Jingsong Wang
Jingsong Wang has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Chunchang Wang
Anhui University
3 shared publications - Li Li
Laboratory of Dielectric Functional Materials, School of Materials Science & Engineering, Anhui University, Hefei 230601, China
2 shared publications Bing Zhao
Institute of Physical Science and Information Technology, Anhui University, Hefei, China
1 shared publicationGaifang Chen
Laboratory of Dielectric Functional Materials, School of Materials Science and Engineering, Anhui University, Hefei, China
1 shared publication- Gaifang Chen
Laboratory of Dielectric Functional Materials, School of Physics & Material Science, Anhui University, Heifei 230601, China
1 shared publication - Jiahao Yao
Laboratory of Dielectric Functional Materials, School of Materials Science & Engineering, Anhui University, Hefei 230601, China
1 shared publication
Latest Publications
- 22 April 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (17) , 18044-18051
Martensitic Transition Associated with Spin-Crossover Enabling Crystal Jumping and Pyroelectric Response
Integrating electronic switching with molecular machinery remains a central challenge in the development of multifunctional stimuli-responsive materials. Herein, we demonstrate a synergistic coupling of spin crossover (SCO) and molecular motion within a hydrogen-bonded supramolecular architecture constructed from spin-active [Fe(3-bpp)2]2+ complexes and flexible bpa molecules (3-bpp = 2,6-bis(pyrazol-3-yl)pyridine; bpa = 1,2-bis(4-pyridyl)ethane). In this crystal, temperature-induced spin conversion of the Fe(II) centers is mechanically associated with a large-amplitude pedal-like conformational change of the bpa linkers. This cooperative evolution of electronic and molecular structures drives a diffusionless martensitic phase transition accompanied by rapid anisotropic lattice deformation. As a result, the material exhibits a thermosalient effect, manifested as the macroscopic jumping of single crystals. Moreover, the conformational change of bpa induces a concomitant displacement of the AsF6– counteranions along the crystallographic polar axis, leading to a substantial modulation of lattice polarization and a distinct pyroelectric response. These findings establish a rational design strategy for bridging electronic switching and molecular mechanics, paving the way for sophisticated multifunctional dynamic crystals.
- 22 April 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (17) , 18044-18051
Martensitic Transition Associated with Spin-Crossover Enabling Crystal Jumping and Pyroelectric Response
Integrating electronic switching with molecular machinery remains a central challenge in the development of multifunctional stimuli-responsive materials. Herein, we demonstrate a synergistic coupling of spin crossover (SCO) and molecular motion within a hydrogen-bonded supramolecular architecture constructed from spin-active [Fe(3-bpp)2]2+ complexes and flexible bpa molecules (3-bpp = 2,6-bis(pyrazol-3-yl)pyridine; bpa = 1,2-bis(4-pyridyl)ethane). In this crystal, temperature-induced spin conversion of the Fe(II) centers is mechanically associated with a large-amplitude pedal-like conformational change of the bpa linkers. This cooperative evolution of electronic and molecular structures drives a diffusionless martensitic phase transition accompanied by rapid anisotropic lattice deformation. As a result, the material exhibits a thermosalient effect, manifested as the macroscopic jumping of single crystals. Moreover, the conformational change of bpa induces a concomitant displacement of the AsF6– counteranions along the crystallographic polar axis, leading to a substantial modulation of lattice polarization and a distinct pyroelectric response. These findings establish a rational design strategy for bridging electronic switching and molecular mechanics, paving the way for sophisticated multifunctional dynamic crystals.
