Sotatsu Otabe
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Sotatsu Otabe has a total of 65 co-authors. Here are the top co-authors by number of shared publications:
- Takuya Kawasaki
Institute of Science Tokyo
4 shared publications Kaido Suzuki
Department of Physics Tokyo Institute of Technology 152-8550 Meguro Tokyo Japan
3 shared publicationsKen-Ichi Harada
Department of Physics Tokyo Institute of Technology 152-8550 Meguro Tokyo Japan
3 shared publications- Ken-Ichi Harada
Waseda University
3 shared publications Kentaro Komori
Graduate School of Science Research Center for the Early Universe (RESCEU) University of Tokyo 113-0033 Bunkyo Tokyo Japan
3 shared publications- Kentaro Komori
University of Tokyo
3 shared publications
Latest Publications
- 15 June 2026
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 137 (5)
Levitated nano-accelerometer sensitized by quantum quench
- 15 June 2026
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 137 (5)
Levitated nano-accelerometer sensitized by quantum quench
- 2 January 2025
- Published by American Physical Society (APS) in Physical Review A
- Vol. 111 (1)
Analyzing the sensitivity of an atom interferometer with a phase-modulation readout scheme
The sensitivity of an interferometer depends on its readout scheme. However, little attention has been paid to the readout schemes of atom interferometers from the viewpoint of their sensitivity. The difference in sensitivity between readout schemes or their optimization has not been considered in the literature. Herein we analytically calculate the sensitivities of an atom interferometer with typical readout schemes by applying the two-photon formalism, which was developed for optical interferometers to deal with quantum noise. Our calculations reveal that by using sinusoidal phase modulation, the sensitivity can surpass that obtained by the conventional phase sweeping scheme. The superiority of this phase modulation scheme for both cold and thermal atomic beams is demonstrated. In addition, we show that the phase modulation scheme is advantageous for atom-flux fluctuation and resists atom-flux drift. This study performs a general analysis of the sensitivity of atom interferometers and identifies an advantageous readout scheme.
- 2 January 2025
- Published by American Physical Society (APS) in Physical Review A
- Vol. 111 (1)
Analyzing the sensitivity of an atom interferometer with a phase-modulation readout scheme
The sensitivity of an interferometer depends on its readout scheme. However, little attention has been paid to the readout schemes of atom interferometers from the viewpoint of their sensitivity. The difference in sensitivity between readout schemes or their optimization has not been considered in the literature. Herein we analytically calculate the sensitivities of an atom interferometer with typical readout schemes by applying the two-photon formalism, which was developed for optical interferometers to deal with quantum noise. Our calculations reveal that by using sinusoidal phase modulation, the sensitivity can surpass that obtained by the conventional phase sweeping scheme. The superiority of this phase modulation scheme for both cold and thermal atomic beams is demonstrated. In addition, we show that the phase modulation scheme is advantageous for atom-flux fluctuation and resists atom-flux drift. This study performs a general analysis of the sensitivity of atom interferometers and identifies an advantageous readout scheme.
- Open Access
Kerr-Enhanced Optical Spring
We propose and experimentally demonstrate the generation of enhanced optical springs using the optical Kerr effect. A nonlinear optical crystal is inserted into a Fabry-Perot cavity with a movable mirror, and a chain of second-order nonlinear optical effects in the phase-mismatched condition induces the Kerr effect. The optical spring constant is enhanced by a factor of $1.6\pm0.1$ over linear theory. To our knowledge, this is the first realization of optomechanical coupling enhancement using a nonlinear optical effect, which has been theoretically investigated to overcome the performance limitations of linear optomechanical systems. The tunable nonlinearity of demonstrated system has a wide range of potential applications, from observing gravitational waves emitted by binary neutron star post-merger remnants to cooling macroscopic oscillators to their quantum ground state.Open AccessKerr-Enhanced Optical Spring
We propose and experimentally demonstrate the generation of enhanced optical springs using the optical Kerr effect. A nonlinear optical crystal is inserted into a Fabry-Perot cavity with a movable mirror, and a chain of second-order nonlinear optical effects in the phase-mismatched condition induces the Kerr effect. The optical spring constant is enhanced by a factor of $1.6\pm0.1$ over linear theory. To our knowledge, this is the first realization of optomechanical coupling enhancement using a nonlinear optical effect, which has been theoretically investigated to overcome the performance limitations of linear optomechanical systems. The tunable nonlinearity of demonstrated system has a wide range of potential applications, from observing gravitational waves emitted by binary neutron star post-merger remnants to cooling macroscopic oscillators to their quantum ground state. - 4 April 2024
