Alvin Tang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Alvin Tang has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Aravindh Kumar
Department of Electrical Engineering, Stanford University, Stanford, California 94305, United States
1 shared publication - Chen Nie
Shanghai Jiao Tong University
1 shared publication - Eric Pop
Stanford University
1 shared publication H.-S. Philip Wong
Department of Electrical Engineering, Stanford University, Stanford, California 94305, United States
1 shared publicationKrishna Saraswat
Department of Electrical Engineering, Stanford University, Stanford, California 94305, United States
1 shared publicationLi Jiang
School of Electronic Information and Electrical Engineering, Shanghai Jiao Tong University, Shanghai, China
1 shared publication
Latest Publications
- Open Access
- 23 September 2023
- Published by Springer Nature in Nature Communications
- Vol. 14 (1) , 1-11
Monolithic 3D integration of 2D transistors and vertical RRAMs in 1T–4R structure for high-density memory
Emerging data-intensive computation has driven the advanced packaging and vertical stacking of integrated circuits, for minimized latency and energy consumption. Yet a monolithic three-dimensional (3D) integrated structure with interleaved logic and high-density memory layers has been difficult to achieve due to challenges in managing the thermal budget. Here we experimentally demonstrate a monolithic 3D integration of atomically-thin molybdenum disulfide (MoS2) transistors and 3D vertical resistive random-access memories (VRRAMs), with the MoS2transistors stacked between the bottom-plane and top-plane VRRAMs. The whole fabrication process is integration-friendly (below 300 °C), and the measurement results confirm that the top-plane fabrication does not affect the bottom-plane devices. The MoS2transistor can drive each layer of VRRAM into four resistance states. Circuit-level modeling of the monolithic 3D structure demonstrates smaller area, faster data transfer, and lower energy consumption than a planar memory. Such platform holds a high potential for energy-efficient 3D on-chip memory systems.
- 23 September 2023
- Published by Springer Nature in Nature Communications
- Vol. 14 (1) , 1-11
Open AccessMonolithic 3D integration of 2D transistors and vertical RRAMs in 1T–4R structure for high-density memory
Emerging data-intensive computation has driven the advanced packaging and vertical stacking of integrated circuits, for minimized latency and energy consumption. Yet a monolithic three-dimensional (3D) integrated structure with interleaved logic and high-density memory layers has been difficult to achieve due to challenges in managing the thermal budget. Here we experimentally demonstrate a monolithic 3D integration of atomically-thin molybdenum disulfide (MoS2) transistors and 3D vertical resistive random-access memories (VRRAMs), with the MoS2transistors stacked between the bottom-plane and top-plane VRRAMs. The whole fabrication process is integration-friendly (below 300 °C), and the measurement results confirm that the top-plane fabrication does not affect the bottom-plane devices. The MoS2transistor can drive each layer of VRRAM into four resistance states. Circuit-level modeling of the monolithic 3D structure demonstrates smaller area, faster data transfer, and lower energy consumption than a planar memory. Such platform holds a high potential for energy-efficient 3D on-chip memory systems.
- 24 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (35) , 41866-41874
Toward Low-Temperature Solid-Source Synthesis of Monolayer MoS2
Two-dimensional (2D) semiconductors have been proposed for heterogeneous integration with existing silicon technology; however, their chemical vapor deposition (CVD) growth temperatures are often too high. Here, we demonstrate direct CVD solid-source precursor synthesis of continuous monolayer (1L) MoS2 films at 560 °C in 50 min, within the 450-to-600 °C, 2 h thermal budget window required for back-end-of-the-line compatibility with modern silicon technology. Transistor measurements reveal on-state current up to ∼140 μA/μm at 1 V drain-to-source voltage for 100 nm channel lengths, the highest reported to date for 1L MoS2 grown below 600 °C using solid-source precursors. The effective mobility from transfer length method test structures is 29 ± 5 cm2 V–1 s–1 at 6.1 × 1012 cm–2 electron density, which is comparable to mobilities reported from films grown at higher temperatures. The results of this work provide a path toward the realization of high-quality, thermal-budget-compatible 2D semiconductors for heterogeneous integration with silicon manufacturing.
- 24 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (35) , 41866-41874
Toward Low-Temperature Solid-Source Synthesis of Monolayer MoS2
Two-dimensional (2D) semiconductors have been proposed for heterogeneous integration with existing silicon technology; however, their chemical vapor deposition (CVD) growth temperatures are often too high. Here, we demonstrate direct CVD solid-source precursor synthesis of continuous monolayer (1L) MoS2 films at 560 °C in 50 min, within the 450-to-600 °C, 2 h thermal budget window required for back-end-of-the-line compatibility with modern silicon technology. Transistor measurements reveal on-state current up to ∼140 μA/μm at 1 V drain-to-source voltage for 100 nm channel lengths, the highest reported to date for 1L MoS2 grown below 600 °C using solid-source precursors. The effective mobility from transfer length method test structures is 29 ± 5 cm2 V–1 s–1 at 6.1 × 1012 cm–2 electron density, which is comparable to mobilities reported from films grown at higher temperatures. The results of this work provide a path toward the realization of high-quality, thermal-budget-compatible 2D semiconductors for heterogeneous integration with silicon manufacturing.