal sloshing conditions. Visual experiments were conducted across four sloshing frequencies and three amplitudes, revealing four distinct sloshing regimes based on interfacial behaviors. The two-phase interfacial region emerges in sloshing regime III due to disturbances from liquid jets and phase transition, and expands significantly in regime IV, which replaces the clear free surface. Non-isothermal sloshing triggers brief surface evaporation and pressurization, followed by sustained vapor condensation and depressurization. Thermal stratification persists in regimes I and II, while de-stratification initiates in the liquid phase (regime III) and extends to both phases (regime IV). The measured results indicate that the peak and average condensation rates scale cubically with those of evaporation rates, and the logarithmic average evaporation rate varies linearly with frequency and follows a power-law dependence on amplitude. We finally propose empirical correlations linking sloshing parameters to evaporation rates and condensation rates to evaporation rates, showing good agreement with experimental data.
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Experimental investigation on liquid–gas interfacial dynamics and phase transition effects under non-isothermal sloshing conditions
Non-isothermal sloshing frequently occurs in cryogenic fuel tanks (e.g., liquefied natural gas and liquefied hydrogen) during marine transportation. The resulting liquid–gas phase transition is strongly influenced by sloshing flows, inducing instantaneous pressure and temperature variations that compromise operational safety and reliability of liquid cargo systems. This paper experimentally investigates the liquid–gas interfacial dynamics and phase transition effects on tank thermodynamics under non-isothermal sloshing conditions. Visual experiments were conducted across four sloshing frequencies and three amplitudes, revealing four distinct sloshing regimes based on interfacial behaviors. The two-phase interfacial region emerges in sloshing regime III due to disturbances from liquid jets and phase transition, and expands significantly in regime IV, which replaces the clear free surface. Non-isothermal sloshing triggers brief surface evaporation and pressurization, followed by sustained vapor condensation and depressurization. Thermal stratification persists in regimes I and II, while de-stratification initiates in the liquid phase (regime III) and extends to both phases (regime IV). The measured results indicate that the peak and average condensation rates scale cubically with those of evaporation rates, and the logarithmic average evaporation rate varies linearly with frequency and follows a power-law dependence on amplitude. We finally propose empirical correlations linking sloshing parameters to evaporation rates and condensation rates to evaporation rates, showing good agreement with experimental data.
- Open Access
- 16 July 2025
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 73
Numerical modeling and investigation on the adsorption kinetics and thermal regulation effects of adsorbent coating for cryogenic storage
- 16 July 2025
- Published by Elsevier in Case Studies in Thermal Engineering
- Vol. 73
Open AccessNumerical modeling and investigation on the adsorption kinetics and thermal regulation effects of adsorbent coating for cryogenic storage