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 132 (14) , 143602
Kerr-Enhanced Optical Spring
We propose and experimentally demonstrate the generation of enhanced optical springs using the optical Kerr effect. A nonlinear optical crystal is inserted into a Fabry-Perot cavity with a movable mirror, and a chain of second-order nonlinear optical effects in the phase-mismatched condition induces the Kerr effect. The optical spring constant is enhanced by a factor of over linear theory. To our knowledge, this is the first realization of optomechanical coupling enhancement using a nonlinear optical effect, which has been theoretically investigated to overcome the performance limitations of linear optomechanical systems. The tunable nonlinearity of demonstrated system has a wide range of potential applications, from observing gravitational waves emitted by binary neutron star postmerger remnants to cooling macroscopic oscillators to their quantum ground state.- 4 April 2024
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 132 (14) , 143602
Kerr-Enhanced Optical Spring
We propose and experimentally demonstrate the generation of enhanced optical springs using the optical Kerr effect. A nonlinear optical crystal is inserted into a Fabry-Perot cavity with a movable mirror, and a chain of second-order nonlinear optical effects in the phase-mismatched condition induces the Kerr effect. The optical spring constant is enhanced by a factor of over linear theory. To our knowledge, this is the first realization of optomechanical coupling enhancement using a nonlinear optical effect, which has been theoretically investigated to overcome the performance limitations of linear optomechanical systems. The tunable nonlinearity of demonstrated system has a wide range of potential applications, from observing gravitational waves emitted by binary neutron star postmerger remnants to cooling macroscopic oscillators to their quantum ground state.- 27 June 2023
- Published by American Physical Society (APS) in Physical Review D
- Vol. 107 (12) , 122005
Intracavity signal amplification system for next-generation gravitational-wave detectors
This article summarizes our study to develop an intracavity parametric signal amplification system for improving the sensitivity of a gravitational-wave detector at high frequencies to aim at an observation of a postmerger remnant of a binary neutron star collision. The detector configuration is based on a dual recycling interferometer and an optical parametric amplifier crystal is inserted into the signal recycling cavity. The cavity is detuned and an optical spring is generated for the differential motion of the two end mirrors. The amplifier converts the energy of the pump beam to the optical spring and the spring frequency can be enhanced to a few kilohertz. The system is contrasting to the squeeze injection technique commonly used in second-generation gravitational-wave detectors. Although both techniques use an optical parametric amplifier crystal, the squeeze injection reduces noise while signal amplification increases the signal to modify the optomechanical dynamics of the system.
- 27 June 2023
- Published by American Physical Society (APS) in Physical Review D
- Vol. 107 (12) , 122005
Intracavity signal amplification system for next-generation gravitational-wave detectors
This article summarizes our study to develop an intracavity parametric signal amplification system for improving the sensitivity of a gravitational-wave detector at high frequencies to aim at an observation of a postmerger remnant of a binary neutron star collision. The detector configuration is based on a dual recycling interferometer and an optical parametric amplifier crystal is inserted into the signal recycling cavity. The cavity is detuned and an optical spring is generated for the differential motion of the two end mirrors. The amplifier converts the energy of the pump beam to the optical spring and the spring frequency can be enhanced to a few kilohertz. The system is contrasting to the squeeze injection technique commonly used in second-generation gravitational-wave detectors. Although both techniques use an optical parametric amplifier crystal, the squeeze injection reduces noise while signal amplification increases the signal to modify the optomechanical dynamics of the system.
- 3 February 2023
- Published by American Vacuum Society in AVS Quantum Science
- Vol. 5 (1) , 014403
Recent advances toward mesoscopic quantum optomechanics
We present a number of approaches, currently in experimental development in our research groups, toward the general problem of macroscopic quantum mechanics, i.e., manifestations of quantum noise and quantum fluctations with macroscopic (engineered and microfabricated by man) mechanical systems. Discussed experiments include a pendulum, a torsion pendulum, a ng-scale phononic-crystal silicon nitride membrane, a μ g-scale quartz resonator, and mg-scale mirrors for optical levitation. We also discuss relevant applications to quantum thermometry with optomechanical systems and the use of squeezed light to probe displacements beyond conventional quantum limits.
