Evangelos Delikonstantis
Research Subjects
Evangelos Delikonstantis has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Georgios D. Stefanidis
School of Chemical Engineering National Technical University of Athens, Iroon Polytecneiou 9, Zografou Campus, Athens 157 80, Greece
9 shared publications - Kevin Marcel Van Geem
Laboratory for Chemical Technology, Ghent University, Technologiepark 125, B-9052 Ghent, Belgium
6 shared publications - Fabio Cameli
Laboratory for Chemical Technology, Ghent University, Tech Lane Ghent Science Park 125, B-9052 Gent, Belgium
5 shared publications - Stavros-Alexandros Theofanidis
AristEng S.à r.l., 77, Rue de Merl, L-2146 Luxembourg City, Luxembourg
5 shared publications - Afroditi Kourou
Laboratory for Chemical Technology Ghent University Zwijnaarde Belgium
3 shared publications Amvrosios G. Georgiadis
Avenue Pasteur
3 shared publications
Latest Publications
- Open Access
- 12 November 2026
- Published by Elsevier in Molecular Catalysis
- Vol. 607
Nanosecond Dielectric Barrier Discharge plasma for dry reforming of methane via Ni-based mixed metal oxides catalysts: effect on product distribution and energy efficiency
- 12 November 2026
- Published by Elsevier in Molecular Catalysis
- Vol. 607
Open AccessNanosecond Dielectric Barrier Discharge plasma for dry reforming of methane via Ni-based mixed metal oxides catalysts: effect on product distribution and energy efficiency
- Open Access
- 16 August 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (33) , 17875-17896
Process Design and Greenhouse Gas Analysis of an Electrified Mixed Plastic Waste-to-Olefins Value Chain
This work presents the conceptual process design and life-cycle Greenhouse Gas (GHG) analysis for converting mixed plastic waste (MPW) into polymer-grade olefins (≥99.9 wt % ethylene and propylene) via sequential pyrolysis, e-cracking, compression, and separation. The integrated plant-wide process modeling was performed within a Python-based framework as an alternative to conventional commercial simulators. Eight scenarios were assessed by combining centralised and decentralised configurations, combined heat and power (CHP)-powered and fully electrified operation, and grid versus renewable electricity supply. Under fully electrified conditions, the carbon footprint strongly depends on the electricity source. When onshore wind-harvested electricity is assumed, GHG emissions decrease to ∼0.08 kg CO2-eq per kg of high-value chemicals (HVCs), placing the process within the EU’s 2040 climate objective of a 90% reduction relative to the sector’s conventional benchmark (i.e., naphtha steam cracking, ∼1 kg CO2-eq per kg of HVC). Sensitivity analysis showed that transport-related emissions are a significant contributor in the fully electrified scenario. In particular, maintaining the targeted 90% GHG reduction relative to the conventional benchmark is only feasible for MPW transport distances of ∼ 160–180 km.
- 16 August 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (33) , 17875-17896
Open AccessProcess Design and Greenhouse Gas Analysis of an Electrified Mixed Plastic Waste-to-Olefins Value Chain
This work presents the conceptual process design and life-cycle Greenhouse Gas (GHG) analysis for converting mixed plastic waste (MPW) into polymer-grade olefins (≥99.9 wt % ethylene and propylene) via sequential pyrolysis, e-cracking, compression, and separation. The integrated plant-wide process modeling was performed within a Python-based framework as an alternative to conventional commercial simulators. Eight scenarios were assessed by combining centralised and decentralised configurations, combined heat and power (CHP)-powered and fully electrified operation, and grid versus renewable electricity supply. Under fully electrified conditions, the carbon footprint strongly depends on the electricity source. When onshore wind-harvested electricity is assumed, GHG emissions decrease to ∼0.08 kg CO2-eq per kg of high-value chemicals (HVCs), placing the process within the EU’s 2040 climate objective of a 90% reduction relative to the sector’s conventional benchmark (i.e., naphtha steam cracking, ∼1 kg CO2-eq per kg of HVC). Sensitivity analysis showed that transport-related emissions are a significant contributor in the fully electrified scenario. In particular, maintaining the targeted 90% GHG reduction relative to the conventional benchmark is only feasible for MPW transport distances of ∼ 160–180 km.
