Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Corey D. Markfort has a total of 72 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Influence of Surface Complexity and Atmospheric Stability on Wind Shear and Turbulence in a Peri-Urban Wind Energy Site

    by Wei Zhang, Elliott Walker, Corey D. Markfort

    The large-scale deployment of wind energy underscores the critical need for accurate resource characterization to reduce uncertainty in power estimates and to enable the installation of wind farms in increasingly complex terrains. Accurate wind resource assessment in peri-urban and moderately complex terrains remains a significant challenge due to spatial heterogeneity in surface terrain features and atmospheric thermal stability. This study investigates the influence of surface complexity and atmospheric stratification on vertical wind profiles at a utility-scale wind turbine site in Cedar Rapids, Iowa. One year of multi-level wind data from a 106-meter-tall meteorological tower were analyzed to quantify variations in the wind shear exponent α, wind direction veer, and horizontal turbulence intensity (TI) across open-field and complex-surface wind sectors and four thermal stability classes, defined by the bulk Richardson number Rib. The results show that the wind shear exponent α increases systematically with atmospheric stability. Over the open-field terrain, α ranges from 0.11 in unstable conditions to 0.45 in strongly stable conditions, compared to 0.17 and 0.40 over the complex surface. A pronounced diurnal variation in α was observed, particularly during the summer months. Wind veer was greatest and exceeded 30° under strongly stable conditions over open terrain. Elevated TI values peaked at 32 m in height due to flow separation and wake turbulence from nearby vegetation and sloping terrain. These findings highlight the importance of incorporating terrain-induced and thermally driven variability into wind resource assessments to improve power prediction and turbine siting in complex heterogeneous terrain environments.


  • Open Access

    Improvements to the dynamic wake meandering model by incorporating the turbulent Schmidt number

    by Peter Brugger, Corey D. Markfort, Fernando Porté-Agel

    Predictions of the dynamic wake meandering model (DWMM) were compared to flow measurements of a scanning Doppler lidar mounted on the nacelle of a utility-scale wind turbine. We observed that the wake meandering strength of the DWMM agrees better with the observation, if the incoming mean wind speed is used as advection velocity for the downstream transport, while a better temporal agreement is achieved with an advection velocity slower than the incoming mean wind speed. A subsequent investigation of the lateral wake transport revealed differences to the passive tracer assumption of the DWMM in addition to a non-passive downstream transport reported in earlier studies. We propose to include the turbulent Schmidt number in the DWMM to improve (i) the consistency of the model physics and (ii) the prediction quality. Compared to the observations, the thus modified DWMM showed a root-mean-square error reduction by 2 % for mean velocity deficit and 1 % for the turbulence intensity, relative to the unmodified DWMM, in addition to better temporal agreement of the dynamics. This is in contrast to an error increase of 35 % and 36 % if only a more accurate downstream transport velocity is used without including the turbulent Schmidt number.


  • Open Access

    Improvements to the Dynamic Wake Meandering Model by incorporating the turbulent Schmidt number

    by Peter Brugger, Corey Markfort, Fernando Porté-Agel

    Predictions of the dynamic wake meandering model (DWMM) were compared to flow measurements of a scanning Doppler lidar mounted on the nacelle of a utility-scale wind turbine. We observed that the wake meandering strength of the DWMM agrees better with the observation, if the incoming mean wind speed is used as advection velocity for the downstream transport, while a better temporal agreement is achieved with an advection velocity slower than the incoming mean wind speed. A subsequent investigation of the lateral wake transport revealed differences to the passive tracer assumption of the DWMM in addition to a non-passive downstream transport reported in earlier studies. We propose to include the turbulent Schmidt number in the DWMM to improve (i) the consistency of the model physics and (ii) the prediction quality. Compared to a benchmark, the thus modified DWMM showed a root-mean-square error reduction by 5 % for mean velocity deficit and 7 % for the turbulence intensity, relative to the unmodified DWMM, in addition to better temporal agreement of the dynamics. This is in contrast to an error increase of 64 % and 41 % if only a more accurate downstream transport velocity is used without including the turbulent Schmidt number.