- 3 February 2023
- Published by American Vacuum Society in AVS Quantum Science
- Vol. 5 (1) , 014403
Recent advances toward mesoscopic quantum optomechanics
We present a number of approaches, currently in experimental development in our research groups, toward the general problem of macroscopic quantum mechanics, i.e., manifestations of quantum noise and quantum fluctations with macroscopic (engineered and microfabricated by man) mechanical systems. Discussed experiments include a pendulum, a torsion pendulum, a ng-scale phononic-crystal silicon nitride membrane, a μ g-scale quartz resonator, and mg-scale mirrors for optical levitation. We also discuss relevant applications to quantum thermometry with optomechanical systems and the use of squeezed light to probe displacements beyond conventional quantum limits.
- Open Access
Photothermal effect in macroscopic optomechanical systems with an intracavity nonlinear optical crystal
Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of optomechanical coupling due to the presence of a nonlinear optical crystal in an optical cavity. We propose a novel method to predict the influence of the photothermal effect by measuring the susceptibility of the optomechanical oscillator and identifying the net optical spring constant and photothermal absorption rate. Using this method, we succeeded in precisely estimating parameters related to even minor photothermal effects, which could not be measured using a previously developed method.
Open AccessPhotothermal effect in macroscopic optomechanical systems with an intracavity nonlinear optical crystal
Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of optomechanical coupling due to the presence of a nonlinear optical crystal in an optical cavity. We propose a novel method to predict the influence of the photothermal effect by measuring the susceptibility of the optomechanical oscillator and identifying the net optical spring constant and photothermal absorption rate. Using this method, we succeeded in precisely estimating parameters related to even minor photothermal effects, which could not be measured using a previously developed method.
- 3 November 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (23) , 42579-42593
Photothermal effect in macroscopic optomechanical systems with an intracavity nonlinear optical crystal
Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of optomechanical coupling due to the presence of a nonlinear optical crystal in an optical cavity. We propose a novel method to predict the influence of the photothermal effect by measuring the susceptibility of the optomechanical oscillator and identifying the net optical spring constant and photothermal absorption rate. Using this method, we succeeded in precisely estimating parameters related to even minor photothermal effects, which could not be measured using a previously developed method.
- 3 November 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (23) , 42579-42593
Photothermal effect in macroscopic optomechanical systems with an intracavity nonlinear optical crystal
Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of optomechanical coupling due to the presence of a nonlinear optical crystal in an optical cavity. We propose a novel method to predict the influence of the photothermal effect by measuring the susceptibility of the optomechanical oscillator and identifying the net optical spring constant and photothermal absorption rate. Using this method, we succeeded in precisely estimating parameters related to even minor photothermal effects, which could not be measured using a previously developed method.
- 2 September 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (3) , L031501
Improving force sensitivity by amplitude measurements of light reflected from a detuned optomechanical cavity
The measurement of weak continuous forces exerted on a mechanical oscillator is a fundamental problem in various physical experiments. It is fundamentally impeded by quantum back-action from the meter used to sense the displacement of the oscillator. In the context of interferometric displacement measurements, we here propose and demonstrate the working principle of a scheme for coherent back-action cancellation. By measuring the amplitude quadrature of the light reflected from a detuned optomechanical cavity inside which a stiff optical spring is generated, back-action can be canceled in a narrow band of frequencies. This method provides a simple way to improve the sensitivity in experiments limited by quantum back-action without injection of squeezed light or stable homodyne readout.
- 2 September 2021
- Published by American Physical Society (APS) in Physical Review A
- Vol. 104 (3) , L031501
Improving force sensitivity by amplitude measurements of light reflected from a detuned optomechanical cavity
The measurement of weak continuous forces exerted on a mechanical oscillator is a fundamental problem in various physical experiments. It is fundamentally impeded by quantum back-action from the meter used to sense the displacement of the oscillator. In the context of interferometric displacement measurements, we here propose and demonstrate the working principle of a scheme for coherent back-action cancellation. By measuring the amplitude quadrature of the light reflected from a detuned optomechanical cavity inside which a stiff optical spring is generated, back-action can be canceled in a narrow band of frequencies. This method provides a simple way to improve the sensitivity in experiments limited by quantum back-action without injection of squeezed light or stable homodyne readout.