- Open Access
- 6 March 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (5) , 951
Humidity Sensing Properties of (In+Nb) Doped HfO2 Ceramics
(In+Nb) co-doped HfO2 ceramics, Hf1-x(In0.5Nb0.5)xO2 (x = 0, 0.005, 0.05, and 0.1), were prepared via a solid-state reaction method. Dielectric measurements reveal that the environmental moisture has an obvious influence on the dielectric properties of the samples. The best humidity response was found in a sample with the doping level of x = 0.005. This sample was therefore selected as a model sample to further investigate its humidity properties. In doing so, nanosized particles of Hf0.995(In0.5Nb0.5)0.005O2 were fabricated via a hydrothermal method and the humidity sensing properties of this material were studied in the relative humidity range of 11–94% based on impedance sensor. Our results show that the material exhibits a large impedance change of nearly four orders of magnitude over the tested humidity range. It was argued that the humidity-sensing properties were related to the defects created by doping, which improves the adsorption capacity for water molecules.
- 6 March 2023
- Published by MDPI AG in Nanomaterials
- Vol. 13 (5) , 951
Open AccessHumidity Sensing Properties of (In+Nb) Doped HfO2 Ceramics
(In+Nb) co-doped HfO2 ceramics, Hf1-x(In0.5Nb0.5)xO2 (x = 0, 0.005, 0.05, and 0.1), were prepared via a solid-state reaction method. Dielectric measurements reveal that the environmental moisture has an obvious influence on the dielectric properties of the samples. The best humidity response was found in a sample with the doping level of x = 0.005. This sample was therefore selected as a model sample to further investigate its humidity properties. In doing so, nanosized particles of Hf0.995(In0.5Nb0.5)0.005O2 were fabricated via a hydrothermal method and the humidity sensing properties of this material were studied in the relative humidity range of 11–94% based on impedance sensor. Our results show that the material exhibits a large impedance change of nearly four orders of magnitude over the tested humidity range. It was argued that the humidity-sensing properties were related to the defects created by doping, which improves the adsorption capacity for water molecules.
- 10 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (22) , 21508-21517
Significantly Improved Humidity Performance of La2O3-Based Sensor Modified by Li, Na, and K+ Ions
The effects of Li + , Na + , and K + ions loading on the humidity sensing performances of La 2 O 3 -based humidity sensors were investigated in detail. Single ion loading shows that Li + -loading greatly decreases the impedance in the low humidity range and thus has no effect on improving humidity sensitive response. Na + -loading increases the sensitive response over 4 orders of magnitude but causes large hysteresis in the medium humidity range. K + -loading raises the sensitive response over 4 orders of magnitude with smaller hysteresis loop. Significantly improved humidity performance of a large humidity sensitive response nearly 5 orders of magnitude, satisfactory response/recovery time, low hysteresis, and good linearity were achieved simultaneously by optimizing the ratio of Li + , Na + , and K + ions. This work underscores that alkaline ion modifying is a facile method to improve the properties of humidity sensors.
- 10 October 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (22) , 21508-21517
Significantly Improved Humidity Performance of La2O3-Based Sensor Modified by Li, Na, and K+ Ions
The effects of Li + , Na + , and K + ions loading on the humidity sensing performances of La 2 O 3 -based humidity sensors were investigated in detail. Single ion loading shows that Li + -loading greatly decreases the impedance in the low humidity range and thus has no effect on improving humidity sensitive response. Na + -loading increases the sensitive response over 4 orders of magnitude but causes large hysteresis in the medium humidity range. K + -loading raises the sensitive response over 4 orders of magnitude with smaller hysteresis loop. Significantly improved humidity performance of a large humidity sensitive response nearly 5 orders of magnitude, satisfactory response/recovery time, low hysteresis, and good linearity were achieved simultaneously by optimizing the ratio of Li + , Na + , and K + ions. This work underscores that alkaline ion modifying is a facile method to improve the properties of humidity sensors.
- 20 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 3 (9) , 3990-3998
Enhanced Humidity Sensing Performance of the La2Ti2O7/La(OH)3 Nanocomposite
- 20 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 3 (9) , 3990-3998
Enhanced Humidity Sensing Performance of the La2Ti2O7/La(OH)3 Nanocomposite