  • Open Access

    Field measurements of wake meandering at a utility-scale wind turbine with nacelle-mounted Doppler lidars

    by Peter Brugger, Corey Markfort, Fernando Porté-Agel

    Wake meandering is a low-frequency oscillation of the entire wind turbine wake that can contribute to power and load fluctuations of downstream turbines in wind farms. Field measurements of two Doppler lidars mounted on the nacelle of a utility-scale wind turbine were used to investigate relationships between the inflow and the wake meandering as well as the effect of wake meandering on the temporally averaged wake. A correlation analysis showed a linear relationship between the instantaneous wake position and the lateral velocity that degraded with the evolution of the turbulent wind field during the time of downstream advection. A low-pass filter proportional to the advection time delay is recommended to remove small scales that become decorrelated even for distances within the typical spacing of wind turbine rows in a wind farm. The results also showed that the velocity at which wake meandering is transported downstream was slower than the inflow wind speed but faster than the velocity at the wake centre. This indicates that the modelling assumption of the wake as a passive scalar should be revised in the context of the downstream advection. Further, the strength of wake meandering increased linearly with the turbulence intensity of the lateral velocity and with the downstream distance. Wake meandering reduced the maximum velocity deficit of the temporally averaged wake and increased its width. Both effects scaled with the wake meandering strength. Lastly, we found that the fraction of the wake turbulence intensity that was caused by wake meandering decreased with downstream distance contrary to the wake meandering strength.


  • Air demand in deep drop structures

    by Troy Clayton Lyons, Larry J Weber, Gabriele Villarini, Corey Markfort, Allen Bradley, Jacob Odgaard

    Air entrainment is a complex and often ignored phenomenon in the field of hydraulic engineering. Yet our society relies on many types of air-entraining hydraulic structures to serve the needs of the world’s ever-growing population. As we build larger and more complex hydraulic structures in urban areas, air entrainment issues become ever more critical. In cities, deep vertical drop shafts are commonly used to convey stormwater runoff and sanitary flows hundreds of feet underground into expansive deep tunnel systems, entrapping large amounts of air along with the falling water. Sometimes, entrapped air escapes uncontrollably, manifesting as violent expulsions of air and water at street level. Engineers often utilize hydraulic models to test the performance of deep drop shafts before they are built, but these models imperfectly predict the air-water interactions. However, due to their large size, full-scale evaluations of most hydraulic structures prior to construction are impractical. Therefore, better understanding and development of hydraulic models are vital to building safe and effective structures to serve the needs of current and future generations. This work investigates air demand in deep drop shafts and the limitations associated with hydraulic modeling of air-water flows. Air demand is simulated using two reduced-scale physical models of vortex-flow drop shafts designed for deep tunnel systems. Air demand is measured for a range of water flow rates, drop shaft heights, drop shaft diameters, and submergence levels, enabling analysis of each parameter with respect to air demand. Dimensional analysis is used to identify the design variables important to air demand and then confirmed through experimental data analysis. Regression analysis is used to fit mathematical expressions to the data and predict air demand from the relevant design variables. Model scale effects are evaluated using three geometrically similar hydraulic models. The findings show that the primary parameters affecting air demand are water flow rate, drop height, and submergence. Air demand was shown to decrease as water flow rate increases, increase as drop height increases, and decrease as submergence increases. Correction factors were developed to adjust air demands for relative shaft height differences. An empirical relationship to predict air demand was developed from the relevant variables. Correction factors were developed to compensate for model scale effects and adjust model air measurements to full-scale. The data suggests that air flows in deep drop structures are under-represented in reduced-scale models to a larger extent than previously believed. This dissertation provides new guidance for assessing air demand and understanding the relationships between key design parameters in deep drop shafts. An improved understanding of air-water scale effects expands the effectiveness of reduced-scale hydraulic models in predicting the performance of full-size installations. This work enables several adjustments to model scale air measurements through the use of correction factors. Although this work was motivated by deep drop shafts, the results are relevant to a number of other hydraulic engineering applications associated with air-water flows.