- Open Access
- 10 December 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (50) , 61076-61095
Alternative H 2 O 2 Production Processes: An Outlook on Candidate Technologies Beyond the Anthraquinone Process
Hydrogen peroxide is currently made on a large scale via the auto-oxidation (AO) process, an indirect process via the hydrogenation of anthraquinone over a Pd catalyst, followed by reaction with O2. The AO process has a significant climate footprint, since H2 is usually sourced from methane steam reforming. A more sustainable H2O2 production process is, therefore, highly relevant. Potential alternative routes include the direct reaction of H2 and O2 and processes that use electricity, either directly via electrochemical or bioelectrochemical systems or indirectly via plasmas. Despite research on these routes, there are currently no real challengers to the established AO process. An overview of these alternative processes is provided before considering the energetic, techno-economic, life cycle, and safety challenges facing them. By highlighting these challenges through comparison with the AO process, this review aims to inspire further work for scaling up these alternative processes for truly determining their industrial viability. As these processes may ultimately prove more advantageous than the AO process for on-demand production, their industrialization might not need to occur on the same production scale as that of the AO process.
- 10 December 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (50) , 61076-61095
Open AccessAlternative H 2 O 2 Production Processes: An Outlook on Candidate Technologies Beyond the Anthraquinone Process
Hydrogen peroxide is currently made on a large scale via the auto-oxidation (AO) process, an indirect process via the hydrogenation of anthraquinone over a Pd catalyst, followed by reaction with O2. The AO process has a significant climate footprint, since H2 is usually sourced from methane steam reforming. A more sustainable H2O2 production process is, therefore, highly relevant. Potential alternative routes include the direct reaction of H2 and O2 and processes that use electricity, either directly via electrochemical or bioelectrochemical systems or indirectly via plasmas. Despite research on these routes, there are currently no real challengers to the established AO process. An overview of these alternative processes is provided before considering the energetic, techno-economic, life cycle, and safety challenges facing them. By highlighting these challenges through comparison with the AO process, this review aims to inspire further work for scaling up these alternative processes for truly determining their industrial viability. As these processes may ultimately prove more advantageous than the AO process for on-demand production, their industrialization might not need to occur on the same production scale as that of the AO process.
- Open Access
- 13 May 2025
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 15 (15) , 4330-4351
Methane and nitrogen oxides abatement from marine exhaust gases: a review on available plasma-catalytic systems
The review covers advancements in plasma technologies for CH 4 and NO x abatement, highlighting the potential of plasma-catalytic reactors and the need to optimize energy inputs and operating parameters for efficient deployment in maritime sector.
- 13 May 2025
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 15 (15) , 4330-4351
Open AccessMethane and nitrogen oxides abatement from marine exhaust gases: a review on available plasma-catalytic systems
The review covers advancements in plasma technologies for CH 4 and NO x abatement, highlighting the potential of plasma-catalytic reactors and the need to optimize energy inputs and operating parameters for efficient deployment in maritime sector.
- Open Access
- 15 July 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (15) , 14767
Correction to Conceptual Process Design and Technoeconomic Analysis of an e-Methanol Plant with Direct Air-Captured CO2 and Electrolytic H2
[This corrects the article DOI: 10.1021/acs.energyfuels.3c04147.].
- 15 July 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (15) , 14767
Open AccessCorrection to Conceptual Process Design and Technoeconomic Analysis of an e-Methanol Plant with Direct Air-Captured CO2 and Electrolytic H2
[This corrects the article DOI: 10.1021/acs.energyfuels.3c04147.].
