TSTetiana Solomko

Tetiana Solomko

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tetiana Solomko has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • ЕФЕКТИВНІСТЬ ПОЛІТИКИ ДЕРЖАВНОГО РЕГУЛЮВАННЯ ЕКОНОМІКИ УКРАЇНИ ПІД ЧАС ВОЄННОГО СТАНУ

    by Ольга Гаршина, Тетяна Бауліна, Тетяна Соломко, Олександр Рудаков

    The article substantiates the assessment of the effectiveness of the policy of state regulation of the economy of Ukraine during the Russian-Ukrainian war. Based on the statistical analysis of macroeconomic indicators, reverse trends in their dynamics were identified compared to the peace period: consumer spending grew much more slowly than GDP, the gap between them per capita was growing; GDP increased due to increased consumer spending and militarization of the economy, its growth was largely inflationary and was non-inclusive. A significant reduction in foreign direct investment was recorded; domestic sources of investment exceeded foreign ones by approximately 6-7 times. A slowdown in the growth rate of labor productivity and an increase in the growth rate of average wages were detected, as well as an increase in the gap between the absolute values of indicators per capita. An increase in the gap between labor productivity indicators and real incomes per capita was proven. It was determined that the reasons for the fall in real incomes are high inflation and an increase in the unemployment rate, which are the consequences of the low quality of economic regulation; GDP growth did not ensure an increase in real incomes of the population. The increase in the share of budget expenditures in Ukraine's GDP was recorded by more than 2 times to the level of 60% and approaching the effect of crowding out private investments. The conclusion was made about the weak effectiveness of regulatory policy during martial law: of all the main goals of economic development, only moderate GDP growth was achieved, which only in the fourth year of the war reached the pre-war level. It is proposed to attract foreign direct investment to regions with a lower level of danger in the west of the country, while simultaneously introducing real incentives for foreign companies; introducing long-term investment programs for the restoration of the energy sector, optimizing supply chains, and developing a system of incentives for employers to eliminate regional disparities in the labor market.

  • Open Access

    НАПРЯМИ РЕФОРМУВАННЯ ПОДАТКОВОЇ СИСТЕМИ УКРАЇНИ В УМОВАХ ВОЄННОГО СТАНУ З МЕТОЮ ЗАБЕЗПЕЧЕННЯ ЕКОНОМІЧНОГО РОЗВИТКУ КРАЇНИ

    by Тетяна Володимирівна Бауліна, Ольга Костянтинівна Гаршина, Тетяна Юріївна Соломко, Олександр Миколайович Рудаков

    У статті обґрунтовано необхідність реформування податкової системи України під час воєнного стану з метою забезпечення економічного розвитку; проаналізовано причини, за яких знижується ВВП країни і скорочується стягнення прямих та непрямих податків у воєнний час. Виявлено негативні тенденції соціально-економічного розвитку України у 2022 році; доведено, що має місце скорочення споживчого попиту домогосподарств у 2022 році. Зроблено висновок про необхідність бюджетного фінансування економічного розвитку країни під час воєнного стану. Доведено необхідність посилення фіскальної функції податків з метою збільшення надходжень до державного бюджету, перш за все, за рахунок ПДВ та акцизного податку, які мають найбільшу податкову ефективність. Доведено, що не міжнародні вливання, а лише надходження з національних джерел дозволяють забезпечувати економічне зростання національного господарства. Запропоновано збільшити ставку ПДВ на 1,5%, розроблено новий підхід до оподаткування акцизним податком, прогресивну шкалу оподаткування для заможних українців, запропоновано корегування податку на приріст капіталу та впровадження податку на доходи фрилансерів з відповідними ставками. З метою підвищення ролі і статусу прямих податків пропонується порівнювати доходи, що оподатковуються, не з мінімальною, а з середньомісячною заробітною платою.


  • Open Access

    Identification of the features of structural-phase transformations in the processing of waste from the production of high-alloy steels

    by Viacheslav Borysov, Tetiana Solomko, Mykhail Yamshinskij, Ivan Lukianenko, Bohdan Tsymbal, Andrey Andreev, Viacheslav Bratishko, Tamara Bilko, Victor Rebenko, Tetiana Chorna

    This paper reports a study into the peculiarities of the structural-phase composition of the alloy obtained by using anthropogenic waste from the production of high-alloy steels involving reduction melting. That is necessary for determining the technological parameters that could help decrease the loss of alloying elements in the process of obtaining and using a doped alloy. This study has shown that at an O:C ratio in the charge of 1.84, the alloy consisted mainly of the solid solution of carbon and alloying elements in α-Fe. The manifestation of Fe3C C carbide with alloying elements as substitution atoms was of relatively weak intensity. At the O:C ratios in the charge of 1.42 and 1.17, there was an increase in the intensity of the Fe3C carbide manifestation. At the same time, the emergence of the carbide compounds W2C·Mo2C and WC was identified. Several phases with different content of alloying elements were present in the microstructure images. Cr content in the examined areas changed in the range of 0.64–33.86 % by weight; W content reached 41.58 % by weight; Mo –19.53 % by weight; V – 18.55 % by weight; Co – 3.95 % by weight. The carbon content was in the range of 0.28–2.43 % by weight. Analysis of the study results reveals that the most favorable ratio of O:C in the charge was 1.42. At the same time, the phase composition was dominated by a solid solution of the alloying elements and carbon in α-Fe. The share of the residual carbon concentrated in the carbide component was in the range of 0.52–2.11 % by weight, thereby ensuring the required reduction capability of the alloy when used. The study reported here has made it possible to identify new technological aspects of obtaining an alloy by utilizing anthropogenic waste, and whose indicators provide for the possibility of replacing part of standard ferroalloys when smelting steels without strict restrictions on carbon content.