  • Flood mitigation and nutrient reduction benefits of flood control wetlands

    by Ashley J Knudson, Corey Markfort, Bongchul Seo, Craig Just

    In this study, we investigated the potential peak flow and nitrate reduction benefits of a recently constructed flood control wetland using a PCSWMM model. The predicted peak flow reductions for the NRCS type A and type D design storms, for the 2-, 5-, 10-, 25-, 50-, 100- and 500-year return periods, were 15-26% and 9.6-17%, respectively. The wetland storage volume (130.4 ac-ft) above the pool level provided ample peak flow mitigation benefit for all scenarios, including the 500-year type A storm with the maximum simulated inflow of 79.3 m3s-1 predicted to decrease to 60.6 m3s-1, a 23.6% reduction. In contrast, a smaller wetland in the same watershed predicted only a 0.9% reduction for the 500-year type A storm. This smaller wetland did not have sufficient storage to provide attenuation for all storms, while the wetland of interest did. Nitrate sensor data (R2 > 0.8 compared to grab samples) was inserted into the model and used to predict a concentration reduction between 9.7 and 68% for decay coefficients between 4x10-6 and 8x10-5 hr-1. Holding the decay coefficient constant at 5.5x10-5 h-1, a baseflow of zero m3s-1 showed a 60% predicted nitrate concentration reduction while the maximum simulated baseflow (0.5 m3s-1) produced a 27% predicted reduction. Our predicted nitrate reduction range was consistent with removals cited in the Iowa Nutrient Reduction Strategy (11 to 92%) for wetland to subcatchment area ratios between 0.5 and 2%. The Strategy states an average area ratio of 0.78% will provide an average nitrate concentration reduction of 52%. The area ratio for the wetland in this study was 0.95%, which suggests the predicted maximum nitrate concentration reduction of 68% is likely to be achieved after the wetland is fully mature.

  • Open Access

    Comment on wes-2021-95

    by Peter Andreas Brugger, Corey D. Markfort, Fernando Porté-Agel

    Wake meandering is a low-frequency oscillation of the entire wind turbine wake that can contribute to power and load fluctuations of downstream turbines in wind farms. Field measurements of two Doppler LiDARs mounted on the nacelle of a utility-scale wind turbine were used to investigate relationships between the inflow and the wake meandering as well as the effect of wake meandering on the temporally averaged wake. A correlation analysis showed a linear relationship between the instantaneous wake position and the lateral velocity that degraded with the evolution of the turbulent wind field during the time of downstream advection. A low-pass filter proportional to the advection time delay is recommended to remove small scales that become decorrelated even for distances within the typical spacing of wind turbine rows in a wind farm. The results also showed that the velocity at which wake meandering is transported downstream was slower than the inflow wind speed, but faster than the velocity at the wake center. This indicates that the modelling assumption of the wake as an passive scalar should be revised in the context of the downstream advection. Further, the strength of wake meandering increased linearly with the turbulence intensity of the lateral velocity and with the downstream distance. Wake meandering reduced the maximum velocity deficit of the temporally averaged wake and increased its width. Both effects scaled with the wake meandering strength. Lastly, we found that the fraction of the wake turbulence intensity that was caused by wake meandering decreased with downstream distance contrary to the wake meandering strength.

  • Open Access

    Comment on wes-2021-95

    by Peter Andreas Brugger, Corey D. Markfort, Fernando Porté-Agel

    Wake meandering is a low-frequency oscillation of the entire wind turbine wake that can contribute to power and load fluctuations of downstream turbines in wind farms. Field measurements of two Doppler LiDARs mounted on the nacelle of a utility-scale wind turbine were used to investigate relationships between the inflow and the wake meandering as well as the effect of wake meandering on the temporally averaged wake. A correlation analysis showed a linear relationship between the instantaneous wake position and the lateral velocity that degraded with the evolution of the turbulent wind field during the time of downstream advection. A low-pass filter proportional to the advection time delay is recommended to remove small scales that become decorrelated even for distances within the typical spacing of wind turbine rows in a wind farm. The results also showed that the velocity at which wake meandering is transported downstream was slower than the inflow wind speed, but faster than the velocity at the wake center. This indicates that the modelling assumption of the wake as an passive scalar should be revised in the context of the downstream advection. Further, the strength of wake meandering increased linearly with the turbulence intensity of the lateral velocity and with the downstream distance. Wake meandering reduced the maximum velocity deficit of the temporally averaged wake and increased its width. Both effects scaled with the wake meandering strength. Lastly, we found that the fraction of the wake turbulence intensity that was caused by wake meandering decreased with downstream distance contrary to the wake meandering strength.