- Open Access
- 26 June 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (27) , 12035-12052
On the Electrification of CO2-Based Methanol Synthesis via a Reverse Water–Gas Shift: A Comparative Techno-Economic Assessment of Thermo-Catalytic and Plasma-Assisted Routes
- 26 June 2024
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 63 (27) , 12035-12052
Open AccessOn the Electrification of CO2-Based Methanol Synthesis via a Reverse Water–Gas Shift: A Comparative Techno-Economic Assessment of Thermo-Catalytic and Plasma-Assisted Routes
- Open Access
- 29 January 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (4) , 3251-3261
Conceptual Process Design and Technoeconomic Analysis of an e-Methanol Plant with Direct Air-Captured CO2 and Electrolytic H2
- 29 January 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (4) , 3251-3261
Open AccessConceptual Process Design and Technoeconomic Analysis of an e-Methanol Plant with Direct Air-Captured CO2 and Electrolytic H2
- 25 October 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 49, 1416-1425
Conceptual process design and technoeconomic analysis of an e-ammonia plant: Green H2 and cryogenic air separation coupled with Haber-Bosch process
- 25 October 2023
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 49, 1416-1425
Conceptual process design and technoeconomic analysis of an e-ammonia plant: Green H2 and cryogenic air separation coupled with Haber-Bosch process
- 27 September 2023
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 57 (40) , 14961-14972
Valorizing the Steel Industry Off-Gases: Proof of Concept and Plantwide Design of an Electrified and Catalyst-Free Reverse Water–Gas-Shift-Based Route to Methanol
Conversion of steel industry off-gases to value-added chemicals enabled by renewable electricity can significantly reduce the environmental burden of the steelmaking process. Herein, we demonstrate that CO2 reduction by H2, both contained in steel mill off-gases, to form syngas via the reverse water-gas-shift reaction is effectively performed by nanosecond pulsed discharges at atmospheric pressure. The experimental results suggest the following: (i) An optimum interelectrode distance exists, maximizing CO2 conversion. (ii) CO2 conversion at constant SEI follows a nonmonotonic trend with H2 excess. CO2 conversion increases with H2 excess up to H2:CO2 = 3:1 upon shifting the chemical equilibrium. At larger H2:CO2, both gas cooling, promoted by the high H2 content, and hindered CO2 collisions in a highly diluted stream hamper CO2 conversion. (iii) SEI enhances CO2 conversion, but the effect decreases with increasing SEI due to equilibrium limitations. A stoichiometric H2:CO2 feed ratio in the plasma reactor is recommended for higher energy efficiency. Intensifying MeOH productivity via SEI elevation is not advised as a 2-fold SEI increase results only in 17% higher MeOH throughput.
- 27 September 2023
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 57 (40) , 14961-14972
Valorizing the Steel Industry Off-Gases: Proof of Concept and Plantwide Design of an Electrified and Catalyst-Free Reverse Water–Gas-Shift-Based Route to Methanol
Conversion of steel industry off-gases to value-added chemicals enabled by renewable electricity can significantly reduce the environmental burden of the steelmaking process. Herein, we demonstrate that CO2 reduction by H2, both contained in steel mill off-gases, to form syngas via the reverse water-gas-shift reaction is effectively performed by nanosecond pulsed discharges at atmospheric pressure. The experimental results suggest the following: (i) An optimum interelectrode distance exists, maximizing CO2 conversion. (ii) CO2 conversion at constant SEI follows a nonmonotonic trend with H2 excess. CO2 conversion increases with H2 excess up to H2:CO2 = 3:1 upon shifting the chemical equilibrium. At larger H2:CO2, both gas cooling, promoted by the high H2 content, and hindered CO2 collisions in a highly diluted stream hamper CO2 conversion. (iii) SEI enhances CO2 conversion, but the effect decreases with increasing SEI due to equilibrium limitations. A stoichiometric H2:CO2 feed ratio in the plasma reactor is recommended for higher energy efficiency. Intensifying MeOH productivity via SEI elevation is not advised as a 2-fold SEI increase results only in 17% higher MeOH throughput.